Santa FE SM (2001-06) :: 2004 - Check Engine Light Is On / EVAP Canister Solenoid
I have a 2004 Santa Fe 2.4L the check engine light is on and says about the evap canister solenoid. I am trying to located it but I can't find it. So, where would it be located at so I can take it apart and where is the Canister located as well...
View 1 RepliesPrius (2004-09) :: Red Triangle And Multiple OBD Error Codes
The red triangle warning on my dash recently came on so I am taking it to the nearest dealer on Monday. I think all of this is covered under recalls/warranty. Am I right?
View 4 RepliesPrius (2004-09) :: Engine Shutting Down While Driving - Multiple Codes
Three times recently my 2008 Touring Edition Prius has experienced a shutdown of the engine while driving. Each time I was able to coast and/or use battery power to get to a safe location. The “Triangle-of-Death” and the Check Engine Light was illuminated on the dashboard. Since my car is equipped with a scangauge, I was able to see the codes and clear them on the spot. After restarting the car, it showed no adverse reaction to shutting down and all was seemingly well until the next event. The codes listed below all seem to be communication lapses.
My question is; where do I start in my pursuit to diagnose and repair?
7/15/14 - 98,889 miles U0293 and U0100
7/23/14 - 99,414 miles U0293 and U0100
8/21/14 - 101,065 miles U0100 and U0000
Prius (2004-09) :: 2008 Abruptly Slowed Down And Became Undriveable / Multiple Error Codes
I was driving my 2008 Prius and it abruptly slowed down and became undriveable. I had all of the warning lights - the red triangle master warning light, hybrid syatem warning light, and the check engine warning light. The car had to be towed home. The gas engine starts and runs - driving forward feels like the brakes are on - will not drive in reverse,. I checked the codes and had the following : POA1D, POA78, POA90, and POA94.
View 2 RepliesPrius (2004-09) :: Red Triangle Of Death And Multiple Other Icons On Dashboard - Receiving 5 Codes
While driving to work I received the red triangle of death and multiple other icons on my dashboard. After a few minutes my AC sputtered off. After a few minutes it came back on. This occurred off and on the duration of my drive. I pulled the codes and had P0A93, P3193, C1241, C1313, C1377 come up. The fluid in the pump for the inverter is not moving when the vehicle is turned on.
View 9 RepliesVolvo :: Getting P0442 Code Periodically - Wrong Evap Canister?
I've been getting a P0442 periodically from my 97 850 wagon (base, no turbo). I've replaced the gas cap, the electrical part of the ignition switch, and all the deteriorated rubber vacuum-hose couplings I can find under the hood, but I'm still getting the code. I want to inspect the hose couplings at the evap canister, but there doesn't appear to be any way of getting to them other than removing the canister from under the car. Is there any other access to these?
Also, I've got VIDA running on my PC, and even though I've given it the VIN, it shows me the wrong evap canister in the parts diagrams. It shows the cylindrical canister, but my 850 has the rectangular canister. Where I can view accurate diagrams showing the evap components in this car?
Ford - Windstar :: Location Of EVAP Canister Purge Solenoid?
Where the EVAP canister purge solenoid is located on a 1999 Ford Windstar with the 3.8 engine?? I replaced the vent valve that is located on the canister itself but cannot locate the purge solenoid valve.
View 2 RepliesFord - Explorer :: 1994 - Missing Connector For EVAP Canister
I'm converting the automatic in my 94 explorer to a M5OD-R1 five speed transmission. I got the manual wire harness from the donor truck and it plugs into the existing connectors, but it's missing a connector for the evap canister. Should I just use the automatic harness and modify it to bypass the clutch safety switch and wire a switch for backup lights? Or use the manual harness and wire the evap canister to the ecm? I'm not much of an electrician, just trying to find the correct way to do this so the truck runs good.
View 3 RepliesPassat (B6) :: Evap Flapper Motor Failure And Charcoal Canister Error Code
An MIL light came on the dash the other week while driving. Dealer cleared the error code but next morning it returned. Car is now in the shop to have the flapper motor and canister can replaced. Get it back tomorrow, Got '08 Jetta 2.5 as a loaner. I will run out of warranty in another couple of weeks(48100 mi. on it now).
View 10 RepliesFord Ranger / B-Series :: 2003 V6 - Code P1450 - Location Of EVAP Canister And CV Solenoid
A buddy of mine has a 2003 Ford Ranger Edge V6 3.0L, he got the code P1450 the other day and asked me to look at it. Got all the info on what it could be but where ex actually is the EVAP canister and CV solenoid located? And what is the problem?
View 1 RepliesFord - Explorer :: 1999 - Code P1451 EVAP System Canister Vent Solenoid Circuit Malfunction
I have a 1999 Ford Explorer with the V-6 SOHC that is stuttering and stalling when I try to accelerate. A very slight acceleration will get the vehicle moving, but anything coming close to normal gas pedal pressure causes immediate stuttering and/or stalling. Check Engine light came on when problem started yesterday.
Where is the EVAP System Canister Vent Solenoid? I bought a code reader after beating my head against the truck all afternoon and got code "P1451 EVAP System Canister Vent Solenoid Circuit Malfunction". My Haynes book says on the left side frame rail... can't find anything along there that looks like it (based on picture from Rock Auto for replacement part) and found some people online talking about it being in the engine compartment on the passenger side...
Just crawled all over the truck and I think I found the charcoal canister, but couldn't trace it back to the vent solenoid... There was something right next to the canister, but again, it looked nothing like the replacement part listed on Rock Auto...
Ford Wiring/Electrical :: P1451 Code - EVAP Control System Canister Vent Solenoid Circuit Malfunction
I'm not too knowledgeable about wiring and electrical systems. I'm getting a P1451 code (EVAP Control System Canister Vent Solenoid Circuit Malfunction) on my 99 4.2. I've read that it could be a bad solenoid, bad wiring, or a blown fuse. So far I've;
- checked (and changed) the related fuse
- checked the wiring for damage at the connector
- checked voltage at the connector (12 volts)
- checked the resistance at the solenoid (around 60 ohms)
- actuated the solenoid with a 9V battery (can hear it opening and closing)
I haven't had a chance to check the wiring all the way back up the frame to yet, but I noticed that the ground at the trailer wiring harness has broken off the frame. Would this potentially cause a fault in the upstream wiring? I'm going to slap a new connector on and bolt it back down anyway, but as it's Labour (Labor) Day I'll have to wait for the stores to be open tomorrow.
Prius (2001-03) :: 2002 Check Engine Light Codes For EVAP System And Misfire
My check engine light came on the other day, with no symptoms or problems. Today I stopped at the Auto Parts store and had the codes read. They were P0440, P0441, P0446, and P0301. They are for the EVAP system and misfire.
I had read here that one of the codes could be for the gas cap so I tightened it and then, also as read on here, disconnected the negative 12 V battery cable to perhaps clear the check engine light. I was curious.
When I started the car again, I now have not only the check engine light, but the red triangle exclamation point. How would you proceed? The 12 volt battery is around 5 years old. The entire exhaust system was replaced last year.(not O2 sensors though)
The hybrid battery was replaced at 70,000 miles and I now have 110,000 miles on it. I really wonder why disconnecting the battery and reconnecting it caused more error lights to appear? Also, the Auto parts guy said his code reader was fine for my car but I seem to remember here that there may be a special Prius one.
Ford F-150 (2004-2008) :: Multiple Codes - Random Misfire Detected
I have a 2005 F-150 W/ 5.4 triton, and am having multiple codes. They are:
P0172- System to rich(Bank 1),
P0174- System to lean(Bank 2),
P0300- Random misfire,
P0303- Cylinder # 3 misfire detected,
P0304- Cylinder #4 msfire detected.
Golf IV / Jetta IV :: 2004 - Multiple Fault Codes / Random ASR Light Coming On
The vehicle is a 2004 Jetta MK4 1.8t.
Last thing I had replaced about 2 months ago was the Solenoid valve, the MAF and Solenoid hose. Car ran fine for about a month, and bam...engine light came back on, along with the ASR light. At first it was saying "cat converter" so I researched that, and what a surprise, it spoke about being a $1k piece to replace. NOTHING HAS BEEN CHEAP ON THIS CAR, and I'm losing my mind.
The latest adventure happened today coming back from the gym. Car started jerking (which has been normal since every now and then the ASR light will come on, which I'm told is the traction control light. Causing the car to jerk. Simple fix is pulling over, shutting the car off, and turning it back on. That always clears it, and then I'm back on the road.) but instantly it lost power. It wont shift, but the traction control light didn't come on. I plugged my OBD2 tool up, and came back with these fault codes:
P0420: Catalyst System Efficiency Below Threshold (Bank 1)
P0753: Shift Solenoid "A" Electrical
P2637: Torque Management Feedback Signal A
I'm going to go to these guys tomorrow, but I would just like to get an educated guess on what might be going on, so I don't look like a lost dog while they're figuring out what to do next. These guys seem knowledgeable, but they're missing something since I've been in and out of their shop several times and still getting my traction control light on at random times, and now all 3 of these codes.
Does that Solenoid code have anything to do with the Solenoid valve they put in? I was told that cleaning the throttle body and the cat converter might work. Would those be cheaper options to consider, and see if that works?
I also read that unplugging the alternator and plugging it back in, then cleaning the male and female with electrical cleaner might work. I was told about a month ago that my battery barely passed. Could this be causing any of my issues? I also did a log while I was driving, but all that's showing up is a google map document.
Ford F-150 (2004-2008) :: Truck Started To Develop A Miss - Multiple Codes
Apparently yesterday (no known reason) my sons truck started to develop a miss (so it feels like to me).
2005 f150 5.4 auto 215000km 4x4 stx. No specific cylinder codes. All general codes.
P1000
P1464
P1550
P1703
P1780
None of which I can see causing the miss. No check engine lite, no other codes. Not sure what to look at next. I am starting to disconnect the coil packs one at a time and see if I can pin down the cylinder.
Ford - Escape :: 2004 V6 Misses / Bucks And Jumps - Multiple Check Engine Codes
This is a Ford Escape XLT with the 3.0L V6. I get the following codes - P0316 P0300 P0136 P0305 P0306. Sometimes it runs just fine and sometimes it misses and bucks and jumps. It has been taken to a local shop and they said they found a loose ground at the computer. They said they corrected this and it should run fine. It still shows the same codes and runs like it did before they worked on it.
View 10 RepliesPrius (2004-09) :: CEL Came On, Charcoal Canister Pump Needed To Be Replaced
I just took the car to the dealer, for a recurring Check Engine light, and after changing the gas cover 2 months ago, now they tell me that it needs to replace the Charcoal Canister pump . I have a 2008 Prius, bought used 18 months ago, with approx. 70k miles
View 4 RepliesCherokee :: Evap Line From Fuel Tank Is Partially Missing
I have been replacing brake lines on our old rusty Cherokee when I discovered the evap line from fuel tank is partially missing, rusted away near the back. I have never noticed raw fuel smell, but what issues will this problem cause? I will replace the line if needed which apparently involves dropping the fuel tank.
View 1 Replies