Stalling - Chrysler :: 1999 Cirrus Would Randomly Stall When Driving Or While In Idle
I started having problems with my '99 Cirrus last month, it would randomly stall while driving or while in idle. With no check engine light or any other tell tale signs of a problem. I'm not entirely knowledgeable about how the entirety of the car's systems function, though I new I should check my fuel system. I wasn't getting any fuel to the engine whatsoever, so I replaced the fuel filter because when I got it off and looked at it it was clear it was bad. Then I put it all back together to try and run it and it continued to stall.
Thinking it must be the fuel pump at this point I dropped the fuel tank and replaced it. It ran for about 35 miles before the same problem started happening again. So I checked all the fuses, and relays and just to be safe replaced all the relays related to the fuel pump, and fuel system and i even replaced the auto shutdown relay. The car continued to have the same problem, so I did some research and found out it could be a dirty throttle body so I cleaned it even though it wasn't that dirty, and checked my air filter for how clean it was and it was clean. The car still continues to stall in idle and while driving.
Chrysler - Cirrus :: 1997 Won't Start On Its Own Without Being Jump Started
I have a '97 Chrysler Cirrus that won't start on it's own without being jump started. Once jump started it runs fine, but then the next time you go to start it the battery is drained again. My highly uneducated guess is that I need to replace the alternator. Am I on the right track? I replaced the battery and the problem persisted.
View 7 RepliesChrysler - Cirrus :: 2000 V6 - No Start After Sitting Out In Wet Weather
2000 Chrysler Cirrus 2.5 V6, 84,300 miles. Twice, after sitting out a day or 2 in wet weather, it was very, very difficult to start. Each time, it didn't fire at all, but then did finally start after 4 or 5 tries and ran fine.
Tried spraying water everywhere under the hood, while it was running, but got no miss or other symptom. After then sitting a day or 2 in the garage, it started and ran fine the first 2-3 miles, then started stumbling/missing and stalled at a light. It restarted and continued to stumble/miss before running fine after another 1-3 miles. Changed the distributor cap and repeated the same test, getting same result. Also checked fuel pressure--it's on the money, building specified pressure and holding as expected. No check engine light or other symptom and no relevant codes.
Chrysler - Cirrus :: 2000 Lxi Died While Driving On The Highway
My car died while driving on the highway. The mechanic said it was the distributor, but also that the fuel pump wasn't working. When he replaced the distributor, the car works, no fuel pump problem. Does the fuel pump shut off when the engine dies or is this going to be another problem down the road? 2000 Chrysler Cirrus Lxi...
View 1 RepliesChrysler - Cirrus :: Speedometer Stopped Working - Sensor Or A Cable?
I have a 97 Chrysler Cirrus, and have been driving it for about 5 months. The other day, as I was driving, the speedometer stopped working. It did that one time before, but started back working. However, this time, it still is not working and I have no idea how fast/slow I am going. Often, my car has little glitches where you have to lock/unlock the door a certain way or it does not work right. Everybody jokes that my car has OCD! Also, once you crank the car, you have to turn the key back halfway or certain things don't work- like the clock, wipers, turn signals, etc. I don't know if this is related to the speedometer situation or not. The last time the speedometer stopped working, I had the AC on and a cassette tape in the deck; I was trying to hit the rewind button, but kind of accidentally pushed between fast-forward and rewind, and that is when the speedometer stopped working. I am not sure this is related. Do you know if my car has a sensor or a cable for the speedometer? Is this something that can be easily and inexpensively fixed?
View 1 RepliesChrysler - Cirrus :: ABS Light Came On / RPM Gauge Stopped Working Occasionally
I have a 1997 Cirrus. The ABS light came on about 2 weeks ago -- this is after i drive about 30 yards. The brakes seem to be operation ok and when the light does come on there is no bell or chime sounds to indicate something is wrong. ALSO, the RPM gauge just started to not work. Occasionally it may operate correctly but most of the time it just sits on zero. What the fault or faults are?
View 1 RepliesDodge - Stratus :: 1997 - Auto Trans Not Shifting / Total Limp Mode
I read another blog on here about stratus not shifting and decided to ask someone about my limp mode problem. A few months ago I was driving uphill when it jerked before it got into limp mode. I thought maybe the hot weather caused it(it was 95 deg). I let it sit overnight. and the next day car was fine. for about 3-4 months. Now it got into limp mode only after it goes through all the gears once only. When i come to a stop it will go into limp again. Got a 0700 and 0760 codes. My speedometer works. tach works. Basically everything works as it should.
I decided to change the ATF and filter, both speed sensors and i get the same old codes after a drive around the block. I then decided to remove the neg terminal overnight. Next day I would have no signal at the data link port. When i removed the key from the ignition my dash lights for the mileage will stay on for another 3-4 seconds before disappearing. I checked the ground wires to the PCM and TCM which are good. Fuses and relays are also good. I even swapped some of them. Still no change. 1997 stratus 2.4 auto...
Chrysler - Cirrus :: 2000 - Code P0303 And P0305 / Vacuum Leak
I own a cirrus 2000 which lately have been giving me trouble. I took it to a mechanic for tune up and ended up having a lot of issues. At the moment I am having a lot of rattle or hard driving. The car shakes alot and recently I took it for a diagnostic and the result was P0303 and P0305 and vacuum leak. What causes this problem and how can I get it fixed?
View 5 RepliesFord F-150 - 1997-2003 :: Overheating / Temp Gauge Climbs And Then Truck Goes Into Limp Mode
I am looking at a 1997 F150 with a 5.4 in it, guy who owns it says if you drive it down the street the temp gauge climbs and then the truck goes into limp mode but if you check the engine temp under hood it is nowhere near overheating. Where I should start to look for a problem here? If this is too complicated I will pass on the truck, its not worth it to me to get this truck if it is going to be a nightmare. I have a 2000 with a 4.6 that runs great so this would just be a spare for me, but would like to have it because its in such nice shape.
View 1 RepliesChrysler - Cirrus :: 1998 Not Starting / Mild Thud Followed By Brief Hissing Sound When Turn The Key
My 98 Cirrus (V6 automatic) is not starting. The battery is working fine and it lights up everything...the wipers, headlight, the turn signals etc.... But when I turn on the ignition...nothing. I hear a mild thud followed by a brief hissing sound when I turn the key from the 1 position to the 2 position (referring to a 0-1-2-ignition key positions)...like "thuh...sssssss." It seems it comes from the underside of the car. Then when I turn from the second key position to start the engine, I get no response at all. I tried putting the gear in park / N...but no difference.
The weird thing is, approx 15 min before I attempted to start the car, I had to drive the car across the parking lot. It ran fine at that time. Could it be a fried starter motor?
Ford Super Duty (1999-2016) :: Transmission Would Not Work In Tow Mode And Caused Engine To Go Into Limp Mode
I have a 2008 F350 with a 6.4 Powerstroke diesel engine that just experienced total engine failure. It has around 65K miles.
There is a heavy burn star pattern on all 8 pistons, a few pistons are cracked, a few cylinder walls are scored, glow plugs are melted, both heads are cracked with multiple stress fractures in each head.
About 1 month previously, the transmission would not work in tow mode and caused the engine to go into limp home mode. The dealership just replaced the entire tranny as a warranty item. About 1 week before the engine failure, I put in a 5.25 oz bottle of Lucas injector cleaner with a full tank of gas.
The Ford dealership is saying that the star pattern on all 8 pistons is due to high pressure fuel overspray and is evidence that I had a tuner on this engine and that the warranty is invalid. I did not have a tuner. What might have caused this engine failure?
Also, they only ripped down the top half of the motor, not the bottom half. I heard this might have been caused by a cracked crank shaft, but Ford refuses to investigate this possibility.
06 Charger Won't Start Sometimes - Going Into Limp Mode
I have a 2006 Charger R/T. My car used to not start (even thought the battery, starter, and alternator was good). I had it fixed, and the problem seemed to be electrical. However after that, it would always start, but would go into "limp mode". I let it sit for two days, and the limp mode disappeared. However, it will only start on occasion. It won't start after about 30 mins after use. It won't start for a few hours. All electrics work fine, it just won't even attempt to crank. Try to start it later, it will work fine. Even though the check engine light was NOT on, I was able to pull three codes out of it: U0100, U0103, P0700. I did have to replace the notorious "pink thingy", but everything (should be) connected fine.
View 1 RepliesPhaeton :: 2004 V8 - Going Into Limp Mode
Happened once or twice where I tried to back up a hill and the car went into limp mode. Neither the dealer nor my mechanic could replicate it.
View 5 RepliesGolf VI R :: Limp Mode With APR Flash?
So I was driving kinda hard yesterday on the highway, and it was about 80 degrees outside. At some point in the drive, I got no boost from the turbo at all (my gauge also was showing no boost). I pulled over, stopped the car, and restarted it, and the car was back to normal. Is this something I should be worried about? I am running 93 program APR Stage 1+ with VWR intake and HPFP.
View 24 RepliesSanta Fe (CM - 2007-12) :: MIL Comes On And Goes To Limp Mode
My 2007 Santa Fe was acting up at one time, then stopped doing it, and recently started again. My wife is the primary driver so I'm not always in the vehicle when it happens. When the vehicle is started cold, it will run a short distance then the MIL comes on and it goes to a 5 mph limp mode. After pulling over and shutting the vehicle completely down for a couple of minutes, it will run normally with the MIL still on. However, by the time I get back home to pull the codes, the MIL goes off. I don't remember the exact codes, but when it acted up last time I believe the codes had something to do with the TPS, Pedal Pos Sensor, and one other I can't remember.
View 3 RepliesSanta FE SM (2001-06) :: 3.5L - CEL Came On And Car Will Go Into Limp Mode
I have been having a problem where the Santa Fe will drive great for a week, sometimes only a day and the engine light will come on and the car will go into limp mode. It will drop you from 65MPH to 10 MPH, if you put it in park the RPM's will race and stomping on the pedal will not affect the RPM's. After you turn it off for a couple of minutes it will drive ok again. I have replaced the Throttle Position Sensor and the Accelerator Pedal Sensor, cleaned all connections and checked wires in them. I have also cleaned the Throttle Body. The Dealer wants to replace the Throttle Body.
Had Engine Codes:
P0123 - Throttle Position Sensor 1 Signal Circuit High Imput
P1110 - Throttle Actuator Control System Malfuntion
P0222 - Throttle Position Sensor 2 Signal Circuit Low Imput
P1175 - Electric Throttle Valve Control System (ETS) Valve #
P1196 - Throttle Actuator Control System Limp Home-Stuck
Golf IV R32 :: EPC Light Came On And Car Gone Into Limp Mode
So on cold mornings my r has been kicking on the epc light and gone to limp mode. The only codes are for the coolant temp sensor and an intermittent accelerator position sensor. Would the temp sensor really cause this? After awhile I can start it up and it runs fine.
View 7 RepliesMalibu :: Code 2135 And Also Goes Into Limp Mode
My 2010 Malibu has been throwing a code 0f 2135 also goes into limp mode. Code comes up as throttle pos sen. So looking I can see it is all built in one with the throttle body. Can it be changed with out any special tools?
View 3 RepliesIS F (2008-2014) :: Car Went Into Limp Mode When Restarted
I have a 2008 ISF with a k&n intake and QTP exhaust cutouts. About a month ago my car died on me and when I restarted it, the car went into limp mode. The "check vsc" light is on along with the traction light and CEL. I took it to my mechanic and he said I needed to replace the MAF sensor and I did. 100 miles later the car went into limp mode again. So I took it to a mechanic that knows Lexus vehicles very well apparently, and he diagnosed it to be my intake. So he replaced it with the stock intake. Now I've driven another 100 miles and the problem has come back again. The car is throwing all kinds of codes when I connect the obd2 scanner to it.
It is throwing p0031, p0037, p0051, p0057, p0102, p1360, p1361, and a whole bunch more.