Honda - Odyssey :: 2006 - CV Joint Boots Are Torn / Leaking

The Honda dealer tells me that both of the van's CV joint boots are torn/leaking. Their recommended solution is to replace both front CV axles at a cost of about $500 per axle.

Is replacing the axle the standard repair when the boot is torn, or is the dealer trying to "over-fix" the problem at a greater cost to me? Can't they just replace the boots (at a lower cost, hopefully)?

View 4 Replies

Acura - Integra :: 1999 - Upper Ball Joint Boots Cracking

I get told that both of the front Upper Ball Joint Boots are cracking. Replacement was recommended.

It has 95k miles and never raced - 1999 LS model.

Is this normal on Acura Integra's? Has double whisborne suspension. Should I use Honda part?

View 15 Replies

Subaru - Outback :: 2000 - Replacing Ball Joint And Steering Rack Boots

Our 2000 Subaru Outback has just over 200k. We want a vehicle that is safe, but do not want to put a lot of money into this. At the last service the dealership said the left ball joint boot and power steering rack boots need to be replaced and the rear differential bushings are broken or loose. All of this would be > $1000 to repair. They said that the ball joint could get dirty and fail catastrophically and be a safety issue. Is that right or will the steering start to feel rough beforehand? Can we drive it safely?

View 11 Replies

Ford - Explorer :: 2004 - Upper Ball Joint Boots Are Dry Rotted And Torn

I just noticed that the upper ball joint boots for both uppers are dry rotted and torn! Only 40k miles and the boot falls apart when I touch any portion of it. Is this normal, so much for quality?

Anyway my question is how hard is it to R&R them and do I have time? IOW will the ball joint wear out really fast?

Rust bubbles front of hood both corners, the tranny thing, now the ball joints all within 40k miles. rear glass trim breaks and falls off.

View 4 Replies

Lumina :: How To Replace The Lower Ball Joint

1999 Lumina / I need to replace the lower ball joint. The original one is installed by 4 rivets.

According to the factory service manual, you need to use 1/8 drill bit to open a pilot hole, then use a 1/2 bit to finish it.

View 10 Replies

Ford Super Duty (1999-2016) :: How To Remove Driveshaft To Replace U-Joint

Rear-most connection before pumpkin, need to replace the U-Joint. I got the four bolts out at the flange but the shaft won't drop. I beat on the connection a bit, not enough to hurt though. What am I missing? How the heck do I get this apart and drop the shaft to replace the U-Joint???

View 9 Replies

Passat (B6) :: 2006 - How To Replace Battery

Can I replace the battery in my 06 Passat myself? I've been told that I must take it in to the dealer to have it done, so they can reprogram the car. Doesn't sound right to me.

View 2 Replies

Passat (B5) :: 2003 - CV Boots Are Shot

Went in for a tune-up and inspection on my 03 1.8 passat. Turns out my cv boots are shot. How much should I expect to pay for parts & labor, I will not be going to the vw stealership to get this done. It's just the fronts that need to be done.

View 11 Replies

Passat (B5) :: CV Boots Are Twisted And Leaking

My girlfriend and I replaced both of thee axles on her Passat this past spring. She just brought her car in for a oil change and the mechanic noted that both outer CV Boots are twisted and leaking and the right front sway bar link has some play. Do these two could problems could be connected? Is the sway bar link a replace able part?

View 1 Replies

Passat (B6) :: 2006 - How To Replace Wiper Motor

Have to replace the wiper motor in '06 Passat 2.0T? Do you need some type of puller to get the wiper arms off the spindles so the black plastic cover can be removed to access the wiper motor?

View 4 Replies

Passat (B5) :: Drive Axle Boots Ripped

So I went to rotate my tires today and noticed grease around the inside of the rim to which i then noticed that my Drive Axle Boots are ripped. I noticed the grease around the wheel well last time I changed my oil and thought it was something I drove through. I guess Not How much should this job cost? I called the mechanic and he said because there is no "clicking" noise when I turn that he can replace the boots and add grease and it should be fine but that job will cost $500, $250 for each side. Should I stop driving the car right away?

View 13 Replies

Passat (B6) :: 2006 - How To Replace Factory Radio / CD System

I got a OEM GPS,TV,DVD,BLUETOOTH, iPod controller ALL-IN-ONE device and donot know how to install. My car is 07 passat and I read a thread showing 2006 Passat Radio Removal Write-Up... If I wanna go further, what else I have to remove so that I can do more wiring jobs.

View 5 Replies

Sonata NF (2006-10) :: Steering Rack Leaking From The Two Boots At The End

The steering rack on my 2009 Sonata was previously replaced under warranty but now it start to leak seriously.from the two boots at the ends of the steering rack ends. Is it possible to replaced seals only where it leaks?

View 13 Replies

Passat (B5) :: Can't Remove Cv Joint Boot

I have a 2004 1.8T 4Motion (automatic) that blew a CV joint boot. After inspection of the other side, I decided to replace both (just the outer boots). Got the axles out without much trouble but now I cannot drive the joints from the axles. I've tried both and neither is cooperating, I've knocked out off them with a mallet but they aren't budging. Is there something to do besides just driving them off?
Axles are tubes (hollow) p/n's 8D0 407 271 (& 272) ED.

View 10 Replies

Passat (B6) :: CV Boot Joint Minor Leak

How hard to replace it? I found a minor leak from left crimp clamp, the grease leaks all around it. It looks not too bad, but the grease will leak all out later. I thought there is repair kit on ECS, It seems I can replace brake pad,rotor and cv boots joint in the same day.

View 17 Replies

Passat (B5) :: Clicking Noise From CV Joint While Parking

I noticed a clicking noise while parking my car this weekend and looked to see that indeed my CV boots were torn and grease is everywhere. I know the easiest way to go is to replace the axle....

View 12 Replies

Passat (B6) :: 2008 - Driver Side CV Joint Removal

Looking for a good DIY video on removing drivers side cv joint, my joint broke and I removed it however the inner joint inner spline is still in the trans, there is a c clip on the shaft of the new cv joint that I'm assuming is holding it in. I just don't know if pressure is all I need to pull it out.

View 2 Replies

Passat (B6) :: Oil Dripping From Joint Between Inter Cooler And Turbo

Not sure whats going on here. Could this be normal and I've just never seen it? I dont see oil ANYWHERE else under there. Just in this 1 spot.

View 3 Replies

Passat (B5) :: CV Joint Or Axle On Driver (right) Side Blew Out While Driving

Just to clarify, I've got a UK spec B5 wagon, manual, 1.8T (AEB, I believe) and it's a 2000. Last night when I was driving home, either my CV joint or axle on the driver (right) side blew out. Needless to say, I'm going to replace my axles or just the outer joints, but I've been shopping around and I'll find parts that will fit an A4 with a 5 speed and AEB but not a Passat, or parts that fit strictly AUG or ATW engine codes. How would I go about finding which axle will actually fit my car?

Here's a video so you can hear the noise : [URL] .....

View 1 Replies