Ford - Explorer :: 2008 V6 - Erratic / Jumping Idle While At Higher RPMs
My wifes 2008 Eddie Bauer Explorer V-6 recently started having an erratic idle and we've started noticing it while at higher RPM's. Its almost as if there is a cylinder that misfires but no engine light is coming on. The car stumbles like it is going to start to die, then the idle jumps up and smooths out. A little while later it does the same thing. The car has I think 74,000 miles on it and has never had the plugs or wires changed. I change out the fuel filter roughly every 24,000 miles and did it recently in the spring. Any places where I should start looking? Could a misfire not trigger the check engine light?
View 3 RepliesElantra XD (2001-06) :: P0519 Idle Erratic / RPMs Constantly High
My friend was having trouble with her 2001 elantra. Her idle was erratic and her RPMs were constantly high. we checked every where for a vacuum leak but could not find one in any of the lines. We went on to switch out the idle air control valve, the throttle position sensor, and even cleaned out her throttle body. we threw up our hands and sent it to a shop. Come to find out there WAS a vacuum leak. apparently in the air idle control valve sensor there is a gasket that seemed to be missing. I of course didn't think about replacing a gasket when I replaced the sensor because I never saw one there.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Flutter At Cruising Speeds And Erratic Idle
I've been having problems with hesitation and a flutter at cruising speeds as well as erratic idle. I have a 2000 F-250 SD with 497K Miles. I was having poor starts during florida winter ( had to plug in a couple times) Had no oil coming out of #2 inject and #8 buzz was weak. Flutter was there and was the original reason I started digging. Right now the only code Im throwing with my chip turned off is a P0470. I cleaned the tube and the sensor but its still throwing.
I have recently replaced all Injectors, Glow Plugs, Valve Cover Gaskets & Harnesses, CPS, Fuel Pump, ICP was replaced before new plug no oil showing.
Mods: 6637 Air Cleaner, TS-6 Chip
Truck has mad power now no problem starting. Its really starting to frustrate me Ford dealer wont troubleshoot unless I remove the chip. I feel like it should be something simple because on the throttle it will set you back in your seat cruising at 70+ no flutter ..... but slow down to 50 55 in traffic and let off the throttle when you start to ease back into it 1500 - 1800 "buck buck buck" if I monitor ICP pressure I see a fluctuation in psi of about 200 -300 psi (1400 to 1200 or 1000 to 800) . If I throttle harder it will stop or let off the throttle. I can feel it do it sometimes before the TC locks so I dont think its a TC issue. I even tested with OD off and I can recreate. The magic area appears to be 1500 - 2000 rpm....
Ford F-150 - 1997-2003 :: 1999 - Service Engine Soon Light On Sometimes At High Rpm Or Rough Erratic Idle
My trucks symptoms include a illuminated service engine soon light, sometimes a high rpm idle, and sometimes a rough erratic idle. When a scan was done it indicated the oxygen sensor was defective. The issue is: which specific one (there are multiple oxygen sensors) or how could I check or determine the faulty one for sure. I am trying to economize and replace only the bad one myself if possible. I own a good multimeter, can it determine the bad one? 1999 F-150 4.2 Litre V6 oxygen sensor dillemna....
View 7 RepliesGrand AM :: 1999 / 3.4 - Erratic Idle On Start-up
Starts rough but clears up after about a minute, I'm assuming the IAC is sticking. Whats the proper procedure for disconnecting and removing the cleaning and re-installing?
View 4 RepliesElantra XD (2001-06) :: Losing Power After Logging 250 Mi / RPMs Also Become Erratic
I'm currently moving cross-country from LA to St. Louis. Had routine maintenance done b4 I left. I've only made it to New Mexico so far b/c my car is losing power after logging 250 mi. RPM's also become erratic. Doesn't completely stall, but won't let me go more than 45mi/h. After a rest break, the problem doesn't re-create.
At my first mechanic stop, the computer checked-out as ok. That mechanic changed the spark plugs and also told me the 2004 has no fuel filter (fuel filter being my suspicion of what was wrong).
Today it lost power again. Jim Bob at a rural garage said maybe the alternator or fuel pump. I have an appt. at Pep Boys tomorrow, as the dealers don't have any avail appts. until Fri.
The contents of my apt. are in the trunk and backseat. Is it worth it to remove them (to get to the fuel pump) at the cost of another hotel day, or should I limp home at 250 mi. a stretch?
Ford - Mustang :: 1994 - Erratic Idle And Stalling
I have a 94 Cobra Mustang with a 5.0. For the past few months it has had an erratic Idle and stalls when trying to idle. I've had a number of suggestions on how to fix it and nothings seems to work. I checked for vacuum leaks, changed PCV, new plugs, new IAC valve, tested ICM and throttle TPS and even adjusted idle. Still no luck.
View 3 RepliesFord F-150 - 1997-2003 :: Erratic Idle When Get Off The Freeway And Stop
I have an 01 f150 4.6 4x4 automatic with 90,000 miles. I have an erratic idle but it only happens when I am on the freeway well actually when I get off the freeway and stop. the idle will fluctuate between 750and then drop to 400 then back and forth til I get moving again. I replaced the IACV because it was doing the weird humming and vibrating the intake tube. The humming is gone but still idles funny as stated above.
View 4 RepliesFord Aerostar :: Erratic Idle - Air / Fuel Ratio Is Too Lean Or Rich For PCM To Correct
97 shortie. 3.0 245,000 miles. I've already cleaned the throttle body and the idle air control valve. Throttle position sensor reads 5 volts, good ground, and a smooth voltage increase from idle to wide open throttle and back down. Which of these codes is most likely to cause erratic idle? Mostly in the morning.
P0340 Camshaft position sensor.
P1443 Evaporative purge flow sensor.
P0401 Insufficient EGR flow.
P0171 Air/fuel ratio is too lean or rich for PCM to correct.
I doubt it's number 1, and number 4 seems too general to be any use. I'm leaning toward number 3. Seems I read somewhere that the tube from the exhaust gets plugged up. This started when I disconnected a plug from the blue air bag box to get rid of that beeping. Coincidence?
Ford F-150 (2004-2008) :: Vacuum Leak Causing Erratic Idle - Codes PO171 / 174?
I tugged on the little hose on the back pass. side of the engine,(5.4),...
and I could hear the vacuum leak that is apparently causing the erratic idle, and PO171 & PO174 to come up.
I know this hose is hooked to the Charge motion Control Valve on the back of the manifold,..I can't imagine what it does, as it terminates with some kind of plug or check valve??? Haynes say's to remove the entire manifold to get to the CMCV.
I can see it with a mirror,. I am thinking maybe long needle nose from Harbor freight,...bend the tip short,..maybe be able to change it out?????
Ford Escape / Hybrid :: 2001- Erratic Idle Speed Due To Vacuum Elbow Collapsing?
I've read quite a bit in various threads about the large vacuum elbow collapsing, causing erratic idle speeds. My 2001 3.0 had that issue int he past. I shoved a 1/2" copper 45 degree elbow inside of the rubber elbow, and the problem was solved... until a few days ago.
We're now getting into the hot part of summer here. I've notice the same symptoms are beginning to return, once the engine compartment gets hot. My question is... is the large vacuum line a "hard line" all the rest of the way to the engine, or are there other places along it's length that can also collapse under vacuum?
Ford Ranger / B-Series :: Erratic Idle / Sporadic Miss / 3 Cylinders On Right Bank Dropping In And Out
Its a 1994 with 4.0, automatic, 4x4. Running fine, parked it, a week later I'm getting a bad but sporadic miss that according to the stealership is the 3 cylinders on the right bank dropping in and out. Driving down the road you can feel them drop out and when they come back its a kick in the pants like a turbo kicked in.
Shop says wires are good, plugs are good, and then lost me when they started talking around in circles and not making much sense.
What could make 3 cylinders all on the same side of the engine drop in and out? This wasn't anything that slowly came on. Fine one day, crap the next. The only thing I did prior to was replace the IAC because it was idling high, it was cruddy inside, and it looked like it was original. It was running fine after that till this issue popped up out of nowhere.
Mileage was claimed to be 178k but I'm beginning to suspect it's probably 278k.
Ford 6.0L Power Stroke Diesel :: 2005 F350 - Rough Starts And Erratic Idle
A while back my 05' f350 6.0 was having rough starts and an erratic idle. It died coming up to a stop sign it started back up after 2 cranks and then it did that same on the way home. The next day leaving work it wouldn't start. I knew i had a couple injectors on the way out so i decided it was time to replace all 8 upon tearing it down i noticed my oil cooler was leaking so i figured it was time to rebuild that and finally do the egr delete that i had been wanting to do. well i put it all back together and got a no start.
The dash gauge on my oil pressure is reading normal when i cranked it so i went and bought a scangauge2 to read the icp its hitting 1500psi when i crank it. The ipr% is reading good. But my ficm main power is at 26v with the key on then it drop to 14v while cranking and eventually down to about 9v. Its never at the 48v that its suppose to be at. The scan gauge is also showing that my ficm sync=0. Would the sync be showing 0 since the ficm is bad? My batteries are fully charged and i have both of them on the charger while I am cranking it.
Ford Ranger / B-Series :: 1999 - Rough And High Idle At 850 RPMs
1999 B3000 with a 3.0. The truck idles at 850rpms. When it starts it idles at around 1000 and runs very rough. When I disconnect the IAC the engine dies. The AC also has problems it blows cold at idle but at highway speeds after 7-8 minutes running the compressor kicks out. One can turn it off and it blows cold again after a few minutes.
View 5 RepliesFord Super Duty (1999-2016) :: 6.0 Engine Idle RPMs Are About 770
Just changed the oil in my 6.0 and I'm sitting here looking at my tuner and is telling me my idle rpms are about 770.
Before I changed my oil it idled around 750.
It's running fine, I was just wondering why it changed? More pressure to the injectors with the newer oil?
Tiguan :: Erratic Idle With AC On
At my wits end with a Tiguan problem that my dealership seems to be clueless ....
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Idle Surging / RPMs Will Drop By 300 Or 400 For A Few Seconds
My '03 7.3 is "surging" on idle. When warmed up, and idling, the RPMs will drop by 300 or 400 for a few seconds and then will correct and shoot back up. It cycles like this (every 5 seconds-ish) continually . I just put in a new IDM and checked the UVCH - is there a separate idle control mechanism that I need to have a look at? (2003, 7.3, 214K, stock).
View 14 RepliesPassat (B5) :: High / Erratic Idle When Raining
The other day when it was raining out my car started idling below 1,000RPM/running rough. I was thinking it might be the coils, so I changed those, cleaned out my TB (Throttle Body), did a TB alignment (with VAG-COM) and now my car is idling at 1,200RPM and jumping up to about 1,600-1,800RPM, like I'm constantly revving it. I even swapped out my whole TB from my A4 and it still does it! If I disconnect the throttle position sensor it seems to idle normal.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Zero Flow At Idle And Dribble At About 1300 RPMs And Increase
I just flushed my coolant system and installed a red ELC, Riffraff billet thermo housing, Ford thermostat, new hoses and Riffraff coolant filter. When I first started the truck and was waiting for the thermostat to open I notice at idle the flow from the coolant filter into the Degas bottle was a lot.
Fast forward a week and about 75 miles I have zero flow at idle and it will start to dribble at about 1300 RPM's and increase from there. It seems the flow would not be dependent of the thermostat being open since the connection is below it. I am wondering if my Donaldson filter is already full?
I used a flusher that uses air and water, after flushing I used air to blow to tap water out. How fast have you guys seen one fill up? I ordered 2 extra but just do not want to waste the first one