Prius PHEV Plug-In :: Should Upgrade Suspension While Going PHEV?
I am planning to get a Hymotion Plug in Conversion on my '08 Prius soon. Whether or not I should upgrade the suspension? Would upgrading the suspension increase the car's load capacity, compensating for the weight of the new equipment, or just improve handling? Seems like I remember reading that even though the conversion adds about 200 pounds, it is effectively more like adding 300 lbs.
View 19 RepliesPrius (Gen 2) :: Battery Goes From Full Charge To Dead And Back Very Fast
Here's whats going on. Battery goes from full charge to dead and back very fast. Assuming its a battery issue I removed the battery and volt metered every cell
View 19 RepliesPrius Plug-in 2012-15 :: Does ICE Charge Battery When Idling In EV Mode?
I have noticed this, and thought it strange. I don’t see the charging arrows in the display.
View 1 RepliesPrius Plug-in 2012-15 :: No Complete Charge - Battery Not Working?
On my last few charge cycles, the PiP's battery has not been charging completely. Even when I get the "charge complete" message, the top part of the battery indicator remains unfilled and I'm only getting 14.1 estimated range.
For comparison, last month I used to get 15.2 to 15.6 of estimated EV, when the battery icon filled completely after each charge. I always use the charge timer to set charging to finish 10-20 minutes before I need to drive the car.
My M-F routine:
- car finishes charging at 8:30 (13.8-14.1 estimated EV)
- I drive 8 miles to work at 8:20-8:30 (5-7 estimated EV remain, depending on traffic)
- I set charge timer to finish at 6:30 (13.8-14.1 estimated EV)
- I drive 8 miles to home at 6:30-6:45 (5-7 estimated EV remain, depending on traffic)
My weekend routine is obviously different, more driving, more charing, and not using the charge timer. Could it be because i'm not using all the EV so the battery is being lazy and not feeling like charging more than I need? Are there any known side effects of mixing 110V and 220V charging?
Prius Plug-in 2012-15 :: Battery Charge Stacking While Parked
I had been running on EV then parked in the cold to wait for the wife. Turning on the heater started the ICE (of course). It charged the battery about 0.6% then stopped charging, ICE still running. So I switched to HV and it restarted charging about 0.3% and then stopped charging. So I switched back to EV for a few seconds than back to HV and the charging resumed another 0.3%. Once the coolant temperature reaches 130 degrees the ICE stops. Nice heat until the coolant gets down to 118 degrees and the ICE starts again. Back in EV and the battery is charging and the HV/EV switching continues to add more charge. Until time to leave I picked up about 5% SOC, kept warm. Not good for mpg but 5% SOC is nice.
View 19 RepliesPrius Plug-in 2012-15 :: Battery Depletes Quickly From Full Charge Even When Not In EV Mode
I don't plug my PiP in often due to the cost of electricity here, but what I have noticed that when it has a full charge, around 13Miles, it will quickly drop down to 7-8, even when not using EV. Meaning, I start up car, turn off EV and the motor gets warm. Engine shuts off and I drive normally using the ICE. Over the course of a few miles, I'd say about 10, that EV range slowly drops down to 7-8 and then maintains itself around there. Pretty much the whole time I would have been using the ICE to maintain ~70MPH on the highway, not climbing, just flat.
View 6 RepliesPrius (2004-09) :: 14 Blink Code On Hymotion LED - 12V Battery Replacement?
I'm getting the 14 blink code on my Hymotion LED indicating that my 12v battery is needing replacement. My question is that the car seems to run fine with the exception of my mileage is low. I'm ordering the Optima replacement. Can I still drive around for another week without worry?
View 2 RepliesPrius PHEV Plug-In :: How To Run On EV At Speed 52
I have 4kw eng. kit now planning to add one more to it. (parallel) How I can increase my EV speed to 52.
View 15 RepliesPrius PHEV Plug-In :: Using BMS+ To Increase ICE Assist
I have been using a BMS+ with my 4KWH kit for a few weeks now. I want to know if there are any other users out there using a BMS+ with a Engineer Kit. I have found that the BMS+ to increase ICE assist and improve fuel efficiency in highway mode (greater than 70kph). Since most of my driving in is in highway mode I find this device to be very useful.
View 19 RepliesPrius PHEV Plug-In :: EV Mode Won't Stay On
Any additional scenarios that can kick EV mode off? (I have read if the traction motor is above 104 degrees, EV mode is kicked off.)
Could too much (Enginer) power being dumped onto the HV buss (with a fully charged NiMH battery) also kick EB mode off?
Yesterday my NiMH battery was fully charged, all bars greed (don't know SOC because ScanGauge was set to AMPs). Three hours after a lengthy drive on a 70 degree day when I did have difficulty entering EV mode, I started the car, successfully engaged EV mode and the Enginer Kit, was backing out, and the engine immediately started. (No beeps indicating EV mode was turned off.)
My guess would be that after 3 hours of sitting in a shaded and cool garage that the traction motor would not be 104 degrees.
Could too many AMPs going into the PRIUS (not Enginer) DC-to-DC converter with a FULL NiMH battery cause the engine to start to somehow cool the Prius Converter? (It does have a cooling system, right?).
Prius PHEV Plug-In :: Forced EV Mode When Put In D After Turning The Key
I have noticed that when I put my 01 Prius in "D" after I turn the key but, before the ICE starts, it seems to force it into an "EV" mode (the ICE doesn't start, and I can drive on battery only until its charge is way lower than the system usually lets it get). I also get all the warning lights (Triangle, Check Engine and Hybrid Warning). If I pull over, turn it off and turn it back on, the ICE will start and the car will function normally (all the warning lights will still be on unless I cycle the ignition several times). It has happened to me at least 5x in the past two years (only because I'm so impatient and put the car in "D" too fast not because I'm trying to do it).
View 3 RepliesPrius PHEV Plug-In :: 2009 - Cannot Enter EV Mode Now
I have a 2009 Prius with an Enginer 4kwh battery pack. I know that the Prius' programming has a number of parameters that control when it will enter EV mode.
The display says "Cannot enter EV mode now" when engaging my Coastal EV mode switch at times when I believe it should be able to enter EV mode. Here are the conditions from a recent trip:
-Stopped at a light
-The ICE not running
-Car fully warmed up (just drove 10 miles)
-AC off
-Outside air temp 62 degrees
-Battery showing green bars with the top bar white
If I enter EV mode when the car is started cold then it works fine. Once I've driven it a while I can't get it to return to EV mode reliably.
The last time I spoke with my local Toyota dealer they said that because the 2009 American Prius was not shipped with an EV mode switch they would not support that mode.
Prius PHEV Plug-In :: Engine Indicator Won't Indicate Charging
A good thing about Prius PHEV conversions in general is that they mostly don't change the appearance of the car, except for an outlet on the bumper and a switch on the dash.
You can't tell when it's charging and when it's done, without opening the bottom hatch (which may require unloading cargo). The "low battery" indicator can't be seen in daylight.
The charger has a light that turns red when charging and green when charged (or when the battery pack is disconnected). My preference was to move this light to the power connector on the bumper, but this was not practical. Instead, I found that it was very easy to get access to the reverse light in the tail light assembly, without even removing the cover.
Prius PHEV Plug-In :: Check Engine (Malfunction Indicator Light)
Yesterday, I was driving home in EV mode, PHEV on, about 80°F, no hills, not accelerating, SOC about 4 bars, about 1/2 mile out, when it dropped out of EV mode, and then I got the red triangle and the check engine light. Today I grabbed the code with an OBD2 reader, and got this:
Freeze Frame Information:
1. DTC for which Freeze Frame was Stored - P0A92.
2. Engine Coolant Temp - 138.20 °F.
3. Engine RPM - 1,888.00 Rpm.
4. Vehicle Speed Sensor - 14.91 Mph.
5. Intake Air Temperature - 96.80 °F.
6. Time Since Engine Start - 101 Sec.
7. # Warm-ups since DTC Cleared - 74.
8. Distance since DTC Cleared - 706.50 Mi.
9. Control Module Voltage - 13.69 V.
10. Ambient Air Temperature - 80.60 °F.
11. Accelerator Pedal Position D - 30.98 %.
12. Accelerator Pedal Position E - 46.67 %.
13. Time since DTC Cleared - 30 Hr32sec.
Does this happen because it's in EV mode? Do I just have to put up with it every so often? (This is the second time it happened.)
Prius PHEV Plug-In :: EV Mode Audible Sound / How To Stop The Beep
I have got a plug in supply phev kit, and I live in the uk. As the software on the kit is written for the American market, I'm assuming our speeds are a little different, ie, the phev kit always wants to enter ev mode automatically below or at 30mph, and the kit does do this, but our 30 mph speed must be different to the usa, as the kit tries to enter ev mode when I'm doing speeds of over 30mph even up to 35 mph, the the cars software stops this from happening and the audible alarm sounds, 4 beeps, and words on the led state ev mode not allowed because we are of course going too fast.
This is of course quite annoying sometimes when the kit is constantly trying to get into ev mode and alarms are frequent at speeds between 30 and 35 mph, over this speed the kit stops trying to go into ev mode.
The kit is working really well to be honest, and I am very pleased with the way it works. One thing I would like to do is to try to stop the audible alarm when the ev mode is not allowed, is there a way of disabling the cannot enter ev mode chime / beep alarm with software, I do own a techstream light.
I wish the PIS program and software was open source, I could alter the parameter myself then.
One more slight thing that could be addressed is sometimes, but not very often, when I am driving in mixed or blended mode, the oem hybrid battery gets too full of charge and the engine starts to burn off the Excess charge in the battery, again if the PIS program was open source, I could adjust the point at which the kit battery adds into the oem battery, I would drop that parameter a volt or 2 to stop the oem battery going into excess and burn off process.
I must say though, apart from these 2 slight annoyances, the kit is awesome.
Prius PHEV Plug-In :: Chirps On Occasions / Engine Drops Out Under Light Acceleration
For those of you with more experience with the Hymotion pack than I:
1) What does it mean when the car "chirps?" It seems like I get 3 or 4 chirps on occasion, with each chirp itself being a rapid succession of 3 individual chirps? I assume it is something to do with the Hymotion pack because I never heard them before the pack was installed.
2) Under light acceleration, say 1 mph/sec, when the engine is just barely contributing to acceleration, at around 31mph (+/-) the engine stops putting out power (the arrows from the engine disappear), the car noticeably hesitates when the engine drops out, I get 3 or 4 chirps, then the engine comes back "online" about a second or two later and all is well. Under normal (i.e. faster) rates of acceleration, this does not happen.
Prius PHEV Plug-In :: Early System Shutdown - Warning Lights / Error Codes
Have been having cascading problems since installing PIS 10kWh system in April. Early system shutdown, failed BMS boards, then triggering of Prius warning lights. The latter required disconnecting the 12v battery to 'reboot' and cancel them per Robb of PIS. But then, when attempting to do an electrical load test using air con & other accessories, we triggered several yellow warning lights that do no go away with a reboot. Have been told that we need to have a dealer read the codes to troubleshoot.
Read more: [URL] ....
Prius Plug-in 2012-15 :: Scheduled Timer For Plug-in Charge Only Shows Finish Time?
After my 25k service it seems the timer scheduler when the square button is pressed/held flashes at 7am. When i press the H button the hour advances to 12am then closes. I want to start the charge at 12am and finish at 5AM. The timer windows closes when i move the finish hour to 12am and then my regular clock hour changes. It used to be when i pressed/held the timer button the start time would show at 12 am and after setting it would go to the finish hour.
View 8 RepliesPrius Plug-in 2012-15 :: A/C And Heater With EV Charge?
Does the A/C and heater run only with Ice? Or is it able to run on EV alone?
View 12 Replies