Mazda - Protege :: 1999 - Idle Speed Is Higher Than Normal
The idle speed is higher than normal, about 800-900 RPM. Whenever I stop for the traffic light, the engine will behave as if someone is pressing the gas pedal intermittently. It has new spark plug wires and coil.
View 8 RepliesMazda :: 1996 Protege - Lower Climate Control Hard To Move
128,000 + miles... The lower climate control is physically hard to move like something is blocking it. However, the intensity control moves just fine. Both do their job of controlling the temperature/intensity, etc. Why might the lower control be hard to move? Can I fix it myself?
View 3 RepliesTouareg :: 2004 - Front Left Air Suspension Sitting Lower Than Normal
By way of brief background, I have a 2004 Touareg with 180,000 miles. I recently noticed that the front left air suspension was sitting lower than normal after the truck had been sitting. I discovered that the shock was leaking air and in the subsequent days began getting "Running Gear Workshop" warnings on the MFI. I got both the orange ones and a red one that instructs you to stop immediately. It reset after parking, and restarting. In summary, I knew I had a problem.
Today, I stopped at the dealer and they confirmed that the fitting at the top of the air shock was in deed leaking. Attached is a photograph showing the fitting. It is important that you inspect these fittings ASAP if you have air suspension. There is a TSB that references corrosion and possible failure. See TSB 43 07 01
Initially I was told that the entire air shock would have to be replaced but after doing research and with the assistance of Spockcat, I discovered that the fitting can be replaced assuming the female portion of the connection is not corroded. Replacing the entire air shock assembly is expensive. Apparently, there have been some instances where the fitting has failed during driving and bad things happen.
Mazda - Protege :: 2003 - Unable To Shift Into First Gear From A Stopped Position In Hot Weather
This issue with my 2003 Mazda Protege 5, manual transmission, has been going on for years. I'd like to sell the car, so I'd like to fix it.
On occasion I am unable to shift into first gear from a stopped position. This never happens in the late fall, winter, or early spring - it all seems to depend on how warm it is outside. It is always fine at the start of the trip, but becomes a problem in what seems like a period of time proportional to how warm it is outside. Again, when its cool outside, it pretty much doesn't happen. But once we pass 25C / 77F it is common, and will almost certainly happen on any trip of over a 10 minutes. The hotter the weather, the faster it shows up as a problem.
If I leave the car and come back after it cools down, first gear works fine again. And I can downshift into first gear as I come to a stop with no issues - I just hate riding the clutch like that, so I've been starting in second gear instead.
Mazda - Protege :: Bucking / Hard To Shift Into Gear / Chugging / Slight Odor Of Oil And Very Slow Moving
1996 Mazda Protege, 133224 miles, mostly city driving, automatic transmission
This weekend the car started bucking, problems shifting into gear, chugging, slight odor of oil, very slow moving. This morning (in my pf's) I ran the Scan OBDII and there were no error messages. I checked fluids and they were fine.
Possible problems? I am at a decision point, get rid of the car (needs tires, front brakes and it burns a bit of oil each month (1-2 cups) or fix it.
Mazda :: 2002 Protege 5 - Hesitation At 3k Rpm
Have 2002 mazda protege 5 . During acceleration at 3000 rpm the engine hesitates. Computer said o2 sensor, replaced it but that wasn't it. Drilled out both catalytic, that wasn't it. Found hole in mass air flow tube, figured that is it. I haven't replaced that yet, however I used gorilla tape thinking it would be a temporary fix but that didn't work. I know I need to replace that tube, but think that it may now be a fuel pump issue??
View 5 RepliesMazda - Protege :: 1999 - Won't Start When Hot
I have a 1999 Mazda Protege. As of last summer it started giving me problems with not wanting to start after I had driven it around town for a little while. (IE: to the grocery store, to the bank and then to my sister's house. It wouldn't give me the same problem if I just went to the grocery store and back home. It would start up fine and I'd be on my way. Only when I went somewhere and shut it off then repeated that a couple more times.) I took it to a mechanic who wholeheartedly believed it was the coil packs not allowing my car to function properly.
So we replaced those and everything seemed on the up and up. (Keep in mind that this was towards the end of summer and the temperature was dropping.) The car was perfect all throughout the fall and winter, but now that the temperature outside is starting to rise again it's beginning to do the same thing it did last summer. I don't want to take it to another mechanic that's going to have me dish out an extravagant amount of money again only for the problem to persist.
Mazda :: Protege ES 1.8L - Rattling And Knocking Front End
2000 Mazda Protege ES 1.8L
What's a good way to find whats the cause of all the rattling and knocking in the front end of my car when going over uneven terrain? It seems that noise appears only if one of the wheels is lifted up a little bit. I am attaching a picture describing the "motion" here:
Steering wheel doesn't shake when driving at high speeds and is fairly stiff, but it does pull to the right a bit, maybe because I didn't perform a front end alignment (I know this is not good) after I had most of the stuff in the suspension of the replaced; all 4 struts + boots + mounting blocks, ball joints, control arms...
Now the only part, I didn't replace was the sway bar link on the passenger side and it's being knocking for 3 years. The one on the driver side was replaced at the time the struts were replaced but I didn't have enough money to pay for the other one.
Another mechanic told me when I was quoting that sway bar links aren't really necessary as a safety feature, and a google search showed me that there are people that just take the sway bar off the car, so I left it there and just tried to live with the noise. now I am noticing the driver side is knocking as well, and I am wondering if it has to do with because I didn't replace the one in the passenger side?
I just want to rule out the possibility of another component being the cause of the noise because I am prioritizing safety over ride comfort in my attempts to save some money.
Mazda - Protege :: 1996 - A/C Isn't Blowing Cold Air
it was over 100 degrees today in Lawrence, Kansas and on the way home from work, the air conditioner stopped making cool air. Hot air now comes out. This is a different problem that the poster before me seems to have. Mazda Protégé, 1996, 128,000 plus miles on it.
A reconditioned one was installed in 2006, compressor replaced in July, 2012.
Mazda - Protege :: Loud Tire Noise Between 20 And 40 Mph
I read here that some tire noise can be caused by bad belts. How do you know if the tire belt is bad? My tires get loud between 20 and 40 mph. Mechanic says the tires are OK but to replace them to get rid of the noise.
View 7 RepliesMazda - Protege :: Brakes Stuck And Burning Up
Basically, my car (2002 Mazda Protege) has been acting like my brakes are engaged. Not all the time, though - The first time I get out and drive it, it drives smooth as silk like always. But then after I put it in park and then get back in and head out (I'm a delivery driver, so this is constant), sometimes it feels like the brakes are constantly being pressed. No, the emergency brake is not on. Most of the time it's almost not even noticeable so, like an idiot, I put it off for the past week. But today, it was very, very, very bad. I was having to press the gas to the floor to get up to speed, and then it was constantly trying to slow down. My brakes were definitely getting burned up while it was doing this, but luckily it stopped.
It may be unrelated - I know I have an oil leak, but today I saw a very unusual spot where something leaked out in my driveway. I checked my oil, and it was where I expected it to be, but this was a relatively large stain which would be very unlike my current leak.
Mazda - Protege :: Little Hesitation And Jerkiness During Acceleration
Started my car yesterday and as I was accelerating, it made a very loud noise. It sounds like normal engine acceleration noise, only ten times louder. It was present whenever I accelerated, but not when I was coasting or idling, and not when the car was in neutral. (It's a stick shift.) During acceleration, there was a little hesitation and a little jerkiness, but not horrible. The problem came on suddenly - no problems with the car before yesterday.
View 4 RepliesMazda - Protege :: Generator Or Alternator Same Thing?
My Mazda 1996 Protege appears to have no alternator, but there is something called a generator. Are they the same thing?
View 19 RepliesMazda - Protege :: Dashboard Lights Cutting Out
Here's a quandary for those who know more than I do:
I have a 2000 Mazda Protege with 182,000 miles on it. On occasion my dashboard lights (and radio, for that matter) cut out, going completely dark. Now here's the kicker: If I give the dashboard a little tap with my hand, everything comes back all glowing and lit.
My fear had been the alternator was going bad (Again!), but since it seems to be coming back with a bop on the dashboard...is this just a loose ground? What should I be looking for? Is this something a novice like myself could be taking care of, or where should I be directing my mechanic?
Mazda - Protege :: 2003 - CEL Came On Again / Engine Without Motor Oil?
I have a 2003 Mazda Protege. I had the check engine light come on and took it to my local repair shop. They diagnosed it as a bad oxygen sensor. They replaced it, but a week later, the light came back on. So, I decided to take it to the dreaded dealership and pay for their "expertise". They informed me that the light was a result of a intake hose with a hole in it. They also told me that the vehicle's oil pan was rusty and needed to be replaced. The vehicle did not leak oil. After a week of driving, I noticed spots of oil on my driveway. I checked the oil and it was low, so I decided to have it towed back to the dealership to have it checked out. I assumed it was the oil pan that had not been installed properly.
Today, the service tech informed me that my engine was blown and needed to be replaced. He told me that this cam warped and didn't leak before because the pressure was being release through the rusty oil pan. This sounds absurd to me. It seems to me that what has happened is their responsibility. What could have caused this? A co-worker suggested that more than likely the mechanic could have made a mistake and started the engine without motor oil either after the oil pan was replaced or after the vehicle sat overnight and the oil drained out. Does this seem more logical? If the dealership is at fault, but will not fix it, what can I do?
Mazda - Protege :: Stalling But Would Never Loose All The Power
I was driving my car on the highway, stopped to get gas and it started stalling but would never loose all the power. The check engine light did not go on. They have replaced spark plugs, hoses and it keeps doing the same, they told me there could be water in the fuel i pumped so i burned through the gas, drove 5 hours back home and when going uphill i would give it gas the rpms would go but no speed.
I took it to the ford/mazda dealership in town and said that the codes it was giving em they could not decipher, their best guess was a timing belt issue, they suggested i took it to an exclusive mazda dealership...but the closest one is 3 hrs away. They said it wasn't my transmission. There is no set speed when it stalls..it does it often maybe every 20 seconds or so...the car is a mazda protege 2000 with about 140000 miles...
Mazda - Protege :: 2001 - Getting Code P0421
I have sel code of P0421. What are the odds of the downstream sensor being bad vs a bad catalyst converter? The car runs great and I get 19+ mpg in town driving. It is a 2001 Mazda Protege, 2.0L V4 .....
View 15 RepliesMazda - Protege :: 1998 - Won't Start At Cold?
I have a 1998 Mazda Protege LX 1.5 L 4 Cylinder and i have been having some starting issues, and stalling at stop lights.
To be clear i have replaced/cleaned, Injectors, Spark Plugs, Spark Plug Wires, Distributor Cap, Distributor Coil, Air Filter, Cleaned MAF, Cleaned the EGR Valve,
My car won't start in the morning, just gives cranks but if I press gas pedal it starts and have to keep it until engine gets hot enough. then it works till the car cools down again, and repeat the problem in the morning when I have to go to work. When the car is warm it starts fine but has idle issues regardless of temperature. As usual when the engine is cold or cool, it won't start.
Visited 2 different mechanic shops and the problem still exist, I don't know how and what they did it, it only worked for couple of months and the engine noise was bit high, I believe he just increased the idle, When i am at stop lights it has a rough idle and tries to die, When it idles it idles rough, Every once in a while I get a CEL Cylinder Misfire on cylinder 4. I'm confused on want to do , Don't know what else to do and its getting tiring, The car also feels like a lack of power.
Mazda - Protege :: 2002 - Won't Accelerate Properly?
I own a automatic 2002 Mazda Protege with about 167,000 miles on it. The other day I was at a stop light and when I accelerated it felt like the car was taking longer than normal to get into gear. I am scared that it may be a transmission problem.
View 2 Replies