Prius (2004-09) :: ABS Light Came On When Car Started After Strut Replacement
I replaced my front struts today and afterward the ABS and "(!)" light came on as soon as I turned on the car. I checked the speed sensor lines and they all look okay so I didn't damaged them in the process. The car brakes quite soft but still works and the regenerative braking still works. The mechanic pulled the following codes: C1300 and C1319. I went ahead and reset the ABS light by crossing pin 4 and 13 on the OBD2 connector technique. That reset the lights, and the brake also works as normal as well. After driving around a bit, turned off the car, then turned it back on the lights came back on again.
View 6 RepliesLexus RX 2004-09 :: RX350 Left Rear Strut Developed Leak And Started Making Noises
I have a 2009 RX350 with 51,000 miles (just 1000 over warranty). The left rear strut developed a bad leak and has begun making the noises associated with the failed strut. I will be changing out both rears and have two questions that I cannot find info for on the web.
1) I noticed the 2 latches on the side covers inside the back area to remove the panel and expose the rear strut tower, are these the only two latches I need to remove to access the upper bolts, or are there hidden screws or things I need to do to remove the panel?
2) What are the torque specs for the rear strut bolts?
Ford F-150 (2004-2008) :: Front Strut Replacement
I've just begun to replace my front struts (Monroe quick strut pre-assembled). The thing is, the top bearing plate bolts and the lower mounting point are out of alignment by 90 degrees. The included directions say they can be rotated but gives no procedure and they do not just "turn" easily obviously. How to rotate them to fit??
View 3 RepliesCamry :: 2004 LE - Dull Clunk Noise In Rear End After Strut Replacement
I just replaced all 4 struts on my 04 Camry. The car has 87,000 on it. I went with the Monroe OESpectrum struts and new strut mounts (Monroe). Springs looked fine, the rubber spring seats were fine as well and the bellows, so reused those items.
I now have a noise in the rear end that I did not have before. It sounds like it is coming from the lower part of the car and is not metal sounding. It is a very dull clunk when going over bumps in the road and is coming from both sides.
I replaced the sway bar bushings a couple years ago. I checked those and there is no play and appear to be fine. Also checked the sway bar links and they seem fine to me, but not sure what makes those bad. Torqued what I could. Used an electric impact wrench on the strut nuts and could not torque that because the rod spins.
I am taking it in on Monday for an alignment and to have the shop see if they can figure out the noise. Is it possible that the new parts could be binding and the alignment may take care of it? I have doubled checked my work and everything appears to be on correct.
Golf/GTI VII :: Strut Noises At Low Speeds
Hear struts on rough surfaces in parking lots or other rough surfaces at low speeds? It is something that I started noticing and I'm not sure if it is a standard VW thing or if it indicating some sort of premature failure. My previous car didn't do that (wrx) but I know every car manufacturer is a bit different.
Having gone through dealerships in the past for sounds that were not that loud I don't feel it is worthy of a dealership trip unless it gets more audible. They usually just say they heard nothing and everyone tells me I am ...
I want to get VWR springs but if I can hear the struts now it makes me wonder if it will accelerate failure. As stated above, I don't notice it at any normal driving speed, just slow maneuvering on rougher surfaces.
Passat (B6) :: 2009 - Squeaking / Creaking Suspension Noises Seeming To Originate From Shock / Strut Tower Areas
Any noted 2.0T, B6 experience/solutions for squeaking/creaking suspension noises seeming to originate from shock/strut tower areas? I purchased new in 2009, 37K mi ago. VW dealer service persons think they hear it sometimes. Been chasing this problem for a year or more, mostly notable in cold weather. Condition evident driving on uneven pavement, dips in the road etc. Passengers ask "what is that squeaking".
View 7 RepliesGolf IV R32 :: Suspension Clunking - Strut Caps Raised A Little Under Load
Installed fk coils about 5k miles ago. I replaced the strut mounts and the bearing with new oem. I am not "slammed" by any means but a very mild drop. I noticed the strut caps are raised a little under load, can this be the cause of the clunking sound? The strut cap going down on bumps etc? Or could the strut mounts have already failed. Seems a bit premature to me. I guess I'll have to take it apart and take a peek.
View 2 RepliesVolvo :: 2005 XC90 - Clunking Sound Coming From The Driver Strut
I purchased my 2004 XC90 2.5T today. it's got 150k miles.
1. there is a clunking sound coming from the driver strut, I'm thinking it is the bushing on top.
2. should i just replace the whole strut assembly? if so is there a diy? and a kit for this?
3. Rear window doesn't stay up, im thinking the sliders on the window are broken?
4. most importantly, whats the best iPod / iPhone hook up for the volvo.
5. also what mods for keeping it clean.
Attached File(s) : IMG_4763.jpg ( 1.44MB )
Golf/GTI VI :: Rough Clunking Noise After 034 Density Strut Mount Install
Setup: WRD Street Advantage Coilover kit. Installed and sit at 24.75" all around. 034 Density mounts and new bearings. 19,xxx mi.
7 weeks ago I installed WRD Street Advantage coils. The install went great, no problems. Drove a week or so and decided to replace the strut mounts with 034's density strut mounts and new bearing to get rid of the creaking sound at low speed. Ordered them and put them on this weekend. After driving it I realized the creaking of the old weaker strut mount was gone. However, I inherited a rough clunking or knocking sound (as if something is loose and moving around), which seems to be coming from my passenger side. This happens at all speeds and not specific to turning the wheel. I unistalled/reinstalled everything in the front 4 times and went through everything with a fine tooth comb, but can't find anything loose. All bolts are torqued to spec.
I even removed the sway bar end links and drove it, still there. So it's not the end links. I also tried using the OEM endlinks which are longer than the ones from WRD to increase the space between the axle and the sway bar, possibly thinking it was hitting and causing the noise. No luck, still there. The only thing I noticed is that with the car on jack stands the strut mount is tight to the body but I still have slight play in the spring and it's perch. Is that normal? I'm assuming under load it's tight again. So the only variable in my situation is the new Density Mounts and bearing, can these cause heightened noises due to the increased heardness of the mounts?
Camry :: Spring Clunking Noise Coming Out Of Driver Side Strut Tower
So I installed my H&R lowering springs about 2 months ago and I am very happy about the stance, ride, and handling up until about 2 weeks ago. The car always had a bit of a spring clunk coming out of the driver's side strut tower, but it has become more apparent and pronounced over the last few days. I already tightened the strut nut and shock tower bolts, what else is there to check out?
View 14 RepliesPrius (2004-09) :: Replacing Hatch Gas Strut?
I need to replace these as they are weakening. Can I get replacements at my FLAPS or are they a Toyota-only item? I'm asking because on another vehicle, I could not get the strut from a FLAPS due to the length not being a standard length with the proper connectors.
View 1 RepliesPrius (2004-09) :: Disassemble Front Strut / Top Bearing
I was going to put on some lowering spring on my prius last night but i couldnt figure out how to get the top bearing off. Looking for pictures or a guide or something?
View 1 RepliesPrius (2004-09) :: Changing Rear Strut / Cannot Get New One Back In
I've been (for the first time) changing my struts on my 08 prius, having read a couple of threads, have manual, etc. The fronts went in fairly easily, but I noticed that when taking out the rear (left), it (the spring) was under a fair amount of compression when it "dropped" out. I was thinking, "how will it go back in once I swap out the strut?".... Also, it seems to me that the stud/spindle is in the way, making it very difficult to get the strut back in as well. I believe I have the vehicle jacked up in the same manor that Patrick Wong shows, with the 2x4 under the axle, and a 2nd jack as well. What is the trick to get this back in???
View 6 RepliesCamry :: Strut And Spring Assembly Replacement On 2007 LE
Looking to replace my strut and spring assembly on my 2007 Camry LE with 130,000 miles. What is the best China units out there. The list is many Prime Choice, Detriot Axle, Unity, FCS, AST, Sensen, ect.... Maybe they all are made at the same factory. FYI Monroe and Gabriel could be made in China. KYB complete units are assembled in USA, I called them up.
View 13 RepliesCamry :: Steering Wheel Crooked After Strut Replacement
So I changed the front struts, springs, mounts, bearings, etc with factory Toyota parts. The car is a 2007 Camry LE 4 cyl with over 200k miles. While the car does not pull to one side, the steering wheel is now at roughly the 2 o'clock position for the car to be driving straight. Nothing else was changed, replaced, or modified. I do notice the car sits much higher now than it did before (old struts leaked oil and needed to be changed).
View 8 RepliesCamry :: Weird Noise Coming After Strut Replacement
I recently replaced my factory struts with KYB's all in one solution. I also did the craft felt mod that HardTop suggested. Ever since they have been replaced I'm getting a weird noise. When I turn the steering wheel in either direction it makes a rubbing sound that is very audible. The vehicle drives fine, and the struts ride really well. However, the noise is a touch annoying.
View 8 RepliesToyota :: Knocking Noise After Strut Assembly Replacement
I ran over a rather large pot hole while driving home in the middle of the night. It destroyed my tire and tire sidewall and soon after the strut started to make a knocking noise while going over bumps. I replaced both front strut assemblies with Monroe Quick Struts (photo attached). After the install, the noise was gone and everything seemed good so I gave the car to my wife. After several months, I decided to drive the car to see if everything was still OK and it wasn't. The knocking noise on the driver front strut came back.
I took the car back to my mechanic and he said that he thinks the strut assembly was defective and that I should get a replacement since it was under warranty. I would just pay labor again for him to change it. Something seemed off by the conversation, so I decided to take the car to another mechanic for a second opinion, but before I do that I want to pose this question here. What could be the problem? Why did the knocking noise come back?
I've attached more photos. You will see two photos of the tops of the strut assemblies from under the hood. The first top photo is of the passenger left strut that is good (with the wheels straight). The second top photo is of the problematic driver front strut. You can see the top is slanted left with the wheels straight. The rest of the photos are from around the driver side wheel.
I did complete a wheel alignment after the install and the car pulls left when the steering wheel is straight after the alignment.
More information about the Monroe Quick Strut: [URL] .....
Honda - Cr-v :: Front Shock Strut Assembly Replacement
Took my 2004 Honda CRV 2W Drive to my local dealer for the 90K maintenance. There they recommended for me to replace the front shocks strut assembly--not quite remembering the reason but they told me that it needs to get done. Before I get the work done, I am trying to find as much info on what next steps to take.
View 10 RepliesPrius (2004-09) :: 2006 - Cracked Strut Boot On Passenger Side
While swapping on my winter tires yesterday, I noticed the strut boot (I believe it's called) on the passenger side has a large crack, almost split in two. See picture attached.
The Prius is a 2006 with almost 370K KM (~231K miles), and I am hoping to keep the car for another 1-2 years, until the PIP2 is out.
Is this something to be concerned about? The strut is not leaking, and the suspension seems otherwise fine.