Ford - Explorer :: 1993 - Fuel Gauge Misreading - Fuel Sending Unit Replacement?
I have finally gotten my 93 Explorer back on the road. Now I have a few things that I am trying to get fixed.
The first things that I need to get repaired is my Fuel Sending Unit replaced. How hard is this and what kind of pitfalls am I looking at.
The problem that I am having is that my fuel gauge is never right. The other day I ran out of gas, but the gauge said full. Go firgure.
Anyway I have been told that the problem is my sending unit in the fuel tank. So is there any advise on this repair.
Escort :: Fuel Leak At Sending Unit Gasket
Replaced fuel pump which is fine now, but installed new lock ring and gasket and getting fuel seepage around the sending unit area.
The gasket that came with the fuel pump seems kind of thin to provide a good seal here.
Accent MC (2006-11) :: Gauge Not Working After Changing Out The Fuel Sending Unit
I just changed out the fuel sending unit in my 08 Accent and now the gauge doesn't work. Everything appears to be plugged in.
View 2 RepliesChevrolet - 1500 :: 1995 - Fuel Pump Bad Somewhere Between The Relay And Sending Unit
My 95 chevy 1500 pickup is having fuel pump issues. Somewhere between the relay and the sending unit. Pulled the tank, and put power directly to both the pump and the sending unit. They both run. Put in new relay, still not turning on the pump. Do not know if this is related, but the switch to turn on the interior light when you open the door does not work on the drivers side door. If I pull on the switch the light will come on.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuel Sending Unit Connectors
I recently dropped my tank and one of the connector clips broke taking it off. How can I find anther connector or clip, I have looked at the ford dealer, napa and oriellys with not luck. It seems as if they don't exist. The ford dealer wants me to buy a new fuel line. Also I did something that now I know is not good but I cut the connector out to take to the parts stores and they said that it can not be put back together. Is this true?
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Check Fuel Sending Unit Connection
So I did the hutch mod several months ago and all was fine.. Couple days ago I went to fill up, cheap diesel, for upcoming trip.
Fuel gauge was working and showing just less than 1/2 tank. Went to Walmart with gift card and started pumping. Got to talking with duramax owner and noticed fuel was finished. did not pop off like the level was high in fill tube just can to end of money..
SO I get in, turn on key to get mileage to mark down miles, gallon, amount etc and noticed the fuel gauge look like it wanted to go up and then it drops to "E" and the fuel light comes on..
Yesterday I drop spare and check sending unit connection which was OK so must be issue with sending unit. ?? So I might need to take camper shell off, fiberglass, and lift bed.. too much fuel in tank and not going to be driving it enough to get down. What size are the bolts holding bed to frame and how do I need do this??
Ford Super Duty (1999-2016) :: 2003 F250 - Fuel Sending Unit - Gauge Drop Dead Below E?
I've got a 2003 F250, SD, 5.4L Triton that I've owned since new. It has 205,000 kms on it and has run flawlessly since owning it.
Yesterday I went to use the truck after it sitting for about 2 weeks, which isn't uncommon for this time of year as I'm in the landscaping business. It never sits long, though as I make a point of using all the trucks, periodically, just to "blow the stink off" as my Dad would say.
Anyway, when I fired it up the gauge was drop-dead below "E" so I go to fill it up and it takes in fuel and it won't take a drop more. I got under the truck and knocked on the tank in various spots and the tank seems almost plum full.
When I power the truck off and back on, all the gauges come to life and settle on their appropriate readings, except for the fuel gauge. It powers up to full and then drops to below "E" as though I had turned the truck off again.
My question is, am I reasonably safe to assume my sending unit has bitten the dust? I figured that since the gauge comes to life upon startup and then drops to "E" after the rest of the gauges initialize, the fuel gauge itself probably isn't the problem?
Is there a chance that as I drive it over the next few days, and the tank empties, maybe the "sloshing" of fuel might dislodge a stuck part?
Venture :: 2004 - Power Steering Feels Tight / Fuel Level Is Good
I have a 2004 Venture where the power steering feels tight. Fluid level is good. No leaks (had it repaired a year ago where line was leaking, and now repaired).
Turning the wheel under most circumstances feels pretty normal. However, say, doing parking maneuvers SOMETIMES feels like I have non-power steering for maybe a quarter turn, and then it picks up again.
Golf V R32 :: Fuel Level Sensor Failure / Gauge Went To Zero
In the last 24 hours my fuel level sensor is failing intermittently. After filling yesterday the fuel gauge went to zero and the MFD read "---" for any range or fuel calculations. Rebooted the car ( ) and it came back on, then off again. today it seems to be working, but I'm waiting for the other shoe to drop.
View 5 RepliesPrius (2010-12) :: Speedometer And Fuel Level Indicator Blank - Instrument Cluster Failure
While traveling speedometer and fuel level indicated blanked out. No other problems--I could see our speed by using GPS.
Toyota service said a circuit board was burned out. I searched and found numerous such problems with 04 up to 09 and eventually (in 2012) Toyota initiated an extended warranty to cover replacement of the board.
Corolla / Matrix 2009-13 :: Oil Pressure Sending Unit?
know where the Oil Pressure Sending Unit is located on a 2011 Corolla. I am planning on taping into that so that I can attach a bypass oil filter that will slow filter the oil down to 2 microns. Although in doing that, I will not ever have to change the oil again, but only change out the filters and top the oil off. I will occasionally need to send in an oil sample to make sure that there is no degradation in the oil.
View 5 RepliesFord :: 1999 E-150 4.2L - Lost Oil Pressure Sending Unit
The oil pressure gauge is dancing on my 4.2L '99 Ford E-150 (V-6) and at times the oil light comes on but there's no rattling or other signs of oil deficiency in the engine. I'm pretty sure it's a problem with the sending unit and did an oil change today but for the life of me couldn't find where it's located. I looked all around the filter when I replaced it but to no avail. The Haynes manual and internet pics I find are not recognizable parts in them to reference. I can't tell if they're looking under the car, on top, driver's side etc.
View 11 RepliesGolf IV R32 :: Small Oil Pressure Sensor Sending Unit
Looking for a "small" sending unit that works with an electrical gauge. When I mean small I'm talking smaller than 2 inch diameter and 3.25 inches long.
I have a sending unit with those dimensions and would like something more compact if at all possible. The range needed would be 0-100psi.
Trans Sport :: 1993 - Oil Pressure Sending Unit / Best Way To Access It
1993 TransSport 3.8: Where the heck is the oil pressure sending unit, and what is the best way to access it? What size of OPSU socket does it take; 1", 1 & 1/16", or 1 & 3/16". Do I need the 3/8" or 1/2" drive; extra deep or other wise? The van has a gauge on the dash.
View 6 RepliesCelica :: 92 - Can't Find Oil Pressure Sending Unit / Blinkers Don't Work
I have a 92 Celica 1.6L STX, first of all I can't seem to find my oil pressure sending unit, second none of my blinkers work! I've replaced the fuse, the flasher, and the bulbs they still don't work.
View 2 RepliesFord - Windstar :: 2000 - Temp Sensors Or Sending Unit?
My question is about a 2000 ford windstar with 3.8 engine. Does this vehicle have a coolant temp sensor and sending unit or just a sensor?
View 7 RepliesFord - Explorer :: 1996 - Replaced Sending Unit - Overheating?
I had to replace the temp gauge in my 1996 Explorer. I also replaced the sending unit. Now, it is overheating, badly. I replaced the thermostat, twice. Filled the coolant and removed the air in the system. It seems to get good water flow, and there are no coolant leaks. The radiator looks clean, and the cap looks ok. But, as soon as the engine warms up, it goes right past the midline on the gauge all the way to hot - at idle. It gets worse if I drive it. I have grounded the gauge and it seems to be working fine. What could the problem be?
View 5 RepliesFord Ranger / B-Series :: Oil Pressure Sending Unit Location
3.0 - Where is located ?
View 2 RepliesVenture :: 2002 Chevy - New Fuel Filter Leaking Gas
Yesterday our 2002 Chevy Venture minivan died in the store's parking lot. It would not stay running when we started it and let off the gas. As long as we were pushing the gas pedal down, the van would run. As soon as you let off the gas, it died.
So my husband walked to the auto store and bought a new fuel filter. He then tried to replace it in the store parking lot. As soon as he took off the 'male hose' from the fuel filter, a lot of gasoline sprayed him in his face and of course he came out from under the van screaming and in pain. (Don't worry with kids we had over 8 bottles of water in the van and I flushed his face and eyes for over 10 min and he is fine now).
Anyway, in the process of flailing under the van when the gas hit his face, he jumbled up these little black and rainbow colored rings and lost a long rusty screw/bolt that screws the main round body of the fuel filter to the underneath of the car and holds it in place.
We searched and could not find the bolt. My husband jumbled up the small rubber rings and did not know what was from the old or new filter. He tried placing them on the new fuel filter but as soon as he turned on the car, not even the engine just turned the key to where you can play the radio... all this gas sprayed out from the new fuel filter. After many tries of re-arranging the little o rings he gave up and called a tow truck.
Today he called auto zone and they looked at a new fuel filter in it's box (same one my husband bought) and told my husband that there was only one small black o ring on the fuel filter. So he put one ring on his new fuel filter (on the male hose I think) but still the filter sprays gas as soon as he turns the key. He then went and bought new 'hose clips' and tried those. The fuel filter still sprayed gas.
So, what I am now trying to find out is what could possibly be causing the fuel filter to spray the gas (leak). My husband (in his words) is a welder, not a modern car mechanic and is getting really stressed over this.
1. Does he need new or different sized little rubber rings?
2. Could the missing bolt that screws the large body of the filter to the car be causing this gas leak?
3. I read he should turn off the gas some where and then replace the filter, could this cause a gad leak issue because he did not do this before replacing the fuel filter?