Sonata NF (2006-10) :: Grinding Noise At Low Speed
Just put on eibachs and car is randomly making a grinding noise when slowly accelerating or braking.. Also noticing a fairly loud clicking noise when going in reverse. The noise isn't consistent and seems to happen more right after startup. I haven't gotten the alignment done yet and was wondering if this could be the problem. Will try and post a video soon.
View 8 RepliesSonata NF (2006-10) :: Hard Shift From 3rd To 2nd Or 1st During Deceleration
Recently my wifes 2009 Sonata limited has started having a hard "clunk" when braking. It feels like a hard shift from 3rd to 2nd (or 1st?) during deceleration. Only really occurs when moderately cold and only during the first 10 miles or so of travel. What I should check?
View 4 RepliesSaab :: 2006 - Right Front Wheel Rubbing / Grinding When Cold / Coasting And Braking?
2006 SAAB SUV AWD, Right front wheel rubbing/grinding. When cold, coasting and braking. Not continuous. It has completely died while turning. New tires all around. Had both front brakes replaced x2 in 2 years. Still rubbing feel in right front.
View 4 RepliesGolf VI R :: 2013 With 30K Miles - Whirring / Rubbing Sound During Deceleration
Started getting a whirring / rubbing sound during deceleration and took it into dealer for diagnostics. They said driveshaft needs replacement. Fortunately they are covering under warranty but it's got me concerned about longevity.
I've got an APR Stage 1 ECU upgrade but otherwise stock. Not a track car and i'm not moonlighting at the drag strip dropping the clutch at 5000 RPMs to try and make into the 11's so am baffled by the issue.
Golf IV / Jetta IV :: Ticking / Clicking And Rubbing Noise During Deceleration Only
While switching freeways yesterday and shifting down into 3rd before hitting the exit ramp I heard I a slight clunk, and then this continual noise began. I initially wasn't quite sure if it was my car or the sound of the of the large semi engine braking in front of me so I continued on to the freeway and was able to shift back up to 5th and get to speed.
However, I held back to around 60Mph because the noise started to worry me as I continued to hear it after passing the 18 wheeler semi. I got off at the next exit and noticed that the noise ONLY occurs when the car is decelerating. It happens in every gear as well as neutral; having the clutch in or out doesn't make a difference either.
*When accelerating in any gear, even the slightest bit, the noise disappears.
I've scavenged the forums to find a similar issue but to no avail.
I've uploaded a video that shows the issue occurring. The video is taken from the driver's side wheel, but the sound resonates throughout the front of the car, can't really pinpoint where though.
2002 Jetta 1.8t possible transmission noise
[URL] ....
2002 Jetta 1.8t ... 210k Miles
I've recently replaced the Control arms, outer tie rod ends, ball joints, springs, struts, all for rotors/pads, rear calipers, handbrake cables, timing belt (with pulley kit) water pump, etc. full syn Oil changes every 3k-3.5k miles, Premium petrol only.
Sonata NF (2006-10) :: 2009 - Rubbing Sound From Right Rear
My 2009 Sonata has developed a 'rubbing' sound that seems to be coming from the right rear wheel. The brakes are new, the rotors are fine, there are no marks on the tire or wheel. This sound only shows up when I apply the brakes and generally at slowing speeds. If I press the brake pedal down hard the sound doesn't emit. We have checked suspension, brakes, rotors, tire and wheel.
View 2 RepliesSonata NF (2006-10) :: Steering Wheel Squeal / Something Rubbing On The Inside
It was something rubbing on the inside do you believe this to still be the case? I bought the car new in 12/2009 and have 58237 miles now. Sonata SE V6
2009 Sonata Steering Noise - YouTube
Sonata NF (2006-10) :: Calipers Changed Now Rubbing Noise When Braking
I discovered a few weeks ago that my 2009 Sonata 2.4L SE had a sticking caliper on the rear driver's side. It had gone bad on the passenger side as well, but not as bad. I had the calipers, rotors, and pads replaced on the rear yesterday. As soon as that was done, I started hearing a noise when braking that sounded like a rubbing noise, almost like a long "sigh." It happened at any speed as long as I pressed the pedal far enough to bring the vehicle almost to a complete stop.
I originally thought the calipers weren't the right fit, but the parts I confirmed the parts I ordered (Nastra) through Rock Auto were correct. I've driven about 80 miles since then and nothing has changed. I didn't see anything wrong when I took the tire off, but I don't think this sound is normal. Taking it in to the mechanic tomorrow. Could it be a wheel bearing? Wrong parts?
Sonata NF (2006-10) :: Light Rubbing Scrapping Noise While Making Turn
Last night on my way home I was cruising took a wrong turn and had to make a u turn. While making the turn i noticed a light rubbing scrapping noise when i had my wheel turned to the passenger side. I got out made sure nothing was suck to the wheel or under the car. Heard it all the way home, got up this morning checked car again nothing seemed wrong drove to school noise was gone.
View 10 RepliesCavalier - Chevrolet :: 2001 - Grinding On Downshift And Coasting / Deceleration
Replaced the clutch on my son's 01 Cavalier 4 cyl. Replaced Clutch as it was slipping, and replaced hydraulic throw out bearing/slave cylinder at same time. New throw out bearing failed after only 500 miles or so, seal broken, started grinding on down shift and coasting (deceleration) followed by leak and no pedal. Replaced with new Slave Cylinder and Throw out bearing, the new one is starting to show same grinding noise on shifting and deceleration. What could cause this? Used the spline alignment tool to adjust the plate on center the right way. Could the pressure plate springs be off center? The flywheel was purple could it be warped and throwing the pressure plate springs off center thereby causing them to rub against the I.D. of the Throw Out Bearing slave cylinder seal?
View 14 RepliesSonata NF (2006-10) :: V6 - Grinding Noise On Startup
I just bought a 2006 Sonata LX V6 a few days ago and in almost every way it seems like a great car. My '08 GLS V6 which gave me 150k great miles got totaled in November, which really sucks, but I wanted to find another '06-'08 V6. I noticed when I started it for the test drive that the car made a bit of a grinding noise on start up. I didn't think much of it and figured that the warranty from the dealership would cover any problems.(I probably should've checked earlier, but the dealership's warranty only covers cam and lifter noise and engine failure) After I looked into the issue more, I found out that it is a fairly common problem on the early 3.3's with the timing chain tensioners. I'm pretty concerned based on just the nature of the repairs and the cost I've seen for them.
I'm the third owner so the 5 year/60k warranty is expired, but I know there is a TSB out for the issue. I can't find the TSB anywhere but I've heard to have it repaired the car has to make the noise on start, sit 10 minutes, and make the noise again. If it does, the oil needs to be changed and the test repeated again. Since I'm running Hyundai 5W-20 and an OEM filter already, I tried the test on my own. It made the noise on start, sat 10 minutes, and made it again. It is only for a couple seconds, but it's still concerning to me. I guess what I'm trying to ask is if what I've described is covered under the TSB. I really don't wanna have to worry about something like that right now, so my next question is whether the issue I have is detrimental to the motor. My worst fear would be to have the chain jump a cog on the cam gear and slam valves into pistons.
Sonata NF (2006-10) :: Rattling / Grinding Sound During Acceleration
I have a 2008 Hyundai Sonata GLS 2.4L with 131,000 miles on it. When I accelerate from a stop, there is a buzzing/rattling/grinding noise coming from the engine bay of my car. It's really hard to describe, there is a definite buzzing sound, but also almost like there is a bolt rattling around and banging into things. This only happens for a couple of seconds. It also seems to be worse when I'm accelerating up hill. If I accelerate slowly from a stop, the noise does not occur, and it also does not occur if I accelerate while I'm already moving.
View 4 RepliesSonata NF (2006-10) :: Brakes Grinding - Caliper Was Sticking
I have a 2007 Sonata V6 I bought used two years ago. When I bought it mechanic serviced the rear brakes as the caliper was sticking. Now the rear brakes make a grinding noise when I brake and when I drive the rear brakes make a sound like slight metal on metal contact. I know Sonatas are known for brake problems. Should I replace the rear pads, rotors, calipers (including pins) and if so what brands are decent to buy? I have used rock auto in the past.
My car has about 198,000km on it (123,000 miles).
Sonata NF (2006-10) :: Grinding Noise At Cold Startup
Need to determine the noise before I took the vehicle in to be serviced. I don't know if I would necessarily describe this as grinding...to me it doesn't sound like metal on metal..but it's not normal.
Only happens on a cold startup, and even then it hasn't been 100% of the time...probably 80% of the time though.
2007 Hyundai Sonata - Startup Noise - YouTube
I found this thread, Grinding Sound On Statup but not sure it's the same issue. This just started. Vehicle has 150K miles on it.
Sonata NF (2006-10) :: Grinding Noise Only Occur When Car Is Moving
Have a '06 V6 GLS w/ approx 105K miles. About a week ago I started hearing a noise. The noise sounds a lot like a brake pad wear indicator, metal grinding on metal. However, the noise does not seem to be related to use of the brakes. The noise only occurs when the car is moving. It is intermittent. Comes from the front of the car. Seems to usually occur when making a sweeping or gentle right turn. Speed does not seem to matter - can be going 20 to 60 mph. Noise will last from less than a second to as much as 5 to 10 seconds and then goes away.
I have taken a cursory look at the crankshaft damper pulley and it appears to be ok...
Sonata NF (2006-10) :: Loud Grinding Noise When Press Down On Clutch
I have a 2009 Hyundai sonata, 2.4, 5 speed manual, gls, when I press down on clutch whether from a stop or when shifting, I get a loud grinding noise and the radio goes dead at same time!, I know it is the starter attempting to "engage", at least that's what I believe it to be, it also "'starts "from, the "on " position when I press on clutch.
View 8 RepliesSonata NF (2006-10) :: 2009 - Gear Grinding In Neutral And Park
My 2009 Sonata, 2. 4 L engine, base model with automatic transmission started up and ran OK, but 20 minutes later when I parked the car and shifted towards Park the gears grinded in neutral, stopped grinding in Reverse, and then grinded again when I made it to Park, and I quickly turned off the engine.
When I restarted, it grinded in Park, OK past Reverse, Grinded in Neutral, and then OK in Drive. How serious this is, or if there is anything I can check out on my own?
Sonata NF (2006-10) :: 2007 - Grinding / Halting Sound On Certain Turns
I have a 2007 Hyundai sonata and I'm having a strange problem with my car. It doesn't happen alot but whenever I make certain turns the entire front end grinds and stops moving. It usually happens after being parked at an angle then pulling out.
View 1 RepliesSonata NF (2006-10) :: Grinding Screeching Sound When Going Left In A Curve
Ok in the last couple weeks I noticed when I am going left in a curve a grinding screeching sound from what sounds like my left front. It only does it when I am in a curve going left. It wont do it going right or just even turning a corner left just a slight turn.
View 2 Replies