Passat (B6) :: CV Boot Joint Minor Leak
How hard to replace it? I found a minor leak from left crimp clamp, the grease leaks all around it. It looks not too bad, but the grease will leak all out later. I thought there is repair kit on ECS, It seems I can replace brake pad,rotor and cv boots joint in the same day.
View 17 RepliesPassat (B5) :: 2004 - How To Remove Shift Boot From Knob
I'm trying to swap out the shift boot of my 2004 (B5.5) Passat 1.8T 4Motion and running into trouble. According to the instructions from the new Red Line shift boot, I should be able to separate the two collars that hold the boot to the knob. However, the white post that's part of the knob assembly has a piece that's bigger than the lower black collar, preventing it from being removed. Is there something I'm missing? How can I remove the boot without damaging the existing knob assembly?
View 7 RepliesGTI 337/20th Anniversary :: Inner CV Joint Boot Cover Won't Come Off
Trying to do new boot kit on inner cv joint. I have the ball and cage type inner joint. The joint cap comes off really easy (and a new one comes in the boot kit). The boot cover doesn't come off so easy (and there is no replacement in the boot kit). Bentley's and pretty much every other source of info says to carefully drive off the boot cover to remove cage. But they all pretty much gloss over how to do this carefully. I've hit it a couple of times with a screwdriver blade and hammer, but it's not budging. Trying not to hit it too hard.
View 6 RepliesSubaru - Outback :: 2006 Occasionally Smell Something Burning - CV Joint Boot Leaking?
I believe that I have a leaking CV joint boot in my 2006 Outback. Occasionally smell something burning. Lifted hood and had some smoke. Saw leak and a friend stuck a finger into a hole in the boot.
View 9 RepliesFord Super Duty (1999-2016) :: How To Remove Driveshaft To Replace U-Joint
Rear-most connection before pumpkin, need to replace the U-Joint. I got the four bolts out at the flange but the shaft won't drop. I beat on the connection a bit, not enough to hurt though. What am I missing? How the heck do I get this apart and drop the shaft to replace the U-Joint???
View 9 RepliesGolf V R32 :: Separate Boot From Knob To Install New Boot?
I'm repainting my peeling shifter trim plate and replacing the shift boot with a new one. Lots of support available on removing the shifter and disassembling the trim plate, but no clear instructions on how to remove the boot from the knob. It looks like this inside:
How do I separate the boot from the knob to install a new boot? The only instructions I found showed a metal collar which is not the case in our cars.
Passat (B5) :: How To Attach Inner Tie Rod Boot To Steering Rack
I'm going to replace tie rods assembly. I have a question about inner tie rod boot. How do you attach it to the steering rack? No room there, horrible access.
View 1 RepliesPassat (B5) :: CV Boot Split Open With Grease / Oil Everywhere
While changing over to snow tires yesterday, I noticed the driver's side CV boot was split open with grease/oil everywhere.
Questions:
How urgent is this repair? Is the car drivable for a short while until I can get it fixed?
How much might I expect a CV boot replacement to cost?
Passat (B6) :: How To Replace CV Joint Boots On 2006 VW 2.0T
I went to get my tires rotated and the mechanic noticed that the right outboard CV Joint boot on my passat had a little tear in it, but the grease hadn't leaked all out. I replaced both the outboard and inboard CV Joint Boots. Below is a nice link for DIY step by step write up with great pictures.
[URL] .....
Passat (B5) :: Clicking Noise From CV Joint While Parking
I noticed a clicking noise while parking my car this weekend and looked to see that indeed my CV boots were torn and grease is everywhere. I know the easiest way to go is to replace the axle....
View 12 RepliesPassat (B6) :: Outer CV Boot Cracked During Brake Bleeding
I was bleeding my brakes today and when I took off the wheel on the driver side, I found grease on my rim. I can't believe that my outer cv boot is cracked for a car with less than 57K miles.
View 16 RepliesPassat (B6) :: Releasing Shift Knob And Boot From The Transmission?
How to release the shift knob and boot from the transmission stalk on a B6 Passat automatic?
View 1 RepliesPassat (B6) :: 2008 - Driver Side CV Joint Removal
Looking for a good DIY video on removing drivers side cv joint, my joint broke and I removed it however the inner joint inner spline is still in the trans, there is a c clip on the shaft of the new cv joint that I'm assuming is holding it in. I just don't know if pressure is all I need to pull it out.
View 2 RepliesPassat (B6) :: Oil Dripping From Joint Between Inter Cooler And Turbo
Not sure whats going on here. Could this be normal and I've just never seen it? I dont see oil ANYWHERE else under there. Just in this 1 spot.
View 3 RepliesPassat :: 2006 - Vibration In Front Right Part Of Car After Boot Replaced
I recently had my front right boot replaced due to a hole. After being replaced there was a vibration in the front right part of the car (same place as where the boot was replaced.) Now I brought the car back to the shop where the boot was replaced, and they told me this vibration was caused by a bad wheel bearing in that section. After the shop replaced this bad wheel bearing, the problem still existed. Now this vibration happens only when I accelerate to 3300-3500RPM, and occurs at times when I make turns. What this might be or how this is caused?
View 1 RepliesPassat (B6) :: Fuse Locations For 12V Supply In The Center Console And The Boot
On a trip I managed to pop both the fuse in the rear of my 07 B6 Variant and also the one in the rear of the center console. Checking the manual indicates a 20A fuse in both position 33 and 35 in the right hand fuse panel. Following the numbering scheme in the manual there were no fuses of that value there.
What are the correct position numbers. Also following the other threads my power outlets were switched with the ignition.
Passat (B5) :: CV Joint Or Axle On Driver (right) Side Blew Out While Driving
Just to clarify, I've got a UK spec B5 wagon, manual, 1.8T (AEB, I believe) and it's a 2000. Last night when I was driving home, either my CV joint or axle on the driver (right) side blew out. Needless to say, I'm going to replace my axles or just the outer joints, but I've been shopping around and I'll find parts that will fit an A4 with a 5 speed and AEB but not a Passat, or parts that fit strictly AUG or ATW engine codes. How would I go about finding which axle will actually fit my car?
Here's a video so you can hear the noise : [URL] .....
Passat (B5) :: 1999 - Lower Control Arms Breaking At Ball Joint?
My daughter has a 1999 Passat 4cyl.... In the last year I've had 2 lower control arms at the front ball joints just break away. Lucky it has been when she was either stopping or at very slow speed.
On inspection this looks like a very unsafe design flaw. The aluminum control arm is strong except for the light metal around the ball joint it's self. If one of these let go at speed it could be fatal!!
What causes the break other than normal wear and is there any signs before one lets go?
Passat (B6) :: How To Remove DRL
Without vagcom?
View 8 Replies