Chevrolet - 1500 :: New Shocks - Knocking / Clunking Over Bumps

I've just installed new shocks on my 1997 Suburban K1500 4WD. Now there's a knock that appears to come from the driver's side. The knock seems to be as the wheels descend while crossing rolling bumps rather than abrupt jolts; for example; pot holes or running over reflectors embedded in the road don't cause the knocking.

Here's what I've checked: balljoints, inner and outer tie rods, idler arms are OK; brake calipers secure; 4WD is fine; steering shaft is OK (don't feel the knock in steering wheel); can't find anything loose.

View 10 Replies

Chevrolet - 1500 :: 1998 - Severe Leak Of Anti-freeze

I have a 5.0L with around 144k mileage. I noticed a reasonably severe leak of anti-freeze the day after I had the oil changed at a shop (coincidentally?); nothing out of the ordinary on that day. The temp's have never showed as being beyond normal. I saw that there was a bit of weeping from the water pump, so changed that believing that the gaskets might be the real culprit (third pump on this truck). I re-filled the system with fluid (green silicate as the system had been modified several years back), ran the engine, and found that there is still a leak, not as severe, but most definitely bad. It honestly appears to be dripping at the oil pan gasket, just left of the crank on the lower end. The location doesn't really seem logical to me.

View 4 Replies

Chevrolet - 1500 :: Slight Rough Idle / Loss Of Power - Vacuum Leak

I have a misfire in the 6 cylinder on my 98 Chevy c1500 5.7l 350 v8 2wd. I changed the spark plugs and wires, cap and rotor, and changed the spider injector i put the spider injector in from another engine I had. After doing all this the code still comes up. The truck runs fine and except it idles slight rough not bad at all and now it says I have a vacuum leak and while I'm driving you can feel the loss of power. I tried all the ways to do it like on YouTube. What is wrong with my truck?

View 10 Replies

Accent LC (2000-05) :: Error Code P0442 Indicating A Leak In Evap Emissions

This began as a troubleshooting exercise for a P0442 code (2002 model) indicating a leak in the evap emissions system. Often caused by simple things like a loose/poorly sealing filler cap. Not this time

It's a neat design, tucked away up in the fender well. Even sports a very effective stone guard (plastic shield) which hides all that tubing from view. But the shield also traps all the road salt and mud and packs it into the crevices between the tubes where it stays from one winter till the next. Even a powerful car wash probably can't dislodge the caked on mess once solidified.

View 1 Replies

Ford F-150 - 1997-2003 :: Vacuum Leak - Error Codes Indicating Bad O2 Sensors

I am having problems with a 2003 Ford F 150 with a 4.2 L V6. The problem is that it is giving me code errors that would indicate bad O2 sensors. I replaced both the upper and lower O2 sensors, and still I get the same codes. I was told by the mechanic with the computer reader that this usually means a bad vacuum seal. He suggested looking for bad hoses, but did not offer much more than that. How to proceed?

View 2 Replies

Ford Ranger / B-Series :: Occasional CEL Indicating Code PO442 - Small Leak Detected?

2001 Ranger-4 Liter-169,000 Odometer Miles ... Over the past year I would get an occasional CEL indicating PO442 Leak Detected (small leak). I would simply erase it. Now it's occurring more frequently at approximately 300 odometer miles.

There must be lots a places for a small leak to develop. But, I am thinking that there might be one or two places that are somewhat common.

View 2 Replies

Ford A/C :: 2002 - Air Turns Hot After Sometime - Compressor Clutch Disengages Over 1500-1600 RPM?

I have about 80K miles on my 2002 F-250 P/S. My AC will cool big time when I first turn it on. But, after I have been on the road for a while (20-50 miles), the AC turns hot. I noticed that the compressor clutch disengages when the engine goes over 1500-1600 RPM and when the engine slows back down, the clutch re-engages. I have had:

1. Bugs cleaned from the front.

2. Evacuated and recharged (3 times).

3. Cycling switch replaced.

All these were done by an authorized Ford dealer. But the system still gets cantankerous at cruising speed (1900-2000 RPM).

View 5 Replies

Chevrolet - 1500 :: 1997 - Won't Start With Key?

I have a 97 chevy and the only way to start it is to jump the starter relay, not sure if it is the key switch ot the nuetral saftey switch.

View 2 Replies

Chevrolet - 1500 :: 1997 - ABS Light Goes On And Off?

I have a 1997 Chevy C1500 with about 85k miles on it. I had the breaks checked and replaced over a year ago and this problem is pretty recent. When I got the brakes done I had the pads replaced on the front disks and I had the back drum pads and some brake part replaced that was inside the drum. Looked like a little hydraulic piston of sorts (sorry, not to up on my car lingo here lol)

My issue is my ABS light comes on from time to time for no apparent reason at all (at least that I notice). I can be just sitting at a stop light and I will notice it comes on, stays on, then randomly will go off. The car seems to break fine, especially at higher speeds (30-70mph). On occasion however at low speeds (5-15mph) when coming to a some what sudden stop my brakes seem to skip? Kind of feels like a grinding feeling. No gravel or slick road, just plane ol pavement. I think this is the ABS system but Ive only ever driven one other car with ABS breaks that the I believe the ABS system activated while stopping on ice and it felt the exact same.

I have not noticed if the light comes on during these low speed stops, as I am just now putting all these pieces of a puzzle together to figure out if something is really wrong with my ABS system or if its just a sensor or something.

View 3 Replies

Chevrolet - 1500 :: 1997 - ABS Light Goes On And Off

I have a 1997 Chevy C1500 with about 85k miles on it. I had the breaks checked and replaced over a year ago and this problem is pretty recent. When I got the brakes done I had the pads replaced on the front disks and I had the back drum pads and some brake part replaced that was inside the drum. Looked like a little hydraulic piston of sorts...

My issue is my ABS light comes on from time to time for no apparent reason at all (at least that I notice). I can be just sitting at a stop light and I will notice it comes on, stays on, then randomly will go off. The car seems to break fine, especially at higher speeds (30-70mph). On occasion however at low speeds (5-15mph) when coming to a some what sudden stop my brakes seem to skip? Kind of feels like a grinding feeling. No gravel or slick road, just plane ol pavement. I think this is the ABS system but Ive only ever driven one other car with ABS breaks that the I believe the ABS system activated while stopping on ice and it felt the exact same.

I have not noticed if the light comes on during these low speed stops, as I am just now putting all these pieces of a puzzle together to figure out if something is really wrong with my ABS system or if its just a sensor or something.

I would like to have some knowledge or information in case I have to take it to a mechanic to have it looked at. The last people (Just Breaks) I took it to really tried to screw me over. After they worked on it the Emergency break light was on and his fix was to just "unplug" the sensor. I said Heck no! Fix it! after three bleeds it tripped the sensor off. So I am a bit hesitant to have them looked at after that experience.

View 4 Replies

Chevrolet - 1500 :: Suburan Occasionally Won't Start

Infrequently (once every couple weeks) my 2002 Suburban won't start. The starter seems to work properly as the engine tries to turn over and even seems to initially start for a fraction of a second but then dies. If I wait 10 to 30 minutes it will usually start without a problem. This problem does not seem to be related to outside temp, recent use or car position. After dealing with this occasionally inconvenient problem for months I took the car to a service shop and was told that if they could not reproduce the problem that trying to fix it would be a wild goose chase. When the problem occurred again I took it to another shop who kept the car for 3-4 days but was unable to reproduce the problem.

They suggested that there was a problem with the fuel pump but did not want to replace it unless they were sure that was the problem. I then spoke to the Chevy dealership shop who also said it was most likely the fuel pump. In my frustration dealing with this problem I took the car back to my local shop and ask them to replace the fuel pump ($800). Unfortunately, the intermittent problem has persisted and I'm not sure what to do next. I did have an after market remote ignition added a number of years ago and took it back to them to see if this could be related and they said no way. I have also wondered about the security system being a problem in that my rear hatch cargo door does not lock even though the other doors lock normally.

View 3 Replies

Chevrolet - 1500 :: 1993 - Vibration During Acceleration

Car: 1993 Chevy C 1500 (2WD) manual transmission Background: The car sat unused in a garage for 2 weeks (no problems before this) the first drive after its break, the pickup almost felt like it was slipping and power was not getting to the wheels. The vibrating began the next day. The vibrating is very obvious and unpleasant under acceleration at approximately 2000 RPMs in any gear. Grease was injected via grease zerk into the center carrier bearing area and the vibrating was marginally better. Today the back end of the truck was lifted up and put into gear and brought up to 30 MPH. The pickup was then lowered and a test drive revealed that the vibrating was considerably diminished.

An inspection of the drive shaft reveals:no vibrating in neutral the U-joints are not loose or leaking; the drive shaft has 2 small dents which are countered on the opposite side by weights;the drive shaft will move up and down ~1 inch or less if pushed in bench press fashion near the carrier bearing;the drive shaft does not move in the direction of the length of the vehicle;the drive shaft will rotate freely 1/16th to 1/8th of a turn before it is stopped by the back of the transmission or the rear differential; no mud clods in wheel wells;new tires properly inflated.

View 9 Replies

Chevrolet - 1500 :: Hesitation In Truck When Accelerating

1992 WT pick up 263,000 miles had new head gasket installed valves lapped and tune up it was doing it before and does get better when truck warms up, but still can hesitate at times. When cold you have to feather gas pedal to truck accelerating, you can hear truck motor pop through throttle body but will continue to speed up.

View 2 Replies

Chevrolet - 1500 :: Bubbling Noise When Accelerating

My 02 silverado has started making a bubbling sound when I accelerate. The sound is coming from under the passenger side dash.

View 2 Replies

Chevrolet - 1500 :: 1998 - Cab Lights Are On All The Time

I own a 1998 Chevy K1500 Silverado. About a year and a half ago my interior lights stopped turning off. I found that the only way to make the lights go out is to pull the interior light fuse. With the fuse pulled my lights will go out when the key is in the off position. With the key in any position besides off and the radio on my cab lights are on half bright. If I turn off the radio or pull the radio fuse the lights go out. My mechanic and I both investigated this and came up with the same answer: the Keyless Entry Module. After living with no cab lights for a year and a half (in northern New Hampshire) I broke down and paid the 180 bucks for the "Remote Function Actuation Module" (I had to take my dash apart and get the part number off the old module to figure out which one of three or four possible modules was used in my truck). Now that I have replaced the module I still have the same problem. If it's not the module then what is causing my lights to stay on all the time with the fuse in or come on half bright with the fuse pulled?

View 1 Replies

Chevrolet - 1500 :: 1993 - Throttle Does Not Respond

I drive a 1993 Chevrolet 1500 v6, 2wd. I have changed every part I can think of related to the fuel system. When I try to accelerate, the engine hesitates, it gets louder, and my truck will jerk. Sometimes, however, it is responsive. Often times, it will be responsive for a few minutes and start to decelerate.

View 2 Replies

Chevrolet - 1500 :: 1990 - Truck Is Backfiring

Just got a 1990 k1500 with the 4.3 v6 and 5 speed and it backfires. A buddy told me it was shooting flames out of my exhaust. What does that mean?

View 7 Replies

Chevrolet - 1500 :: Grinding Noise When Attempting To Go From 2H To 4H

Year: 1999Make: Chevrolet
Model: Silverado 1500 LS
Issue: Bad Transfer Case

Late model 99 Chevrolet Sliverado 4x4 with push button transfer case. At the end of last winter the transfer case began a grinding-noise when attempting to go from 2H to 4H.

I have a great mechanic who has proven both his skill and honesty to me a few times now. I took the truck in for diagnosis. His hope was that the electronic transfer may be faulty but unfortunately found metal shavings when he went to check the lubricant in the transfer case.

Diagnosis: Bad Transfer Case - Replacement necessary.

Mechanic has recommended a salvaged transfer case from reputable salvage dealer.

I have sourced a rebuilt transfer case with manufacturer warranties from a "major parts chain" for approximately 1/3 more cost.

My debate: The truck (while very late model), has a rebuilt engine that has less than 50k miles on the rebuild. I have expectations that I will continue to drive and maintain this truck for a very long time.

Although I am always aligned with less cost, my first response is that the rebuild from "major parts chain" is warrantied and far less likely to require a replacement in the remaining life of the vehicle.

However I am also uncertain how to evaluate the existing transmission. Presumably it has >100k. Is there a risk in pairing an OEM rebuilt transfer case with a transmission this old?

View 3 Replies

Chevrolet - 1500 :: Transmission Does Not Engage In Drive

Overhaul trans, new old pump, but doesn't engage in drive. Reverse and all three low work fine. Drive will only work when rpm's are applied. But without any power.

View 4 Replies