Ford Excursion :: Vibrating Rotors - Brake Calipers Replacement
Front caliper replacements--fwd? Person I bought this from said they'd just relined the brakes before I got it. After having it a week, I randomly checked torgue on lug nuts...a whopping 80 ft lbs. So now I have the vibrating rotors. When I back up I hear scraping like a bad set of bicycle brakes against an out of round rim. The pads are pretty thick. I bought new rotors and pads but I wonder if I shouldn't get calipers as well. This X likes to bite me in the butt--something simple is always about 5 times more complicated than anticipated.
View 1 RepliesBrakes - Civic - Honda :: 1999 - Parking Brake Won't Fully Disengage?
The parking brake on my 99 honda civic won't fully disengage. If you use it when you go to put the lever down it pops back up slightly. Just barely one click and sometimes not even that. I just replaced the rear brake drums, shoes, wheel cylinders, and it was badly needed. I thought that this would solve my parking brake problem as well, but after I got everything back together and the car on the road the problem persisted.
I saw in the Hayne's manual for the car the parking brake can be adjusted from underneath the armrest. So would an adjustment fix my problem? If loosened would the brake stay down when not in use and still work when I need it? I also saw as part of the procedure the manual has you put the rear end on jack stands. If you are just tightening or loosening a cable why would the back wheels need to be off the ground? Is this absolutely necessary?
Ford 6.7L Power Stroke Diesel :: 2014 - Brakes Squeaking - Replaced Brake Pads And Calipers?
We had approximately 7000 miles on our 2014 250 when we first heard our squeaking when we applied the brakes. This happened after we had been driving a while. Took it to the dealer to see what was causing the noise. They found out it was the front brakes. They removed both front wheels to find the inner pads wearing at an angle and the caliper piston boots partly melted in middle. They ended up replacing the brake pads and calipers with new and machined rotors.
View 14 RepliesTouareg :: Brake Squeak - Piston Is Not Disengaging With Rotors
I had my front brakes replacement a couple of months ago but I noticed that when after making a complete stop & letting the wheels roll, I hear a squeaking sound coming from the brakes. I had this checked by the local shop & was told that the piston is not disengaging with the rotors. Is this accurate or do we just need to lubricate? Also, if the pistons are defective, will this be covered under warranty?
View 2 RepliesFord Excursion :: Rotors Rubbing On Caliper Bracket - Brake Rotors Too Thick?
I replaced my warped front brake rotors a couple thousand miles ago and all was fine but when I went to swap over to my snow tires, I can see that the outer part of the rotor has been rubbing on the caliper bracket. This is happening on both front rotors. Could my new rotors be too thick or something?
View 4 RepliesGolf IV / Jetta IV :: 2001 Gti VR6 Stuck In Reverse / Clutch Won't Fully Disengage
My 01 GTi (12v VR6) was having some trouble shifting into, and out of, first and reverse so after a bit of research I decided to try adjusting the shift linkage as it seemed like a possible easy fix. After doing that I tried backing it up in the driveway and after a couple of shifts to different gears it ended up getting stuck in reverse. When I pushed in the clutch pedal to let it roll forward I noted that it seemed to be resisting rolling forward despite the steep incline. Once it reached a less steep incline it stopped rolling forward completely, so I'm thinking that it probably won't come out of gear because the clutch won't disengage all the way.
I've done some searching around and from what I've read so far it sounds like it could be a worn or damaged clutch fork, the hydraulic lines, master or slave cylinder, or even a broken clutch plate. What I don't want to do is pull the transmission and clutch, only to find that it was something much easier to fix.
Golf/GTI VI :: New Calipers Installed / Squeaking Sound Comes From Brakes?
So I just installed the Porsche Cayenne 18Z calipers onto my GTI. The install went great but now when I go around corners at speed there's a squeaking sound that comes from the brakes. I tried to epoxy the hub centric ring onto the rotor and grease up the outside of the hub where the rotor sits, but it's still squeaking.
View 4 RepliesTouareg :: Squeaking Noise From Brake Pedal?
Major squeaking noise started end of last week. Could it be the brakes? but no sensor warning light came on! 36K Miles.....
Service at 30K showed brake pads to be okay. I did my own inspection and agreed. I took it to the dealer this morning (I've always had problems with them so I'm used to having to fight and try to get a good price) Dealer says I need Fron Brake Pads (to me they still look okay) and this is what's causing the problem. I'm going to replace them and advised them to drive the car after completion to check the front Drive Shaft since this seems to be a problem with this vehicle.
Concerns: Brake Light sensor did NOT come on. Squeaking noise = Could be Front Shaft.
Touareg :: 2007 - Ultra Low Speed / Random Brake Squeaking
My 07 FSI v8 w/16k miles; has a developed a ultra low speed, random brake squeak/squeal -- I notice it at when rolling up to the bank teller or Starbuck's, etc. Recently, my 07 v10 w/6.8k miles just started doing it.
I purchase a can of this this to try tonight : [URL] .....
Camry :: Rotors / Pads (new) - Low Medium Squeaking Sound From Brakes
I recently had rotors and brake pads replaced on my 2007 Camry (front pads/rotors and read pads/rotors).
It was done last week and she is braking fine. But sometimes now when I brake there's a low-medium squeaking sound from the brakes. Is this normal / what's the likely cause?
Touareg :: New Wheels An Refinished Calipers.
Thought I would share. Been working on the T-reg all day long. I will likely finish tommorow and will post final pics then.
http://forums.clubtouareg.com/...=1550
Modified by PJF at 1:37 AM 4-1-2007
Prius (2004-09) :: 3 Brake Dash Warning Lights Came On After Got New Brake Pads / Rotors
i have the brake (!) the ABS and the VSC lit up after i got new bearings and new brake pads and rotors, the car was also stalling before the mechanic removed these bearing "dust cover" circles that must have been causing speed sensor interfernce bc the spedometer was stuck on 0....so the car seems to be done stalling after those were removed and all the big lights went off then i hit the brakes a few miles later and those three lights came on...
View 2 RepliesLexus IS 2014+ :: Front Brake Pads Touching The Rotors / E-Brake Engaged And In Park
I noticed the front brake pads were touching the rotors when I was painting the brake calipers. I had my e-brake engaged and in park. I'm assuming the e-brake only brakes the rear wheels because the front rotors were still movable. Although the car still rides fine but I'm not sure if this is normal.
View 1 RepliesGolf V R32 :: Brake Noise Might Be Grooves On Brake Rotors
Just thought I'd ask, I was at the dealer last week and while there asked them to take a look at my brakes because they were making a slight screeching sound but only when first applied when speed was slow.
They said it all looked good but that the sound I was hearing was from grooves that had been etched into the driver's side front rotor. I find it hard to believe that my rotor would have grooves in it after only 21k miles, considering I don't track it or drive it aggressively that would have caused that.
Accent MC (2006-11) :: Noisy Front Brake Calipers
Since I have this car i noticed that the brake calipers (especially the front) are very noisy. This problem is caused by caliper's floating guides that become loose and the entire brake caliper shakes. I asked at a kia mechanic who answered to me to change the calipers support. For my trusted mechanic is useless because, according to him, this type of support have this problem (he tell me that also others car have this problem like older nissan micra) and sooner or later would return noisy.
Some time ago with greasing the floating guides i temporary solved but drying up over time the problem come back.
5 Series :: 1992 - Front Brake Calipers Locking Up
Fairly recently acquired 1992 525i, 101,000 miles. Love the car and driving feel, don't mind putting the effort in but do not know where to start. She needed some work including both upper and lower control arm bushings. Replaced those over the last couple of weekends. This week the front brake calipers are locking up adding significant drag to the car, overheating the front brakes, smells and feels hot. Rear brakes appear to be fine. Seller had replaced brakes within the last 5,000 miles. I thought maybe he did not 'grease' the caliper guide pins and components, so I tried that and all was well for a few miles then back to the same locking brake calipers.
Is this brake caliper, brake cylinder, master cylinder or ABS related? Do I need to bleed the system? I cannot not imagine how but could replacing any of the front suspension components have had anything to do with this? I read on one thread about an interconnection (power assist) provided by the power steering pump and that 'over filling' the PS reservoir could cause such a problem. I did add fluid to the reservoir recently but the level is between the marks on the cap dip stick.
If caliper, or cylinder related is this DYI? How about the ABS? I have been looking for some good links to address this problem and repair procedures but no luck as yet.
Ford Excursion :: 2002 - Brake Calipers Seizes Too Often
I have two 2002 ford Excursions, both with 7.3, one 2WD and one 4WD. I have replaced ALL brake calipers with lifetime warranty Napa semi-calipers. It is sometimes an intermittent problem, I might have smoking brakes on one wheel (mostly the rears) one day and it will work fine for weeks or months and then do it again. It seems that about 1X per year I end up having to replace the calipers as they seize up and cause the brakes to smoke and cooks the caliper piston boot to a crisp.
I use high temp brake caliper grease (not sure if it is silicone based) and bleed the brake system about 1X per year because I thought the brake fluid was absorbing too much moisture. The slide pins come pre-greased, but I always check and re-grease them. Could I be putting too much grease onto the slide pins, Hydrolock?
I live in high humidity, in the middle of a rain forest near (about 5 miles away) a live volcano, Kilauea, on the island of Hawaii. Our area is very wet and we have acid raid and acid air (H2SO4 volcanic smog in the air) which corrodes everything, corroded pistons getting stuck?
I have not tried other brands of calipers because I cannot afford to keep buying new brands, I just trade in the toasted calipers at Napa for no charge. I have replaced all the rubber brake hoses and i upgraded to DOT4 (not silicone based) blue racing brake fluid that has a very high wet and dry boiling point. I am thinking of investing in stainless steel calipers, but those are pricey.
IS F (2008-2014) :: Cleaning Brake Calipers Without Removing The Wheels?
I just noticed that my black brake calipers look dull. I used my finger to check it and behold, the shine is back. Is there anyway i can clean the brake calipers without removing the wheels?
View 13 RepliesSanta FE SM (2001-06) :: Fast Rusting On Front Brake Calipers?
I've replaced the front brakes twice now on my 2004 2.4L Manual Santa Fe.
Each time the dealership has commented on some excessive rusting of the calipers, and this last time around one had actually seized and they had to cut it off.
When I got brand new ones put on I noticed they were nice an shiny silver. Within 3 weeks there were full rusted...and still are. I don't get it??
2004 Santa Fe .... Is it possible something is dripping from somewhere that is caused this premature rusting?