Toyota - Corolla :: Grinding Noise When Starting
My 2009 Toyota Corolla has started to make a grinding noise when starting. The sound is identical to when you try to start an idling car. What the problem is?
View 7 RepliesToyota - Corolla :: 2009 - Grinding Noise While Turning Right
I have 2009 corolla with 70000 miles on it. I replaced new brake pads. I have some metal grinding noise when i turn right only. I tried looking online and got few similar problem faced by other people. I am not sure if its exactly same issue. No accident damage. Mostly driven on freeway.
1) noise looks similar
2) I do not get noise when i accelerate
3) for car this old is it expected ?
Toyota - Corolla :: 1998 - Grinding Noise When Let Off The Gas And Engine Goes Down To Idle
I have a '98 5-Speed Corolla. If I rev the engine when the car is in neutral and warming up I hear an odd grinding noise when I let off the gas and the engine goes down to idle. The noise does not occur if I put my clutch in. Is this something to worry about?
Also, I'm wondering what CV joints sound like when they're failing.
Toyota - Corolla :: 2004 - Slight Grinding Noise From Front Right
I have an '04 Corolla with 206k with a slight grinding noise from the right front when I make a left turn. Is it the outer CV joint? The noise sounds like the tire is rubbing against a splash guard but it's not.
View 3 RepliesToyota - Corolla :: 2005 - Grinding Noise From Front Right Wheel
I recently brought my 2005 toyota corolla to my mechanic to give my car a check up as i will be going on a three week road trip soon.Upon assessment, my mechanic told me that my front right wheel bearing was making a strange noise and that i should replace it. I went ahead and had it replaced. after i had it replaced the front right wheel area was still making a grinding noise (louder than before it was replaced). I brought it back and he replaced it again with a new wheel bearing.
Again after the 2nd replacement it continued to make a load crunching, grinding noise when ever i brake the car. So once again, i brought it back. I thought perhaps it was my brake rotor and had him check that. He did just that and said the break was fine. He said it may be because the axl was not sitting true. so i had the axl replaced. well today i picked up the car and drove it approx 5 miles and the same crunching/grinding noise persists!!! I brought it back and it is once again being worked on. I need it fixed and am worried that my car won't hold up for my upcoming 4000mile road trip. I have attached a video clip of the sound to this post.
Toyota - Corolla :: 2005 - Making Grinding Noise While Shifting?
Our 05 Corolla, 160,000 miles, has started making a grinding sound when we upshift into 3rd, unless we let the rpms fall to below 1000. My husband said the clutch needed adjusting, but the dealer said this clutch is not adjustable. The dealer found nothing wrong and could not get the car to make the noise while in the shop. (It did actually get better for a while but got worse again almost immediately after the visit to the dealer.)
Our other car (a Saturn) has over 250K miles on the original clutch, so I don't think it's our driving. What could be wrong, and is this something that needs to be addressed soon lest we damage something irreparably? Also, this car has, since purchase, been nearly impossible to shift on the coldest mornings. Really, sometimes it is all I can do to get the lever in reverse to back out of the drive in winter (in Kansas). Warming up works, but it seems to take an inordinate amount of time before shifting is"normal."
Toyota - Corolla :: 2008 - Engine Runs But Car Does Not / Loud Grinding Noise
I was driving my car today, and I stopped at a stop sign. When I went to go, I pushed the gas, and my car revved up, moved forward, then all of a sudden it made a loud grinding noise (Like I was dragging metal sheets), and the gas stopped responding (but the engine was still running). The car still turns on, but whenever the gas is pushed, it doesn't go and makes that awful noise. What could be wrong?
View 2 RepliesToyota - Corolla :: Metal Grinding Noise - New Pads Resurfacing When Replacing Rotors?
I replaced my pads 3 months ago. Now I have a metal grinding sound (not squeaking). The mechanic says I need new rotors, and he will resurface the pads. I know I can replace the rotors myself; but do I need to resurface the 3 months old pads? If so; how will they resurface them?
View 4 RepliesToyota - Corolla :: 2007 - Metallic Grinding Noise When Turning Into A Parking Spot
My car has been doing this more. When I turn into a parking spot or my works' parking garage my car front end makes a Metal Grinding noise But it does not make this noise when I am driving - turning corners. Car is a 2007 Toyota Corolla LE (I miss my Beetle). The Toyota service says brakes are fine and they see nothing. I am not the only one that hears it... My son has hard it and I have startled some pedestrians.
View 1 RepliesCorolla / Matrix 2009-13 :: Toyota Making A Loud Grinding Metallic Noise On Front Left Side
I have a 2009 Toyota Corolla and it's making a loud grinding metallic noise on the front left side. It does it while I drive the faster I go the louder it gets. When I turn to the left it makes it louder, when I turn right the noise decreases. PG&E have been breaking the roads by where I live and there's a lot of little rocks I drive thru. I'm wondering if that's the problem?? What do I do?
View 4 RepliesCorolla / Matrix 2009-13 :: TSB - Grinding Noise On Start Up
I have a 2009 Corolla with 67k on the odometer so it is outside of warranty. I recently found about the TSB for the grinding noise on start up and took the car to my mechanic to have it looked at. He said he wasn't able to do the job because he would have to do some sort of computer update (ECU reflash?) and he doesn't have the means.
My car is currently at the dealership, and they want around 1800 dollars, 1400 for the VVTI gear, and another 400 for a tensioner. I have a friend who used to be a Toyota mechanic, and he says he can do the work as stated in the TSB, but he's unsure if the ECU would need updating, and it does not mention anything in the TSB. So what I am wondering is if :
1. Does changing the VVTI gear actually fix the grinding noise? I was reading an old thread where members said it was still there after having the TSB done.
2. Does there need to be anything done to the ECU after doing the TSB?
Corolla / Matrix 2009-13 :: Grinding Noise Whenever Start Up
I have a 2009 corolla S. no warranty. 59k miles. my car gets a grinding noise whenever i start it. this is the example of the sound.
YouTube ....
Corolla / Matrix 2009-13 :: Cranking / Grinding Noise At Start For Half A Second
Sometimes when I start my car it makes a weird cranking/grinding noise for half a second. The closest thing I have to engine mods are my TWM short shifter, and my borla axle back exhaust.
The noise only happens after my car has been sitting there, parked for a few hours. So to bring it to Toyota/mechanic would be nearly impossible to replicate, unless I left it there for a while. And even then, the noise only happens sometimes.
Yes I'm pressing my clutch pedal all the way down. No I am not holding the key too long when starting the car. What it might be?
Toyota :: 1999 - Grinding Noise On Cold Start
I have a 99 Toyota Tacoma 4 cylinder. Just reached 200,000 miles this past Sunday. I did a cold start this morning and there was a grinding, metallic noise from under the hood. I turned the key bafk because it didn't sound good. Turned the key again and it started like normal and ran fine. I had a new starter installed last Thursday and now I'm wondering where this noise is coming from. Before I changed my starter, I had the bad starter symptoms in the last two weeks, slow to crank over, the whining airplane noise (happened 3 times in the last 3 weeks). But now, this new grinding noise has me even more worried. Does my engine have to get used to the new starter and what other issues could this be? The battery passed the battery test at Autozone, and my alternator is fine as i unplugged the positive and negative wires from the battery while was truck was running. I really really like my truck and am trying everything in my power to keep it running as smoothly as possible.
View 19 RepliesFord F-150 (2009-2014) :: Grinding Noise At Start Up Only
I have a 2010 XLT, 85K, just started having a horrible grinding noise at start up for about 2-3 seconds, then gone. Going to dealer tmrrw. Multiple people said, possible oil pump hydraulics, ??????. Whatever it is, they say its expensive!!!!!
View 3 RepliesToyota - Batteries - Corolla - Alternators :: 2014 - Starter Making A Loud Buzzing Noise
I bought my 2014 Corolla new a little over 3 years ago. Yesterday, when I was leaving work to head home I went to start my car and I was just met with my starter making a loud buzzing noise. My lights in my car, car fob, and etune radio were all working properly, but the car was just not able to start! My coworker told me that he heard of a trick where if you knock on the starter with something while trying to start it, it might give it enough of a kick to get going. Whether or not it was coincidence, it did work.
I was able to drive home, about 15 minutes (still daylight, did not need car lights), with no trouble. When I got home I turned my car off and waited for a few seconds and tried to start again. It worked, but it sounded like it struggled. I did it one more time and it failed with that same noise again. I resolved that I would just go get a new battery in the morning.
In the morning, my car was able to start, albeit with some struggle again. I made it all the way to work, and over lunch I was able to start it again and drive it to AutoZone to have them test the battery starter alternator. They told me the battery was too depleted to test it, so I went across the street to Walmart and bought a new battery. After replacing it, the car started like a champ as expected, and I drove back to Autozone to have them test my alternator and starter. The starter came back good, but they said that there was a fault in the test with the alternator. I gave them my old battery and asked them to trickle charge and test it just to see if it happened to still be a good battery that was just losing charge, or if it really was just a dying battery.
Toyota :: 1986 - Grinding Noise A Few Times But Would Eventually Start Up
So we have had problems with the starter (and flywheel?) since we acquired the truck, these problems being that when we would go to start the car, it would make a horrible "grinding" noise a few times, but would eventually start up. Recently, the car would not start at all, and made no noise when the key was turned. Called AAA, they gave us a jump, and the truck started again. Assuming the problem was then with the battery, we replaced it as well as both terminals. The truck would still not start after doing this, no noise at all when key turned. My questions then would be, if the battery is not the problem, why did the truck start after we had a jump? I'm thinking it might be the starter, and if the starter was shot, would the truck have no sign of life when the ignition was turned on? Should i try and change the starter or is there possibly another variable? 1986 auto Toyota Pickup....
View 1 RepliesToyota - Corolla :: 1998 - Brakes Are Squeaking And Grinding Often
We have a 1998 Toyota Corolla with 170k miles. The brakes are squeaking and grinding often. In Feb. the front brake pads were replaced, but the noises continued. In May, they replaced the front pads again, within a week the grinding and squeaking continued. Finally, I took the car in late July and had the mechanic drive the car around. He said the back brakes were making the "grinding" noise and the front was squeaking. He said it was "cheap brake parts". When he looked at the brakes he said the back brakes needed adjusting and may not be working as well, therefore making the front brakes work hard. This caused the front brakes to get hot and develop a glaze. He adjusted the back brakes and scratched up the front brakes. The car was fine for about 2 weeks or so. The sounds have gotten progressively worse and I refuse to drive the car. The brakes seem to work, but the sound is so terrible like something is loose, or off and scraping metal. We have used this mechanic for years with a recommendation from our neighbors.
View 4 RepliesToyota - Corolla :: 1991 - Gear Grinding / Car Rolls When Parked As If It Was In Neutral
OK, my daughter bought a clunker. Engine compression tested good, and transmission shifted fine so I proceeded to fix the car. Everything went fine until I got to the passenger side axle. I've always reused the inboard "tulip", and have never pulled one. Until today. The boot on the remanufactured shaft would not fit over the old tulip. I rented a slide hammer with a cv remover attachment and removed the old tulip. I then installed the new shaft, using a hammer on the end of the shaft to reseat the new shaft in the transmission. I didn't hit it hard. Now the car makes a horrible groaning sound when I put it in reverse. When I shift back to park, it sounds like a gear grinding. Also, the car rolls when its in park as if it was in neutral. I'm totally stumped as to what I did wrong. Did I destroy the transmission???
View 19 Replies