Santa FE SM (2001-06) :: Rear Brakes Keep Wearing Out
My rear brakes keep wearing out extremely prematurely (2,000-7,000 mile intervals) and have been for 60,000+ miles. (No joke my mechanic has warrantied the rotors and pads over and over literally like 10 times) its the insides pads of the back that wear down while the outsides and front are fine...is the proportioning valve causing this problem or is it something else? We've changed the calipers and brake hosed
View 17 RepliesSanta Fe (CM - 2007-12) :: Front Suspension Squeak Noise / Rubber Bushing Is Broken
For some months, I've heard squeaking noise from passenger side suspension. Sound like it's from shock & spring on bump road.
This video sound is very similar : Squeaking Noise, Front Driver Side - YouTube ...
I looked at my suspension. and found rubber bushing is broken. Driver's side bushing is normal.
Is this noise related to the broken bushing?
Is it easy to replace the rubber by myself?
A guy said ATP AT-205 reseal will fix this noise in Youtube video. Is it true?
How To Fix Squeaks In Your Car - YouTube ....
Ford Brakes/Suspension :: Replacing Shocks / Bushing Completely Seized Up To The Bolt
I made a thread in the F150 section but maybe it should have went here. Anyhow I'm replacing the front shocks on my 99 150, and well the bushing was completely seized up to the bolt on the bottom of the shock and I ended up breaking the one side of the shock mount off with it. I can't see any easy way of getting it off, I fear I might run into the same problem with the other side.
Would it be ok to just bolt the new shock back on, sans the forward mount? If its just bolted through the rear bolt hole will there be too much play? I really don't feel like replacing the whole lower suspension arm on this beater truck, and I dont think my welding skills are up to that. I don't think my little stick welder even has enough heat.
Ford - Explorer :: 2001 - Rear Body Mount Bushing Replacement
2001 Ford Explorer Sport (not sport trac) 4.0l 5r55e 2wd.. Ok so I picked up a sweet deal of an explorer yesterday.
Sure enough I get her home and find out she needs both the rear body mount bushings replaced. Ok no sweat so I go to autozone...they cant find them... Ok I look in the book for replacement procedure... Nothing, To YouTube! ...nope nothing there either.
Prius (2010-12) :: Coating On Audio / Climate Remote Control To Prevent The Rubber From Wearing Out?
As the topic line states, would you put some type of coating on the audio/climate remote control to prevent the rubber from wearing out? I can envision if I'm using it frequently, over time, the rubber part is going to wear out.
View 14 RepliesSanta Fe (DM - 2013+) :: Burning Rubber Smell Coming Out Of Right Rear Wheel Well
Today I noticed a strong burning rubber or plastic smell coming out of the right rear wheel well. All other wheel wells did not have this odour.
We had a bout of freezing temp's here recently and some snow, I'm wondering if the brake on that wheel may have seized slightly through the all wheel drives tourque vectoring or through parking brake use.
I'm going to drive it to the dealership tomorrow without making an appointment in hopes they will look at it right away as making an appointment this time of year is probably going to take forever.
Something I might be missing or can do?
Santa FE SM (2001-06) :: Slow Start And Burning Rubber Smell
Vehicle:
01 Santa Fe LX 2.7 AWD w/112k miles
Symptoms:
- Slow Start (when cranking takes 2 full seconds before it will turn over and you can hear the engine cranking slower, use to turn over right away)
- Very Strong Burning Rubber Smell
History:
Last January it got down to -20 here in Albuquerque and I would have to go to work at that time. About a week later (when it was still getting down to about 0) I was driving home from work when I smelled a slight smell of burning rubber. I thought it was the car in front of me. The next day I had the same thing. It continued for about a month till the temps rose a bit and then went away. I could never find the cause. I then went all spring, summer, and fall without any problems on my Santa Fe.
As the temps begun to drop over the past 6 weeks we started to smell the burning rubber again, at first only when I would start the car till it warmed up. About 2 weeks ago the car started cranking slower and would take longer to turn over and within the past week I can smell the burning rubber smell even when I had the engine at temp. There's not any idiot lights on. The car is running fine except for what was mentioned, gets up to temp and stays there (a little below the middle on the gauge like normal). I pop the hood and looked at the belt, looked good (no cracks). Checked all the fluids and the only thing that's low is the coolant.
Santa Fe (CM - 2007-12) :: Emergency Brake Engaged - Burnt Rubber Smell From Left Rear Tire
My mother-in-law moved my car and put the emergency brake on (2010 Santa Fe) when she got out. When I got into drive home, I drove about 10miles with it engaged (for some reason the light didn't indicate it was on). When I got home I noticed a burnt rubber smell from the left rear tire. (no smoke though)
Our driveaway is an incline. After engaging/disengaging the e-brake, the light started coming back on again. If I put the car in neutral and release the regular brakes, it will quickly roll back. If I put the e-brake on in netural and disengage the regular brake, it still holds fine on the hill.
I know the damage can vary, but any test or check I can do to determine the amount of damage?
Accent LC (2000-05) :: Bushing Loose - Rear Control Arm Removal
Alright, after taking everything off and replacing all the joints/bushings, I am left with the control arm. (it hasn't been easy either)
I am at the control arm (Passenger side) and i got the rear bushing loose. I managed to brake the front one loose, with a lot of force, but it spins. I see in HMA that it has a bolt, or so it appears, but how on earth do you get to that?
Avalon 2005-12 :: 2006 - Rattling After Rear Shock Bushing Replacement?
So I have to replace them since I have this rattling in the rear and my mechanic has diagnosed it to be the rear bushings...
View 1 RepliesFord Escape / Hybrid :: 2016 - Squeak From Right Rear Sway Bushing Only Happens During Starting Out And Stopping
2016 2L Escape. My question is this. I've had the vehicle for the past 12 months and each rainy season here in California, I admit its not often we get rain but we have it now and its about time. Anyway while driving in wet conditions I get a squeak from what I think is the right rear sway bushing and it only happens during starting out, stopping and parking lot speed bumps all at low speed. No noise at when driving at speed. I've had it to the dealer 3 x to fix, they grease the bushing and it seems ok for awhile but not he permanent fix I was hoping for.
View 1 RepliesPassat (B6) :: Rear Brake Pads Wearing Too Quickly
My car has about 37k on it; and while the front pads look to be about 50% worn; the rears look like they are closer to 90%. Is this normal? The car is also sluggish while braking especially when the engine is being auto-revved to keep the system voltage up (a known problem). It also seems that the car will step into ABS lock-up mode too soon in a panic stop situation; which might also indicate that the brake system is biasing too much power to the rears; too little to the fronts.
I've never had a car wear the rear brakes more rapidly than the fronts; usually the rears are much more lightly utilized to reduce the tendency to skid. Is there any way to adjust brake bias? I'm getting ready to change rear pads and flush brake fluid.
Golf IV / Jetta IV :: Rear Tires Wearing Fast
I'm trying to figure out why I am having problems with my read tires wearing fast. I knew my car was out of alignment and took it to a shop and they told me I have -1.05 negative toe and bad camber.
Can some shims fix my issue or would I be better with a whole new rear beam. As far as I know the car has never been lowered, but how would I be able to tell?
Passat (B6) :: 2007 - Rear Brakes Are Wearing Out So Much Faster
I have a 2007 Passat with 47,000 miles on it. The dealer tells me I need new rear brakes now, but the front brakes have 50% life left in them. When I asked why the rear brakes are wearing out so much faster, he said VW rear brakes always seem to wear out twice as fast. Is this true?
View 3 RepliesPassat (B5) :: (2003 1.8T) Rear Brake Pads Wearing Out
What's with the rear brake pads wearing out before the front brake pads. Took my '03 Passat in last week to the dealer for the recall and the service dept. guy said my brake pads were worn out. I took the car to my local mechanic who specializes in VW's. Sure enough, rears were almost gone but fronts still had plenty of meat left on them. Of course I had him replace the rears. But I always thought the fronts wore out first. Could this anomaly be due to ABS?
View 11 RepliesGolf VI R :: Rear Tires Wearing Prematurely On Inner Edges?
About a week ago I had my car on a hoist getting new exhaust tips installed. At that time I noticed the rear tires are wearing prematurely on the inner edges. So are the fronts but not nearly as bad as the rears. I asked around and was told that this is normal for the factory Pirellis because of the negative camber built in to our cars. This being the reason the car corners so well. I understand the physics of this and I really like the way the car corners. My question is this---Can the negative camber be taken out of the car thusly reducing wear on the inner edges of the tires?? And how much will this be noticed while driving the car normally, and during spirited driving?? I have noticed that some fellows will purposely mod their cars with increased negative camber on the rear wheels, I'm assuming this is to achieve a certain "look".
View 5 RepliesPrius (2004-09) :: Rear Axle Cracks / Rust At Corner / Bushing Arm - Squeaking Brake Pedal
Just hit 225k with my 2004 Prius about a week ago. I passed inspection without replacing the (slightly) cracked rubber bushings for now, but what worries me is the cracks and a slight hole (it has not rusted completely through). Pictures attached. Should I do anything about this, and if so what?
Also, I've noticed that when I let go of the brake pedal, especially after a medium to the hard stop, I hear a squeaking... what's the cause for that? I know the front rotors have a bit of rust on the edges, but not sure if that's the cause... it seems to come from the back.
Other than that, the only other noise I've noticed is a slight clacking/tapping when the A/C is on, usually in hotter weather. The only thing I needed to pass inspection was to replace the muffler after a year and 1/2 ago, the last non-OEM part they put in at another shop was junk and rusted through pretty badly leaving a hole that was leaking. Ended up getting it replaced at the dealer with the OEM part this time...
Corolla / Matrix 2009-13 :: Right Rear Brake Pad Is Wearing Unevenly
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
Ford Super Duty (1999-2016) :: 2001 F250 - Sway Bar Bushing Replacement?
I have a friend with an 01 f250 super duty who needs to replace sway bar bushings.
View 6 Replies