Infiniti :: 1999 I30t Will Not Crank / Start Up - Only Clicking Noise When Turn The Key
I have am 1999 Infiniti i30t. My car will not crank/start up. When I turn the key there is only a clicking sound. But the car lights & hazard lights do work. What I think I'm hearing is the alternator when I try to start it. We have tried to jump start it, no success. Jump starting the battery got it going but it would only last about 5 minutes before it was dead again. When I turn the key there is just a clicking sound.
View 2 RepliesInfiniti - I30 :: Starter Clicking When Turn The Key / Car Doesn't Sound Like Cranking Or Even Trying To Start
I drive an Infiniti i30. When I bought it, the guy who sold it to me told me that the car runs great but that I would have to turn the key kind of hard to get the car started. Over time, this problem has progressively gotten worse. There have been times where I'd be stuck in a parking lot for over an hour trying to get the car to start. When I turn the key, I can hear the starter clicking, and all of the dash lots and radio will come on but the car doesn't sound like its cranking or even trying to start. The weirdest thing is that the first time I drive my car in the morning it starts up just fine. It's once I turn the car off after driving somewhere and try to start it again that I have problems. I'll have to turn the key 100 times or more sometimes to get it to start if its not the first time of the day. What this could be?
View 4 RepliesInfiniti :: 1999 I30t Will Not Crank / Start Up
I have am 1999 Infiniti i30t. My car will not crank/start up. What I think I'm hearing is the alternator buzzing when I try to start it. We have tried to jump start it, no success. jump starting the battery got it going but it would only last about 5 minutes before it was dead again.
View 4 RepliesToyota :: 1999 - Grinding Noise On Cold Start
I have a 99 Toyota Tacoma 4 cylinder. Just reached 200,000 miles this past Sunday. I did a cold start this morning and there was a grinding, metallic noise from under the hood. I turned the key bafk because it didn't sound good. Turned the key again and it started like normal and ran fine. I had a new starter installed last Thursday and now I'm wondering where this noise is coming from. Before I changed my starter, I had the bad starter symptoms in the last two weeks, slow to crank over, the whining airplane noise (happened 3 times in the last 3 weeks). But now, this new grinding noise has me even more worried. Does my engine have to get used to the new starter and what other issues could this be? The battery passed the battery test at Autozone, and my alternator is fine as i unplugged the positive and negative wires from the battery while was truck was running. I really really like my truck and am trying everything in my power to keep it running as smoothly as possible.
View 19 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Grinding Noise When Drive Slow And Especially Turn To The Right
Have an f350 4x4 diesel that when I drive slow and especially turn to the right it makes a grinding noise. It seems to either go away or just gets muffled by road noise when cruising. The ball joints were bad so I replaced them and I figured with this especially when I turn right it had to be a wheel bearing so I replaced both of them and still same thing. Don't want to throw money at it hoping to fix the issue. Also front duff is full of oil.
View 5 RepliesInfiniti - I35 :: Rattles / Grinding Sound When Car Is In Motion
I have an Infiniti i35 with about 150,000 miles that has a grinding sound that the car makes when the car is in motion. If I come to a stop, it goes away. When I start to move, the sound comes back very slowly and increases with speed. The noise doesn't go up but the grinding just goes faster. On the interstate, the steering wheel shakes a little and I can feel the gas pedal shaking too. What could this be?
View 4 RepliesInfiniti :: 2003 - Ignition Won't Even Turn Over After Alternator Change
have a 2003 infiniti m45...was showing the battery light; co-worker tested with a ohm meter and the reading was 12.5(before stalling); suggested the alternator was bad. Just replaced the alternator and now the ignition won't even turn over(dead as a door knob)...before the change, removed the battery(which is dead by now), followed the steps and now I'm dumbfolded...what could be wrong?
View 4 RepliesInfiniti - G20 :: Turn Signals And Hazard Lights Not Working?
Recently my Infiniti G20's turn signals and hazard lights stopped working. I replaced the flasher relay and turn signal switch but it did not solve the problem. Here is the kicker or clue. The lights flash when locking or unlocking the car with the remote FOB.
View 7 RepliesLexus IS 2014+ :: Grinding Noise And The Hub Became Difficult To Turn
I am replacing the rear passenger hub assembly and as soon as i put a significant amount of torque to the axle nut...i get a crazy grinding noise and the hub becomes very difficult to turn. When I disassembled the old assembly it took very little effort to push the axle freely in the splines of the hub after i took the 32mm nut off. Now when i start to get the grinding, i remove the axle nut and it take some serious whacks with a larger hammer and brass drift to free the axle spline in the hub.
Ive dug around online and found someone that had to slip a couple pieces of wood in between the sheet metal dust shield and the end of the axle to fully seat it.
Camry :: 2009 LE Grinding Noise On Sharp Left Turn?
I have 35k on my 2009 camry, (past warranty). All of a sudden in the last few days when I make a sharp left turn (like into a parking spot) I hear a grinding noise from my car. Not really a full on grinding, but like a quiet fart can muffler noise. No issues with alignment, driving straight, or sharp right turns.
View 5 RepliesPrius (Gen 3) :: Grinding Noise From Front End When Applied Brakes At U Turn
Coming to a left turn signal I was anticipating it turning red on me, and I drove into the turn lane briskly 30mph and then applied brakes as I made a u-turn. It sounded like a cross between dragging the front air dam and metal on metal brake grinding as I made the turn. Stopped immediately and did not scrap the air dam and all front end components checked out, okay. Car is driving just fine now, has only done this once.
View 18 RepliesPrius (2010-12) :: 2013 - Grinding Noise When Making U Turn
What might be causing this symptom?
View 14 RepliesGolf VI R :: Honking / Grinding Noise At Max Turn Slow Speed
A sort of honking/grinding noise, like really loud squealing brakes - but a lower sound, when at low speed, with the wheel turned right for maximum turning. Generally located in the front end.
It occurs consistently when I am returning home, slowing to a stop to pull around a curve in the road, right before I back into my driveway. It occurs with the clutch in or out, and with the brakes on or not. I tried doing slow sharp turns in a parking lot and I can't replicate it there.
It's happened for almost as long as I've had the car, and there's only about 1300km on it now. I've just been trying to track it down to replicate for the dealer. Taking it to the dealer is obviously my next step. I think I'm going to have to take a tech for a ride to my house to replicate it!
Car is completely stock so far.
Golf IV R32 :: Grinding Noise While Making A Left Hand Turn
The other day I hit a good size bump at speed, slightly bent a wheel which I didn't even notice at first. The car drove straight and had no other symptoms, thought everything was okay. A couple days later I heard a weird grinding noise while making a left hand turn, it was so faint I honestly thought it was the fender liner. After the noises continued and further examination I noticed that the carrier is rubbing the rotor on the lower drivers side corner.
View 1 RepliesCamry :: 2007 - Steering Wheel Grinding Noise On Left Turn
Lately my 2007 Camry (2.4 L, Auto) has developed a bit strange problem. When I'm driving on highway, even slight left turn results in a grinding noise and sort of resistant steering wheel. It happens only when I turn left. As soon as steering wheel gets back to straight, the noise and steering wheel resistance/hardness goes away. I don't really feel much when I'm driving slow on the city streets. Although some time when I am little bit fast, I feel slight grinding noise and steering hardness. No problem in turning right at all.
View 5 RepliesGmc - Yukon :: 2007 4WD - Grinding Noise In The Front When Make A Sharp Turn
I'm having 4WD problems with my Yukon, but the dealer keeps telling me there's nothing wrong with it (this has been going on for 2 winters now), which is either code for, "let's wait until it's extended warranty expires, so we don't have to pay for it," or "the computer says nothing is wrong, so that's all we're going to look at." When it's in 4WD, anytime I make a sharp turn or even turn a corner there's a grinding noise in the front, if I try to back up, it will only go as far as one revolution of the tires then stop (I have to take it out of 4WD to backup), eventually the "Service 4WD" light comes on, but apparently nothing gets recorded on the computer. It has 32,000 miles on it.
View 6 RepliesFord - Explorer :: 2013 - Grinding / Rubbing Noise In The Middle Of The Turn
My new 2013 Ford Explorer Limited (5000 miles) recently started making a grinding/rubbing noise with a slight to significant braking action in the middle of turns (typically left turns, at moderate to slow speed, e.g., at stoplights) when my foot is on the accelerator, not the brake. Lasts about 1 second, happens once a day or so, typically when the car is cold. The dealer was flummoxed, tried replacing the steering gear, but the same thing happened as soon as I drove out of the lot. Apparently no codes showing on brakes or ABS.
View 2 RepliesGTI 337/20th Anniversary :: Clicking / Grinding And Creaking Noise When Turn Wheel
I've just started noticing a "clicking/ grinding/ creaking" when I turn my wheel. It makes the noise if I'm parked, or driving slowly. I can feel it in the steering wheel, and hear it in the cabin, but can't hear anything when I'm under the car.
It sounds like 'two pieces of rubber binding on each other', is the best I can describe it. I THINK its coming from the driver's side. I've considered: strut mounts shifting, CV joints, something in the steering column, Tie rods, power steering pump...
Everything is tight on the wheel when I try to move it by hand (on jacks), and no rips/ tears in any boots.
Ford Ranger / B-Series :: Grinding / Rubbing Noise In Left Turn Only
I recently acquired a B4000(for a steal!), had it almost a month now and im starting to notice a few problems, all driveline related (I think).
1. Have a "grinding/rubbing" noise in a LEFT turn only. It is a 4x4 and I haven't turned a bolt on it yet, save for very minor stuff. Since this particular model has some costly parts, I'm trying to prevent buying unnecessary parts! I have a set of 31 x 10.50 on it, and even though there is some minor tire rub, im 90% certain this is not the case.
2. Has a somewhat "hard" shift when going into O/D(I think), doesn't do this all the time, I wonder if problem #2 and #3 are related.
3. Appears to be about 1in slack in the rear driveline, wondering if it is the rearend, and specifically the spider gears or pinion?
4. Also seems to be just a LITTLE slack in the front left CV axel, is this something I should be worried about? the front right is good and tight, Tcase shifts like its suppose to.