Santa Fe (CM - 2007-12) :: High Mounted Stop Light Bulb Replacement
I need locating the locking clips that hold the high mounted stop light assembly in place. Are there any diagrams?
View 6 RepliesLexus LS 2007+ :: High Mounted Stop Lamp Removal On LS460
I have a blown LED on a 2007 LS460. Bought a set of the Stop Lamp and started to embark on my little DIY today.
Both side covers are held on by a little plastic hook underneath near the row of LED bulbs. Hence, you will have to press down firmly to unhook and slide the cover towards you and lift it up to remove. (watch my youtube link below).
The center piece is held on by 2 screws (nearer to the row of LEDs) and 2 plastic clips (nearer to the C-pillars). Remove the 2 thumb screws and the plastic clips (twist or turn them 90 degrees and they should come off easily). At this point, remember to unhook the plastic connector.
Replace the center Stop Lamp piece and install everything in reverse order.
Santa FE SM (2001-06) :: High Mount Stop Light Glow Even Without The Brake Applied
Recently I noticed that three LEDs in my 05 SantaFe's high mount stop light glow even without the brake applied. When the brake pedal is depressed, the entire light glows as it should. But only the three LEDs glow at all times.
View 13 RepliesSanta Fe (CM - 2007-12) :: Stuck In Drive While In Operation - Faulty Stop Lamp Switch
I have 2008 Hyundai Santa Fe......approx 10K miles......no major issues to date
Drove my son to school this morning and pulled into a parking spot.....the shifter would not move into PARK......it was stuck....would only go into NEUTRAL and DRIVE....the vehicle was idling
I was a little panicked, but put on the parking brake and called the dealership on the cell.....they told me to pop the cover on the switch near the shifter and and depress the reset button (needed a flat head screw driver).......it took about four tries and then finally worked.....
I shut the vehicle off, restarted it and tried to put the car into REVERSE...to back out of the parking spot......shifter was stuck again.....had to depress the reset button......
Immediately took the car to the dealership where it was DIAGNOSED with a faulty "stop lamp switch".......causing the shifter to stick and the brake lights not to work... this was a recall item for the 2007 Santa Fe, but not the 2008 (that I'm aware of)
Dealership replaced the stop lamp switch and had me in and out in a hour.......but they did not initially give me a write up......i told them this was a very dangerous situation that had just occurred and I wanted a write up.....they happily complied....
So keep a flat head screw driver (glove compartment) in the car and have your dealership take a look at the stop lamp switch, on your next visit, even though it was only recalled on the 2007.......I will also be contacting HYUNDAI directly...
ETA: ESC light was illuminated when I was trying to get the vehicle into PARK from DRIVE......also contacted HYUNDAI and gave them a description of the incident and now have a case number.
Santa Fe (CM - 2007-12) :: OEM Headlight Bulb Replacement
2008 Santa Fe. Removed 2 bolts and 1 nut as shown in manual. cleared the clip at the bottom outboard corner. What else am I missing? I'm still Unable to remove the headlight bucket. It will only come out about an inch or so then feels like something else is holding on.
View 8 RepliesAccent MC (2006-11) :: 2009 - How To Replace Fog Lamp Bulb
One of the fog lamps on my 2009 Hyundai Accent has blown and I want to replace it, but I am not particularly technical. How to do this? Or any website or video tutorial.
View 3 RepliesSanta Fe (CM - 2007-12) :: 2009 - Check Engine After Timing Belt Replacement
I have a 2009 Sante Fe with 60,258 miles. I had the timing belt changed at 60,000 miles at the dealer. I now have a check engine light that shows the following two codes.
P0321
P0612
These codes are related to a timing belt change? Could a sensor have been removed for the work and not replaced correctly?
Santa Fe (CM - 2007-12) :: 2009 Won't Stop Locking And Beeping
I have a 2009 Sante Fe Sport 3.3; that recently just started locking itself. The way i knew was because the horn kept going off as if we were pushing the lock button on the keyfob a bunch of times. Well the keyfob wasn't being pushed and the only way I could get it to stop beeping was to hold the unlock button on it. I thought it was the battery dying on the keyfob but I took it out and the car continued to beep. We are taking it in to the service department tomorrow. The only was I can stop the madness is if I have the door partially open, to break the circuit (I would imagine)
View 16 RepliesSonata NF (2006-10) :: High Brake Light Bulb Replacement
After losing 4 bulbs trying to put the new light in from the bottom on my 07 Sonata's high brake light, I finally figured out, that if you take a dremel or other small cutting tool and cut of the tab on the bulb socket, the whole assembly will slide back into place from the top. Cut the tab even with the holes where the two wires go into the socket, and you should have no problems.
View 23 RepliesSanta Fe (CM - 2007-12) :: High Speed Vibration Come From The Rear
I had this item of concern as a response to another thread but I thought I'd open up a new thread and see if I could get any more attention.
I bought a used GLS and upon initial drives I have noticed a high speed vibration that seems to come from the rear (I don't feel any in the steering). In the colder weather recently I've noticed a pronounced vibration at a lower speed (just before shift points). between 2nd and 3rd. This seems to be worse with short drives or in morning.
Vibration seems to be worse just after a tighter right turns or even some left turns. I notice the most vibration right around 25mph. I also get it with moderate acceleration into a certain torque range. Like driving at 45 and accelerating up to 60. What is going on? It seems like it is linked to acceleration (torque) and possible pressure from turns. CV joint / axle? Wheel bearing? It seems like a tire would be worse as speed increased and more consistent.
Ford - Explorer :: 2001 - Rear Body Mount Bushing Replacement
2001 Ford Explorer Sport (not sport trac) 4.0l 5r55e 2wd.. Ok so I picked up a sweet deal of an explorer yesterday.
Sure enough I get her home and find out she needs both the rear body mount bushings replaced. Ok no sweat so I go to autozone...they cant find them... Ok I look in the book for replacement procedure... Nothing, To YouTube! ...nope nothing there either.
Santa Fe (CM - 2007-12) :: 2010 - Malfunction Indicator Lamp Stays On After New Battery
Yesterday I changed battery after that its seems malfunction indicator lamp stays on, i checked with hyundai service center they told to reset the program then diagnose the problem, then only come to know the issue or not issue they asked 20rial, i m wondering just changed the battery got some issue.
View 4 RepliesCadillac - Deville :: Paint Is Peeling On Front Bumper And Rear High Brake Lamp Is Cracked
Over the past year I have had to replace 2 window regulators, a front motor mount, rear brake reline, new wheel engine bearing, a Plenum, and on top of all that the paint is peeling on the front bumper and the rear High Brake Lamp is cracked! Any connection between all these repairs or just my really, really bad luck?
View 9 RepliesSanta Fe (CM - 2007-12) :: Transmission Mount Leaking
I was just advised that the transmission mount on my 2007 Hyundai Santa Fe is leaking. Part #21910-2B500. I am looking at $444 to have it replaced. How easy is it to replace? Are there special tools needed?
View 9 RepliesCorolla / Matrix 2009-13 :: Heater Knob Control Bulb Replacement
We have a 2010 corolla S and the heater knob control bulb is gone. How do I replace this?
View 1 RepliesCamry :: 2007 Gen 6 LE - Climate Control Bulb Replacement
I own a 2007 Camry LE and one bulb behind the temperature dial is burned out. It is the bulb for the indicator on the outside edge of the dial. I am curious how to remove the panel and rotary dial to access and replace the bulb. I've searched the forums but cannot find a description with pictures (hope I didn't miss it somewhere).
View 6 RepliesLexus LS 2007+ :: Small Bulb Under The Headlight Burned Out - Replacement?
One of the small bulbs in the corner of the headlight assembly is burned out. does any one know how to replace it?
View 1 RepliesLexus ES 2007-12 :: 2010 ES350 - High Mount Third Brake Light Removal?
My wife's 2010 ES 350 third brake light has an intermittent LED issue. The last 3 LEDs on the pass side flash on/off when the brake is depressed. My understanding is there may be a broken solder joint. My problem is I can't seem to get the assembly out. How the high mount assembly is mounted and how to remove it?
View 2 RepliesAvalon 2005-12 :: 2007 - High Mount Brake Light Works Sporadically
My high mount break light works sporadically. When I break, sometimes you can see it as bright as it can be, other times it is dim, and then sometimes no light comes on. The dealership could not even figure out how to get to the led unit.
View 8 Replies