Santa Fe (CM - 2007-12) :: Tiny Grinding Noise Coming From The Front End
I have a 2007 SF Ltd. About 6 months ago I noticed a tiny grinding noise coming from the front end. I took it to the place that installed the brakes and rotors and had them look at it. The said that they didn't see anything but the cleaned up the rotors and oiled the slide pins. That didn't seem to sold the problem, so I took it to the shop that does all my inspections and such. They mentioned that they didn't see anything and that if if was only first thing in the morning, it might be some very minor rust that is building and being worn off. Lately, the grinding noise has gotten much more consistent and loud. Both places said the pads looked almost new and other than the turning of the rotors, they looked fine. If it isn't the pads or the rotors, what could be causing the grinding noise? A friend of mine had the same issue but his dealer told him that his vehicle "just had noisy brakes". That doesn't see to be an acceptable answer.
View 3 RepliesSanta Fe (CM - 2007-12) :: 2008 - Grinding Noise Coming From Front Of Vehicle When In Neutral
When I start my vehicle, it makes a grinding noise, sounds like it's coming from the front of the vehicle, when I put into gear it stops. It started gradual and is getting worse. It's a 6 cylinder automatic, with 108 k miles.
View 3 RepliesSanta Fe (CM - 2007-12) :: Front Tire / Wheel Noise
My wife has a 2010 Santa Fe with AWD and 40,000 miles on it, and my daughter has a 2008 AWD with 38,000. I don’t drive my wife’s car much but after taking it on a trip I noticed that the front wheels/tires seemed louder than normal, exactly like a bad wheel bearing or when you are running snow tires. I had the tires balanced and inspected and took the car to the dealer sure that there was a front wheel bearing going out but they said it was fine. A week later I was driving my daughter’s 2008, same noise. Tires on both cars are fairly new and don’t appear to have any problems. So, is this common to these cars and considered normal?
View 2 RepliesSanta Fe (CM - 2007-12) :: 2010 - Noise From Front Right Wheel When Starting Out
Well, even though I love my 2010 SF SE I have had a few issues. I've had my power steering pump replaced twice and now I'm hearing a clunky/creaky noise coming from the right from wheel. I"m thinking it is a sticky caliper. It happens most frequently when I am just starting out from having the car parked for a while. When I put my foot on the brake and then release it I get the noise. It seems to go away after I have been driving a while.
Can't say I ever had this much trouble with my previous generation SF. Nothing major but annoying none the less. BTW I have just under 30k miles.
Santa Fe (CM - 2007-12) :: Creaking Noise From Front End When Turning The Wheel
My parents have a 2007 hyundai santa fe AWD and recently there is this creaking noise from the front end when you have the car in reverse and you're foot on the brake and turn on the wheel, I had someone in the car and I stood outside it sounds like its coming from the center of the wheel near the hub it has that sound like a rusty door hinge, is there a problem with front wheel bearings on these cars we had the two rear ones replaced under warranty because of a humming thrumming noise and now there is a humming thrumming noise again but hard to tell if front or rear and the tires are in good condition no cupping.
Is there an easy way to check the hubs on these cars besides the normal move the tire up and down for play. By the way the car has 105000 kms on it...
Santa Fe (CM - 2007-12) :: Odd Clicking Noise On Front Driver Side Wheel
Truck has 1800kms on her, pretty much brand new but there is an odd clicking noise on the front drivers side wheel when I adjust the steering from left to right and vice versa. Its quiet if I am going straight, but it sounds like there is a linkage loose. Its not too loud or noisy, but having problems with tierods/knuckle assy?
View 1 RepliesSanta Fe (CM - 2007-12) :: 2008 3.3 AWD - Clicking Noise Coming From Driver Side Front Wheel Area
I've got a 2008 santa fe limited 3.3 awd with about 170000 km on it. Lately when I brake I've been hearing a clicking noise coming from what sounds like the driver side front wheel area.
Had it in to my mechanic who checked the brakes and said that pads/calipers/rotors were all fine. They replaced the passenger side front bearing on the lower control arm a few weeks ago and said there is no play or noise coming from any other suspension components.
Where to look next? My mechanic isn't sure what it is so I was going to take it to the dealer and see if they can fix it. Also had new tires installed about a month ago
Ford Excursion :: Pop Noise In Front End / Left Front Wheel Grinding
Driving at hwy speeds and head a pop noise in front end. Stopped and couldn't find anything, heard it a couple of more times, still nothing found, now I have a grinding noise left front wheel. What the issue may be. 2001 Ford EX 4X4.
View 6 RepliesSanta FE SM (2001-06) :: Grinding Noise When Turning Wheel To The Left
I am hearing a grinding noise when I turn the wheel to the left.. and when I straighten it again the noise goes away.. no noise at all when turning the wheel to the right. what could it be? 2006 Hyundai Santa Fe / 205,000 km's
View 4 RepliesSanta FE SM (2001-06) :: Brakes Make A Grinding Noise - ABS / ESC And 4 Wheel Drive Lights On
2004 Santa Fe, after starting car the brakes make a grinding noise, the nthe ABS, ESC and 4 wheel drive light come on. After the initial grinding the noise stops and the brakes work fine. Just the lights stay on.
View 4 RepliesSanta Fe (CM - 2007-12) :: 2008 - Grinding Noise When Restarting The Car
I have a 2008 Sante Fe with 165K mileage. At times, not regular, when restarting the car we hear a grinding noise. Immediately we turn the car off and re start, noise goes away. Could this be the starter going bad? Dealership wants 400 to fix.
View 27 RepliesToyota - Sienna :: Grinding Noise From Front Driver Wheel
Had my wheel bearings replaced 3 weeks ago from a mechanic I never went to, as mine was on vacation. 3 days later tire fell off while driving. So we took it to my regular mechanic and had all safety issues fixed. New brakes, rotor, hub. But noticed that a grinding noise appeared. Took it back to mechanic, and he said that it was due to the spindle being slightly bent. Thst it wasnt a safety concerns, but will cause rotor/ brakes to wear out quicker.
I'd like to trust my mechanic, as he has always done good work for me in the past. But am a little shaky over every noise. I'd he correct?How soon should I get it repaired? I just dropped over $600 to get the can drivable again. So if I can push it off until I can afford it that would be great! Otherwise, I might need a small loan to repair.
Elantra MD (2010-15) :: Grinding Noise Comes And Goes - Front Wheel Grumbling
Tonight it was a perfect 72 degrees and I had to run over to a friend's house and pick up my backpack as I didn't feel like riding my bike the ten miles home with that thing on my back. As I usually do when it's nice outside, I opened both front windows and the sunroof and immediately noticed a mid-level pitch grinding noise that comes and goes but is mostly noticeable at low speeds. Initially I thought it was the brakes dragging but it doesn't change with a brake application so I'm guessing it's the front wheel bearings. I'm calling the dealer in the morning to set up a service appointment.
View 1 RepliesToyota - Corolla :: 2005 - Grinding Noise From Front Right Wheel
I recently brought my 2005 toyota corolla to my mechanic to give my car a check up as i will be going on a three week road trip soon.Upon assessment, my mechanic told me that my front right wheel bearing was making a strange noise and that i should replace it. I went ahead and had it replaced. after i had it replaced the front right wheel area was still making a grinding noise (louder than before it was replaced). I brought it back and he replaced it again with a new wheel bearing.
Again after the 2nd replacement it continued to make a load crunching, grinding noise when ever i brake the car. So once again, i brought it back. I thought perhaps it was my brake rotor and had him check that. He did just that and said the break was fine. He said it may be because the axl was not sitting true. so i had the axl replaced. well today i picked up the car and drove it approx 5 miles and the same crunching/grinding noise persists!!! I brought it back and it is once again being worked on. I need it fixed and am worried that my car won't hold up for my upcoming 4000mile road trip. I have attached a video clip of the sound to this post.
Santa Fe (CM - 2007-12) :: 2010 - Grinding Noise Coming From The Back
2010 SF Limited, about 46,000 KM.
Heard a grinding noise coming from the back of the truck today. First thing I thought to look at was the rotors. They looked warped/wavy and were really hot. I'm worried that the pads are used up and its metal on metal, really looks like rotor damage. I'm confused by this...
1) I get a safety inspection done every time i'm in for service (6km), no service rep has ever warned me about my pads.
2) Aren't squealers supposed to warn the driver of low pads?
3) Pads wear out faster in the front than they do in the back. How could the back pads be used up already? The front looks fine.
So if my back calipers are seized, or the e-brake line froze, then i'm driving with the back brakes engaged full time. This should not have happened to a truck so young. Do I have a warranty case here?
Santa Fe (CM - 2007-12) :: 2008 - Grinding Noise In Park And Neutral
I have a 2008 Hyundai Santa Fe and there is a loud grinding sound when the car is in park and neutral. This noise doesn't happen all the time but i would say 50% of the time. When there is the noise it does go away when i put the car into drive or reverse.
View 16 RepliesFord F-150 (2009-2014) :: Grinding Noise In Front Passenger Wheel
Just installed new actuator and wheel hub assembly on my 2009 f150,truck still had grinding noise in front passenger wheel , New solenoid and vacuum hose kit installed when test drove noise still there until you put the truck in 4 wheel drive it disappears . The noise returns as soon as you take it out of 4 wheel drive. Also mechanic said steering was tight,installed new shaft same thing, could this be the rack and pinion.
View 5 RepliesCamry :: 2007 - Steering Wheel Grinding Noise On Left Turn
Lately my 2007 Camry (2.4 L, Auto) has developed a bit strange problem. When I'm driving on highway, even slight left turn results in a grinding noise and sort of resistant steering wheel. It happens only when I turn left. As soon as steering wheel gets back to straight, the noise and steering wheel resistance/hardness goes away. I don't really feel much when I'm driving slow on the city streets. Although some time when I am little bit fast, I feel slight grinding noise and steering hardness. No problem in turning right at all.
View 5 RepliesTrailBlazer :: Grinding Noise Coming From Front Left Wheel When Braking In Reverse
So whenever I brake while reversing (and rarely while moving forwards) I hear this odd grinding noise coming from the front left wheel and can feel it through the brake. Im not a petrol head but I decided to replace a wheel bearing hub myself recently to save money. I am pretty sure I reconnected the anti lock brakes correctly though I doubt it's that. My brakes are good.
View 4 Replies