Prius (2001-03) :: Replacing HV Wiring Harness?
Since Toyota didn't have the replacement wiring harness in stock and it took nearly two weeks to get it, and I didn't take a picture of the old one before I removed it, I don't remember where these wires attach!
View 12 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - Got Code P1316 - Injector Wiring Harness?
I have a 2000 Ford F550 7.3. I bought a Superchips programmer to read the codes on my truck and up pops this P1316, so I did some research and found out that the most common problem is the injector wiring harness. I bought new valve cover gaskets and the injector wiring as well because the truck is old and I figured new wires wouldn't hurt.
So after installing the new wiring harness and gaskets I'm still getting this Code! The truck idles rough and serge's sometimes, also there is a lack of power and some shaking between 40 and 50 miles per hour, however form 50 to 60 MPH seem's to be just fine. I don't trust the "Mechanic Shops" around here and will only take the truck in as a last resort.
Ford Ranger / B-Series :: 2007 - Replacing Pioneer Audio System - Dash Wiring Harness?
I'm going to replace the bone stock/non-"Pioneer Audio System" radio with a new Pioneer head unit in my 2007 Ranger Super Cab. After looking at the wiring between the third-party Metra Ford adapter and the supplied Pioneer harness, I'm left with a couple of connections that must be made to other wiring harnesses in the dash.
First up is a wire from the supply side of the parking brake switch; the second is to the supply side of the Reverse lights. These are in the Pioneer harness and both are about 12" long, so I'm guessing the connections can be accessed fairly close to the radio well in the dash.
Installing a new Pioneer radio in their 2007, and where did you pick off those two connections?
Ford Wiring/Electrical :: Moving Engine And Ignition System - Wiring Harness For Further Use?
I plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
Ford 7.3L Power Stroke (1999-2003) :: 2001 - Injector Engine Wire Harness
I'm trying to find a part number for the wiring harness that sits on top of the motor and plugs into the valve cover gaskets. The previous owner replaced the pigtails but the wires were cut so far back that there is virtually nothing left coming out of the harness. What the actual harness looks like other than it has the 9 pin plug on it or whether both sides require an individual harness. What is the part number or picture of said harness. Just in case.... it's a 2001 7.3.
View 14 RepliesFord - Explorer :: 1994 - Wiring Diagram For Fuel Injector?
I'm in desperate need of a wiring diagram for a 1994 explorer fuel injector wiring diagram. I am working on why my injectors are not working ( another thread) and I now need this to back trace all the wires in this loop.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Engine Lost Power - Injector Harness?
So after hitting a pothole, it would seem like half the engine lost power, after some searching around, i found that i would most likely be the harness inside the valve cover that has lost connection.
Its the right side, so i would need to take of the turbo pipe, and probably something else to get to it.
Since i'm doing this job, what to check out along the way? I want my 7.3 to be as reliable as possible.
I will probably ask some questions along the way, it can be a challenge sometimes to own a car that not many mechanics are familiar with, but as i have read online, this should be a very straight forward fix.
Can the harness be upgraded so it doesn't happen again? Its an 02
Subaru - Outback :: 1998 - Engine Wiring Harness Replacement?
My wife's Subaru just died on us. 98 Outback Legacy with quite a bit of miles on it. It was running fine, she took it to the store and then it would not start. It would crank but not fire. Internet searches led me to believe that it was a cam or crankshaft sensor. I go to pull the plug off and the weather beaten wires just snapped....
Turns out my option is splicing a new plug on or replacing the wiring harness. Now, SHOULD we decide to just replace the wiring harness. Is that a rip off?
Chevrolet - Blazer :: Squirrel Chewed Through Engine Compartment Wiring Harness
Click and Clack... When it wouldn't start one day (away from home) he had to keep going back to where it was to try to figure out what was wrong. He came up with a few different diagnoses but came to the conclusion it was the fuel injector inside the gas tank and went online to order one. Once it finally got towed back home, he had a chance to really get a good look and found that all those wires had been chewed and eaten. They're too short to splice back together.
View 11 RepliesDodge - Caravan :: 2003 - Shutting Off While Driving / Engine Wiring Harness And Controller
My 2003 Dodge Caravan is shutting off while I am driving, starts up ok but goes a little and then shuts off, has to cool down all day and night to go about three miles, got a diagnostics done and it says I need an engine wiring harness and controller. My question is, is there a curtain part of the harness or wiring that could be bad that causes it to shut off, and what part would that be, can it be repaired instead of replacing the whole harness and wires?
View 11 RepliesFord Wiring/Electrical :: 1987 F250 - Engine Compartment Harness Smoked
1987 F-250 4x4, 460cid... My engine compartment harness smoked. Do the 1987 models have wiring problems and I need any wiring diagrams that are out there.
View 6 RepliesPhaeton :: W12 Engine Misfiring - Injector Circuit Malfunction Cylinder 7
The engine sometimes has misfiring, and the VCDS reports "Injector Circuit Malfunction Cylinder 7, sporadically". I changed the spark plug, the injector and the ignition coil. So the problem remained and after about 600-800kms the fault came back. Now I moved a little bit the cables of the injector plug and I noticed that the problem is solved, until a few hundred kms were driven. The cyl. 7 is near front side and I could move the cables to the injector plug under the intake manifold.
Now I know, that the problem is the plug of injector (see pics)....
My question.... I bought the plug but it is not the complete like on the pics, it's only the middle part where the cables go in. It has not this sponge-like thing which is in the whole in which goes in the cable. The grey thing which locks the plug is also not in the new plug. Maybe if I have to exchange this small parts on the new plug? I can't imagine how to change the plug, do I have to cut the cables and put them in the new plug. What kind of attachement do the cables have in this plastic plug?
Ford 6.0L Power Stroke Diesel :: Difference Between Injector Harness?
Is there a difference between the two harness #'s here besides the first number:
3C3z9d930aa
4C3z9d930aa
Are they the same part? Is one for a different model truck than the other?
Ford 6.0L Power Stroke Diesel :: 2005 Injector Harness Fit On 2004?
Will a 05 injector harness work on a early 04?
View 1 RepliesNissan - Frontier :: Dripping After Engine Shut Down - Fuel Injector Is Leaking
If after you shutdown a engine, and a fuel injector is leaking. Is there any sign to look for, that can pin point this problem.
View 1 RepliesS-10 :: No Start After Replacing Injector Spider?
I have a 96 ZR2 4.3L VIN W engine. original problem: rough idle, ran pretty good on highway, chk engine lite on, error code P300 random misfire. Just in general maint. I replaced fuel filter first. After replacing injector spider now engine will not start.
View 6 RepliesSonata I45 (LF 2015+) :: Rough Idle With Engine Sputtering - Fuel Injector Failure
My new 2015 Sonata 2.0Twith 8000 miles started running oddly about 2 weeks ago. Rough idle with engine "sputtering". Erratic acceleration -- merging into traffic on highway and car not going over 40mph, even with gas pedal all the way to the floor. On deceleration, clunky down-shifting. Very hard to drive. Dealership first came back with diagnosis of "buildup on throttle plate" (Note - I use only high-quality gas AND only have 8000 miles on car, 3500 or that being one long highway road trip). Then, after 3 days of diagnosis, they say I need 2 new fuel injectors I am baffled how a new car can have either buildup or failed fuel injectors...
View 13 RepliesPrius (Gen 3) :: Not Having Wiring Harness Will Damage The Car?
I will be getting the DDM HID kit and wondering about the necessity for a wiring harness as it seems many are running without it. I am concerned the not having it will somehow damage the car (based on researching HID's in general) but loving the plug and play idea of running without one.
View 2 RepliesCherokee :: Oil Dripping Down Onto ECU Wiring Harness
I have a 1999 Jeep Grand Cherokee 4.0 liter/6 cylinder that has 164K miles. I've kept it in pretty good shape with tons of new parts over the past 3 years or so, and don't want to part with it. However, lately it's been getting horrible gas mileage (about 10 MPG highway), has been running roughly, and smells bad.
Finally took it to the dealer after several attempts by my local, independent shop. Dealer said that the car has been dripping oil down onto the ECU wiring harness for so long that the oil corroded the wires and harness plugs/sockets to the point that they are un-repairable. He said this harness is no longer made, and even if I could find one in a junk yard, it would be "pure luck" to be able to use it and have it work.