Passat (B5) :: 2005 - Extra Turn Signal Clicking Coming From Hazard Switch
New owner of a 2005 Passat GLS TDI.
For some reason, the Hazard switch clicks a few times after using the turn signals (randomly), or while driving it will start clicking for a few seconds. The lights do not flash. it is only the audible sound coming from the hazard switch area.
Where does that sound come from? the hazard switch? Would replacing the switch with a new one fix it?
Nissan - Sentra :: Turn Signal And Hazard Lights Not Working Sometimes
The turn signals and hazard lights on my nissan sentra are working some times and all of a sudden they stop working. The problem is occuring almost every day. What could be the problem?.
View 4 RepliesFord F-150 - 1997-2003 :: Turn Signal / Hazard Won't Working?
I have a 1998 Ford F150. The turn signals do not work nor the hazard flashers. When I trun on the hazard flashers(they do not come on) the turn signals will then work. Checked all fuses both under dash and in the engine compartment. With flashers turned on and using the turn signals, the relays located in engine compartment are working. It appears that the only way for the turn signals to work is to recieve power through the hazards.
View 2 RepliesSuburban :: 1999 - Turn Signal Fuses Blown
This morning everything worked on a 1999 Suburban 4x4. One hour later, my blinkers (turn signals) were not working. Flashers were.
I checked the fuse (fuse 16) for the turning signals - blown. I bought some fuses - replaced turn signal fuse. It blew immediately and then the hazards no longer worked. I replaced that fuse and the hazards lasted a few seconds.
Hazards & brake lights are on the same fuse (fuse 1) so I am left with no brake lights, hazards or turn signals - I am an accident waiting to happen!
I switched my cigarette lighter fuse for the hazards/brake light fuse - didn't start the car - and turned on the hazards. I heard the fuse blow immediately.
My husband put a new radio in last year at this time and has fog lights wired to it - but that was last year not last week...
I know trailer lights are attached to fuse 16 (turn signals). I bought this car used, but it does have a trailer hitch with wires that I have never used.
Where to even start looking for the short... a short that would cause the hazards/brake lights to short out also.
Sebring - Chrysler :: 1999 - Turn Signal / Hazard Flashers Don't Work
The turn signals/hazard flasher on my 99 Sebring Jxi stopped working a couple of weeks ago. When I use the signal lever or press the hazard flasher switch, you don't hear any click of the flasher relay, and the lights (front and rear, and on the dash) don't light up at all.
So far, I have:
* Checked the fuse
* Replaced the flasher
* Replaced the turn signal switch
* Replaced the flasher AGAIN (mechanic says that if there was a problem with the turn signal switch, it can burn out the flasher)
* Checked the fuse AGAIN, and even replaced it (even though it's the same fuse for the wiper/washer, and that's still working)
I asked my mechanic about it, and he said that a bad ground can also cause problems. The big question is: where do I begin to look?
Ford Excursion :: Right Turn Signal / Hazard / Brake Lights Do Not Work
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
Golf IV / Jetta IV :: 2004 - Clicky Turn Signal Sound Without Hazard Lights Blinking
My Jetta has had an off-and-on clicky turn signal sound without turn signals or hazard lights actually blinking. I put up with it for a while, but recently it's been more clicky than not. I'm aware this is a common problem. I had already tried the cleaner spray "trick" which made the problem worse if anything. Today, I removed my signal stalk as described here and gave it a cleaning. After re-assembling, the clicky problem didn't go away, and now the high beams are always on (even with the key out of the ignition, and the car isn't running). I temporarily dealt with this by pulling fuses 18 and 19 for high beams. It's an ok short-term workaround. Low beams still work fine.
I'm considering replacing the hazard signal relay, but a while ago I messed up while trying to use ghetto removal keys to pull my radio.
Chevrolet - Optra :: 2007 - Hazard Lights Won't Work Unless The Turn Signal Switched On At The Same Time?
I have a chevrolet optra 2007 and the hazard lights won't work unless the turn signal (left or right) is switched on at the same time. Turn signals work perfectly fine.
View 7 RepliesFord Super Duty (1999-2016) :: Turn Signal / Hazard Relay Is Clicking With Key Off
My neighbors 02 250 6.8l the turn signal/hazard relay is clicking with key off, sounds exactly like a turn signal when truck is off and switches are not engaged. Here's the weird thing, if you hit the brakes the relay stops clicking, if you engage the turn signal or the hazards the lights on the dash are in time with the relay as it should be, but when the turn signal switch or hazards are turned off the relay keeps clicking except when you hit the brakes. Also the turn signal will work with ignition off, if you pull the relay out the turn signals and hazards are inoperable but the brake lights still work. I swapped in a new relay and same thing...
View 8 RepliesFord Wiring/Electrical :: Right Front Turn Signal Light Works But Hazard Doesn't
1994 Econoline E350. All the other lights work but on the front right the turn signal light flashes but the Hazard lite will not flash. I check for power at the wire at the light and there is none.
View 6 RepliesFord - Explorer :: 1998 - Right Turn Signal Recently Stopped Working / Hazard Lights Work
The right turn signal on my 1998 Ford Explorer recently stopped working. The flasher was making a horrible buzzing sound when I tried to signal right, but worked fine signaling left.
I just replaced the flasher, which has cleared up the buzzing noise when trying to signal right. The flasher clicks like it's supposed to, but the lights still do not flash.
Here's a summary of the current symptoms:
-Hazard lights work fineFlasher clicks; interior indicators flash; exterior lights flash
-Left right signal indicator works fineFlasher clicks; interior indicators flash; exterior lights flash
-Right turn signal does not work
-Flasher clicks
-Interior indicator stash off; exterior lights stay off
What to check next???
Golf IV R32 :: Directional And Hazard Lights Fuses Keep Burning Out
My fuses on the directional (10 amp) and Hazard lights (15 amp) keep blowing out it just happened all of a sudden? What it can be? t 2004 R32....
View 1 RepliesFord F-150 - 1997-2003 :: No Brake / Turn Signal Or Hazard Lights When Trailer Lights Plugged In
I've got a 2001 f150 supercrew 4x4 with the 4.6. I plugged in trailer lights and now I have no brake, turn signal, or hazard lights. I've checked fuses and none are blown.
View 8 RepliesPassat (B5) :: 2002 1.8t Sedan - HIDs Blowing Low Beam Fuses
Car is a 2002 b5.5 1.8t sedan.
Bought the DDM Tuning HIDs, 3500k 35w for the fogs, installed with no problems. Also ordered the 5000k 35w for the low beams. Installed them, they flickered on for a second, then nothing. Let the ballasts charge for a while but still nothing. Called DDM, they said my car needs a error code eliminator kit thing later they were at my doorstep. Plugged one side in, flicked on then nothing. Thought both sides might need the code eliminators plugged in...wrong. both flickered on, and then nothing. Tried again, no flicker, both low beam fuses burned. Plugged the regular bulbs in, changed the fuses, lights working again.
I don't know much about electrical, but DDM said i def don't need a relay kit. Do I need a relay kit? Or would putting higher amperage fuses in the place of the original ones work? if so what amperage?
Ford Super Duty (1999-2016) :: 2006 F350 - Keeps Blowing Fuses For The Brake / Turn Signals?
I have a 2006 F350, it keeps blowing fuses for the brake/turn signals. The puzzling​ part is it only does this when the truck is running.
View 2 RepliesPassat (B5) :: 1998 V6 Turn Signals And Hazard Not Working?
I just bought a 98 passat sedan v6 four days ago. When I purchased it the turn signals and hazards were working. I was driving yesterday and they went out all of the sudden. Thought it was the fuse at first, changed it, still not working. I bought a turn signal flasher relay, but the repair manual doesn't tell me which one it is so I can change it.
View 2 RepliesCelica :: Right Turn Signal Fuse Keeps Blowing Out
I have an 87 ST. Recently the turn signal fuse keeps blowing out. This only happens when I use the right turn signal. It will cycle about 5 or 6 times then the fuse blows out. Hazards are fine, left turn signal is fine, all bulbs, contacts, and wires are fine. I'm guessing it could be either the turn signal switch itself, or the relay.
View 1 RepliesPrius (2010-12) :: Tail / License And Rear Turn Signal Lights Not Working - Fuse Blowing
This issue came on suddenly. I unplugged the license plate lights- fuse still blew. I don't know where the wire harness is for this group of wires going to these lights to check for frayed or melted wires. I don't see any damage any where. I am severely limited for funds for a mechanic so I need to try and figure this out first myself. Looking for pictures of how I can traces the wires through the car?
View 1 RepliesAlero :: 2001 - AC Is Blowing Fuses?
I have a 2001 Olds Alero. The AC compressor went out so my father in law and I replaced it. It worked fine for about one month, not it keeps blowing the a 10 amp fuse (can't remember which one at this moment, my wife is at the store with the car). I have been told that it is a bad wire, I can't see any pinche wires and have looked up to where the wires go into the tape/plastic casing. I have also been told that it is the compressor that is doing it (the parts store said this was not the case... I think they just don't wanna warranty anything).
View 12 Replies