Santa FE SM (2001-06) :: Brake Pedal Is Very Soft And Goes To The Floor Before Braking Occurs
Here's the short of it. 3rd time in a year the brakes on my 2005 SF (177K miles, 2.7L) have gone out.
The brake pedal is very soft and goes to the floor before braking occurs. Typical signs of a bad master cylinder.
The first time was a year ago. I bought a re-manufactured master cylinder, change it and bled the brakes. Worked like a champ and lasted 10 months.
To months ago same exact symptoms. I assume it was a bad re-man part. It's under warranty, not big deal. I do warranty exchange, bleed system, brakes return. All is good.
Less then 3 weeks later, brakes gone, same symptoms! This time I spend the difference and get a brand new OEM cylinder with reservoir. Replace, bleed, problem fixed. Brakes go out in less than a week.
I'm not leaking anywhere. Reservoir is to corect level. ABS light is NOT on. No chattering in brakes. Braking is smooth both when power brakes work and when not. No visible damage to calipers. I'm 99% sure there is no air in the system, but I'm going to try bleeding again. I have not put it up on a lift to yet to check all the lines.
Ford Brakes/Suspension :: 2001 F350 - Brake Pedal Go To Floor As Pressure Is Applied - Bad Master Cylinder?
2001 F-350 / 7.3L / 147K ... What are some symptoms of the master cylinder going out? And is there a such thing as a rebuild kit anymore? The pedal has been getting spongier & spongier over the past months. Truck still stops O.K. but you have to brake earlier than I used to. Pedal can go almost to the floor. Pedal continues to go to floor as pressure is applied. Does not go to floor though.
View 4 RepliesDodge - Dakota :: Pulsation In Brake Pedal And Sort Of Wobbly Feeling In Steering Wheel
I had a front brake job done on a 2002 Dodge Dakota pickup at 85000 miles. When I stepped on the brake, I felt pulsation in the pedal and a sort of wobbly feeling in the steering wheel. Also the brakes were making noises while driving. Classical sign of a warped rotor?! Long story short brand new rotors, brake pads and calipers, later the pulsation is mostly gone but the braking is still not smooth at one point while the tires are turning. Now i do have to older tires on the front but i just bought two brand new tires for the rear. Would it be wise to put the new tires on front to see if there might be some unevenness caused by the old tires before i take it back to the shop?
Also the feeling of the brakes catching on one point seems non existent or so minimal I can not be sure if the road surface interfering while driving slow of applying the brakes gently. But slowing down from higher speeds (above 40 mph) and using more then gentle braking ( not standing on the pedal with both feet) it is definitely there. Before the brake job braking caused the steering turning right. (sign of more braking action on the right - right?). Now with new stuff still pulls to the right but not as strongly. Should not this disappear with the brake job? Or get the new tires on front and see what gives?
Camry :: Brake Pedal Sinks To The Floor When Braking
A friend brought me a car with the issue that the brake pedal sinks to the floor when braking. She said it was never low on fluid so I replaced the master cylinder and bled all of the lines with a friend pumping the pedal. The pedal would still sink to the floor. I tried vacuum bleeding the brakes and found that the front left consistently had large bubbles.
I Teflon taped the fitting on the calliper and the bleed screw which improved the problem but didn't fix it. I then replaced the calliper. The front left calliper still won't bleed and the brake pedal still goes to the floor. When I bleed it the regular way, the fluid comes out of the bleeder like it bled nicely. Neither of the rubber hoses that connect to the calliper have any visible damage. I had a friend pump the brakes while looking at the hoses and their is no bulge or swelling in them. Could the ABS need to be bled?
Ford Brakes/Suspension :: Brake Pedal Goes All The Way To The Floor
My dad is having problems with his truck, brake pedal goes all the way to the floor even after bleeding all the brakes and the master cylinder. The wheel cylinder didn't have clips in it and he fixed it and it hasnt changed. What do we do? Its a 1993 f150 4.9l.....
View 4 RepliesFord Brakes/Suspension :: Brake Pedal Goes To The Floor
I did a complete rebuild of my brake system in April. Drums, shoes, wheel cylinders, springs, hoses, pads, rotors, calipers, master cylinder, proportioner valve and flushed all the lines and refilled with synthetic fluid. I have made five trips from Southern California to Idaho hauling home furnishings, one trip to Oregon and one trip to Northern California since overhauling the brakes with everything working great. Now something strange is happening. The brake pedal goes to the floor with very little resistance. It isn't spongy like there is air in the lines. It just goes to the floor if you push it all the way down.
The truck stops ok but it is really scary with the pedal going down like that. You can feel when the rear brakes come on because there is a little resistance in the pedal when they come on. You can actually lock the rear brakes up and skid the rear tires. If you push the pedal down further the front brakes start coming on and if you push all the way to the floor the truck will nosedive and you will get planted in the windshield.
I wonder if the aftermarket Bronco Graveyard proportioner valve is blowing all the pressure to the rear wheels because it won't do it if you take the vacuum off of the vacuum booster. You have full pedal when the booster is deactivated and all the wheels operate normally with the exception of having to plant both feet on the pedal to stop it.
Ford Brakes/Suspension :: 1992 F250 - Brake Pedal Goes To Floor
My buddy just bought a 1992 f250 460 the brake suck the pedal goes to the floor don't know if master or the booster or the rod needs to be adjusted or what the brake look ok and it stops ???
View 7 RepliesFord Brakes/Suspension :: Brake Pedal Fades To Almost The Floor With Little Pressure On It
I am working on a e-150 van, 2005. the brake pedal fades to almost the floor with little pressure on it. I just replaced the master cylinder, bled the entire system, and it STILL fades to the floor. driving, or in park. engine running. 4 wheel disc, 4 wheel abs...
View 5 RepliesFord Brakes/Suspension :: 1987 F350 - Brake Pedal Moving To Floor?
1987 F-350 460 Auto Trans. Brake Pedal slowly going to the floor. Stopped at a red light yesterday on a slight down hill and I noticed the brake pedal slowly going to the floor. I had to put the truck in Park to avoid bumping into the car in front of me. I checked brake fluid level and still at the full level, check rims for brake fluid leak from brake cylinder, none. Could my master cylinder need rebuilding or is my vacuum diaphragm going. Not sure that's what its called.
View 7 RepliesFord Brakes/Suspension :: 1987 - Brake Pedal Slowly Going To The Floor - Master Cylinder?
1987 F-350 460 Auto Trans. Brake Pedal slowly going to the floor. Stopped at a red light yesterday on a slight down hill and I noticed the brake pedal slowly going to the floor. I had to put the truck in Park to avoid bumping into the car in front of me. I checked brake fluid level and still at the full level, check rims for brake fluid leak from brake cylinder, none. Could my master cyclinder need rebuilding or is my vacume diaphragm going. Not sure thats what its called.
View 14 RepliesFord Brakes/Suspension :: 1977 F250 - Brake Pedal Goes To The Floor And Sticks When Running
When depressed the break peddle is firm, when released break peddle does not return, replaced mc and booster, bleed breaks. Still having same problem.
View 1 RepliesFord Brakes/Suspension :: Hissing Sound Each Time As Depressed Brake Pedal Sank To The Floor
Brake pedal to the floor... And a lot of fluid on the ground.
I was coming home (empty fortunately) last evening when I noticed the brake pedal give an initial resistance, then slowly sank all the way to the floorboard when slowing down to turn onto my street. When I got to the house, I noticed a hissing sound each time as the depressed brake pedal sank to the floor. When I got out, there was a lot of brake fluid on the ground on the left rear side. It appears to be between the fuel tank and frame rail. From the side it is the section between the fuel filler to just ahead of the left rear wheel. The tank and frame rail is drenched and dripping DOT 3.
I am lucky to not have been pulling my 5th wheel when this happened! However, I have a camping trip coming up in a few weeks, but now my TV is broken. What has happened, and an estimate for repairs? Where is the best place to have it fixed, dealer or specialty shop? I just bought this vehicle in January and it has 102,500 miles, and came complete with full and meticulous repair records. The P.O. was incredible at upkeep, so this is something curious and flukey to me. But do I need to worry about the other side now, too?
Dodge - Vibration :: Braking Quite Hard And Clattering Noise In Brake Pedal
Just bought this van used last fall. Had an occasion, a few months ago, to brake quite hard (to avoid hitting a bird in the road--yeah, I know...) and felt a clattering vibration/noise in my brake pedal. It's happened a few times since then. Is this a problem that needs to be looked at or a normal reaction to quick, hard braking? (Braking noise in 2008 Dodge Grand Caravan)
View 9 RepliesDodge - Dakota :: Water In The Right Front Floor When AC Running
i have a dodge Dakota and there is water that leaks into the front right passenger side when I run the AC...
View 3 RepliesElantra XD (2001-06) :: No Brake Pedal - It Goes To Floor
I have been working on my 01 Elantra for 2 days now. My problem is that I have absolutely no brake pedal at all, it just goes right to the floor. and this is only when the car is running, when it is off I give it a quick pump and i have a nice firm pedal. I installed a new master cylinder, bench bled it and all that jazz. I replaced the rear brakes and a wheel cylinder, I have also bled the brakes multiple times, and mutliple ways. bled the master while on the car and all the brakes while the car is off and while it is running. I dont know what else could be wrong with this. I looked at all the lines and there are no wet spots, no hoses are swelling up. everything looks top notch...i just have no brakes why.
View 15 RepliesFord Brakes/Suspension :: 1999 E350 - Anti-lock Brake Pulse In Pedal At Low Speed Light Braking
I have a '99 E350 van that I am feeling a light anti-lock brake pulse in the pedal when I am rolling to a slow stop under light braking. Braking doesn't seem to be affected, but it doesn't feel right. I tried locking up the brakes and didn't feel any anti-lock pulse...seems backwards.
View 1 RepliesDodge - Dakota :: 1998 - Water Leakage - Pooling Up On Both Sides Of Floor
I have a 1998 Dodge Dakota in very good shape. I bought it from my brother who has owned it since 2000. I drove the truck from Reno, NV to southeast Alaska where I live, and all along the pacific coast. It rained a LOT and I noticed pooling of water on the floor at my feet, soaking the carpet completely and pooling up. I thought I was tracking water in the truck from my boots. BUt I have had it here in Alaska for 7 months now, and it is still HORRIBLE! It rains here all the time and I can't get rid of the puddles. There are no plugs in the floor for drainage and I can't figure out where it is coming in. The windshield looks good, and the door seals look good also. I cannot figure out where the water is getting in so I can stop it. THe truck is going to rot and rust if I can't fix it! And here's the thing, the water is pooling on BOTH sides of the floor-passenger and driver. I am baffled. No one ever sits on the passenger side so its not coming from boots! there is no way for water to flow from one side of the floor to the other.
View 2 RepliesDodge - Suspension - Dakota :: 2002 - Headlights Won't Come On
The parking lights come on, the turn signal lights work, the interior lights and high beams work. Could it just be a fuse or two? Dodge Dakota 4WD 2002 ...
View 3 RepliesDodge - Dakota :: 2007 Vibration When Braking At High Speeds
I have a 2007 dodge Dakota with 112K miles. At 105K I had the front brake rotors and pads replaced. The rear brakes were fine. There was a problem with one of the rotors and I returned a week or two later and one, which was warped, was replaced. Ever since that second visit I have had an intermittent vibration from the vehicle. When I brake the whole truck vibrates. And by vibrating, I mean some pretty heavy shaking. It is not the steering wheel vibrating. I took this back to the mechanic where they were unable to find any issues with the brakes. Also, we could not (of course) re-create the issue while it was in the shop. I have not been able to find the pattern. It happens when I am braking at high speeds, but not every time. It also happens at lower speed, but again, not every time.
View 2 Replies