Santa Fe (CM - 2007-12) :: ESC Indicator Stays On
I drive a 2010 Santa Fe and have had this issue for a couple of months. After driving for approximately 20 minutes my ESC indicator light comes on and stays on. I'm not braking at the time or doing anything other than driving in a straight line on a clear road at about 80 km/hr. Drives fine for the rest of the trip even with the indicator on. After I shut the car off and then restart the indicator is off. Later in the day when I drive for another 20 minutes or so the indicator comes on again and stays on until I shut the car off and restart.
View 16 RepliesPrius (Gen 2) :: 2005 - Malfunction Indicator Lamp Came On
I pulled my 2005 Prius out of the garage today and parked it on the driveway. When I went back later that day to pull it back under the garage, nothing would work and the "Malfunction Indicator Lamp" came on. I was thinking my battery in my key had gone bad and replaced it. When I tried to start the car for the second time the engine would not turnover, the clock light looked dim, the locks would not work and my headlights would not come on.
View 2 RepliesPrius (2004-09) :: Malfunction Indicator Lamp Went On
My 2004 Prius won't start for the first time in its 45,000 miles. First try only the malfunction indicator lamp went on. After a pause and a few tries later, the fuel gauge and gear indicator cluster flashed on and off while I was attempting to start (fuel indicator racing across its grid and gear indicators outlined with "dotted" lines -- tank is 1/2 full BTW).
Later tries got no response except the malfunction lamp. I tried both keys in the ignition, also checked door lock functions, and found the keys will still lock the doors, but the click is noticeably weak and the unlock function doesn't work.
Prius (2004-09) :: Malfunction Indicator Lamp Came On
I have a 2008 Prius with about 34,000 miles. While I was driving yesterday the malfunction indicator lamp came on. I returned home (was 20 miles away), but did not notice anything wrong while driving. Thanks to Priuschat, I found discussions that said to check if the gas cap was on correctly; sure enough, mine was not on tightly. I've just put the cap back on, but when I started the car, the malfunction indicator still came on. Will the warning light clear on it's own (if the problem was the gas cap).
View 3 RepliesPassat (B6) :: Malfunction Indicator Lamp Light Is On
Car is running fine.. I cant tell any changes in the car at all. Going to the dealer to get fixed and also make them fix my darn headliner that has supposedly been on backorder for 3 months now.
View 2 RepliesPassat (B5) :: 2004 - Malfunction Indicator Lamp Came Up And Remained On
Yesterday (Saturday), I stopped to get gas in my 2004 Passat. I left the gas station and forgot to put the gas cap back on and close the gas cap door properly. I drove about 2 miles home and then noticed I had left it open so I closed it. I didn't drive the car anymore yesterday but then took it to church this morning and when I did, the malfunction indicator lamp (yellow light that looks like an engine) came and and remained on. I turned the car off and then restarted it and it remained on.
When I looked in the owners manual, it says this is related to the emissions system. On other cars I've owned, not having the gas cap on tight can cause the "check engine" light to come on so I'm basically assuming the equivalent happened here. Any way to turn that light off easily? I assume it would go out over time and/or the next time I get gas as has typically been the case in other cars I've owned (including a 2000 VW Eurovan). The car runs fine and doesn't seem to have any other issues or problems.
Prius (2004-09) :: 2008 - Random Malfunction Indicator Lamp Occurrence
I have an 08 prius with about 36k miles on it. Never had a problem other then getting the water pump replaced under warranty during scheduled maintenance.
View 3 RepliesPassat (B5) :: 1999 VW Shaking The Most When Change Gears - Malfunction Indicator Lamp
I just starts my 1999 VW Passat (manual) today, and the Malfunction Indicator Lamp (MIL) was on. The car is shaking the most when I change gears, then it shakes but it's ok when I'm driving. I saw it could be bad, and I shouldn't drive the car. I drove to a VW dealer garage to fix it.
I just wanted to know what it could be, if you had the same problem and what it was. Also how much it should be too, etc. I know that my engine was hot yesterday, it was smelling a bit burned after a couple of very steep hills in San Francisco, I was using a lot the first gear because of stop signs and cars behind and in front of me.
Passat (B5) :: Malfunction Indicator Lamp Reads Manufactured Fuel And Air Metering
So 3 weeks ago, I noticed the malfunction indicator lamp came on. I immediately went to the Auto Zone and have them use the diagostnic device to identify the "malfunction". The device pulls out "p1136 manufactured controlled fuel and air metering." The guy said it could be the gas cap being loose so he loosens it and tightens it. He said he would erase the message and advised me to go to an auto mechanic shop if the lamp light shows up. That evening the light lit up.
I haven't driven that car for approx 3 days then I drove it to go get gas. After I got gas, the light disappeared. I dunno why. It stayed disappeared until several days later. So, i am wondering...is it a big a problem? can i still drive?
Prius (2001-03) :: Malfunction Indicator Lamp - Master Warning Light Came On?
I bought a 2001 Prius from a private seller after they had just replaced the Hybrid battery with a Gen II battery and it has been running great until the last few days.
First the Malfunction Indicator Lamp and Master Warning Light came on and my husband and I took it to a dealer. The dealer said the error code was P3000 but didn't know more than that. He said he didn't know if the v12 battery currently in the car is the correct battery and he said it looked like it wasn't secured correctly. He said I would have to take it somewhere else to have it worked on.
When we picked up the car everything was normal again and none of the warning indicators came on. After driving it for about 80 miles both warning indicators came on again. I continued driving the car 15 miles, turned it off for about 5 hours and when I turned it on again only the Malfunction Indicator Lamp came on. At first my gas mileage was unaffected but now it has decreased slightly. I usually get about 41 mpg and I'm getting about 37-38 mpg since we picked up the car.
Santa Fe (CM - 2007-12) :: Malfunction Indicator Light Blinking
Month ago the malfunction indicator turned on. On checking it was found that wires over the engine were eaten by rats. Reconnection of wires solved the problem.
Today the malfunction indicator light is blinking. Could it be the same wires going loose?
Prius (Gen 2) :: Hybrid System Warning Light Popped Up - Malfunction Indicator Lamp
On my way home from work tonight, the master warning light and the check engine (malfunction indicator lamp) appeared on the dashboard, and the hybrid system warning light has popped up on the multi-informational display.
View 11 RepliesGolf/GTI VI :: Power Lost When Driving / Dash Illuminated EPC And Malfunction Indicator Lamp
Out driving the other day and suddenly lost power and dash illuminated the EPC and Malfunction Indicator Lamp. Did a bee line to my home and experienced loss of power and engine vibration. At traffic lighta it emitted large quantities of white or blue smoke that smelled like gas.
Connected to VCDS and had 4 codes:
000768 - Random/Multiple Cylinder Misfire Detected
000769 - Cylinder 1 P0301 - 000 - Misfire Detected - MIL ON
004874 - Cylinder Disabling
000135 - Fuel Rail/System Pressure
My assumption was a bad coil, so I swapped them but no joy. Then decided to swap coils and plugs and observed cylinder #1 was filled with gas. Siphoned it out and it was able to fill about 1/4th of a beer bottle, or 3 ounces. Top of piston #2 looked slightly wet, but the origin could have been overflow from #1 via intake manifold. I'm thinking #1 injector stuck in the open position. Car is out of warranty so it may be on my dime unless I can convince dealer that this is power-train or emissions related. Best case, I need one or two injectors, oil replacement from gas contamination, plugs and labor. I thought about the worst case and it could be the above + a complete short block + catalytic converter. No tune, 100% stock
Ford F-150 - 1997-2003 :: Crank But Not Fire Or Start / Read Codes By Malfunction Indicator Lamp
Have a 2000 F-150, 5.4L. Once recently in a parking lot, it would crank but not fire or start. Wife called me to come get her. By the time I got there, she said it started "after she loosened the gas cap & re-closed it." But, it started fine for next several weeks. Yesterday it didn't. I read a bunch of threads here on possibilities. Many troubleshoot items I checked out or had done.
Chilton manual says you can get limited error codes from the light on dash flashing - MIL - Malfunction Indicator Lamp Method.
For now, I'm trying to find the 2nd, separate, one-wire lead "near or with the (main) Diagnostic Connector." They call the single wire / connector the "Self-Test Input connector" (STI). You're supposed to use a jumper between that STI & the upper, right connector of the main diagnostic connector. Then you (may) get flashes corresponding to codes via the key on, engine off method.
I see no such single wire lead or connector anywhere near there. Not up under the dash either - stuck my head under there & used mirror. There's a separate connector (not in use) clipped on the L side of the main diagnostic connector, but it has 5 pins inside. I took pics, but forum says I "may not post attachments." Been a member for yrs. That extra 5 pin connector faces toward firewall.
There's an "empty hole" - 1/4 in. (facing forward) in the bracket that holds the main diagnostic connector. Just above the main connector. Not sure if something was ever there
If no one knows how / if the Malfunction Indicator Lamp Method works or where the jumper goes, I'll be forced to buy a code reader w/o researching which are decent or crap (around $200 or less). I maybe? could wait to order one online (if knew which one). Also have AutoZone, O'Reilly, Advance, NAPA, PepBoys & others locally.
* The truck shows a check engine soon light, so should be a code already. * Yes, I tried her loosen / tighten gas cap trick.
* Also put a slow charger on for a while & even used the fast start setting on charger. No go, but engine turns really fast.
* Crawled under the gas tank & listened for fuel pump to activate when key is turned to Run.
* Fuel pump made a small noise - more like a relay or "clicking" - not a whine or whir.
* Checked most fuses - under dash & hi voltage box - that have anything to do w/ fuel pump, PCM & several others - mentioned in similar threads here.
Can't really check relays & don't want to just start replacing parts. I don't have a code reader & reluctant to buy one from local store w/o some reasonable research. (I don't mind buying one, but...). If I could drive it to the auto store, I wouldn't be asking this. Chilton's doesn't say if this malfunction indicator lamp method will work if a vehicle won't start. But, a code is already thrown.
Santa Fe (CM - 2007-12) :: Battery / Seat Belt And ESC Indicator Lights Off And On
2007 Sante Fe Limited original owner. 87000 miles, great car. Having a problem with battery light coming on and then going off, also seat belt light off and on but no sound. The other night my ESC light came on for a while. New battery, alternator and serpentine belt installed a few months ago.
View 25 RepliesSanta FE SM (2001-06) :: Malfunction Indicator Light
I've just bought a 2005 Santa Fe CRDI 2.0 Second hand, one owner from new, 60,000miles in 7 years. Just had it's 60,000 mile service. Until today perfect. Started car and no revs. but when I put in gear and moved the car, the revs kicked in and I was able to drive normally. Pulled over to side, into neutral, no revs FOR 1 2 or 3 SECONDS, then revved as normal, put in gear, and able to drive OK. Meanwhile, the MIL light came on and stayed on. I know what the hand book says but before I take it to our Hyundai dealer.
View 5 RepliesPrius (2010-12) :: Hybrid Malfunction Indicator
I have a Gen III Prius with 13,000 miles. It is less than a year old and I just got the Hybrid Malfunction indicator...I'm a bit upset about this and am wondering what it means. I'm not going to be able to take it into the dealership until next week, and was hoping to get some information about the indicator. It's a blurry shot but it is an exclamation mark with wavy lines below it.
View 7 RepliesSanta Fe (CM - 2007-12) :: Stuck In Drive While In Operation - Faulty Stop Lamp Switch
I have 2008 Hyundai Santa Fe......approx 10K miles......no major issues to date
Drove my son to school this morning and pulled into a parking spot.....the shifter would not move into PARK......it was stuck....would only go into NEUTRAL and DRIVE....the vehicle was idling
I was a little panicked, but put on the parking brake and called the dealership on the cell.....they told me to pop the cover on the switch near the shifter and and depress the reset button (needed a flat head screw driver).......it took about four tries and then finally worked.....
I shut the vehicle off, restarted it and tried to put the car into REVERSE...to back out of the parking spot......shifter was stuck again.....had to depress the reset button......
Immediately took the car to the dealership where it was DIAGNOSED with a faulty "stop lamp switch".......causing the shifter to stick and the brake lights not to work... this was a recall item for the 2007 Santa Fe, but not the 2008 (that I'm aware of)
Dealership replaced the stop lamp switch and had me in and out in a hour.......but they did not initially give me a write up......i told them this was a very dangerous situation that had just occurred and I wanted a write up.....they happily complied....
So keep a flat head screw driver (glove compartment) in the car and have your dealership take a look at the stop lamp switch, on your next visit, even though it was only recalled on the 2007.......I will also be contacting HYUNDAI directly...
ETA: ESC light was illuminated when I was trying to get the vehicle into PARK from DRIVE......also contacted HYUNDAI and gave them a description of the incident and now have a case number.
Santa Fe (CM - 2007-12) :: 2009 - Rear High Mount Stop Lamp Bulb Replacement
How to replace the bulbs of the rear high mount stop lamp on a 2009 Santa Fe?
I got the bulbs already, located the 2 nuts on the inside directly behind the brake light, but when I remove them, the assembly won't pop out.
I know the manual says they recommend getting these particular bulbs replaced at an authorized Hyundai dealer, but since I already bought the bulbs, I'd like to try and do it myself if at all possible.