Sonata NF (2006-10) :: Dim Low Beam Headlights
The low beams on my 2010 Sonata seem dim compared to my other vehicles. I do not want to install HID lamps but would like a recommendation for a brighter lamp.
View 8 RepliesAccent MC (2006-11) :: Headlights Operates In Low But Not High Beam
08 accent passenger headlight was noticed to not be operating while in low beam. Switched to high beam- it works, but still no low beam.
First instinct was replace the bulb. Low beam works but now.. high beam doesn't?? Bulbs are fine, brand new out of the box and driver's side works like a charm. Bright as heck... passenger's side isn't quite as bright If that's any relation to the problem.
Checked the fuses, they're all good. Made sure bulb was placed in secure. Filament didn't get bounced around either. Was poking around online and seems it could be the relay. Manual doesn't seem to list a relay for the headlights or am I not reading it right?
Lexus RC F 2015+ :: Low-beam Triple LED Headlights Aimed Way Too Low But High-beam Okay
My car is fully stock, with all options available to me (cold weather package not available here). The low-beam triple-LED headlights are aimed way too low compared to all my previous cars, and where they should be. BUT high-beam is aimed properly. So if I adjust the low-beams up, my high-beams might end up lighting up the trees, not the road.
If adjust the headlights up on a fully stock car (not lowered at the front)? Are the high beams still lighting up the road fine? And if you can be specific as the number of turns on the screwdriver, it'd be good too to have an initial adjustment reference.
Sonata I45 (LF 2015+) :: How To Take Out Low Beam Headlights
I bought some new bulbs for the headlights and tried to install them today. I couldn't get the bulb to come out. The manual doesn't really show how to get it out. I know how to take the wire out and that;s about it. How to take the headlight out.
View 1 RepliesJeep - Wrangler :: 2007 - When Switch To High Beam Both Headlights Go Off
Just discovered that both high beams are not working. Regular lights ok. When switch to high beam both go off. I know some bulbs have two filaments, is this the case for this car? Are the bulbs burnt out or something else is wrong?
This is a 2007 Jeep Wrangler Rubicon Unlimited.
Ford F-150 - 1997-2003 :: High Beam Headlights Won't Working?
I added plow lights to my truck and something quit when I had the high beams all on at once. All 4 shut off. Low beams still working. What I fried or where to check? Its a 99 F250 superduty.
View 14 RepliesDodge - Dakota :: Horn Blows And Headlights Go From High-beam To Low When Gas Light Comes On
When my gas light comes on during the day my horn blows every couple minutes at night time the headlights go from high-beam to low-beam every couple minutes. Also, my check engine light is on more than it is off
View 4 RepliesFord Wiring/Electrical :: 1997 - Headlights / Brake Lights Cut Off When Hit High Beam Switch?
So I recently bought a 1997 7.3l F250. It is in fairly good condition, but it has some problems with the lights working. The turn signals and hazards all work, as do the tail lights and headlights. However, when I hit the high beam switch, the headlights cut off entirely. Also, the brake lights do not work at all. Ive checked the bulbs and since they all work Im not sure what the issue is.
View 3 RepliesFord Ranger / B-Series :: High Beam Malfunction - Moving Forward Headlights Cut Out Completely?
I have a 1995 ranger four letre 5sp, dubbed Beula. I figured there'd be a few gremlins and there was and is, which I know to be more common than not in older trucks. The top priority is figuring out why when I push the lever for the high beams forward, the headlights cut out completely, whether in gear or not, and I don't know where to begin troubleshooting. I've surfed around the forums looking for answers and really only found conjecture.
View 14 RepliesPassat (B6) :: 2006 - How To Adjust The Low Beam Headlights
How do you adjust the low beam headlights for a 06 Passat? I have found the vertical adjustment now I'm trying to find the horizontal adjustment. For some reason the lights are aimed way out to either the left or the right. Has been like this since I bought the car. Had the car a month, only 42,000 and it's already been in the shop 3 times. Everything from ignition coil, to steering column and comfort control module.
View 5 RepliesSonata I45 (YF - 2011+) :: High Beam And Using Turn Signal
A few minutes ago on the way to the cabin, I was using the high beam (Auto mode) and when I push the stalk up to make the right turn, the headlights went off for a sec while the dash lights flashed brightly. Almost made me change my underwear!
When I arrived at the cabin, I tested the stalk and it turned out with loose or something like that.
What was causing that action? It never happen with low beams.
Buick - LaCrosse :: 2006 - Low Beam Headlights Stopped Working
I have a 2006 Buick LaCrosse. The low beam headlights have stopped working. I thought that maybe the bulbs needed changed (since I usually have to change them every 6 months) but after changing one with a brand new bulb, it still doesn't work. The "old" bulb looks ok. The fuses are also good (I checked them with a multimeter.) The only thing that I see in my shop manual is something about the ambient light sensor. If this has gone bad, would that cause the low beams to not work? The high beams work fine. The low beams will not work with the headlight switch in the "auto" or "on" position. I don't see any DRL relay or fuse in this car.
View 17 RepliesAccent MC (2006-11) :: No High Beam Indicator On The Dash
I installed a set of bi-Xenon HIDS identical to these.
in my wife's 2008 Accent. I unplugged the DRL module as shown in a thread I found here, but now there's no high beam indicator on the dash. Is there a wire on the plug that I can put a jumper on or something to make this work again?
And before all the nay-sayers growl at me, instead of assisting with this problem, I aimed the lights really low so there's minimal glare to oncoming traffic. We drove about 125 km last night with them and never got high-beamed once.
Accent MC (2006-11) :: 2009 - No High Beam Indicator Light
I bought a 2009 Accent last week after my 1987 Camry wagon bit the dust. It has 47000 km and seems to have been very well maintained. The only problem I have noticed is that the high beam indicator light does not come on, although the hi beams do work. I downloaded an owner's manual but am not sure which fuse the indicator light is on; in any case, everything else seems to be working so I expect the bulb is burned out. My problem : I don't know its location on the instrument panel since it has never worked, and I don't know if it is possible to replace it without special tools.
View 2 RepliesLexus GS 2006-11 :: High Beam Not Working Anymore After Led Change
Wanted to change my stock yellow high beam (DRL) bulb to an LED bulb i bought from jdmtoys I also changed the parking light to LED and it works perfectly, so after changing the high beam bulbs it worked for few seconds then stopped working... I put back the stock high beam bulbs and it still is not working did i blow a fuse or something? Now when I turn the high beam on my headlight turns on instead of the high beam....
This is the bulb i purchased : [URL] .....
Volvo - S60 :: 2006 - Turn Signal Only Works With High Beam On?
My roommate has a 2006 S60 Volvo. One day the passenger turn signal just stopped working. It only works if the high beam is on. The driver side turn signal works fine and so do the emergency flashers. It's not the bulb, not the fuse, not the turn signal lever, and she even took it in the shop and they couldn't figure out the problem without replacing the DIM which would cost a lot.
View 1 RepliesPassat (B6) :: 2007 1.8T - Low Beam On Passenger Side Not Working But High Beam Does
This morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
Subaru - Legacy :: 1996 - High Beam Is Dimmer Than Low Beam In One Headlight
I drive a 96 Subaru Legacy. What does it mean when one of the high beams is dimmer (less light output) than the low beam? I am using a brand-new bulb. It's not an adjustment issue because I was looking at the bulb when it was outside of the housing and it clearly gets dimmer when you switch to brights. However, they are equally bright when on low-beam, so I don't think its just a crossed wire.
View 2 RepliesSubaru - Outback :: Low Beam Is Very Dim And High Beam Doesn't Work?
I replaced the low beam and high beam on my Subaru, now the low beam is very dim and the high beam doesn't work. Careful not to touch the bulb.
View 3 Replies