Ford Brakes/Suspension :: 1991 F250 - Hard Turning Steering Wheel To Right
I have a 1991 F250 Lariat, 4x4, 460 engine, auto trans. I am having trouble with my steering. The power stering turns good to the left but when I turn to the right it is like there is no power and is very tough to turn.
View 1 RepliesFord - Focus :: 2012 - Grinding Noise When Turning Steering Wheel?
Ford Focus 2012 - 25,000 miles
There's a loud grinding noise from the front end of car when I turn the steering wheel... even when the car is off and in park.I can post videos of the noise if needed.
Volvo - XC90 :: Groaning Noise When Turning Steering Wheel During Low Speeds And Stopped
105K miles, developing a groaning noise when turning steering wheel during low speeds and stopped. Can feel slightly through steering column. No other problems, no clunking or any grinding noises, just "groaning" sound on initial movement. Fluid is full. While searching fix, I found this article on the C70 model, sounds like I might have same thing on my XC90. [URL] ....
View 6 RepliesFord Brakes/Suspension :: 2008 - Steering Tight When Turning From Left To Right And Vice Versa?
I have a 2008 f350, crew cab,6.4L. with 27,173 miles. may have a problem with the steering, seems to be tight when turning from left to right or right to left, doesn't seem to center, if I turn a little to left or right it stays there. I can go in complete a circle. Raised front off ground turns ok no binding, nothing loose on the front end.
View 1 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Faint Grinding Noise In Left Front Wheel
I got a 2001 f350 got a noise in my left front wheel i know its not the wheel bearings, it only makes the noice when the locking hub is unlocked i did jack the the truck up and spun the wheel got a faint grinding noises form what seems like the locking hub so my question is bad locking hub or needle bearing holding the axle shaft??
View 3 RepliesFord Brakes/Suspension :: 2005 - Grinding Noise From Front Intermittently?
Have 2005 excursion. Just did ball joints , wheel bearings all of them, axle joints and seals.Also warn manual hubs. Have a intermittent scraping grinding noise sounds like driver but could be both front.4wd works fine in high or low, no vibration just this annoying noise. took brakes apart and no funny wear or foreign object in dust shield.
View 3 RepliesFord Brakes/Suspension :: Steering Wheel Wobble Back And Forth About A Half Inch Or So
I have a 1993 f150. Problem is that the steering wheel can wobble back and forth about a half inch or so. I took the wheel off and it looks like there is a lock ring holding everything in place. I just wondered if there was a solution to this to fix it
View 1 RepliesFord Excursion :: Big Bang In Front Suspension - Jerk When Turning Steering Wheel To Center
Starting having a problem with the front suspension on my 01 excursion. When you go over a incline I am getting a big bang in the front suspension also when you turn the steering wheel to the middle it has a jerk right before its in the straight position.
I have new wheel bearings and new locking hubs coming, this problem still happens without the hubs in. Could it be a front axle or U joint but it happens with the 4x4 disengaged.
Ford F-150 (2004-2008) :: Steering Wheel Shake When Use The Brakes Especially At Higher Speeds
I've had my 07 HD F150 into the dealer a few times for this issue and they have not been able to repair it. When I use the brakes especially at higher speeds you can feel them turning like a warped rotor, sometimes it will make the steering wheel shake. It does it with both my summer tires (22") and my winter tires (17"). Even at slow speeds you can feel it.
The dealer keeps checking and says that the fronts are fine, last time they machined the rear rotors and said it was fixed. To me the fronts look pretty grooved but they keep saying they are fine. Which didn't make sense to me. The truck stops well and has good feel and power but I get this warped rotor feeling. Is the dealer missing something?
Ford Brakes/Suspension :: 2010 F250 - Steering Wheel Gradually Works Itself Off-Center
I have a 2010 F250 King Ranch FX4. I have an odd problem that I am trying to get to the bottom of. We went on a 2,500 mile road trip last year and I noticed on the way home my steering wheel had worked it's way off center counter-clockwise at a perfect diagonal. I had gotten an alignment right before we left and it was perfect center at that point.
I took it back in when I got home and had a tire rotation and another alignment. Within a week the wheel was off again to the same degree, counter-clockwise at a perfect diagonal.
Two weeks ago... tired and annoyed of driving like this, I crawled under the truck and adjusted the steering wheel to center via the drag link adjustment. I tightened everything down tight and this lasted all of three days.
Wat would cause this? Tires are wearing normally, alignment checks out and it tracks straight. I do see some grease like leakage where the pitman arm meets the top of the drag link and again have some small grease where the drag link connect to the passenger side tire. I lifted the front end and tried to move/wiggle the tires and I have no movement... everything is solid. The truck never wanders when on the road... steering wheel is just off.
Truck only has 90k on it of highway miles and an easy life thus far. I am not hard on the truck.
Passat (B7) :: Grinding Noise When Turning Right At Low Speeds
I have a 2013 Passat TDi SE with about 64000 miles on it and 20 rims. I noticed a grinding noise when turning right at low speeds. It was a very slight noise at first, but has gotten louder over the past 1-2 months. The grinding noise sounds like it's coming from the back of the car and only at fairly tight turning radii, with speeds 10 - 20 mph (think going up the levels of a parking garage). What could this be????
Other things to note:
No other noises, vibrations accompany the sound.
I do get the steering rack creek when turning lock-to-lock, but this sound is definitely not that sound.
I mentioned I have 20 wheels thinking that might have something to do with it. They don't rub at all going in a straight line, however.
Sound is only present when turning right.
Sonata NF (2006-10) :: Grinding And Whirring Sound When Turning Steering Wheel
I get a grinding or whirring sound when I turn my steering wheel left or right. I gets worse if press the accelerator pedal. I believe it has something to do with the power steering but I don't know how to troubleshoot the issue....
View 5 RepliesYaris/Scion & Vitz :: 2004 Echo - Grinding Noise While Turning At Low Speeds
I have a 2004 Echo with the 5 speed manual. Everything is factory original on this car except the tires. (159,000 km). While turning hard to the right at low speeds or pulling away from a stop and turning right, I get a harsh grinding/scraping noise and it seems to be coming from the drivers front wheel. If it was a CV joint, or wheel bearing, wouldn't it make noise all the time?
View 3 RepliesSanta Fe (CM - 2007-12) :: Steering Wheel Will Shimmy When Apply Brakes At High Speeds
I have a 2007 Sante Fe Limited that has 93k on it. Within the last year I have noticed the steering wheel will shimmy when you apply the brakes at high speeds, it's slowly came to the point now that anything above 40mph will cause the steering wheel to shake while applying the brakes. I am guessing I have warped or unevenly worn front rotors. The car supposedly had a break job done at 74k and this started happening at about the 90k mark.
I was looking at these : Front Performance Brake Rotors Posi Quiet Ceramic Pads for Santa FE 07 09
Second question, any tool list or required sockets sizes to complete a front rotor and pad replacement? I have a floor jack, jack stands, a set of 3/8 deep metric sockets. I also have a breaker bar. This is my only car so I want to make sure I have everything I need before I start taking stuff apart.
Ford Brakes/Suspension :: Steering Makes Loud Clicking Noise While Driving?
About 3 weeks ago, I noticed the SUV would occasional make a loud "CLICK" sound in the front steering area, usually if I made a fast turn motion (either left or right).
So today I put it up on a ramp and took a look and it's obvious there's a part in there that is coming loose. I don't know what the names of the stuff is in there, so I'm posting a photo with arrows & letters so people can tell me what's what, and also what to do.
I tried putting a vise grip on it and tightening it with a ratchet wrench on the top part (16mm), but the lower nut just spins. I decided to not go any further because I really don't know what that assembly is, what it does, if it's broke, etc.
Ford Super Duty (1999-2016) :: 2001 - Loose Power Steering When Step On Brakes And Turning The Wheel
Starting about a year ago, "sometimes" when I step on the brakes and am turning the steering wheel, I loose the power steering. I took it to Ford and they said that this is a a known issue but they didn't say what it would take to fix it. Because this problem is intermittent it is very hard to get this fixed unless the mechanic can experience and verify the problem for himself...
View 14 RepliesTiguan :: Steering Making Grinding / Rubbing Noise At Low Speeds
The steering on my wife's 2010 Tiguan makes a bit of a grinding/rubbing noise at low speeds? Something isn't right, it sounds the same way my X5 did when the Rack needed to be replaced. It would be strange to have 2 cars needing new racks within the same year....especially since they are both 2010 model.
View 9 RepliesFord Aerostar :: 1997 - Grinding Noise From Steering Wheel?
'97 Ford Aerostar, 155k miles. Airbag model-
The problem: When I turn the wheel, there is some grabbing and tightness, and a strange grinding noise from the top of the steering column, like, right under the steering wheel. What's more, the wheel will actually pivot up and down on the steering shaft. I have tried pulling on it, and it loosen the grabbing, but it won't pull off in my hands or anything....
I suspect a bearing in the upper steering column has failed or has come loose. I guess I need to pull the bag and look around- Are there any tricks to pulling the airbag?
Corolla / Matrix 2009-13 :: New Brakes Rotors And Pads - Grinding Noise When Turning
I performed brake maintenance today with my brother on my 2010 corolla CE, my front rotors were warped and my pads were used ( and also uneven) and I replaced both front rotors and pads.
The install went smoothly, my brother changed a couple of brakes sets and knew what he was doing and showed me up.
Took it for a spin, the brakes work very nicely ( i bought the ceramic wagner bundle ) but theres a slight grinding noise when driving, like the pads are touching and rubbing a bit too much on the rotor, but the driving is unnafected. Also, there's a sqealing noise coming from either side when you turn only.
Braking itself produces no noise whatsoever, only when you turn that it squeals.