Prius (2001-03) :: Code P3125 - Bad Inverter
I bought an 01 Prius with 148k miles. It had code P3125 which mean bad inverter. I replaced the inverter with one from a junk yard with 81k miles. As soon as I was done the car started right up, and I didnt get electrocuted!
Right after the car started I got codes P3115 P3001 and P 3191. I cleared them out and turned off the car for a min.
When I started the car again I got codes P3030 and P3001.
This car has an extensive service history, It has a new Cat and exhaust, a new accessory and HV traction battery that are less than 8 months old. Crank position sensor is new. fuel tank is new.
What could be causing the P3030 and the P3001?
Prius (2001-03) :: Shuddering Transmission - Code P3125 And P3120?
Working on a 2002 prius with 153k miles. bought it with a "Bad transmission" diagnosed by toyota dealer. Got I home and did a quick check but there were no codes. I drove it about 50 feet into my garage where it would shudder badly while being driven which from my experience sounds like a bad MG2 motor. Drained the oil and thought hhmmm th oil does not smell bad and neither did it look burned. Proceeded to pull the mg2 but found it looked brand new, no burned spots or any such thing. SO I put it back together and think its a bad invertor. put on a different invertor that I have lying in my garage that I "think" is good and start the car. get code p3125 and p3120 and still have the bad shuddering when i try to drive it..Is there any way to test it further before I pull the trans and put a new trans back in?
View 19 RepliesPrius (2001-03) :: 2002 Gen I Sputter And Completely Died - Code P3125
My 2002 Prius died the other day. Getting DTC P3125 when I ran it through my scanner, but I don't have an advanced enough one to get the sub-codes. It's got 215,000 Miles on it, so I would expect something major to be happening at this point.
Here's a detailed description of what happened --- I was driving down the freeway the other day and started noticing my car was sputtering a little bit and losing a slight amount of power. I pulled over to a restaurant to say hi to a friend; when I came back out I started the car and the check engine and battery lights came on. About 10 more miles down the freeway the car started heavily limping and barely was able to get me off the freeway, then the car completely died. When I would start it back up it would die in about 5 to 10 seconds. The 12v auxiliary battery, not the main hybrid battery, had completely died.
I figured it might have been just a dead old battery that needed replacement so I put in another new one. It ran amazingly for about five minutes around the parking lot, then the same thing happened again. It completely died just like before.
The 12v battery isn't getting re-supplied with the juice it needs. Something's wrong in there.
The either the inverter is shot, it's just overheating due to a faulty coolant pump, or the MG2 generator isn't putting juice back into the 12v system.
I checked the fluid reservoir. It looks like it's flowing, but there is a few bubbles floating to the top of the fluid. Is that normal?
Prius (2001-03) :: 2002 - P3125 Sub Code 325 With No Start / Inverter Failing
Pulling into parking lot and the triangle and exclamation light appear on dash. Drive about an additional hundred feet with what felt like lower power and no noises.
- Check 12V after about an hour and it reads 12.4 volts.
- Read codes and get P3125 sub code 325.
- Temperatures and HV battery numbers all looked good.
- Clear codes and immediately code comes back with no start, nothing. Did this many times.
This code and sub code lead to the inverter failing. Being that there was no noise as a MG2 stator failure this also leads to an inverter failure right as the MG1 motor starts the engine? Inverter pump still running good as it was recently replaced along with ATX fluid. Within the last two weeks two HV modules have been replaced.
Prius (Gen 1) :: Code P3125 After INV Coolant Pump Replacement
I picked up a 2003 that had a bad AUX battery and P3130 code. Just FYI, aside from the battery it drives fine. Kicks the Warning light after about 15 miles but since the battery was bad it kept getting reset. Replaced the battery with a nice optima conversion.
Took out the inverter coolant pump, tested the circuit (good), tested the pump (bad). Replaced with a new one from dealer. Set up the bleeder tubes and massaged the lines till the new pump stopped SCREAMING at me. Added probably 2 qts of TLLC total. Bleeder tubes never had enough pressure to push fluid back up to reservoir but got solid 2 inches of fluid with no bubbles. Topped of the coolant. Went for a drive around the block, made it halfway (about 28mph) before the light kicked in and the motor seemed to bog down. Limped back home and read the 3125 Code. Code reader does not give me sub codes.
2003 Prius 154K miles on ODO.
Prius (Gen 1) :: Triangle Popped Up And Engine Would Not Shut Off While Parked - Code P3125
2002... 184,000+ miles
I was driving the car and triangle popped up and engine would not shut off while parked (key on) I hooked up the non prius aware scanner (carry one with me at all times) and don't remember the code, but it was a "HV malfunction".
I didn't shut the car off to clear the code as I was not home and attempted to drive it home, meanwhile engine never shut off. I had to come to a complete stop at a red light and the car died. tried restarting it but nothing. so I pushed it off to the side of the road and cleared the code. Tried again and nothing. didn't start, nothing. it beeped and error code popped up. Checked the code and it was p3125.
I know there are subcodes but online it was leading to inverter. but I replaced the inverter last year with a re involt. I had the car towed to my job for $50, to have it towed home, would cost roughly $168. When I got it to work, I did the screen thing and checked the 12v battery and it was reading 10.9 I have been meaning to get a new one for about a year now so I did.
I purchased a new optima battery and installed it yesterday, cleared the codes, tried to start it and nothing. error code p3125. What leads me to believe that it may be a transaxle, well actually a Mg2 is when my inverter went bad, it would start then shudder and die then the triangle would pop up. this time around, it doesn't even start. I have an appointment with the dealership to get the code with subcode read on Tuesday 10/15 for $98.7.
Prius (Gen 1) :: 2001 Car Stalled And Ran On Battery Only - P3000/123 And P3125/287
Car stalled and ran on battery only. Set code P3125, and depleted aux battery. So, I replaced the inverter and recharged aux battery.
Drove it 20-30 miles test driving it, when the MIL came on.
Drove home and found 2 codes set, 1st was set while driving, 2nd was set after parking.
P3000/123 - MPH=22 MG2.RPM=1280 SOC=65% Position=D
P3125/287 - MPH=1 SOC=60% Position=P
Any TSB on this issue?
Prius (2001-03) :: P3120 And P3125 With Subcodes Diagnosed
I bought my Prius after I tested the car around town and on the highway and went smoothly. I drove the car about 200 km after the warning came on board, high temperature and cold engine warning (red and blue). Stopped the car and I found nothing to be hot (engine or inverter).
I rebooted and the errors disappeared but reappeared and on the highway (120 km) car no longer accelerate, pedal did not respond.Stopped and restarted repeatedly trying to get as close to home and a Toyota service. High and low temperature have appeared and disappeared after stopped and restarted. Warnings appear together, none or only one of them.
But after 600 km appeared turtle on board and the car stopped. I was unable to start. They came from Toyota and were able to start with another auxiliary battery and ran 10 km with a tester on the dashboard (at full throttle and the car accelerated 1 km / sec until it reached 60 km / h then accelerated normal to 125km/h. When he put the foot on brake and after that tried to accelerate again the pedal was non responsive and the car stopped again and they towed it.
Next day they told me that the ECU is faulty (the one located behind the glove compartment) together with the Auxiliary Battery.(1100 Euro ECU).They told me that the temperature sensor is 200 degrees Celsius with a cold engine.
We towed the car to another service closer to home (1300 km) and asked a second opinion telling me that is defective inverter. I decided to buy an ECU. (220 Euro/ second hand)
Meanwhile my traction battery died after they tried to start the car many times.
After I charged the traction battery (one module at a time), whole battery shown after charging 301 V.
Now I have the following :
P3120 HV transaxle / Wire harness
INF. Code 249 (Open or +B short in motor temperature sensor)
Prius (2001-03) :: Keep Getting Error Code P1437
keep on getting this error code....I think I have exhaust leak , Would that trigger this code ?....is an Exhaust leak is considered a Vacuum leak??
View 1 RepliesPrius (2001-03) :: Error Code P3030 And P3009 - Bad Transmission?
Could a bad transmission cause error code P3030 and P3009?
This car has no other symptoms other than the Mil light and the check engine light.
Prius (2001-03) :: Way To Diagnose P3009 Error Code Source
The first step is to clear the P3009 trouble code by unhooking the 12V battery for a moment or using a code reader. Now turn the key on/ but NOT start/ready mode, wait 30 seconds and if the code comes back, the leak is in the battery case. If the code does not return, turn key to start to "ready mode" and immediately shift to neutral and stay this mode for 30 seconds. If the code returns, the leak is in the power cables or inverter. If the code did not set, shift to drive and if the code appears now (can take up to a minute or so), the leak is in the transaxle. This is something that can be done in a few minutes without a scan tool or "megger" while never removing any components and not leaving the driver seat.
Ideally you want 3009 in battery case. That might be fixable without buying anything, just take apart battery and clean bus bars etc. If your bus bars are really "gooey", new ones are available from the dealer for a couple hundred bucks. Inverter is harder to replace, transaxle is the hardest.
Prius (2001-03) :: Error Code 1554 - Power Steering Won't Working
I have just won a Mk 1 Prius on eBay and hope I have made a good choice - not having seen the car! There is an error code: 1554 which apparently is why the power steering isn't working
View 8 RepliesPrius (2001-03) :: Severe Vibration When Turning Hard Right Followed By PS Error Code
This summer my power steering went out. I replaced the steering rack with a remanufactured rack, which failed. I got the replacement rack replaced by the remanufacturer and installed by a different shop. Same problem: SEVERE vibration when turning hard right followed by the PS error code, or just little twitchy motions when driving. I'm having the second shop take a look at it again this monday as I suspect that this is a data processing issue.
View 13 RepliesPrius (2001-03) :: Error Code P0001 - Fuel Volume Regulator Stuck Opened
Got a P0001 error , Fuel volume regulator stuck opened....where is the fuel volume regulator is located on a first Gen. Prius?
View 8 RepliesAvalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Santa FE SM (2001-06) :: Error Code P0446 Came On
I've checked the lines from the Purge Valve on the Passenger side of the Intake Manifold, Check OK
I've Checked that Valve OK
I've Replaced the Canister Close Valve
I've got the Gas Cap tight.
I've removed the rubber bushing holding the CCV to the Evap Canister, hoping to isolate the Filter and point the blame on it, no luck there!!
I'm thinking next is to drop the Tank and check over all the Goodies on top.... as much as I hate the thought of that, the two access holes under the seats, just don't allow access to enough of the tank!
any thing there that I could suspect, I see there's a check valve!
There's also the Fuel Tank Pressure Sensor, which may be at fault.
Suburban :: 2001 - Error Code Replace EGR Valve
Have 2001 suburban with the 5.3. Mechanic has replaced EGR valve 3Xs. Error code specifies "replace EGR valve". Each time car runs fine for 4-6 weeks (500-1000 miles) and then service engine light comes on. Shortly thereafter the car will not idle correctly (under 1,000 rpm) and will die at stop. I think the EGR valves are getting clogged up with carbon. Car has 130,000 miles on it.
View 4 RepliesSanta FE SM (2001-06) :: 2003 - Error Code P1159
It seems that i'm most likely going to have to replace the entire plenum .
P1159 here are some details. [URL]..................
I've checked all connecting wires and none appear to be loose. When the issue started to occur and prior to discovering the P1159 code, I also replaced all coils. I replaced the coils because one was arching over to the metal of the engine. I assumed this may be my problem. The issue still persisted obviously. The check engine light never came on so I assumed I wouldn't get a code. I took it over to a friends house with a code reader and that's when I discovered that it was actually giving the P1159 code.
Are there any other model cars that utilize the same engine that I could use the plenum from? Getting this in working condition is going to be the difference in what I can get for it.
Accent LC (2000-05) :: 2001 - Code P0121 TPS Error
2001 1.5L 5-speed Accent
I did a search on this problem and found several people posted the same P0121 code. Strangely many people wrote that replacing TPS did NOT fix it. The code came back in 30 miles or so. Most of them didn't follow up what finally fixed it and only 2 people did by saying they got the code cleared by fixing/replacing:
1. Leak in the intake manifold, bad plug wires, etc.
2. New Head & ECM.
Is there any known fix for the P0121 on Accent 1.5L other than above?