Prius PHEV Plug-In :: Engine Indicator Won't Indicate Charging
A good thing about Prius PHEV conversions in general is that they mostly don't change the appearance of the car, except for an outlet on the bumper and a switch on the dash.
You can't tell when it's charging and when it's done, without opening the bottom hatch (which may require unloading cargo). The "low battery" indicator can't be seen in daylight.
The charger has a light that turns red when charging and green when charged (or when the battery pack is disconnected). My preference was to move this light to the power connector on the bumper, but this was not practical. Instead, I found that it was very easy to get access to the reverse light in the tail light assembly, without even removing the cover.
Prius PHEV Plug-In :: Chirps On Occasions / Engine Drops Out Under Light Acceleration
For those of you with more experience with the Hymotion pack than I:
1) What does it mean when the car "chirps?" It seems like I get 3 or 4 chirps on occasion, with each chirp itself being a rapid succession of 3 individual chirps? I assume it is something to do with the Hymotion pack because I never heard them before the pack was installed.
2) Under light acceleration, say 1 mph/sec, when the engine is just barely contributing to acceleration, at around 31mph (+/-) the engine stops putting out power (the arrows from the engine disappear), the car noticeably hesitates when the engine drops out, I get 3 or 4 chirps, then the engine comes back "online" about a second or two later and all is well. Under normal (i.e. faster) rates of acceleration, this does not happen.
Prius PHEV Plug-In :: Should Upgrade Suspension While Going PHEV?
I am planning to get a Hymotion Plug in Conversion on my '08 Prius soon. Whether or not I should upgrade the suspension? Would upgrading the suspension increase the car's load capacity, compensating for the weight of the new equipment, or just improve handling? Seems like I remember reading that even though the conversion adds about 200 pounds, it is effectively more like adding 300 lbs.
View 19 RepliesPrius PHEV Plug-In :: How To Run On EV At Speed 52
I have 4kw eng. kit now planning to add one more to it. (parallel) How I can increase my EV speed to 52.
View 15 RepliesPrius PHEV Plug-In :: Using BMS+ To Increase ICE Assist
I have been using a BMS+ with my 4KWH kit for a few weeks now. I want to know if there are any other users out there using a BMS+ with a Engineer Kit. I have found that the BMS+ to increase ICE assist and improve fuel efficiency in highway mode (greater than 70kph). Since most of my driving in is in highway mode I find this device to be very useful.
View 19 RepliesPrius PHEV Plug-In :: EV Mode Won't Stay On
Any additional scenarios that can kick EV mode off? (I have read if the traction motor is above 104 degrees, EV mode is kicked off.)
Could too much (Enginer) power being dumped onto the HV buss (with a fully charged NiMH battery) also kick EB mode off?
Yesterday my NiMH battery was fully charged, all bars greed (don't know SOC because ScanGauge was set to AMPs). Three hours after a lengthy drive on a 70 degree day when I did have difficulty entering EV mode, I started the car, successfully engaged EV mode and the Enginer Kit, was backing out, and the engine immediately started. (No beeps indicating EV mode was turned off.)
My guess would be that after 3 hours of sitting in a shaded and cool garage that the traction motor would not be 104 degrees.
Could too many AMPs going into the PRIUS (not Enginer) DC-to-DC converter with a FULL NiMH battery cause the engine to start to somehow cool the Prius Converter? (It does have a cooling system, right?).
Prius (Gen 1) :: Check Engine Light Turned On - HV ECU Malfunction
This morning, I tried to start the 2003 Prius and got a 'check engine' light and nothing. The cabin lights were bright so the 12V looked OK. After three tries, I used the VOM and measured 12.55 V on the battery. But the traction battery level looked unusually low.
So I tried again and it started. Using the ScanGauge, no codes were displayed. So I turned the car off and on three times and cleared the "check engine" light. Then I connected the Auto Ingenuity and read out:
P1636 - HV ECU Malfunction on the HV ECU to ECM bus.
C1213 - HV ECU Communication Circuit Malfunction between HV ECU and Brake ECU
P3002 - HV ECU Communication Malfunction on the HV ECU to Battery ECU
So it looks like there was an HV ECU problem that 'cleared while testing.' Certainly it makes sense to inspect the HV ECU connectors and re-seat them and clean out any debris.
Prius PHEV Plug-In :: Forced EV Mode When Put In D After Turning The Key
I have noticed that when I put my 01 Prius in "D" after I turn the key but, before the ICE starts, it seems to force it into an "EV" mode (the ICE doesn't start, and I can drive on battery only until its charge is way lower than the system usually lets it get). I also get all the warning lights (Triangle, Check Engine and Hybrid Warning). If I pull over, turn it off and turn it back on, the ICE will start and the car will function normally (all the warning lights will still be on unless I cycle the ignition several times). It has happened to me at least 5x in the past two years (only because I'm so impatient and put the car in "D" too fast not because I'm trying to do it).
View 3 RepliesPrius PHEV Plug-In :: 2009 - Cannot Enter EV Mode Now
I have a 2009 Prius with an Enginer 4kwh battery pack. I know that the Prius' programming has a number of parameters that control when it will enter EV mode.
The display says "Cannot enter EV mode now" when engaging my Coastal EV mode switch at times when I believe it should be able to enter EV mode. Here are the conditions from a recent trip:
-Stopped at a light
-The ICE not running
-Car fully warmed up (just drove 10 miles)
-AC off
-Outside air temp 62 degrees
-Battery showing green bars with the top bar white
If I enter EV mode when the car is started cold then it works fine. Once I've driven it a while I can't get it to return to EV mode reliably.
The last time I spoke with my local Toyota dealer they said that because the 2009 American Prius was not shipped with an EV mode switch they would not support that mode.
Prius PHEV Plug-In :: Hymotion Battery Dead - Won't Charge Enough
Hymotion battery pack is dead. Won't charge beyond .8 kw max. Doesn't charge enough to offset the cost of the added weight of the pack.
How can I get this "boat anchor" removed.
Prius (2004-09) :: Check Engine And Hybrid Malfunction Light Popped On?
I own a 2005 prius. It is stock and i recently had the check engine light pop up as well as "problem" when car was started and 2 lights with exclamation point, one on a car and ones in lil brackets. I believe it is called a "hybrid malfunction light". Well one day they all pop up and about 3 days later theyre gone. Only thing i did was fill up the tank, when they came on only 1 bar was left on the tank. My question is should i still take it in to see whats wrong with it? and what could of caused both lights to come on?
View 1 RepliesPrius PHEV Plug-In :: EV Mode Audible Sound / How To Stop The Beep
I have got a plug in supply phev kit, and I live in the uk. As the software on the kit is written for the American market, I'm assuming our speeds are a little different, ie, the phev kit always wants to enter ev mode automatically below or at 30mph, and the kit does do this, but our 30 mph speed must be different to the usa, as the kit tries to enter ev mode when I'm doing speeds of over 30mph even up to 35 mph, the the cars software stops this from happening and the audible alarm sounds, 4 beeps, and words on the led state ev mode not allowed because we are of course going too fast.
This is of course quite annoying sometimes when the kit is constantly trying to get into ev mode and alarms are frequent at speeds between 30 and 35 mph, over this speed the kit stops trying to go into ev mode.
The kit is working really well to be honest, and I am very pleased with the way it works. One thing I would like to do is to try to stop the audible alarm when the ev mode is not allowed, is there a way of disabling the cannot enter ev mode chime / beep alarm with software, I do own a techstream light.
I wish the PIS program and software was open source, I could alter the parameter myself then.
One more slight thing that could be addressed is sometimes, but not very often, when I am driving in mixed or blended mode, the oem hybrid battery gets too full of charge and the engine starts to burn off the Excess charge in the battery, again if the PIS program was open source, I could adjust the point at which the kit battery adds into the oem battery, I would drop that parameter a volt or 2 to stop the oem battery going into excess and burn off process.
I must say though, apart from these 2 slight annoyances, the kit is awesome.
Prius Plug-in 2012-15 :: Mileage Is Off - Check Engine Light Comes On
My son got this for his '05 Prius, and I plugged it into my PiP for awhile. I am learning to brake more slowly and accelerate more gradually, but the mileage is obviously way off. That seems to be about all it's good for, unless a check engine light comes on.
View 10 RepliesPrius Plug-in 2012-15 :: Engine Check Light Is On - Hybrid System?
The engine check light is ON this morning. It said that there are problems for the hybrid system on the display. I sent it to dealer immediately.
View 7 RepliesPrius PHEV Plug-In :: Early System Shutdown - Warning Lights / Error Codes
Have been having cascading problems since installing PIS 10kWh system in April. Early system shutdown, failed BMS boards, then triggering of Prius warning lights. The latter required disconnecting the 12v battery to 'reboot' and cancel them per Robb of PIS. But then, when attempting to do an electrical load test using air con & other accessories, we triggered several yellow warning lights that do no go away with a reboot. Have been told that we need to have a dealer read the codes to troubleshoot.
Read more: [URL] ....
Prius (2004-09) :: Master Warning Light, Malfunction Indicator, VSC Came On
I got this exact warning Monday which is discussed in this thread (linked below) and its problem was a bad inverter water pump while mine seems fine: . Also in the linked thread another whom had gotten the exact warning, but inverter pump was not the problem, believed it meant the Hybrid battery was bad and replaced it. , but mine, at least for now, as discussed below, seems fine.
was about to make a trip, 140 miles, gassed up and when leaving station all these (quoted below) warning lights came on. and the car should have been operating in cold condition still as gas station was only a few miles from home. :
Master Warning Light, Malfunction Indicator, VSC, (!), and Hybrid System Warning on Screen.
Prius (2001-03) :: Malfunction Indicator Lamp - Master Warning Light Came On?
I bought a 2001 Prius from a private seller after they had just replaced the Hybrid battery with a Gen II battery and it has been running great until the last few days.
First the Malfunction Indicator Lamp and Master Warning Light came on and my husband and I took it to a dealer. The dealer said the error code was P3000 but didn't know more than that. He said he didn't know if the v12 battery currently in the car is the correct battery and he said it looked like it wasn't secured correctly. He said I would have to take it somewhere else to have it worked on.
When we picked up the car everything was normal again and none of the warning indicators came on. After driving it for about 80 miles both warning indicators came on again. I continued driving the car 15 miles, turned it off for about 5 hours and when I turned it on again only the Malfunction Indicator Lamp came on. At first my gas mileage was unaffected but now it has decreased slightly. I usually get about 41 mpg and I'm getting about 37-38 mpg since we picked up the car.
Lexus ES 2007-12 :: Check VSC Error And Check Engine Light Along With Slip Indicator Showing Up
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
Prius (2004-09) :: Hybrid System Malfunction Indicator And Gas Engine Won't Stay On
I have a 2008 Prius with 106,000+ miles on it. It was running fine till 2 days ago, I didn't start it yesterday and today when i went to start it, I get the Hybrid System Malfunction light, along with check engine, the red triangle and TPMS light. The gas engine tries to start up, then 1 second later makes a grinding noise and turns off.
I am in Toronto and its cold, but not THAT cold yet. So I am doubtful its temperature related. I checked the fluids and they all seem to be sufficient (engine oil, radiator fluid, power steering fluid). I didn't notice any leaks under the vehicle either.