Prius (2004-09) :: Driver Window Rubber Molding Separated
The rubber molding at the bottom of my wife's driver's window (2007 Prius) has separated. Is replacing this molding a DIY job or do I need to pay the dealer? If I can do it myself, are there any tips for removing the old molding & installing the new?
View 5 RepliesPhaeton :: Rear Molding Lower Door Separated From Car Body
I've noticed on both rear doors, the Lower Moulding (black cover at the bottom of the door) #12 in the attached diagram (Light Blue Circle), is very much separated from the body of the car, it's like bended toward the outside, but it seems to be exactly the same on both sides, I am not sure if this is normal or mine has a defect
Both front doors are OK, not 100% perfectly aligned with the body of the car, but MUCH better than the rear doors....
Lexus LS 2007+ :: Front Window Rubber Molding Replacement?
I have noticed that the rubber window moldings around both front doors is deteriorating. Both are torn and falling apart. There is no wind noise yet but they need to be replaced.
View 2 RepliesDoors - Chevrolet - Blazer :: Alternately Blowing Hot Then Cold With Creaking Noise During Transitions
Auto facts: 2000 Blazer, Mileage: 196,000 Engine: V6, 4.3L Transmission: Automatic Drivetrain: 4WD, Single climate control
Recently had my AC compressor assembly replaced, renewed accumulator/receiver drier, orifice tube, recharge, etc. The AC was cooling well below par after the repairs. Then is started alternately blowing hot (12 sec), cool (3 sec), etc. with a "spooky" creaking noise coming from within the middle dash during each transition (blend door?).
The mechanic charged the system again and agrees there is a refrigerant leak "somewhere" to account for the marginal cooling capability but the dye put into the system before the repair is not showing up anywhere that he can see (so far, having it checked again today). So, are these 2 separate issues? What are the steps of diagnosis and repair possibilities?
Lexus RX 2010-15 :: Rubber / Felt Window Molding Pops Out On RX350
Our new (got April 2014) RX350 seems to have an issue with the rubber/felt window molding getting caught between the glass and metal incorrectly. "Pinched".
View 1 RepliesChevrolet - Blazer :: 1989 - Quarter Sized Holes In The Passenger Door And Rusty
In the photos here you can see there are quarter sized holes in the passenger door and some rust damage underneath the car. To me it doesn't look like that much, but the previous owner did a bunch of work himself - maybe that's why. To remedy all rust what do you think the price would be? Me welding is currently not an option and I have zero experience doing work on cars.
View 7 RepliesChevrolet - Blazer :: Leaking Fluid From The Right Front Side?
My car is leaking fluid from the right front side. What it is.
View 6 RepliesGolf IV R32 :: Front Lower Control Arm Bushings Completely Separated
Front lower control arm bushings are completely separated. Looking to upgrade in some way to poly bushings or some other sort of performance setup.
View 4 RepliesFord Excursion :: 2005 - Securing Side Molding On The Doors?
Our 2005 Excursion has these side moldings (mouldings? whatever) on the doors. Plastic things, probably intended to absorb impacts from shopping carts, etc.
My driver side one is just hanging by the top. Looks to me like these are just taped on?
What I have to do to properly secure this bad boy? Should I remove the whole thing, remove the old tape, and use a whole new set of tape in both places? Does one apply the tape door-first, or molding-first?
And, most importantly, what kind of tape should I use, and where should I get it?
Saturn - S-series :: Water Leaks On Both Front Doors And The Right Rear Door
I have a 95 SL1, 175,000 miles. Both front doors and the right rear door have water leaks. Leak is at the top edge of doors. Seals look ok. During heavy rain it is bad, soaking the seats and floor boards. Would adjusting the door lock striker by pulling the door in tighter to make a more positive seal or should I replace the door seals. I have friends you own Saturns and they have similar problems with door water leaks.
View 5 RepliesPrius (Gen 2) :: Back Seat Doors Don't Open Unless Front Door Is Unlocked
I rarely drive with anyone else in my 2004 Prius. This week we've had out-of-town guests, with two people in the back seat. When the doors are locked, the front seat passenger can pull on the handle to open the door, but the back seat passengers can't open their doors with the handle until someone in one of the front seats pushes the door unlock button. The child safety locks are not set. I keep getting out of my car and forgetting to push the button to let the back seat passengers open their doors. Is there anything I can do to change this rear door behavior?
View 2 RepliesCamry 2012+ :: Front Doors Will Not Unlock Using Key Fobs Nor By Touching Door Handles
The drivers side and passenger side doors will not unlock using my key fobs, nor by touching the door handles. The only thing that happens when I touch the front passenger door handle is that the back doors will unlock. I have to enter my car through the back doors, and unlock the front doors manually. Also, by touching the passenger door handle, I get a series of beeps (3-5). What may be causing this, and how to fix it?
View 2 RepliesLexus GS 2006-11 :: Rubber Seal Between Doors Is Peeling Off?
The door seal between the driver's side front and rear doors on my car is coming loose -- the rubber piece that seals out wind/water/noise?/etc. between where the driver's side front door closes and meets the rear door by the B-pillar. I looked at the way it's designed and meant to be applied and was curious if using gorilla glue or some variant of high strength adhesive would do the trick? It seems to be drying up where the rubber meets the sheet metal.
View 3 RepliesPassat (B5) :: Rear Driver Side Door Does Not Lock Or Unlock From Button On Front Two Doors
The rear driver side door on my Passat doesn't work right, it doesn't lock or unlock from the button on the front two doors....and the window only rolls down when that door is open and the car is running, how to fix?
View 2 RepliesPassat (B6) :: How To Remove Side Chrome Door Molding
How do I remove side chrome door molding? Do they clip off?
View 3 RepliesLexus GX 2004-09 :: Exterior Molding Of Passenger Door Is Unclipped
Just picked up a new to us 2004 GX470 for my wife.
One of the things wrong with the GX470 is the passenger door exterior molding is unclipped at the bottom. I ordered new clips from eBay and they just came in. Now I just need to figure out how to get the molding off without making the problem worse so I can replace all the clips.
Passat (B5) :: 2001 - Door Frame Interior Molding Falling Off
I have an 01 B5 Passat and the interior cloth covering surrounding the front door frames keeps coming off the rubber gasket. I have tried many different types of glue and contact cement but nothing seems to last longer than a few months.
View 3 RepliesTiguan :: Lower Exterior Door Plastic Molding Removal?
How to get the plastic exterior molding on the base of the doors off. I see 2 screws and thats it. Is there a trick to it? I need to replace the passenger side or epoxy one of the clips back on then remount it.
View 2 RepliesLexus GX 2004-09 :: Driver Side Door Molding Clip Missing
My driver side door molding is missing a clip. This is the bottom half of the mold and one of the clips snapped off. I've checked junk yards and they never have any GX's. Just to elaborate the clip I'm missing is on the exterior side of the door, down by the bottom edge.
View 2 Replies