Passat (B6) :: Wrong Screw Twisted Now Fog Light Alignment Is Off
When I installed my HID's in the fogs I twisted the heck out of the alignment screw (the one accessible at the fog grilles). How to properly level it? Factory setting.
View 1 RepliesLexus GX 2004-09 :: Axle Boots Leaking?
Looking for DIY replace the Axle Assembly. I noticed a bunch of grease splattered on the low control arms both sides. Replace the inner and outer boots or have to replace the whole assembly?
View 9 RepliesSonata NF (2006-10) :: Steering Rack Leaking From The Two Boots At The End
The steering rack on my 2009 Sonata was previously replaced under warranty but now it start to leak seriously.from the two boots at the ends of the steering rack ends. Is it possible to replaced seals only where it leaks?
View 13 RepliesHonda - Odyssey :: 2006 - CV Joint Boots Are Torn / Leaking
The Honda dealer tells me that both of the van's CV joint boots are torn/leaking. Their recommended solution is to replace both front CV axles at a cost of about $500 per axle.
Is replacing the axle the standard repair when the boot is torn, or is the dealer trying to "over-fix" the problem at a greater cost to me? Can't they just replace the boots (at a lower cost, hopefully)?
Lexus GX 2004-09 :: 2005 GX470 Front Axle Boots Leaking
A Lexus dealer in NJ told me my 2005 GX470 front axle boots leaking, they gave me a quote to re-build both side.
View 9 RepliesPassat (B5) :: 2003 - CV Boots Are Shot
Went in for a tune-up and inspection on my 03 1.8 passat. Turns out my cv boots are shot. How much should I expect to pay for parts & labor, I will not be going to the vw stealership to get this done. It's just the fronts that need to be done.
View 11 RepliesPassat (B5) :: Drive Axle Boots Ripped
So I went to rotate my tires today and noticed grease around the inside of the rim to which i then noticed that my Drive Axle Boots are ripped. I noticed the grease around the wheel well last time I changed my oil and thought it was something I drove through. I guess Not How much should this job cost? I called the mechanic and he said because there is no "clicking" noise when I turn that he can replace the boots and add grease and it should be fine but that job will cost $500, $250 for each side. Should I stop driving the car right away?
View 13 RepliesPassat (B6) :: How To Replace CV Joint Boots On 2006 VW 2.0T
I went to get my tires rotated and the mechanic noticed that the right outboard CV Joint boot on my passat had a little tear in it, but the grease hadn't leaked all out. I replaced both the outboard and inboard CV Joint Boots. Below is a nice link for DIY step by step write up with great pictures.
[URL] .....
Golf/GTI VII :: Passenger Seat Belt Is Twisted?
So my passenger seat belt looks twisted. The little "tongue" on the inside is still pointing towards the pillar but the belt itself is twisted and hard turns it hits the plastic and makes noise. I tried twisting it and running the buckle through it. That didn't do the trick.
View 9 RepliesGolf/GTI VI :: Noisy CV Boots When It Rains?
Do the wet boots make a clicking/rubbing type noise when turning on your car? It happen on my 2012 GTI, but only when it rains. It's really loud when I turn inside a parking garage. It's definitely not the joint itself, but rather is the rubber boot sticking to itself and releasing on the compressed side of the boot during the turn. No other car of mine has made this type of noise, even those with cheap Chinese aftermarket axles.
View 7 RepliesGolf IV R32 :: Both Outer CV Boots Ripped
So I finally got a chance to pull the front wheels off the car yesterday and noticed that BOTH outer CV boots are ripped and there is grease everywhere. How long this has been going on for but I haven't noticed any grinding or popping noises yet so hopefully they're still good.
I've checked on ECS Tuning and they have replacement boots, OEM ones. I'm honestly really low on funds, and would like to opt for the cheaper ones but wondering if I will regret it,
Also, as far as replacing the boots go, I'm sure it's easiest just to remove both axles correct? Do I need any special tools for this job? Any DIYs? This is my daily so I will have to drive it like this for the time being although I really don't want to.?
Corolla / Matrix 2009-13 :: Suspension Boots Torn
2009 Corolla has both front suspension boots torn to pieces...Is this something that can be replaced without replacing the entire strut?
View 1 RepliesCamry :: 2007 CE / 4cyl - Rubber Boots On Both Front And Rear Struts
I have 2007 Camry CE, 4 cyl, 102,500 miles. The rubber boots on both front and rear struts can be easily lifted with a screw driver to reveal the shiny shaft. Strut seems be pass the 'fast brake' test (no bounciness). There is oily residue on the strut body. Is that normal? If replacement is needed, should I go with Monroe or other brand. I want the original Camry ride.
Brake pads seem to have 3/16"-1/4" thickness left. All equipment is original.
Acura - Integra :: 1999 - Upper Ball Joint Boots Cracking
I get told that both of the front Upper Ball Joint Boots are cracking. Replacement was recommended.
It has 95k miles and never raced - 1999 LS model.
Is this normal on Acura Integra's? Has double whisborne suspension. Should I use Honda part?
Ford Brakes/Suspension :: 2003 F250 - Changing Pad - Retract The Boots?
Trying to change the pads on my 2003 F250. One of the boots is not retracting smoothly. Any recommendations?
I can't get the caliper to bolt back on and I think this is the issue.
Subaru - Outback :: 2000 - Replacing Ball Joint And Steering Rack Boots
Our 2000 Subaru Outback has just over 200k. We want a vehicle that is safe, but do not want to put a lot of money into this. At the last service the dealership said the left ball joint boot and power steering rack boots need to be replaced and the rear differential bushings are broken or loose. All of this would be > $1000 to repair. They said that the ball joint could get dirty and fail catastrophically and be a safety issue. Is that right or will the steering start to feel rough beforehand? Can we drive it safely?
View 11 RepliesSubaru - Outback :: Grinding Noise And Vibrating After Front Axles / Boots Replaced
What would cause noise grinding type and feeling after having axles/boots replaced this morning on my 2005 Outback.Car seems noisy and vibrating
View 5 RepliesSubaru - Outback :: 2008 - Leak In Head Gasket / Axle Boots Cracking
I have a 2008 Outback and I just got news from my repairman that says there is a leak in the head gasket and one of my axle boots is cracking. The axle boot is not the major concern, but is it worth it to spend $ to get it fixed or should I say "Hasta La Vista" and look into buying a new car? I hit a deer and thoroughly damaged the front end about a year and a half ago and I am not sure if that has "shakin' things up".
I currently have about 85K miles on the car. I don't mind repairing the car if it doesn't turn into the Money Pit.
Ford 7.3L Power Stroke (1999-2003) :: 2001 F250 - Intercooler / CAC Boots
I have a 2001 f250 7.3 and I had started to notice I wasn't making as much boost I thought I should have been. I looked around and found a tear in the cold side CAC boot. My question is what is the best option for replacing it, something like RiffRaff or oem? Also should I look at replacing all the boots or just the two up top?
View 14 Replies