Ford Super Duty (1999-2016) :: EBrake Light Show Up On Dash / Turn Signals Stopped Working / Heated Seats No Longer Turn On
Coming back from a trip I got a e-brake light show up on the dash then noticed the signals stopped working and the heated seats no longer turn on. I scanned it with my AE and got a brake fluid sensor error come up but nothing about the signals .... is this a common problem or is there a connection between all this? 2003 F350 6.0L .....
View 2 RepliesPassat (B5) :: Turn Signals Stopped Working
So I get to explore my first repair with this new to me car. Yesterday morning, turn signals works fine. That afternoon, the stalk apparently stopped working, which I have heard of. Interestingly though:
-the brights and cruise work
-the hazards work (my improvised indication that I'm turning )
-the stalk had been replaced once before by the PO.
Did this thing eat another stalk, or are there some other things I should check first?
Camry :: Turn Signals / Hazards Stopped Working
I used the volt meter wrong while testing my turn signal bulbs for power and not they do not work (or hazard lights).
View 3 RepliesSanta FE SM (2001-06) :: Turn Signals Stopped Working
I own a 2004 hyundai santa fe and just recently my turn signals have stopped working. My bulbs are fine because they still light up when I lock my car and my hazards work too. The flashing arrows on my dashboard wont show up for my turn signals but they will show up for hazards. I checked the fuse and its completely fine. I am so confused with what is wrong. The only thing I was doing before was messing with my new head unit which involved unplugging a lot of the stereo and fog lights and hazards but that all should have no affect on my turn signals.
View 6 RepliesGolf IV / Jetta IV :: Turn Signals Stopped Working?
The issue I am now experiencing is my passenger headlight would only turn on once in a while . The driver side headlight would work just fine both high beam light also . Today I opened my hood I verified the cable had a poor ground to the headlight I noticed a burnt smell after checking the cables . I turned on my high beams both sides turn on . Then out of no where my turn signals both (Left - right - back and front stopped working. Including the Hazard lights both front and back). The cluster would not show neither turn signals turning on ( left-right ) I noticed that my headlight turn signal on the passenger side would turn on but not blink it would stay dim only when . I pushed the hazard light button . My cluster would show the right turn signal ( no clicking no flashing arrow ). The driver side would not work either. What can I do to fix the problem? I know that I will not be able to drive the car due to the issue.
View 5 RepliesTouareg :: Turn Signals Won't Working?
A month ago, I needed my horn. No workie. Blown fuse. Yesterday, drove all morning, everything fine. Parked, came back to car, no signal lights on either side, no emergency flasher. Pulled fuse covers, no blown fuses. Restarted car, signals working again. Another change also: Ever since I found out how to view total consumption, miles since fillup, etc on the MFI, I have been unable to change it to current stats. I've pushed the roller wheel over and over again, held it in, etc. Now that this electrical gremlin has reared its ugly head, my trip computer has, on its own, reverted to current readings.
View 4 RepliesGolf IV / Jetta IV :: Turn Signals, AC And Horn Stopped Working
Last weekend my headlights, wipers, turn signals, AC, and horn stopped working. Through searching and another post I narrowed the issue down to my ignition switch. After taking apart my steering column and getting the switch out, I found this...
The house which is connected to the switch, with the one of the red wires obvious fried....
So I'm hoping this problem and I'm wondering who else has had this happen. When I took apart the ignition switch itself, nothing appeared to be damaged. No burns no broken pieces, etc. the metal post on the outside corresponding to the fried wire on the housing was corroded, but that was it.
I think I need to replace the housing since all that plastic melted and I chipped it away to get to the connector. I can't seem to get the connectors on the wire off of the metal connectors that are supposed to be in the housing.
Touareg :: No Turn Signals - Battery Voltage At Zero
I was getting in my Touareg this morning after going to the doctor. As I turned onto the freeway onramp I noticed I had no turn signals at all and my battery voltage was pegged at zero and not fluctuating at all.
Had the battery replaced about 2,000 miles ago when I got the standard System Fault message, but it has started fine since. Even started fine this morning, etc.
Drove to the dealer while I was on the cell with my service manager who knows me by name.. I get there and shut the car off. Turn the alarm on and off and re-started it. Same thing....no turn signals and as I started it the battery voltage went up to 10 and back down to zero.
We're planning to leave it for service and it clears itself. Turn it on and off about 10 times with no error again.....very weird. Dealer needed to order some other warranty parts so they are going to check for any errors when I drop it off next week.
My voltage is consistently in the 12.5 to 13.5 range. Never at 14 volts. My tech at this dealer checked my vehicle the last time when they replaced the battery and said nothing needed to be replaced. Checked all the TSB's, etc. He and his wife have a T'reg so he seems to know his stuff.
I've heard the talk about the 14 volt reading, but he said that is not true, though it does have to have a 12.5 volt or above reading at all times per what he said. Service manager said they saw something similar last week and that owner was also getting some heavy radio static. I noticed some faint radio static, but was also listening to an AM station at the time. I do have NAV.
Touareg :: Voltage Meter Zero And No Turn Signals
Has there been any definite solution to the problem of the voltmeter going to zero immediately after the Touareg starting up and loosing the blinkers, including the hazards. When the vehicle is running in this mode all the other electronics are working fine, I tried them all. The vehicle runs normally, just the volt meter at zero and no blinkers. Has happened three times in two and a half years. I would take it to the dealer but it wouldn't do it there and they would just tell me it is working fine. What can I do, or even tell them to fix it.
View 3 RepliesCamry :: 2004 Toyota Gauges And Turn Signals Stopped Working
A few days ago my speedometer stopped working. Then yesterday all of my gauges stopped working, as well as my turn signals. If this is a fuse issue then which fuse it is?
View 9 RepliesFord - Contour :: 1998 - Turn Signals And Hazards Stopped Working
I drive a 98 Ford Contour Sport. When I was driving today, I signaled a left turn, and the signal began working erratically. This also happened with a right turn, and, since I deliver sandwiches, happened when I turned my hazards on. Throughout the day it got worse, and eventually stopped working. I'm willing to bet that it's a wiring issue since all of my fuses are fine.
View 5 RepliesGolf IV / Jetta IV :: Turn Signals Stopped Working / Brights Not Engaging
Yesterday my 2003 VW Golf TDI turn signals stopped working. The hazard/emergency lights do work. Also, when I push the signal lever forward the brights don't engage. Does this sound like a bad relay or blown fuse?
View 6 RepliesTouareg :: Dash Display For Turn Signals Blacked Out
I love this car, but it makes me crazy at times. Was driving home from work last night and decided to stop at a sports bar for supper. Used turn signal to indicate right turn, looked at the dash, no indicator lighted on the dash, no 'tick, tick' sound.
Looked at the mirror housing, the turn arrow was flashing. The wife and I looked things over once we got parked, front turn signal worked (right and left), mirror housing worked and rear turn signal worked, but no dash indicators. As further information, brake lights worked, too.
Decided to 'reboot' the car. Shut it off, turn it on, no indicators. Went into the sports bar. Returned two hours later. Turned on car, used turn signal to indicate as we were leaving the parking lot, everything worked just fine...
Ford Ranger / B-Series :: 1998 - Flashers And Turn Signals Stopped Working
I recently got a pretty cherry 98 Ranger 3.0 2wd extended cab auto. So far all it has needed was wiper blades, floor mats and a heater blend door. Last week my daughter informed me that the flashers and the turn signals stopped working. I looked for blown fuses and then took the low road and just bought a new flasher (my alldatadiy manual showed that the flasher was common to the turn signals and the hazard flashers so I took a shot at just throwing a part at it). That didn't fix it or else. Any pointers?
View 3 RepliesTouareg :: Speedo Display Indicator When Turn Signals Actuated
When I towed with my 2005 V-8 Touareg, the speedo displayed an indicator (like this - ) when the turn signals were actuated. I now have a 2009 TDI. The brake controller has just been installed and the turn signals work fine but no display.
View 6 RepliesTouareg :: Interior Turn Signals Are Not Working - No Clicking Noise
Finally I'm having my first issue with my Touareg! Coming to work today i noticed that even though i had flipped on my signal via the stalk, there was no mention of it on the dash and no clicking noise. I look off the reflection of the car in front of me and indeed me exterior turn signals work just fine. I get to work, shut off the car and turn it back on. Flip on the turn signal and the inside signal flashes once then goes off again. I again turn off and on the car and get the same result.
View 7 RepliesElectrical-wiring - Chevrolet - Equinox :: Turn Signals And Hazard Lights Stopped Working
I have checked the fuses for the Hazard and the Turn Signals. Both look fine. I tried replacing the turn signal flasher (which was a task in itself). After all of this it is still not working. What else could it be? Simple short?
View 2 RepliesFord Ranger / B-Series :: 1994 - Turn Signals Stopped Working - No Flashing / Blinking
I noticed that my turn signals stopped working. I replaced the flasher. Now the turn signals work but the signal indicators in the dash don't light up. Also, the hazard lights don't work either. No flashing, no blinking when I turn on my hazards. I've seen many variations while searching? 1994 B3000 2x4 extra cab.....
View 14 RepliesFord Wiring/Electrical :: 2004 F250 - Turn Signals And Hazards Stopped Working
So I have an 04 F250 Super Duty 6.0L and suddenly the turn signals and hazards stopped working. First I replaced the switch on the steering column...no luck. Today I replaced the flasher relay under the dash panel (the blue one)...still no luck. I remember checking fuses in the fuse box but don't remember which ones I checked but I didn't see anything obvious. I also took a quick look under the dash at all the wires for any anomalies...nothing. I'm lost... What to do next!?
View 1 Replies