Camry :: Strut And Spring Assembly Replacement On 2007 LE
Looking to replace my strut and spring assembly on my 2007 Camry LE with 130,000 miles. What is the best China units out there. The list is many Prime Choice, Detriot Axle, Unity, FCS, AST, Sensen, ect.... Maybe they all are made at the same factory. FYI Monroe and Gabriel could be made in China. KYB complete units are assembled in USA, I called them up.
View 13 RepliesHonda - Cr-v :: Front Shock Strut Assembly Replacement
Took my 2004 Honda CRV 2W Drive to my local dealer for the 90K maintenance. There they recommended for me to replace the front shocks strut assembly--not quite remembering the reason but they told me that it needs to get done. Before I get the work done, I am trying to find as much info on what next steps to take.
View 10 RepliesCelica :: 1998 Toyota Front And Rear Strut Replacement
Any good video/instructions/tips on replacing the front and rear struts on a 1998 Toyota Celica?
View 2 RepliesCamry :: Weird Noise Coming After Strut Replacement
I recently replaced my factory struts with KYB's all in one solution. I also did the craft felt mod that HardTop suggested. Ever since they have been replaced I'm getting a weird noise. When I turn the steering wheel in either direction it makes a rubbing sound that is very audible. The vehicle drives fine, and the struts ride really well. However, the noise is a touch annoying.
View 8 RepliesCamry :: 2004 LE - Dull Clunk Noise In Rear End After Strut Replacement
I just replaced all 4 struts on my 04 Camry. The car has 87,000 on it. I went with the Monroe OESpectrum struts and new strut mounts (Monroe). Springs looked fine, the rubber spring seats were fine as well and the bellows, so reused those items.
I now have a noise in the rear end that I did not have before. It sounds like it is coming from the lower part of the car and is not metal sounding. It is a very dull clunk when going over bumps in the road and is coming from both sides.
I replaced the sway bar bushings a couple years ago. I checked those and there is no play and appear to be fine. Also checked the sway bar links and they seem fine to me, but not sure what makes those bad. Torqued what I could. Used an electric impact wrench on the strut nuts and could not torque that because the rod spins.
I am taking it in on Monday for an alignment and to have the shop see if they can figure out the noise. Is it possible that the new parts could be binding and the alignment may take care of it? I have doubled checked my work and everything appears to be on correct.
Tiguan :: Clunk Noise Coming From Tight Strut - Pillow Mount Plate Replacement
I have a set of ST coilovers, installed on my tiguan s4motion they ride great but have noticed clunk noise coming from tight strut and I'm pretty sure it's the pillow mount plate, is there anywhere to get replacements or a better plate? ST website doesn't have them separately...
View 1 RepliesCamry :: 2009 Toyota - Front Brakes Clunking / Knocking After Replacement
I changed the front brake rotors & pads on my wife's 2009 Toyota Camry & everything seems fine except when doing sudden or slightly hard stops it seems to do a clunk/knock type sound from the front brakes. It also only does it sometimes not every hard/sudden stop.
One thing that comes to mind is that when I went to tighten one of the guide pin bolts it was a real pain, the big bolt that the screw threads into kept spinning making it hard to tighten the bolt into & none of the others did this. I thought I tightened it down but possibly not?
Grand Prix :: 1999 GTP Rear Strut Shock Knocking
I have a 99' GTP with 199,000 miles. I drive the very bumpy roads of Chicago. Recently when I go over any small bump, large bump, or when I am going fast and break I get a knocking sound mostly out of the right rear wheel, a quieter knocking out of the left rear wheel. It just sounds like a dry knocking when you go over any little bump or inperfection in the road. I am assuming that it is the struts. I don't know if i can just replace the shock part for $50 something or if my problem needs to be solved by replacing the whole strut assembly which includes preassembled strut, coil spring, strut mount and strut bearing?
View 11 RepliesSanta Fe (CM - 2007-12) :: Strut / Shock Failure - Knocking Sound From Front
My 2008 Santa Fe (3.3 2WD) produces a knocking sound from the front every time I go on a bump while the wheel is turned. I can pretty much reproduce it at will. Occasionally, I hear the same sort knock from the rear as well, but I cannot confirm that it is consistent.
I do suspect that something is wrong with the struts. The only issue is that the car has 67k KM (41k miles), and to me, that seems a little early for that sort of thing to happen. My driving is pretty standard on standard roads, although winters up here tend to produce potholes that I sometimes cannot avoid.
I've had my struts fail on my last car (2000 Mazda Protege), but that was 9+ years old and with almost 3 times as much mileage on it.
Lexus RX 2004-09 :: HID Headlight Assembly Replacement?
My headlights suffered from the dreaded condensation problem. I brought them to Lexus after getting the warranty enhancement paperwork and had them replaced. Shortly after the passenger side wheel cover was ripped off after getting caught on some ice during a storm. It was very shortly after that that condensation begin appearing in my passenger side headlight.
At that point I was unaware that the wheel well cover had been ripped off. I brought it back to Lexus to have it looked at since I only had the headlight replaced a few weeks before. I was told it would be at a cost of $2,500 to replace with an additional $400 for the wheel well cover. Needless to say, I did not have the work done that day. While I was waiting them for them to finish the paperwork I bought the wheel well cover for $50 online but since then I've had difficulty locating the headlight.
I brought it to my mechanic and he was unable to find the headlight as well. I have a 2009 rx350 with HID AFS headlights. I have looked on ebay, Amazon and just through the internet to see what I could find but I'm finding only halogen headlights. Most of what I'm seeing on eBay are for non-adaptive lights that are damaged.
Camry :: 2007 / Headlight Assembly Replacement?
I'm trying to replace my dads 2007 Camry XLE japan built headlight assembly because his are insanely oxidized. Besides OEM's and CAPA's, what else are there? Any good aftermarket headlight assembly and achieve great results?
View 8 RepliesPrius (Gen 1) :: Tail Light Assembly Replacement?
I'm a not-terribly-handy (but not totally inept!) apartment dweller with few tools, but it looks like I'm going to need to go buy a deep socket. I park on the street and came out the other day to find my driver side tail light pretty smashed up. I found one for $75 at the junk yard and believe I can swap them myself. I found a YouTube video that shows how to do it on a Gen II. On the Gen II, the nuts holding the assembly in place are 10mm. Definitely not the case on the Gen I. They're much smaller. I have a set of sockets but nothing deep enough to get me past those long bolts, but I'd rather not buy a whole set, since I'm not even sure whether I'd need metric or standard.
what size nuts hold the tail light assembly in place on a 2001 Prius?
Camry :: Steering Wheel Crooked After Strut Replacement
So I changed the front struts, springs, mounts, bearings, etc with factory Toyota parts. The car is a 2007 Camry LE 4 cyl with over 200k miles. While the car does not pull to one side, the steering wheel is now at roughly the 2 o'clock position for the car to be driving straight. Nothing else was changed, replaced, or modified. I do notice the car sits much higher now than it did before (old struts leaked oil and needed to be changed).
View 8 RepliesPrius (2004-09) :: Clunking Noises After Strut Replacement
I had my friend of mine who is a mechanic change my struts out this weekend. I had clunking noises from the right strut Toyota and also a tire place said I needed new struts. So I got them replaced now both sides are clunking see the YouTube video.
View 7 RepliesPrius (2004-09) :: ABS Light Came On When Car Started After Strut Replacement
I replaced my front struts today and afterward the ABS and "(!)" light came on as soon as I turned on the car. I checked the speed sensor lines and they all look okay so I didn't damaged them in the process. The car brakes quite soft but still works and the regenerative braking still works. The mechanic pulled the following codes: C1300 and C1319. I went ahead and reset the ABS light by crossing pin 4 and 13 on the OBD2 connector technique. That reset the lights, and the brake also works as normal as well. After driving around a bit, turned off the car, then turned it back on the lights came back on again.
View 6 RepliesFord F-150 (2004-2008) :: Front Strut Replacement
I've just begun to replace my front struts (Monroe quick strut pre-assembled). The thing is, the top bearing plate bolts and the lower mounting point are out of alignment by 90 degrees. The included directions say they can be rotated but gives no procedure and they do not just "turn" easily obviously. How to rotate them to fit??
View 3 RepliesFord Super Duty (1999-2016) :: 2002 F250 Knocking / Loose Front End Assembly
My 2002 F250 is knocking loose the front end assembly--the gasket is worn out. So I was shopping around and was considering a beefed-up front end assembly.
View 3 RepliesPassat (B7) :: Passenger Side Headlight Assembly Replacement
I am in need of replacing the passenger side Front Headlight assembly. I was wondering, how to assemble it outside of a repair shop. I was also looking to possibly get the part number so I can make sure I am purchasing the correct product for my 2012 VW Passat SE.
View 8 RepliesPrius (2004-09) :: 2008 - Headlight Assembly Replacement
The drivers side headlight assembly on my 2008 Prius has moisture in it. I have 52,000 miles on the car, so I do not think it is covered under warranty. What / how can you replace the headlight assembly?
View 7 Replies