Ford Ranger / B-Series :: 1998 - O/D Light Flashing And Truck Shifting Hard
I am having a problem with my O/D light flashing and my truck shifting hard. Just started out of the blue. After reading a few other topics, I am hoping it is the VSS. Now if only I could find the dang thing. Looking for a diagram, or detailed description on where it's at?
View 14 RepliesFord Wiring/Electrical :: 1995 - Speedometer Not Working / Transmission Shifting Hard And OD Light Blinking
I recently purchased a 1995 F150 4x4 with the 351 Windsor. Upon driving it I realized the speedo didn't work, transmission shifted hard,and OD light blinking. After googling my issue I found out it was the VSS. I climbed under the truck to find out the VSS isn't even plugged in. I searched for the wire but could not find it, only a spliced cable.....
View 4 RepliesFord - Ranger :: 2000 XLT Auto Transmission Shifting Hard
I have a 2000 Ford Ranger 4X4 XLT with a 5R55E automatic transmission.
Coming out of a stop the truck jolts at about 20 mph as it shifts from 2nd to 3rd gear. It feels like it revs too high in 2nd gear, up to about 2400 rpm, and then shifts hard into third. It feels like the truck gets a gentle hit from behind.
Earlier in the week, the O/D light flashed. I took it immediately to an independent tranny shop who pulled the code for me: P7033, incorrect ratio in 3rd gear.
They cleared the code for me. In limited city and highway driving (less than 15 miles each trip) the O/D light has not flashed again. But the problem remains. I plan to take it back to the shop later next week.
What might cause this so that I might have a more informed conversation with the tranny mechanic?
Ford - Ranger :: 2002 - No Clutch Pedal Or Shifting Hard
When I bought my ranger used, the clutch felt ok. But as a couple weeks had passed, it started to get hard to shift. The clutch doesn't slip at all so a friend of mine said there might be air in the system.
I would pump the clutch pedal a few times and then it would shift ok for a while, then back to shifting hard. I found the bleeder and had my son assist me with bleeding the system. Everything was fine at first but I made a big mistake and now i have no pedal feel at all.
My mistake was i didn't realize what I thought was the reservoir was not the actual reservoir. There was a black rubber thing in the reservoir that I filled with fluid. My mistake was I needed to take out this black rubber thing.
So now i am stuck with no pedal and don't know what to do. When I pulled out the black rubber thing, the reservoir was empty so i filled it and it bubbled for a second and then stopped. Tried pedal at this point and there is no feel at all. It just goes to floor with no effort.
Ford Ranger / B-Series :: 1998 - How Hard Is It To Replace A Clutch
I think the time is near for a new clutch in my 98 Ranger, 2wd/ 5 spd. How tough of a job is this? I've changed the one in my 66 Mustang years ago but things were less complicated then.
View 3 RepliesFord Ranger / B-Series :: Shifting Hard / Clutch Won't Disengage At All After Master Cylinder Replaced
My Ranger had been shifting hard for quite awhile. I recently opted to go ahead and replace the clutch, throwout bearing, had the flywheel turned and replaced the pressure plate.
This just seemed to make the problem slightly worse. I thought it was possible that my master cylinder needed to be replaced (the slave was replaced two years ago and didn't appear to be leaking when I had the tranny off). I replaced the master cylinder and now the clutch won't disengage at all. I've spent several days trying different things to bleed the clutch, and I just can't get it to bleed. I took it back off and bench bled it, then put it back on and bled through the whole system. This isn't working. I've tried numerous suggestions-jacking up the back end of the truck, jacking up the drivers side of the truck, I even bought a vaccuum bleeder and used it for 2 hours just having an assistant fill up the reservoir while I sucked fluid out the bleeder valve. The best I could ever get was some resistance on the pedal, but not enough to push the disc away from the flywheel.
I took the pickup to Ford, they said they bled it and charged me 90 bucks and still couldn't get the clutch to release
Ford Ranger / B-Series :: 1992 - No AC And Power Steering / Poor Clutch Disengagement Resulting Hard Shifting
1992 Ford Ranger 4x2 with 2.3L engine and 5 speed manual transmission. 135,000 miles, no AC and no power steering. I am having poor clutch disengagement and resulting hard shifting. The shop added a little fluid to the reservoir last oil change and it is still looking full. I always park on concrete and never see any leaking. I don't know what may have been done before as I haven't had the pickup all that long. Where should I start? Is there probably internal bypass leaking in the hydraulic clutch as there seems to be no external leaking?
View 4 RepliesFord Ranger / B-Series :: 1995 Mazda B4000 - 4wd Light Blinking 6X Then Go Off
So i just bought a b4000 pickup 5spd .. Anyway the truck has eletrical 4x4 with manual hubs. When i turn the switch nothing happens. The 4wd/4wd low lights both flash 6x then go off then flash again while running , driving, koeo, anytime like an obd1 check engine light code flashing. Anyway i checked the wiring for the 4wd switch no power, went to the fuse interior no pwr, went to the engine fuse box power. You don't hear the transfer case engage at all as well.
View 5 RepliesFord - Ranger :: When Turn The Ignition On Only Airbag Light Blinking And Battery Icons Come On
After a cold night when I turn the ignition on only the airbag (blinking) and the battery (steady) icons come on. No cranking - nothing...After a few anxious tries the full set of icons come on and the car starts.No problems during the day. The battery is one year old.The 2007 Ranger (3L engine) has 180,000miles.I've tried my spare ignition key - no difference.Is this a PAS issue or a sticking relay?...
View 4 RepliesFord Ranger / B-Series :: Check Engine Light Started Blinking On And Off - Code 327 / 328 And 334
I've got a 1992 Ford Ranger 2.3L with about 240,000 miles on it. The check engine light started blinking on and off pretty regularly so I pulled the OBD1 continuous memory codes and came up with this.
327 - EVP/EPT circuit below minimum voltage
328 - EGR closed valve voltage lower than expected
334 - EGR closed valve voltage high
I can't say these codes mean a whole lot to me besides I've got issues with my EGR valve and possibly the EGR valve position sensor. I was thinking I'd start by replacing the EGR valve.
Ford Ranger / B-Series :: Airbag Warning Light Blinking / Bad Lamp In Deactivation Switch
I have a 98 Ranger 2wd reg cab 2.3L 5sp. Recently the airbag warning light was blinking 2-7 which indicates bad lamp in passenger airbag deactivation switch. Since the lamp has no numbers or markings on it, and my repair manual has no schematic on that part, where I can find the ma, wattage or ohm rating of the lamp? Or a part number / source for a replacement lamp?
View 13 RepliesCamry :: 1998 - Green AC Light Blinking - What Exactly It Indicating
Green AC light 1998 Camry. I turned the defroster on yesterday and it didnt work...just started fogging up windows worse... while this was going on the green AC light was blinking. Later the defrost worked fine and the green AC light did not blink .... What exactly the green light is indicating. I would assume it indicates the compressor is on and working.. but dont understand why it blinked and did not work at that time I mentioned, and started working again with nothing being done.
View 1 RepliesMazda - Protege :: 1998 - Check Engine Light Is Blinking
The check engine light is blinking on my 98 Mazda Protege. I'd like to purchase one of those little hand held computers so that I can diagnose the problem myself. Should I leave it up to the professionals?
View 19 RepliesFord Transmission :: Hard Shifting / Speedometer Flickering And ABS Light On
1994 Lightning E40d... I was on my way home from work and noticed my speedometer jumping from zero to around the speed I was going on the highway. Then as i got off the exit I noticed hard shifting. It was in neutral between shifts for a few seconds and then it would go into gear jolting the truck forward. The abs light was the only thing on at the time. I tried turning off over drive only to get higher revs which scared me away from the gas pedal. Since I can't afford to replace my transmission. It happened all the sudden over halfway home from a 35 mile drive. I'm assuming it's some kind of electrical issue. What's going on with my baby?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Hard Shifting - SES Light Lit Up
I have run into a problem. My early '99 7.3 PSD decided to throw a very hard shift at me the other day, lit up the SES light and I had to limp it home going 5mph.
I looked on here and found most problems that caused power loss/engine die and replaced the ICP, IPR, EBP and tube, and the CPS. I also did an oil change after all of that to make sure everything was clean when I went to start it up.
BUT, when I tried starting it, nothing happened. It cranks, but does not start. What is the problem? I watched hours of videos and read hundreds of pages of instructions on how to replace everything, and now the truck won't start.
Ford Ranger / B-Series :: Erratic Shifting And Flashing O/D Light
I have a 2003 Ford Ranger, recently I had the heater core fail. One thing that happened during the heater core starting to leak is the "THEFT" light came on brighter than normal and no longer flashes when the truck is off. Also when the theft light started acting up the O/D OFF light came on and would not shut off. If I pushed the O/D off button the Theft light will go out and then come back on after the button is released.
After the heater core was replaced the lights stayed on as described above. Every once in a while the O/D off light would stay off but then come on later. No really problem besides the lights and O/D off button not working. Now today the O/D off light started flashing and the truck kept shifting in and out of O/D.
I'm leaning towards a speed sensor issue. I'm going to check and see if there is any codes tonight and will post my results. One other thing that happen with the heater core leaking is the "CHECK ENGINE" light came on because the O2 sensor was shorted out. Have the O2 sensor now and plan on replacing it while I trouble shoot the erratic shifting in and out of O/D.
Ford Excursion :: Intermittent O/D Light Flash And Hard Shifting - Code P0720
Having this issue for a while. Finally have time off work to dig into it some more. 00 ex, v10. Intermittently flashes o/D light and shifts hard. I replaced 2 out of the three speed sensors. One at the output and the other on the axle. Only active code is the p0720 output shaft speed sensor circuit. Last weekend removed and inspected harness, did not electrically measure it tho. My question is: intermittent problem? I drove it today to see if it was still doing it and it drove like a dream! Haven't had the battery disconnected or anything, just sometimes it does it and other times it a smooth ride.
View 14 RepliesFord Transmission :: 1994 E350 - OD Light Flashing And Trans Shifting Hard
I have a 94 E350 with a 7.3 diesel. I took it to the Ford dealership to have a new fuel filter and oil change when I got it back the OD light was flashing and transmission shifting hard. They tell me they cannot find a problem could they have possibly knock a wire off of something to make this happen...
View 3 RepliesFord Excursion :: 2000 FWD - O/D Light Flashes - Tranny Shifting Hard Then V10 Dies?
OK, so my 2000 FWD 6.8L Ex has 128k actual miles on the odometer w/ a stock 6.8L from a wrecked later model truck with ~115k actual miles on this 2nd engine from what I was told by the PO/2nd owner (I have no reason to doubt him and I verified the history with the original owner). So I'm guessing that the 4R100 is original without having ever been rebuilt.
I've had zero issues with the drivetrain up to this point, this truck has always run like a top and been very reliable. This afternoon in drive time traffic the overdrive light started flashing and at the same time I noticed that the transmission was shifting really hard (snapping into the next gear) and not in a good way. I was in stop and go traffic when it was shifting weird like this. At one point I make it up to 55+ and I noticed that the O/D light had quit flashing and now it was shifting like it normally does. Then back into stop and go driving the O/D light starts flashing again accompanied by the weird hard shifts.
Next thing I'm sitting there with my foot on the brake fully stopped waiting for traffic to start moving through the traffic signal when out of nowhere and no indication of anything being amiss the engine quits and I get dash lights including CHECK ENGINE and THEFT. I cycle the key off and then try to restart it. It took nearly 10 seconds of cranking to get it to start up however once started everything is back to normal and I have NO trouble lights illuminated including no O/D light and it's back to shifting normally. I continue on in stop and go and highway speed driving for the next 15 minutes like nothing ever happened, transmission is shifting like it always has. The truck has been turned off once and restarted since that incident, yet no other indications of any issue. What's going on?? What to check into?