Ford - Contour :: 1998 - Turn Signals And Hazards Stopped Working
I drive a 98 Ford Contour Sport. When I was driving today, I signaled a left turn, and the signal began working erratically. This also happened with a right turn, and, since I deliver sandwiches, happened when I turned my hazards on. Throughout the day it got worse, and eventually stopped working. I'm willing to bet that it's a wiring issue since all of my fuses are fine.
View 5 RepliesFord Wiring/Electrical :: 2004 F250 - Turn Signals And Hazards Stopped Working
So I have an 04 F250 Super Duty 6.0L and suddenly the turn signals and hazards stopped working. First I replaced the switch on the steering column...no luck. Today I replaced the flasher relay under the dash panel (the blue one)...still no luck. I remember checking fuses in the fuse box but don't remember which ones I checked but I didn't see anything obvious. I also took a quick look under the dash at all the wires for any anomalies...nothing. I'm lost... What to do next!?
View 1 RepliesTaurus :: 97 Turn Signals And Hazards Not Working
In my 97 Ford Taurus the turn signals and hazards are not working. I changed the fuses, but still no luck. Someone mentioned that there might be another fuse box under the hood (besides the maxi fuse box). Also someone mentioned the blinker fluid being low.
View 14 RepliesLexus GX 2004-09 :: No AC / Turn Signals / Fan / Heated Seats - Hazards Still Working?
I've driven home from a tree nursery with a utility trailer - hazards on at about 60kph. Took me about twenty minutes to get home. It's a pretty warm day so AC was on. I turned the hazards off to signal turns and then put it back on when it was straight road.
After disconnecting the trailer and later driving to pick up the kids, I noticed the turn signals wouldn't blink but the hazards would still work. The AC would not respond, nor would any of the climate control buttons. The heated seat controls are dead and also the 12V DC outlet next to the seat switches seems to be dead. However, the airbag compressor control still functions normally, the diff lock button still works fine, the headlights and hi-beams still work as well.
I took a few minutes when I reached the first school to check through the fuse box under the hood but there wasn't anything obvious. I'm also considering just removing the negative on the battery to reset the computer. Then, there' s the window thing....
Ford Excursion :: Hazards / Turn Signals / Brake Lights And Cruise Not Working
Well, on our way home during my leave, the wife made the comment about halfway home that the blinkers had quit working. I assumed it was probably a fuse or relay, so we came on home. I have been looking at it for a few days now (too hot to spend too much time out crawling around under the dash ) and I am still having some trouble. My brake lights, and hazards are not working, and neither is the cruise, which was working fine while I drove before the blinkers went out.
I have no power at all to the flasher relay. I replaced the brake light switch because it was definitely worn and looked a little burned inside when I pulled it out and inspected, but still nothing. Have not found any fuses blown. Brake pressure switch fused link harness seems good with my test light. Wipers, brights, everything else on the turn signal switch works fine. Can't even get the cruise to go into diagnostic mode, it only blinks once when I try.
Camry :: 2004 Toyota Gauges And Turn Signals Stopped Working
A few days ago my speedometer stopped working. Then yesterday all of my gauges stopped working, as well as my turn signals. If this is a fuse issue then which fuse it is?
View 9 RepliesPrius (2004-09) :: Turn Signals And Hazards Don't Blink
2004 Prius here. The turn signals and hazard lights stopped working a few days ago. I found a disconnection in the grounding and repaired it. Also replaced the fuse and the flasher switch. Now the lights work, and I can hear the flasher switch clicking, but they don't blink!
View 13 RepliesElantra HD (2006-10) :: Turn Signals Work But Hazards Do Not
Today, I replaced the flexible coupling in my steering column. All went well and seemed great until I realized my turn signals were not working. I tried the hazards and promptly heard the 10amp fuse blow. I took the paneling back off and realized that the wire bundle to the turn signal was being pinched above the steering column.
After lowering the front of the column down and removing the wires, I noticed that there was some damage. One wire (blue) was cut and a few others had damage to the sleeves. I repaired the sleeves and fixed the broken wire. The turn signals now work perfectly fine, but when I activate the hazards all the signals go dark. I cannot find any blown fuses and the relay appears to be working just fine for the turn signals.
Passat (B5) :: Turn Signals Stopped Working
So I get to explore my first repair with this new to me car. Yesterday morning, turn signals works fine. That afternoon, the stalk apparently stopped working, which I have heard of. Interestingly though:
-the brights and cruise work
-the hazards work (my improvised indication that I'm turning )
-the stalk had been replaced once before by the PO.
Did this thing eat another stalk, or are there some other things I should check first?
Sonata NF (2006-10) :: 2008 - Turn Signals / Hazards Won't Work
I recently bought an 08 Sonata from a used car dealer which has 65,xxx miles. Last week my turn signals would work intermittently, and now neither the turn signals or the hazards work. I put in a new relay and a new turn signal switch, to no avail. When I turn the hazards on, the relay clicks once then nothing. When I do the turn signals, nothing clicks. Is there another relay I'm missing somewhere?
View 14 RepliesSanta FE SM (2001-06) :: Turn Signals Stopped Working
I own a 2004 hyundai santa fe and just recently my turn signals have stopped working. My bulbs are fine because they still light up when I lock my car and my hazards work too. The flashing arrows on my dashboard wont show up for my turn signals but they will show up for hazards. I checked the fuse and its completely fine. I am so confused with what is wrong. The only thing I was doing before was messing with my new head unit which involved unplugging a lot of the stereo and fog lights and hazards but that all should have no affect on my turn signals.
View 6 RepliesGolf IV / Jetta IV :: Turn Signals Stopped Working?
The issue I am now experiencing is my passenger headlight would only turn on once in a while . The driver side headlight would work just fine both high beam light also . Today I opened my hood I verified the cable had a poor ground to the headlight I noticed a burnt smell after checking the cables . I turned on my high beams both sides turn on . Then out of no where my turn signals both (Left - right - back and front stopped working. Including the Hazard lights both front and back). The cluster would not show neither turn signals turning on ( left-right ) I noticed that my headlight turn signal on the passenger side would turn on but not blink it would stay dim only when . I pushed the hazard light button . My cluster would show the right turn signal ( no clicking no flashing arrow ). The driver side would not work either. What can I do to fix the problem? I know that I will not be able to drive the car due to the issue.
View 5 RepliesGolf IV / Jetta IV :: Turn Signals, AC And Horn Stopped Working
Last weekend my headlights, wipers, turn signals, AC, and horn stopped working. Through searching and another post I narrowed the issue down to my ignition switch. After taking apart my steering column and getting the switch out, I found this...
The house which is connected to the switch, with the one of the red wires obvious fried....
So I'm hoping this problem and I'm wondering who else has had this happen. When I took apart the ignition switch itself, nothing appeared to be damaged. No burns no broken pieces, etc. the metal post on the outside corresponding to the fried wire on the housing was corroded, but that was it.
I think I need to replace the housing since all that plastic melted and I chipped it away to get to the connector. I can't seem to get the connectors on the wire off of the metal connectors that are supposed to be in the housing.
Ford Super Duty (1999-2016) :: EBrake Light Show Up On Dash / Turn Signals Stopped Working / Heated Seats No Longer Turn On
Coming back from a trip I got a e-brake light show up on the dash then noticed the signals stopped working and the heated seats no longer turn on. I scanned it with my AE and got a brake fluid sensor error come up but nothing about the signals .... is this a common problem or is there a connection between all this? 2003 F350 6.0L .....
View 2 RepliesGolf IV / Jetta IV :: Turn Signals Stopped Working / Brights Not Engaging
Yesterday my 2003 VW Golf TDI turn signals stopped working. The hazard/emergency lights do work. Also, when I push the signal lever forward the brights don't engage. Does this sound like a bad relay or blown fuse?
View 6 RepliesChrysler - Ptcruiser :: Horn / Turn Signals / Hazards / Door Ding Doesn't Work?
I have had this problem for a while now, but can't seem to figure it out. I'm sure it's an electrical issue, but I'm not that great with electrical. My turn signals don't click when I push the handle in either direction. The turn signals come on and stay on but don't blink like they should. I checked the lights in the front and back and they just stay on but don't blink. Also my hazards don't blink. They just stay on and don't make clicking noise either. My horn doesn't work and my door doesn't ding with the key still in the ignition but in the off position. I don't know of it's all related or different issues.
View 10 RepliesFord Ranger / B-Series :: 1998 - Flashers And Turn Signals Stopped Working
I recently got a pretty cherry 98 Ranger 3.0 2wd extended cab auto. So far all it has needed was wiper blades, floor mats and a heater blend door. Last week my daughter informed me that the flashers and the turn signals stopped working. I looked for blown fuses and then took the low road and just bought a new flasher (my alldatadiy manual showed that the flasher was common to the turn signals and the hazard flashers so I took a shot at just throwing a part at it). That didn't fix it or else. Any pointers?
View 3 RepliesFord Excursion :: No Turn Signals / Hazards Work But When Press Brake Tail Lights Just Blink
I have checked all fuses, checked wires on top of steering column all checked out ok. Hazards work but when I press brake tail lights just blink with no brake light but the 3rd brake light works??? Signal switch maybe??
View 14 RepliesFord Wiring/Electrical :: 1973 F250 - No Turn Signals / Brake Lights Or Rear Hazards
Dad borrowed truck and wired 7 pin trailer harness. Lights worked on truck/trailer for use but upon return the turn signals didnt work. Hazards and running and brake lights did work. Replaced TS flasher and Haz flasher. Still no signals. Pulled steering wheel and replaced turn signal cam only, not whole switch. Now no brake lights, no rear hazards or turn signals. Losing my marbles trying to follow schematic and using test light and mulit meter. All bulbs and fuses are good. Running lights and head lights working as well.
View 6 Replies