Touareg :: 2004 V8 - Clunking When Shifting, Going On And Off Throttle
My 2004 V8 clunks when shifting gears, causing the engine to oscillate right through the seat. It also happens when driving a steady speed, e.g., 10MPH in traffic, and you goose the gas or release the gas altogether. So far:
1. Replaced transmission valve body
2. Replaced stepper motor
3. Replaced rear propellor shaft and bearing
I think this started with a reflash of the trans to cure the death lag.
Touareg :: 2004 Transmission - Loud Clunking Noise When Getting Up To About 30 Mph
When driving, getting up to about 30 mph, a loud clunking noise and feeling seem to come from under the center armrest. I have looked underneath to see if something came loose or was missing, but nothing looks out of place. Increase in speed makes it get worse.
2004 Touareg V6 67k Miles
Touareg :: 2004 - Shaking / Vibrating And Clunking - Engine Light Blinked A Few Times Then Solid
On my V6 2004 (just hit 120,000 kms, just changed the oils 2 weeks ago) I was driving on the hiway yesterday, when the whole vehicle started shaking and vibrating - engine light blinked a few times, then stayed ON solid.
I could reduce the shaking by letting go on the throttle pedal, so I stopped and checked, nothing obvious, oil level good etc. I could hear some sort of clunking noise when engine was revved up.
Touareg :: Clunking Noise On Rear Right End Of Car
I took my '04 Touareg V8 with 38k miles to the dealer complaining about a clunking noise on the rear right end of the car. The noise sounds like that of when you engage the low differential and trying to unstuck from a slippery road. It also sounds like when the lock differential is engaged. It only sounds when you start the car from the stop position and not every time.
Now the dealer said this may be from the electronic monitor of the transaxle/ differential.
Touareg :: Tiptronic Will Not Work / Clunking?
T-reg clunking have the additional phenomena of their tiptronic not working ?? The last time it tried to work it flashed upon the screen for a second then disappeared ?
View 2 RepliesTouareg :: Clunking When Shifting Gear / More Apparent On Acceleration?
Occasional clunk when truck is shifting gears. Not consistent. On highway at high acceleration clunk is more apparent. Any thoughts. 2004 v10 with new engine placed at 70,000km now at 85000km. Otherwise truck is running great.
View 8 RepliesTouareg :: Loud Clunking / Transmission Locking During Downshift At High Speeds
My 2004 V8 egg is currently at 111,000 miles and I'm starting to have problems that are really cause for concern. Since the blue book value on the Touareg is worthless and I've got it paid off, I might as well keep it until the wheels fall off of it. Anyhow, on to the problem at hand ...
When driving on the interstate at high speed somewhere around 80 - 90 mph and you push the accelerator to get that extra bit of speed out of the downshift so you can pass or just for the heck of it, the transmission starts clunking, LOUDLY, which of course causes you to let your foot off the gas. The clunking continues for about 5 - 10 seconds until the car has slowed down a bit.
I can still get the car up to speeds of around 110 mph (my wife tried it just about 15 minutes ago on our way back from Florida), but it has to be done gradually as to keep the transmission from downshifting.
Around town the car responds fine. Occasionally it will have a hard shift, but I can't find a reason or pattern to that. Fifth gear also works fine in city traffic, I've used tiptronic to keep it in 5th and I've also watched the main display change from D4 to D5 to D6 and back again without incident.
I'm too afraid to take the car up to 90 and then engage tiptronic and downshift to 5th. This transmission has had its fair share of problems. I'm on my third stepper motor, the forward transmission seal had to be replaced and then later the hydraulic pump had to be replaced. There are no noticeable fluid stains on the belly pans and there are no stains on my garage floor, so I doubt its leaking fluid. Can you even check the transmission fluid level in this thing?
Other than the transmission problem, the Touareg is behaving fairly well. (Knock on wood) It still rides nice and I've learned to put up with the little electrical anomalies that happen like the blue strobe backlight compass (it's just dancing along with the music) and the lights switching ON in full daylight (with the euro switch installed).
Prius (2004-09) :: Clunking Noises After Strut Replacement
I had my friend of mine who is a mechanic change my struts out this weekend. I had clunking noises from the right strut Toyota and also a tire place said I needed new struts. So I got them replaced now both sides are clunking see the YouTube video.
View 7 RepliesSanta FE SM (2001-06) :: 2004 - Clunking / Grinding When Shifting From R To D
Last summer my 04 SantaFe (140,000 mi, automatic) would feel like it was sticking and bumping when backing out of a parking space, then after shifting into Drive it would jerk and then make a huge thunking noise when applying the gas pedal. However, this would only happen sometimes, not all the time, and was not dependent upon the weather, surface, whether it had just been driven or not, etc. It would just happen when it happened. I brought it to the Hyundai garage and they replaced an axle and sensor. I continued having the same problem, brought it back to the garage and they replaced the viscous coupler.
I continued to experience the same problem after that, brought it back to the garage and they had the car for 10 days. I was told they had to get a mechanic in who was familiar working on 04 Santa Fe's and they determined the axle they replaced was bad, so they put in a new one. Everything ran great until I brought the car in early February for an "off balance ceiling fan" noise when accelerating. I brought the car to the Hyundai garage again and had the transfer case replaced.
Now the "clunking/grinding" is back when moving from R to D!!! So I brought it back to the garage again Monday and they said they cannot find anything wrong, and they are convinced it's just a symptom of the age and mileage of the car. However, it happened again today, but worse than ever before. This time it felt like it might not even move from R to D, and then it continued the grinding and bumping after accelerating and then the car felt "sluggish". I am convinced something is really wrong, although they assured me at the garage that the transmission is good, the axle, sensor and boot are all good etc. What else could it be?
Ford F-150 (2004-2008) :: Clunking Noise In Front End
I've got a clunk in the front end....replaced all the ball joints......checked the sway bar......checked the tie rods......can't find anything wrong...... Shocks go bad and clunk???
View 14 RepliesFord F-150 (2004-2008) :: Clunking When Accelerating From Stop?
I've been living with a mild "clunk" or "bump" in the drive train when I would first begin to accelerate from a full complete stop. It would only happen after a complete stop. It almost felt like it could be normal, but it seemed to be getting worse over time.
At first I thought it was my transmission...but after some internet searching I found some threads talking about the slip yoke on the drive shaft being the cause. In that the slip yoke needs to be pulled apart and re-lubed.
Anyway, I thought I'd post and let eveyone know that after pulling the slip yoke and re-lubing with grease my issue is solved! The "clunk" is totally gone. 100% Smooth now. If has this issue I'd highly recommend re-lubing the slip yoke.
[URL]
On my 2004 F-150 SuperCrew, all I needed to do was remove the drive shaft at the rear differential (4 bolts, use 12mm 12 point socket or wrench). Then remove the FRONT clamp on the slip yoke boot. Then slide out the rear 1/2 of the drive shaft. Be sure to mark the drive shaft orientation with the rear differential flange and the slip yoke before you remove the drive shaft to ensure you put it back together correctly.
Re-lube the slip yoke, then slide it back together and reinstall the four bolts at the rear differential. Torque spec is 76 ft-lbs. I used Valvoline FORD-LINCOLN-MERCURY moly grease that I purchased at my local AutoZone. You'll also need to install a new band clamp around the rubber slip yoke boot. I got mine from AutoZone.
Here are some links I found with pictures showing how to do this. Both procedures below are on SuperDuties but its basically the same procedure. Just follow my specific details above for the 2004-2008 F-150
Slip joint regreasing
2004 F250 Slip Yoke Service
Ford F-150 (2004-2008) :: Clunking Sound Comes From Rear End When Going Around 48 MPH
When going around 48mph clunking sound comes from rear end. seems like it does that when you are trying to maintain that speed. Also have had 7 window regulators to go bad on have 1 working window 4 bad now replaced the same one 3 times. Called Ford they said no complaints have come in about the window issue on 2004 trucks...
View 1 RepliesFord F-150 (2004-2008) :: Clunking / Knocking In The Front End
I got a horrible clunking/knocking in the front end of my pickup this morning, jerking the steering wheel like a flat tire, and after a couple miles it stopped..... bearing ???
View 7 RepliesFord F-150 (2004-2008) :: Rear End Whining And Clunking
05 F150 2WD 4.6 LWB, The rear end whines when letting off the gas and makes a clunk or 2 when taking off and a clunk when I stop. It has 277.000 Miles? Or is it just time for another rear end...
View 3 RepliesFord F-150 (2004-2008) :: Popping / Clunking Noise When In 4WD
I've read alot of info about the 4WD system on the F150's, and I'm having trouble diagnosing what might be going on with mine.
When I put my truck in 4HI (or 4LO), I get a popping sound that seems to come from the front middle/front drivers side when going at speeds around 20-25 and over. I don't experience any loss in traction (that I can tell) or power, but the popping is very loud and noticeable (passengers can hear it clearly).
My problem is a little different than most, as their issues with popping seem to happen when they are not in 4WD, where mine is only when in 4WD. I replaced the IWE solenoid today (wanted to anyway to get the updated casing/shroud) and the problem stayed. I also disconnected the vacuum lines at the solenoid and drove - no noise. I then kicked in 4WD on the switch, and the noise started, which leads me to think it is not vacuum related.
I am kind of lost as to what may be going on. I would think something where teeth broke, etc. would make noise all the time in 4WD, not intermittently or at certain speeds. The noise sounds almost like popcorn popping. I went up the same hill about a dozen times today, and it happened maybe 5-6 times. I don't hear it often (if at all) with speeds below 20 MPH. I can switch in and out of 2WD, 4HI, and 4LO all day with no issues, as well.
The only modifications to the front end have been a 2.5 inch leveling kit, and the only other issues I notice in the front end is a shaking when on the highway, that seems to go away after a while of driving at the same speed. I recently had a front end alignment, and the only thing the tech mentioned was that I will need ball joints in the next 6-8 months (but he said they weren't bad).
Santa FE SM (2001-06) :: 2004 - Clunking Noise In Drive Or Reverse
2004 Santa Fe, clunking noise in drive or reverse. checked brakes and cv joints, replaced drivers front and still making the noise. Transfer case was a little low on fluid but not much. Put up on stands and turn wheels with no noise. Put in drive or reverse while in the air and rear wheels sit still. It is a 4wd so I would think that all 4 tires would be turning. While in the air the front both turn and no noise is made.
View 18 RepliesLexus GX 2004-09 :: 2005 - Started Making Clunking Noise?
'05 Gx470 w/ 93k mi. Time for new parts for all orig. frt. suspension? Started having "Clunking" up frt. Assume time for new shocks all around. Also, grease from upper ball joints half-way down steering knuckle arm, so probably dry? Thinking of replacing everything up frt. incl. hub bearings while have all apart and be done w/ it. Notice in FSM that this means replacing both upper and lower control arms that come w/ bushings and ball joints installed. Parts very pricey even w/ discounts ( 27% at myLparts), somewhere around $3,500 +/-, incl. rr. shocks. Rather cry once and hopefully get get another 90K +/- mi. w/o problems. I've always gone w/ OEM parts in past and probably paid the price, but since I'm doing all the work, hopefully evens out in long run.
View 1 RepliesFord F-150 (2004-2008) :: Clunking Sound While Turning Slightly
Recently when I leave my driveway which only has a slight grade to it my truck makes a clunking sound when I hit the gutter and while turning slightly. Also my front drive line from transfer case to front axle has some play in it. I can rotate the front drive line about 3/4" to an 1" while parked in the driveway. Changing u joints. I figured this would be a good starting point. 2005 XLT 4x4 5.4L F150.
View 8 RepliesFord F-150 (2004-2008) :: 2006 - Clunking Noise Started After 4x4 Went Out
I have a 2006 F150 FX4 and after having the 4x4 go out and replaced the front right IWE have fixed the 4x4 but still hearing a clunking noise.
The clunking noise started after the 4x4 went out and was really bad for awhile and then went away and has now come back really bad. It sounds like its coming from the front driver's side wheel area and clunks as fast as the wheel turns.(faster = more clunks).
I'm very new to mechanic stuff but enjoy learning and fixing things myself.