Accent MC (2006-11) :: How To Change Internal Heater Radiator
It is a bit 'of time i notice that the water level goes down more than usual. Lately, the level drops from max to min in a month or so and, in addition, i smell of mold inside the car.
In the past I had the same problem on another car, and it was the tap on the radiator, which leaked. In the case of Rio/Accent, the radiator is a single body, so i suspect that will be drilled. Is it possible to remove it without completely dismantle the dashboard, as happens in many modern cars?
In the past i seem to have touched the internal radiator hoses, on the passenger side, but does not know if there's enough space to pull it off.
Ford Aerostar :: 1992 - AC Hoses Block Radiator Removal
On my 92 Aero 4.0L with A/C, I need to replace the radiator but I am not sure how to move the A/C hoses out of the way to extract the shroud and the radiator.
I have viewed a video where a guy said to remove the serpentine belt and then unbolt the A/C compressor and move the compressor and hoses out of the way. Hope this means that I don't have to discharge or disconnect AC hoses. Not good for me.....
Well, the video instruction seems simple enough......but there doesn't appear to be enough "play" in the AC hoses to move them far enough to extract the radiator, and not being an AC guy (and the potential danger of releasing freon), I am at a loss.
How to move the AC hoses out of the way (without disconnecting the hoses or discharging the system) ....
Not to mention it would be great to find out what the torque specification is for tightening the AC compressor bolts for proper reassembly. And being the backyard mechanic I am, any drawings, details or diagrams that you can provide would be very useful.
BTW, I have looked in the forum for radiator removal information and none of the threads I read addressed moving the AC hoses (which of course run right over the top of the dang radiator).
If I get past these "hoses" I will also take advantage of the radiator removal to replace the fan and fan clutch and thermostat while I am there, but first things first, if you know what I mean.
Ford 6.0L Power Stroke Diesel :: Mishimoto Radiator And Hoses Leaking
In April I replaced the radiator, hoses, water pump and Tstat. I used Mishimoto for the radiator and hoses (silicon). I am having trouble with the hoses leaking where they clamp to the radiator. I put 2 on the lower hose and that seemed to work. No other signs of leak on than drip from the top hose - factory clamp is on and tight as I can turn it - still lost a gallon in 2-3mo. Should I just get a new clamp? OEM stuff was not this prone to leaking ....
View 14 RepliesFord A/C :: 1998 - No Heat / Heater Hoses Cold
My son's 98 Expedition has no heat. The radiator and overflow tank are full, there's no air in the system. The radiator hoses get nice and hot but the heater hoses stay cold. We can hear the flow through the vents change when we change the temp control so I'm sure the blend door works fine. Seems like the problem is that no hot coolant is making it to the heater core. So I'm wondering if there is a diverter valve somewhere that could be bad that's keeping the hot coolant away from the HC or if a clogged HC is the only thing that could cause this.
View 1 RepliesFord F-150 - 1997-2003 :: Hooking Up Heater Hoses
I've replaced my heater core and blend door in my 2000 and getting ready to button things up. Can I hook up the heater hoses after the plenum top is screwed on to keep the core from moving when pushing on hose connections?
View 1 RepliesFord F-150 - 1997-2003 :: No Heat Even Changed Radiator / Thermostat / New Upper / Lower Hoses?
Ok I have a 97 f150 4.6L. My radiator has been bad for a while. With brown rust color. I replaced my radiator, thermostat, new upper and lower hoses. Everything runs great but I have no heat. I flushed everything including the heater core. Core is not leaking into cab, and both heater hoses are cold. What should I do next FYI heat worked great until 5 days ago.
View 14 RepliesFord F-150 - 1997-2003 :: No Heat / Both Heater Hoses Are Cold
Ok I have a 97 f150 4.6L. My radiator has been bad for a while. With brown rust color. I replaced my radiator, thermostat, new upper and lower hoses. Everything runs great but I have no heat. I flushed everything including the heater core. Core is not leaking into cab, and both heater hoses are cold. FYI heat worked great until 5 days ago.
View 7 RepliesFord Excursion :: Heater Core Hoses Run In Parallel Or Series?
I really need to know. Since the X has 2 heater cores, how do the hoses run that connect the two together? Do they run in parallel, or in a series?
View 5 RepliesFord - Explorer :: 2001 - No Heat - Heater Hoses Don't Feel Hot
I've checked just about everything, coolant level is good, engine gets hot, heater control valves moves, blend air door moves, the heater hoses don't feel as hot as I think they should, but the gauge reads in the middle, I burped it thoroughly and still no heat , blower works i actually can switch the blend air door manually, but no change! what am i missing? t-stat was changed too. 2001 sport trac....
View 2 RepliesFord Aerostar :: Minor Coolant Leak Coming From Heater Hoses
I'm feeling a bit embarrassed posting my delima, but I have a minor coolant leak which seams to be coming from where the heater hoses connect to the water pump and as well to the thermostat nuckle thingy. I have replaced all of the hose fittings with SS band clamps.
A couple of weeks ago I replaced the water pump, thermostat, alternator, rad hoses, belts, coolant sensor, PS tension pulley. The water pump is now tight and sealed. Since then the temperature gauge has been continually fluctuating from Normal to near Cold.
I was wondering if I should have placed some type of sealant compound where the heater hoses connect to the water pump and also to the thermostat nuckle thingy.
Initially, I thought it may be residual trapped air in the coolant system. But after a week, it became apparent that the heater hoses were leaking at the engine, and at the water pump, connections.
What puzzles and torments me is why is the temperature gauge fluctuating so widely up and down? This is totally weird.
Ford - F250 :: 1976 - Replaced Hoses / Belts / Water Pump / Fan Clutch - Flowed The Radiator Still Overheating?
I have a 76 f250/460 engine. I have replaced the hoses, belts, water pump, fan clutch, flowed the radiator and it still overheats.
View 4 RepliesCorolla / Matrix 2009-13 :: 10th And 10.5 Gen Radiator Hoses?
I'm wanting to know if the hoses are the same?
i assume they are but never seen the under hood of a 10.5.
Toyota - Camry :: 1998 - When Drive For About 30 Minutes Both Radiator Hoses Expand
I have a 98 Toyota Camry, when I drive it for about 30 minutes both radiator hoses expand and seems like they want to burst.I removed the thermostat but still acting the same. Seems like the car is building a lot of pressure from the engine.. What could this be? Already replaced the water pump and have a new. radiator... The car does not overheat with or without the thermostat.
View 6 RepliesNeon :: Constant Overheating Due To Blocked Heater Core Hoses?
I am working on a friends Neon and he been having an issue with constant overheating even through he has replaced the thermostat, the radiator, water pump and related hoses. However, he is missing the cap to the coolant tank and his heater core hoses are blocked, both incoming and outgoing. Could the blocked hoses be causes it to over heat?
View 1 RepliesFord Ranger / B-Series :: No Heat But Hoses Are Warm / Hot To The Firewall
1998 Ranger. I have no vacuum to the heater control valve (see link below) and hoses are warm/hot to the firewall. Where to start troubleshooting?
More Information for FOUR SEASONS 74809
Ford Ranger / B-Series :: 2002 - IMCR Vacuum Lines - Where Hoses Go Off
Looking for a pic of where the 2 vacuum lines go off the IMCR on a 2002 ranger 2.3. Changed engines now not sure where these hoses go.
View 2 RepliesFord F-150 - 1997-2003 :: Radiator Fluid Is Of Orange / Red - Change It?
I just bought a used 2000 Ford F150 with the 4.6L V8 engine and I have a question about radiator fluid.
In the owner's manual it says that if the radiator fluid is green is should be changed every 30k miles, but if it is orange color it is only changed at 150k miles. I look at the radiator fluid and from outside the plastic case it is in it has a dark'ish orange/red look. When I shine a flashlight down the hole where you would add more fluid it looks orange/red, but also has a green tint when the flashlight shines directly onto the fluid.
How do I know which kind I have forsure? The truck was bought at a Ford dealer, but I never thought to look at it while I was there.=
Ford - Explorer :: Temp Gauge Rises And Falls After Thermostat Change And Radiator Drain And Fill
I did an engine swap for a junkyard motor my 4.0 ohv had a very bad rod bearing so I got one from the junkyard with 117,000,or so they say.Anyhow, after its all said and done it runs perfect except the temperature gauge seems to not get as high up on the gauge as before after sufficient driving(it used to run about middle of the gauge) it drops low at idle then goes up and stays up then goes down.it still has good heat, doesn't seem as good as before tho.I changed the thermostat also.
View 8 RepliesFord Ranger / B-Series :: Oil In Radiator Fluid?
I bought me a 1993 Ford Ranger with 3.0L and 123K miles a few months ago to save on some Fuel. My F-250 was killing me. The Ranger Runs Great! Lately My Check oil Light has been coming on. So I have Checked the oil and it was slightly below the Full line each time the light came on, so I added each time. I have been wondering where the oil has been going cause it has not leaked anything on the ground. Thought it might just be burning a little oil. Well I come out today and on the front right side I see a small area of leaking Fluid. Of course it being Green I knew it was Rad. Fluid. So I Checked Fluid at the Rad Cap and it was Clean and not that low. Then I go and Check the Rad. Overflow Res. and it is Brown. and I can see where it was overflowing a little out into the engine Compartment. So that Kinda of explains where my oil has been going. I am aware the trans Fluid Cooler is in the Rad. and I am 99% sure its oil since I have been having to add oil. I have also Checked my Oil and no Rad. Fluid is getting in the oil at all.
Anyways I have done a little Research and I have seen Blown Head Gasket and Cracked head a lot in my research. So I am guessing I am looking at one of these two issues? Or is there more possible issues that it might be? As little as I paid for the Truck I dont think it would be worth fixing if It was one of those two things.