Accent RB (2012+) :: Check Engine Light Came On - Purge Valve Replacement
So sometime last week my check engine light came on. Took my 13 Accent to the dealership and they said the purge valve is to be replaced. Now my Accent pings when running 87 gas and I read that others (not necessarily Accent owners) who changed their purge valve noticed the pinging go away.
View 5 RepliesPhaeton :: Won't Start After Filling - Evap Purge Valve?
I have difficulty starting after I fill the tank (usually to about 3/4 fill, not topping off.)
I searched the forums and noticed the evap. system N-80 purge valve may be the culprit. Other VW's have the issue including one thread on a Touareg.
I think I'm the first with this issue on a Phaeton. Sometimes getting loose gas cap faults too and on occasion a CEL. I had a fuel pump replaced last week, but this problem predates the pump failure.
Does this sound like the issue here? Doesn't it throw a code? I'm wondering why they didn't discover it when the diag'ed the bad fuel pump.
Saturn :: New EVAP Purge Valve And Clicking Noise
I have a 2001 saturn l200 2.2... Well I put the new EVAP Purge Valve in last night.. Today I start the car and started to clicking so I unplug the new EVAP Purge Valve and it stop clicking and i plug it back in and started clicking..
View 6 RepliesSonata NF (2006-10) :: 2009 - Evap Purge Valve Location
Where are the canister and solenoid valve located, above the tank? 2009 Sonata 2.4L ....
View 1 RepliesFord Escape / Hybrid :: EVAP Purge Flow Valve Sticking
Replacing part 9C915 ?
"CODE P0443 canister purge fault" diagnosed....
Found: EVAP PURGE FLOW VALVE STICKING
Recommending: "Diag, Replace sensor then retest" ....
They want to install a new 9C915 which they called in hand writing a Canister purge sensor but I've seen it called a canister purge valve on another thread by FIREME who puts 9C915 as "toward the driver's headlight assembly, near the radiator. You'll need an 8mm socket to remove it"...
3.0L DURATEC FFV V6 ENGINE
From the "newly washed ashore" who's now double posting after being flogged for trying to keep this info in a single thread rather than spreading it all over the place...
Ford Escape / Hybrid :: 2012 XLT - Evap Purge Valve Location?
Have a 2012 gas powered Escape XLT, 2.5L 4 cylinder.
I need to replace the evap purge valve. Looking at youtube videos and from other posts it seems easy to replace. My problem is where is it located on this Escape?
Is it under the hood or underneath the driver's side? This is just the valve mind you, not the canister in the back.
Passat (B5) :: Check Engine Light On - Combination Valve?
I brought my 2004 Passat 1.8 in for check engine light-- After checking several things and test driving the car they said the finally found the problem-- the "combinations valve" I searched the forum and below was all I found this under that word combo-- is that the only "combination valve"? This is not something I've heard about before-- are they just saying perhaps 2 different valves?
" Turbocharging System, Overview"
For brake booster
10 - Air filter with Mass Air Flow (MAF) sensor - G70 -
11 - Pressure control valve for crankshaft housing ventilation
12 - Combination valve
Accent MC (2006-11) :: Check Engine Light On / High Purge Flow
For the past couple weeks my check engine light has come on due to the code reading high purge flow sensor. I checked my gas cap, lines that run from motor to the gas tank and the purge flow that's under the intake. Can't figure out what is exactly going on. And it has 53k miles and runs just fine...
View 6 RepliesPassat (B5) :: Purge Control Valve Clicking?
The purge valve keep clicking means it is fail?
View 2 RepliesPassat (B5) :: Check Engine Stays On Majority Of The Time - Evap System?
i have a b.5.5 V6 4motion and My check engine stays on the majority of the time. I've had a tech check the code and he tells me its my Evap system. The same tech told me that it was actually pretty useless to repair the problem unless the check engine light bothers me..
View 5 RepliesPrius (Gen 2) :: Check Engine Light Has Been Going On And Off - Evap System?
So, I have a 2009 IV, and it has about 60,000 miles on it. It's still has it's Toyota Certified warranty.
The check engine light has been going on and off for about 3 months. I hooked up my scan tool, and it says there were a bunch of codes popping up for the evap system. I did the obvious repair and replaced the gas cap (with a Toyota cap), and that worked for a few weeks, but the light came on again.
Since it's under warranty, I took it to the dealer and it turns out the vaccum switch (or maybe pump) for the charcoal canister was bad.
Struck me as a rather strange thing to go bad on a relatively newer Prius.
Anyway, had the water pump recall done while it was there, and hopefully all is good now.
Lexus IS 2014+ :: Check Engine Light Came On - EVAP Error
After only 1k miles after purchase my Check Engine light as come on. P0440 and one other (left the paper at work)
I haven't overfilled on Gas, the Gas Cap is completely on (2 clicks), and I haven't OVERLY pushed the car either haha.
The only update was replacing the STOCK filter with K&N Drop In Filter.
Pontiac :: Check Engine Light On / Evap Leak Code?
I've had a check engine light on in my 3.5 Pontiac G6 for awhile now. It's an emission code (can't remember what code but evap leak). The solenoid by canister was also tripping a code that disappeared after I changed it. However, the evap code still persists. Last night while changing my oil I noticed the intake air hose to the crankcase had broke at the case and wasn't connected. It's the hose that runs from the engine intake to the crankcase for the PCV system.
I am replacing the hose regardless, but my question is; would the intake hose for the PCV system being loose cause an evap leak code? I am thinking no but it'd be nice if it was that simple.
Toyota - Corolla :: Check Engine Light On / Small Evap Leak
I have a 2004 Toyota Corolla- the CEL has been on for months- the code is for small evap leakI have tried cleaning rust from filler neck at gas cap- no change. I have had a smoke test done with no leak found.
View 5 RepliesSanta FE SM (2001-06) :: 2004 - Check Engine Light Is On / EVAP Canister Solenoid
I have a 2004 Santa Fe 2.4L the check engine light is on and says about the evap canister solenoid. I am trying to located it but I can't find it. So, where would it be located at so I can take it apart and where is the Canister located as well...
View 1 RepliesGolf IV / Jetta IV :: Check Engine Light Comes On - Code P0456 For Evap Leak
I have a 2005 1.8 TJetta GLI owned for about 2 months now. Gas cap warning pops up then goes away when I turn off the car then check engine light comes on. I've change the gas cap to new oem one changed the purge valve [URL] .... After a couple of weeks same issues again brought it to my mechanic he ran a leak detector and told me that there are Evap leaks. I read somewhere that I might need a need charcoal canister and a fuel tank.
View 12 RepliesCamry 2012+ :: Check Engine Light On - Codes For EVAP Emission Control System
So mad today. Check engine light came on, plugged in my scanner, got P0441 EVAP Emission Control system Purge Flow Fault and P0455 EVAP Emission Control System Leak (Large).
8-month old '13 TCH XLE is getting a check engine light already.
Prius (2001-03) :: 2002 Check Engine Light Codes For EVAP System And Misfire
My check engine light came on the other day, with no symptoms or problems. Today I stopped at the Auto Parts store and had the codes read. They were P0440, P0441, P0446, and P0301. They are for the EVAP system and misfire.
I had read here that one of the codes could be for the gas cap so I tightened it and then, also as read on here, disconnected the negative 12 V battery cable to perhaps clear the check engine light. I was curious.
When I started the car again, I now have not only the check engine light, but the red triangle exclamation point. How would you proceed? The 12 volt battery is around 5 years old. The entire exhaust system was replaced last year.(not O2 sensors though)
The hybrid battery was replaced at 70,000 miles and I now have 110,000 miles on it. I really wonder why disconnecting the battery and reconnecting it caused more error lights to appear? Also, the Auto parts guy said his code reader was fine for my car but I seem to remember here that there may be a special Prius one.
Toyota - T100 :: Check Engine Light On Due To Faulty Emission Evap Control Pressure Sensor
Engine runs perfectly but "check engine" light" stays on due to faulty Emission Evap control pressure sensor (P/N; 89460-0w020). Problem is Toyota no longer makes this part and there is no after market for it. It appears I may have to "junk" a perfectly good truck.
View 9 Replies