Passat (B5) :: 1999 - Throttle Body Malfunction Code P1545
I'm an Mk3 guy but I've gotten the hang of these beasts when I started to fix my brother's '99 B5 AEB. I got a VCDS scan from a friend and got this.
5 Faults Found:
18010 - Power Supply Terminal 30: Voltage too Low
P1602 - 35-10 - - - Intermittent
17953 - Throttle Valve Controller: Malfunction
P1545 - 35-00 - -
17953 - Throttle Valve Controller: Malfunction
P1545 - 35-10 - - - Intermittent
17952 - Angle Sensor 1 for Throttle Actuator (G187): Signal too Large
P1544 - 35-10 - - - Intermittent
16507 - Throttle Position Sensor (G69): Signal too High
P0123 - 35-10 - - - Intermittent
Readiness: 0110 0101
I'm thinking either the throttle body is toast or maybe the ECU.
Golf VI R :: Misfiring With P1545 Throttle Body Code
Started my car this morning to warm it up, idled for ~ 20min. weather conditions. I returned to my car, and it was misfiring and threw the p1545 throttle body code. There was a mk5 tsb for a similar problem involving wiring. 49k miles, stock tune, w CTS catted dp.
View 8 RepliesPassat (B5) :: CEL Code P1545 - Throttle Body Adaptation
I have a 1999 B5 Passat GLS V6. It's been running well, though I had to replace the CCM last winter due to water intrusion. Recently, the battery needed replacing, and I swapped it out, then the car wouldn't restart normally. I can get it to start by holding a bit of throttle, but it still runs rough and won't idle. The Check Engine Light is on, and my OBDII reader gives me the P1545 code. The car will run in 'limp mode', but it maxes at about 15mph, and I need to keep a little throttle on constantly to keep it from stalling. I think I could make it the mile or two to the local VW dealer, but maybe late at night, with no traffic - it's certainly not driving normally, or even just 'poorly'.
A bit of Googling says that I need to do the Throttle Body Adaptation by opening the hood (and maybe the driver's door, turning the key to the 'run' position without starting the car, and then waiting for the whining noise that indicates the throttle servos are running through their range, and then I'll be fine. However, this procedure has not worked. Am I doing it wrong? Or does it not work with this make/model/year?
I walk up to the car, unlock it, pull the hood lever in the footwell, go open the hood fully, then sit in the driver's seat, leave the driver's door open a bit, and turn the key to 'run', without going all the way to 'start'. I've tried this procedure after clearing the code with my OBD reader, with and without cycling the key to off, and various other ways. If I can't make this work, then it's off to the VAG-COM list, and see if there's someone in North Seattle who can assist. I can also take it to the dealer, but I'm not thrilled about trying to drive it even that far.
Santa FE SM (2001-06) :: Code P2135 - Electronic Throttle Control System Malfunction
Back in March I started a thread regarding my 04 Santa Fe 3.5 which would not start after a spark plug change.
After a ton of research, & a smoke test on the intake I came to the conclusion that there was an issue with the throttle sensor as I unknowingly opened it when I was removing the intake to get to the last bolts behind the manifold. Shortly after my post, I decided to bite the bullet & buy a junkyard TB out of another Santa Fe 3.5.
After installing the new TB, the car now starts but runs extremely rich. I am now getting the code p2135 for Electronic Throttle Control System Malfunction.
Luckily up until this point I haven't needed the Santa Fe as it is mainly a winter vehicle. However, winter is quickly approaching & I would like to have her running before the snow starts to fly.
Passat (B5) :: 1998 - Getting Code P1565 Idle Speed Control Throttle Position Lower Limit Not Obtained?
My 98 1.8t Passat is throwing a P1565 Idle Speed Control Throttle Position Lower Limit Not Obtained. I have cleaned the throttle body with no improvement and cleared the code many times with no luck. The car only has 114k on it car runs fine although some times will give me problems starting it ill have to sit and crank it for 40 seconds or more and also will idle on rear occasions 1300 vut normally between 850 and 900.
View 1 RepliesGolf IV R32 :: Throttle Position Sensor Code P0222
2004 VW R32, No engine mods. I did have the vacuum line sealed off for the flapper mod for about 3 months but is is now back to normal.
I've got the MIL, ESP, and EPC lights on and scanning codes as follows:
Code-P0222
Definition:
- Throttle pedal position (TPP) sensor/switch "B"
- Circuit Low
Explanation:
- Open or short circuit condition
Probable Cause:
- Poor Electrical Connection
- Faulty TPP sensor
- Faulty throttle valve control module
I don't know much about the situation but I took it to my friends shop first where we replaced the Throttle body, intake, and MAF. Didn't fix the problem so I took it to my local VW dealership and the tech's exact words were.."the codes coming up as a throttle pedal sensor. Is there perhaps a sensor by the pedal that I could check?
Golf IV R32 :: EPC And Throttle Position Sensor Code / Turning Left And Right
Am getting an EPC light + limp mode + code for accelerator position sensor (implausible signal). I have swapped out the pedal assembly, so it isn't the sensors themselves, and we've checked the wiring to the pedal assembly... I can feel in-car, and I can see via VAG-COM that one of the two sensors is basically toggling between a sensible % reading of pedal position at one moment, and then zero % the next, and of course every time the sensor reads zero, the ECU notes the error and cuts power... but this only happens when the steering wheel is straight or when turning to the right; I can drive around in a leftward circle all day and night without this occurring.
Why? What is there in the steering (either in the column or at the wheels, or basically any place in between) which, if malfunctioning, could affect the accelerator position sensors in one way or another (i.e. either through the normal operation of a safety system, or through a short or other electrical gremlin)?
Ram / SRT10 :: 2003 - Electronic Throttle Control Malfunction
I have taken it to 3 different dealer service centers, and everytime they charge me to update the computer software. They still haven't fixed anything, and everytime I leave the dealer after "getting it fixed", within 25 miles the problem reoccurs. According to my owner's manual the electronic throttle control malfunction warning light is only on the Hemi Rams.
The problem causes the truck to jerk, idle improperly, the engine loses power and shuts off at low speeds usually when turning, and sometimes when the truck accelerates after a complete stop, it hesitates causing the tires to screech when it finally builds up enough RPM to move, this last one has caused me several explanations to police officers on why I am "laying rubber" on their city streets, as if the Hemi emblem doesn't attract enough unwanted attention from the local highway law enforcement officers..
Bonneville :: 95 3.8l - Code 122 Throttle Position Low And Car Won't Start
It gives me a code "122 Throttle Position Low", I replace TPS, but after clearing codes, the same code comes back & car still won't start.
View 14 RepliesAccent LC (2000-05) :: How To Reset A Throttle Position Sensor
I was reading the car's settings using the Torque app and an OBDII bluetooth dongle and I realize that at WOT the ECU is only seeing 85% from the TPS. O know on some vehicles there is an actual procedure like turn the key forward, hold the gas pedal at WOT, turn the key all the way forward w/o starting while pulling the turn signal stalk down or something crazy like that to force the ECU to re-measure while you keep the gas pedal pinned to the floor. I know on other cars when it doesn't read a full 100% you miss out on a small amount of power and MPG so if it's an easy procedure with these cars I'd like to reset it. I did some searching but mostly came up with info on how to replace it and a few related subjects but noting on this specifically for this car specifically.
View 2 RepliesSanta FE SM (2001-06) :: Code P2125 - Throttle Position Sensor Replacement?
Getting code P2125. Read on here to get some electric contact cleaner and see if that works by cleaning the connections.
If I do end up changing out the Throttle Position Sensor, what voltage value do I look for when installing the new one ?
Lexus ES 2007-12 :: Code P0365 - Camshaft Position Sensor Circuit Malfunction On ES350
I have a 2007 ES350 with 90k miles. Purchased in August. I had ignition coil go out and decided to change them all and the spark plugs. When changing cylinder 5's coil and plug, I tried to push the wiring harness out of the way to remove the coil. Result, I moved the wiring harness too far and disconnected the 3 wires (black, yellow and red) that were connected to the cam position sensor connector. (I should've just removed the sensor SMH) I disassembled the connector, got it down the internal pins, soldered the pins to the wires, placed the pins back in the connector and reassembled it with the wires in the order that they appeared to originally be.
Plugged it back in and put everything back in place. Started the car and code P0352 was cleared but replaced with code P0365 Camshaft Position Sensor B - Bank 1 Circuit Malfunction. I'm thinking, either I put that pins back in the wrong order or one of the wires isn't properly soldered in. Either way, I ordered another connector and it should be here tomorrow. I need Either a wiring diagram or a picture of the camshaft position sensor closest to cylinder 5 connected with the wires in the proper order .
Santa FE SM (2001-06) :: Check Engine Light Came On - Code For Throttle Position Open
My check engine light came on the other day and the code stated the the "throttle position is open" so after researching and everyone telling me that i need to change the sensor. I did everything after was fine running better but today only after 3 days replacing it i get the same problems. car has no get up and go hardly can push to 20 mph and when in idle i press the break it starts to bog down and almost want to shut off! and can be really loud...
Santa fe 05' 3.5L ....
Santa FE SM (2001-06) :: Replaced Throttle Position Sensor And Now Idling At 2000 Rpms
2004 2.4L 4cylinder manual transmission. I had a knock sensor code and replaced it. Then I had a code for the TPS and I replaced it with the new part today and after replacement the vehicle idles at 2000 RPM. what should I change?
View 5 RepliesPassat (B5) :: 1999 VW GLS 1.8T - Check Engine Light On / Code P1545 And P1818
I recently purchased a 1999 vw passat gls 1.8t. Initially the guy I bought it off of told me that when he was rebuilding the turbo he stripped the main shaft bolt, so it needed a new turbo. So I bought a k-04 off of ebay and installed it. The battery was dead so I replaced the battery as well. When I first tried to start the car it would start for a second kind of chugging and then die. I went to my local auto parts store and rented a scan tool and it gave me 2 codes. The first code was P1545 and the other was P1818. As far as how many miles the engine has on it I don't know for sure as the engine has been replaced and apparently no one knows how many miles it actually has.
View 2 RepliesGolf/GTI VI :: 2009 - Codes Came On / Throttle Malfunction
I have a 2009 gti and been having some problems with my throttle. Few codes came up for the longest time on and off. So one day after work I started my car and it started just didn't idle high then quit on me so I decided to take it to a local dealer to have the throttle body adpt and it was fine for about a week. Then same codes came back on witch was my angle sensor 2 throttle and position sensor too. So I got a new throttle body been a month I've had no problems until today. It stalled on me so I scanned it and codes for my valve was malfunctioning.
View 1 RepliesPrius (2004-09) :: CEL Code P0505 - Idle Air Control Malfunction
My check engine light has come on twice now and I'm getting a p0505 code, idle air control malfunction. It seems as though there could be a couple causes for this. All my hoses seem tight, so the cheap fix seems out of the question. What could the other causes be, and more importantly, about how much for a shop to fix it. I have a 2006 with 155,000 miles on it.
View 7 RepliesGolf IV R32 :: Shifter Moves Depending On Throttle Position?
When I am in 6th gear (this only happens in 6th) the shifter kicks forward (towards the front of the car) about a quarter inch when I let off of the gas. When I press the gas again the shifter kicks back (towards the back of the car) a quarter inch.
I believe that this is caused by the haldex disengaging, because no matter how slowly I let off of the throttle, the kick is the same strength (or force? dont really know how to describe it). I was wondering if this is normal, or if I should get it checked out?
When I searched the only thing that came up was checking the mounts. I'm not sure this is the solution to my problem since this ONLY happens when I am in 6th gear, all other gears feel solid.
Ford Escape / Hybrid :: CEL Code P0403 - EGR Control Circuit Malfunction
After about 6 months I finally got the alternator replaced in the Tribute. I totally forgot about the CEL that was on for EGR Circuit. I've found a couple of pages ( OBD-II Trouble Code: P0403 Exhaust Gas Recirculation Circuit Malfunction ) that explain how to diagnose the issue but I was wondering if any other route for something that may be more common than another thing.
View 2 Replies