Sonata NF (2006-10) :: 2007 - Trunk And Gas Lid Blowing Fuses
Suddenly my 2007 Sonata Limited trunk and gas lid fuse keeps blowing.
I'm not an electrical guy so I don't know how to check with a meter, I oiled the latches. My car was rear ended near the tank lid/bumper area a few years ago, but everything worked fine til recently.
I can replace the fuse, but after a few uses it will blow, sometimes it will blow without being used. I can't tell if it's the trunk or gas lid causing the problem because nothing will happen immediately, Basically I am only finding out my fuse blew when I need to use it.
Where I could look to inspect the wiring for kinks or it's connection run?
Sonata I45 (YF - 2011+) :: Car Won't Start After Some Messing With Fuses
I was testing parasitic drain on my battery(have a post on that also here) and pulling fuses to determine what the cause was. I figured out it was B+2 fuse, but now after putting all the fuses back, the car won't start.
I depress the brake pedal, but it still states for me to press the brake pedal. I held down the start button and the car starts, but it won't shift out of park. Also, the ESC light won't go away.
Is it just a coincidence that I have a brake switch issue right after I pulled the fuses or did I screw up somehow? Did I break a fuse or something? I also checked the obd error codes, and didn't have any new ones.
Sonata I45 (YF - 2011+) :: Can Low Beams Be Tilted Up Or Down A Little?
I know some cars have an automatic feature that allows the low beams to tilt up or down by a very small amount. I don't think our car has this option, but is there a manual way to do this?
View 20 RepliesSonata I45 (YF - 2011+) :: Fog Lights To Remain On With High Beams
Any mod that will allow the fog lights to remain on when the high beams get turned on?
View 40 RepliesSonata I45 (YF - 2011+) :: How To Make DRL And HIGH-BEAMS Brighter
So I just put in 6000k hid's in my 2011 Sonata Turbo and I want to make my DRL's brighter as well as my high-beams brighter. Is this possible? Also, I'd like to make my fog lights match my HID's, but don't know if I should put HID's in there or LED's.
View 18 RepliesSonata I45 (YF - 2011+) :: Driver Side Headlight Went Out - Low Beams Aren't Working
So about a 2 weeks ago my drivers side headlight went out. I figured it was the bulb (even though I had just replaced them about a month prior). Got new bulbs and nothing. I checked the fuse and it was not blown. I made sure the electrical connections to the bulb weren't dirty and were connected properly.
Then last night my passenger low beam went out. I had changed the bulb when the other side went out 2 weeks ago. Its still brand new and not blown. I did the same thing, the fuse is not blown and the electrical connectors are clean and secure.
I just took my car into the dealer about a week before the driver's light went out and did their "Major Service". They did tell me that I would need to replace my battery soon. Could this be the cause?
I drive a 2011 Hyundai Sonata SE 2.4L
Alero :: 2001 - AC Is Blowing Fuses?
I have a 2001 Olds Alero. The AC compressor went out so my father in law and I replaced it. It worked fine for about one month, not it keeps blowing the a 10 amp fuse (can't remember which one at this moment, my wife is at the store with the car). I have been told that it is a bad wire, I can't see any pinche wires and have looked up to where the wires go into the tape/plastic casing. I have also been told that it is the compressor that is doing it (the parts store said this was not the case... I think they just don't wanna warranty anything).
View 12 RepliesSonata I45 (YF - 2011+) :: Exhaust Blowing Out Grayish Smoke
So this only happens one time a day when i do it. It does not matter if it's early morning or afternoon.
I pretty much give full throttle and i see in my back mirror grayish smoke coming out of the exhaust, kind of like when you are on a very dusty road. But i do it again right after or 10 minutes later and it does not happen again until the next day. Then it's the same deal.
I'm not doing anything different.. I do my oil changes every ~4k miles i drive mostly city with barely any stop and go tho. Is this something i should worry about and go see the dealership? Or is this because it is a GDI engine?
I did not have this with my old car even at high miles. But then again my old car was no GDI. I am currently sitting at 24k miles.
Sonata I45 (YF - 2011+) :: AC Only Blowing Cold Air From Passenger Vent
I have a 2011 Hyundai Sonata 2.0 Turbo Limited and the A/C seems to only be blowing cold air from passenger vents, and on driver side "warm/ hot ". What steps or what i can do to get this fixed.
View 3 RepliesSonata I45 (YF - 2011+) :: Cold Air Blowing On Passenger Side
I own a 2011 Hyundai Sonata GLS. Everything with the vehicle is fine until November of 2015. I noticed that the passenger side is blowing cold air when it should be blowing hot air. The driver side is fine. I thought it was a thermostat issue. At first I didn't change it until I noticed that the temperature gauge was acting up and realized that my thermostat was stuck open which made the engine over cooled. Once I replace the thermostat, I thought it would solve the issue with the passenger side blowing cold air but it did not. Basically its not a heater core issue, blend door is fine, the hoses that runs to and from the radiator to the firewall is fine and the one that runs to the water pump is good. I closed the passenger vents so only the driver side blows hot air. Its an annoying problem. I know the dealer can fix it but they want an arm and leg and it seems like I may be forced to take it to get it fixed.
View 1 RepliesPark Avenue :: Horn Has Been Blowing Fuses
92 PA Base
It's that time again for vehicle inspection and my horn has been blowing fuses. I had it diagnosed by the dealership and they stated the horn pad inside the steering wheel is bad. They also stated the horn pads for my model of PA has been discontinued and that I should install an aftermarket horn. If I don't have this horn installed I'll fail the inspection.
Golf IV R32 :: Cigarette Lighter Keeps Blowing Fuses
So I just got a new Passport Radar for the car and noticed that im getting no power...Checked the fuse box and and fuse was blown...replace it and the fuse blows automatically.
View 6 RepliesCamry :: 2008 - LED Switch Back Keeps Blowing Fuses
I just got my led switch back lights in for my 08 camry. But I have run into a problem I have installed all four led signal lights (switch backs in the front and led ambers in the back) and the led flash relay for my car. What is happening is that the led will turn on for a couple of seconds and then the fuse for the signal lights burns out both the one under the dash and the one under the hood.
View 3 RepliesPassat (B5) :: Turn Signal And Hazard Fuses Blowing Out
I've blown my turn signal fuse for 3 times until the relay burned out. Now I have had cleaned turn signal switch (with CC) from all of the old stuff in there and replaced hazard switch. But it happens again! After 5 minutes driving, both fuses (7,5 AMP for turn signals and 15 AMP hazard) blown out. I'm afraid there are some shorts in wirings.
I'm looking for the wiring diagrams or any other users experience in this matter... Where shall I start from?
There was a water leakage behind and under drivers seat. I removed trims etc. to lift the carpet to take the Comfort Module for checking as there were some weird thing in overall car electric systems (central locking, saloon lightnings, electric windows and dropping gauges on instrument panel. I found a small amount of water in container, where the module is placed, but on the electric parts weren't any water marks... Also it's impossible to connect to the CCM via vag-com.
Subaru - Outback :: 2010 Keeps Blowing Fan Fuses And Overheats
Several weeks ago, my wife drove our Outback for 10 minutes, turned the car off, then turned it back on after 10 minutes. After 15 minutes of its being on the second time and the car being in a car line, the red temperature indicator blinked, then went solid. She pulled over to let it cool, then put coolant in the overflow reservoir when she got home. The reservoir was nearly empty. The very next day, the exact same thing happened, in the exact same sequence - 10 minutes on, 10 off, 15 minutes on in a car line, then indicator came on again.
I took it to a mechanic who could not reproduce the issue after letting it run for four hours. He replaced the fuses and told us to bring him the car when the problem recurred. Reservoir tank is full, no blockage in line from radiator to overflow tank.
The next day, for a third time, the car overheated in the pickup line. We brought it in the following day. The mechanic finally was able to reproduce the issue. He said that both fans (a subi outback has two) needed to be replaced, as they were drawing a tremendous amount. He advised that I take it to subaru to find out if there was anything they could do re: warranty.
I took it to subaru, who said that the fans are not now under warranty (we have 65k on the car). I decided to have them replace the fans anyway, so I asked them for a diagnosis. However, after two days in the shop, they were unable to reproduce the problem. They ran the car in idle, they tried to recreate the stop-and-go/standstill environment of a carline, but no luck. They said that the fans were drawing the expected amount and that they would need recreate in order to diagnose.
I have two questions:
1) Should I replace the fans myself? I can either take the car back to the first mechanic and have him replace the fans or I can do it myself. I can do basic jobs like oil changes, replacing serpentine belts, but I'm not sure what nuances are involved with replacing anything electrical.
2) Most importantly: What would cause both fans in a relatively young subi to spike their amperage draw intermittently? I guess it's possible that i just got two bad fans, but that doesn't seem to be a common problem with this model. So, I want to make sure that this issue is not indicative of some other underlying problem.
Ford Excursion :: Fuses Blowing As Soon As Hit The Headlight Switch
About 11pm 2 nights ago on our way to Florida, hit a nasty bump on I-95 in SC and there went the fuse to the tail lights and dash lights (#17 I believe). Obviously something shook loose from the jarring of that bump and blew the fuse. I've blown this fuse before, but I thought it was due to a cracked LR tail light assembly holding water, which was replaced last weekend.
Now I replace the fuse, and as soon as I hit the headlight switch...it blows again. Holding my breath running around FL at night until the man pulls me over for no tail lights. So far, here's what work has been done:
- Replaced entire LR tail light assembly with new one, new bulbs, new bulb plugs - Sprayed electrical cleaner all over harness plugs, and used electrical grease to hook it back up
- Sprayed electrical cleaner into both trailer plugs
- Did replace both batteries last weekend - noticed on the drivers side battery appears to be some relays next to the battery on the fenders - one appeared to be beat up probably due to prior battery replacements - no clue what they do
I am at a total loss. Worse fear is I can't figure this out and I have to turn it over to the dealership
Ford - Explorer :: 2004 - A/C Blower Keeps Blowing Fuses
Why the rear Auxiliary A/C blower on a 2004 Sport Trac keeps blowing fuses and how to fix it?
View 12 RepliesGrand Prix :: 2000 GTP - Car Keeps Blowing Fuel Pump Fuses
Having an issue with my car blowing fuel pump fuses every once in a while under heavy to moderate acceleration. Have replaced inline fuel filter and the fuel pump resister(white ceramic part). Runs fine with normal driving, but when I want to get some horses out of it, it will cut out and stall and once i replace blown fuse it will start back up again, and I'm off and running again.
View 2 RepliesPassat (B5) :: 2002 1.8t Sedan - HIDs Blowing Low Beam Fuses
Car is a 2002 b5.5 1.8t sedan.
Bought the DDM Tuning HIDs, 3500k 35w for the fogs, installed with no problems. Also ordered the 5000k 35w for the low beams. Installed them, they flickered on for a second, then nothing. Let the ballasts charge for a while but still nothing. Called DDM, they said my car needs a error code eliminator kit thing later they were at my doorstep. Plugged one side in, flicked on then nothing. Thought both sides might need the code eliminators plugged in...wrong. both flickered on, and then nothing. Tried again, no flicker, both low beam fuses burned. Plugged the regular bulbs in, changed the fuses, lights working again.
I don't know much about electrical, but DDM said i def don't need a relay kit. Do I need a relay kit? Or would putting higher amperage fuses in the place of the original ones work? if so what amperage?