Passat (B6) :: CEL On / Code P0299 - How To Replace The Diverter Valve
The CEL on my Passat came on. When I scanned it with VAG-COM, the following fault code was displayed:
000665 - Boost Pressure Regulation
P0299 - 002 - Control Range Not Reached
The car also felt like it lost its power in some way, especially when the turbo kicked in. So after some research, I found out that the Diverter Valve was causing this issue. Rubber diaphragm on original valve was made from rubber and was torn. I replaced it with upgraded valve and wow what a difference!!! Very easy to do, great write up link below.
DIY Diverter Valve Replacement for 2006 VW Passat 2.0T
Elantra XD (2001-06) :: Can't Replace PCV Valve
I've replaced clutches, brakes, timing belts, water pumps, radiators, etc, etc. My 2003 Elantra has 65,000 miles on it and a few years ago I tried to replace the PCV valve with no luck. The PCV valve is threaded into a copper/metal ring that is pressure fitted into the valve cover. When I tried to remove the PCV valve the copper/metal ring spun thus not allowing me to unscrew the PCV valve out of the copper/metal ring. Now when I try to unscrew the PCV valve the copper/metal ring spins in the plastic. I can't get the PCV valve out to replace it.
View 8 RepliesSubaru - Legacy :: Replace Transmission Valve Body Assembly Code
I started my Subbie and all the lights just start going crazy on my dash. So I pulled of the road and started freaking out, Never had a hint of a problem. So I pulled in AutoZone and they ran the codes and now I'm being told I have to replace the brain to my transmission WTH? I don't own a DODGE!!! Had 3 different dodges and the tranny went on all. So I wont own one because of transmission problems. Now my Subaru has been parked since it can only get worse. Is this normal? All the error codes are...
P0700 Transaxle Control System (MIL Request)
P2762 Torque Converter Clutch Pressure Control Solenoid Control Circuit Range/Performance
Ford Excursion :: Error Code P1201 - EGE Valve?
I am getting an error code of 1201. Is this the ERG valve? How do I change out? Looking for Pictures or diagram?
View 5 RepliesAvalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Prius (2001-03) :: HCAC Bypass Valve P1436 Code
How to fix the HCAC bypass valve P1436 code?
US TSB EG015-02
M.I.L. "ON" P1436-HCAC Bypass Valve Improvement, 2001-2002 Prius.
(Road salt may cause issues with valve. possible fix is to replace the Front Exhaust Pipe Assembly if any shaft binding is evident.)
Ford F-150 - 1997-2003 :: 2001 - Got Code P0401 - Replace DPFE Sensor?
I have a p0401 generic exhaust gas recirculation flow insufficant detected code on my truck I was wondering what would be the first thing to check to get ride of this code? my truck hesitates from a stop while excelerating to several thousand rpm. should I try replacing the dpfe sensor? what does dpfe stand for? do they sell this sensor at oreilys or do you half to get this a the dealership?
View 9 RepliesSanta FE SM (2001-06) :: Error Code P0446 Came On
I've checked the lines from the Purge Valve on the Passenger side of the Intake Manifold, Check OK
I've Checked that Valve OK
I've Replaced the Canister Close Valve
I've got the Gas Cap tight.
I've removed the rubber bushing holding the CCV to the Evap Canister, hoping to isolate the Filter and point the blame on it, no luck there!!
I'm thinking next is to drop the Tank and check over all the Goodies on top.... as much as I hate the thought of that, the two access holes under the seats, just don't allow access to enough of the tank!
any thing there that I could suspect, I see there's a check valve!
There's also the Fuel Tank Pressure Sensor, which may be at fault.
Prius (2001-03) :: Keep Getting Error Code P1437
keep on getting this error code....I think I have exhaust leak , Would that trigger this code ?....is an Exhaust leak is considered a Vacuum leak??
View 1 RepliesPrius (2001-03) :: P3100, P3125 Error Code Came On
My Wife was driving our 2001 Prius and got the big triangle and the car went into limp mode.
The Codes were P3100 (info code 196) and P3125 (info code 325)
P3100/196 = Internal Error - Generator CPU Malfunction
3125/325 - Inverter Internal Short. - Generator Inverter Fin - Inverter Internal short
Clear the codes and the car runs fine, but the problem will eventually resurface.
The dealer wanted tor replace both the converter/inverter and HV ECU.
I purchased replacement converter/inverter from Ebay and inverter coolant pump (new) and installed.
Problem eventually resurfaced. I purchased replacement HV ECU from ebay and installed.
Engine would not start (does not attempt to even turn over), but was not throwing any codes. I had this same symptom with a third HV ECU as well. The part numbers on the HV ECU were exact matches.
Santa FE SM (2001-06) :: 2003 - Error Code P1159
It seems that i'm most likely going to have to replace the entire plenum .
P1159 here are some details. [URL]..................
I've checked all connecting wires and none appear to be loose. When the issue started to occur and prior to discovering the P1159 code, I also replaced all coils. I replaced the coils because one was arching over to the metal of the engine. I assumed this may be my problem. The issue still persisted obviously. The check engine light never came on so I assumed I wouldn't get a code. I took it over to a friends house with a code reader and that's when I discovered that it was actually giving the P1159 code.
Are there any other model cars that utilize the same engine that I could use the plenum from? Getting this in working condition is going to be the difference in what I can get for it.
Accent LC (2000-05) :: 2001 - Code P0121 TPS Error
2001 1.5L 5-speed Accent
I did a search on this problem and found several people posted the same P0121 code. Strangely many people wrote that replacing TPS did NOT fix it. The code came back in 30 miles or so. Most of them didn't follow up what finally fixed it and only 2 people did by saying they got the code cleared by fixing/replacing:
1. Leak in the intake manifold, bad plug wires, etc.
2. New Head & ECM.
Is there any known fix for the P0121 on Accent 1.5L other than above?
Volvo - S40 :: 2001 - Getting Error Code P0128 And P0420?
So i've had this volvo for about 6 months now.I knew when I purchased it that the two codes being thrown were p0128-Engine coolant temperature, and p0420- Cat efficiency Bank 1.Inspecting mechanic said it needed a new cat to clear the p0420....I went ahead replaced the thermostat and changed the coolant to "fix" the p0128, and cleared the codes, I think the jiffy lube state inspector did not notice the that the catalytic converter test was Incomplete when he passed it. Lucky me I guess.
But now I know that I'll probably have to fix before it gets inspected again. Eventually the p0128 came back on, so I went and got a new ECT sensor. Still doesn't clear the p0128. What am i missing? Coolant temperature sits at a 3'oclock position pretty regularly and quickly. Where to start on the p0420 besides understanding its the Pre-cat o2 sensor that is throwing the code, is there anyway that these are related?
Elantra XD (2001-06) :: P0441 Code Flow Fault - Changed Purge Valve
I have a 06 Elantra having a problem with a p0441 code flow fault I changed purge valve and canister purge valve I don't know what else to do what else can I do to get it to go away permanent so I can get car inspected no codes for my car can be on but only 1 i/m
View 3 RepliesPrius (2001-03) :: Error Code P3030 And P3009 - Bad Transmission?
Could a bad transmission cause error code P3030 and P3009?
This car has no other symptoms other than the Mil light and the check engine light.
Elantra XD (2001-06) :: Camshaft Sensor Error Code After Tune Up
I just had a ton of maintenance done on my 2003 Elantra. Spark plugs & wires, timing belt, drive belts, water pump, replaced coolant and replaced the transmission fluid. The spark plugs are NGK platinum as recommended in my handbook. As soon as the mechanic started the car after the tuneup, the engine light came on with a cam shaft sensor code. He said it went off on its own.
The engine light came back on when I started the car. There's also a major loss of power after coming to a stop. I have to floor it to get it to go anywhere above 20 mph after a stop.
The mechanic said that when he replaced my water pump the liquid splashed all over everything and he thinks he might have gotten something wet that shouldn't have gotten wet and that all will be fine after it dries.
Santa FE SM (2001-06) :: 2003 - ABS Light Comes On / Error Code C1274
I have a 2003 diesel GS Santa Fe, every now and then when driving the ABS light comes on, not very often but it does, if I switch the ignition off and restart it goes out, I had it on a fault finder computer and it showed code c1274, I think its something to do with the G sensor and the way it breaks (ABS) is it an easy fault to fix? What are the costs involved and will it affect the driving of the car, like I say it rarely comes on and I don't notice any change in how it drives.
View 1 RepliesSanta FE SM (2001-06) :: 2003 2.7L Engine P0113 Error Code
So the check engine sign came up on my car and using the OBD it tells me the error is P0113. After googling the information, it looks like I have an issue with IAT sensor.
I opened the air filter and what I believe what could be the sensor and there was nothing clogging up, so I'm assuming the sensor needs to be replaced
Question is where is the IAT sensor located and how do I dis-assemble it so I can replace it. Is it the piece that is located just before the air filter?
Santa FE SM (2001-06) :: Error Code P0455 - Oil Leak In Engine Bay
I just joined the forum mainly to care of my dads 2001 Hyundai Santa Fe but also I got a check engine light on my way home from work last night.
From last night I saw that oil was all over the timing belt. Today I inspected it with a Coworker and his OBD II reader.
Error Code was P0455, EVAP - Evaporative Emission Control System Leak Detected (gross leak).
Now the oil leak is stronger since the oil spills is on hood (inside hood). I will make a picture tonight when I get home.
I personal think it's leaking from a tube/ valve on top of the timing belt (picture will show more tonight). Thinking of cleaning the timing belt area, then drive a little around or leave it in idle to spot where the leak is from.
Common issue? I googled around but since P0455 is a common issue (on my 9-2x as well) I couldn't find anything about this I am also limited from my search since I am currently at my work PC incl. strong firewall.
I will see if google let me find a picture...