Elantra HD (2006-10) :: How To Clear The Airbag Signal
My 2010 Elantra sedan had an accident, the airbag and driver side seat belt was deployed. And the airbag light is on after that, beside the Hood and the headlight panel is curved, nothing is wrong. The people is also safe.
I bought an airbag and replaced it, and went to a body shop to clear airbag signal. That guy said my seatbelt was still need to be replaced, since he can only clear one signal, there was another signal there.
Several days later, I bought a seat belt and replaced it, and wen to him again. He said there is no signal there, but the airbag light is still on, there should be something wrong somewhere.
My hood is still cured, but nothing is wrong with it. What can I do? The signal doesn't bother me, but I think it cannot pass the inspection.
Santa FE SM (2001-06) :: Code B1382 - Airbag Light Came On And Will Not Clear
2003 Santa Fe GLS 120K mi. 2wd, 2.7L, AT.
Been having for some time an intermittent problem where the air bag light will come on and not clear. I can clear it sometimes by removing the neg. batt. term. and letting it sit for a few minutes. The "air bag" light always seems to come on when someone sits in the passenger seat. The dealer reported a trouble code of "B1382-- PSAB harness improper pin tension" They said that they re-seated a connector and it was good to go. Now the "air bag" light is on again. Does the description refer to the pin tension in a connector? which connector does it refer to and can I just tighten up the female part of the connector such that the male pin makes better contact? Is it the yellow connector under the seat?
Santa FE SM (2001-06) :: 2003 2.7L - Airbag Light Won't Clear And Stays On
2003 Santa Fe 2.7L, 2WD, 118K Mi.
This is a recurring problem. Air Bag light comes on and stays on. Seems to always get triggered by someone sitting in the front passenger seat AND the right side rear passenger seat. First couple of times I was able to clear it by removing the neg. battery terminal for 30 to 45 min. Then it stayed on and didn't clear. I took it to the dealership and they said they cleared it by cycling the connector behind the glovebox. It has been ok for a long time until yesterday night when I had 5 people in the car. Now this morning the "Air Bag" light is on and won't clear. I tried disconnecting the neg. battery terminal because it was easy to do but no luck. I have checked the connectors under the passenger seat thinking someone is bumping a connector with their feet but all connectors seem ok.
Passat (B5) :: ABS And Airbag Lights Came On Whenever Start The Car
whenever i start my car the abs and airbag lights comes on and stays on at 1st it used to be the abs light only then sometimes while driving it would go off and then comes on back. but now its both the abs and air bag lights that comes and the abs goes off from time to time but not the air bag ...
View 2 RepliesPassat (B7) :: Airbag Error And No Interior Lights
I went to a stereo shop to have all my doors covered with DynaMat. They did a great job there but now I have an airbag error. How do I reset this? I do have a VCDS cable. I know it was because the battery was not unplugged before the door trim was removed so I'm not that worried, just wondering if VCDS can take care of it or I MUST go to the dealer.
My other issue are the interior lights. I had them all replaced with LED bulbs and when I left the shop I turned the map lights on and all was good. I left the shop to put some fuel in and when I started the car again I had no lights. Now NONE of my interior lights go on. What Happened? I've seen plenty of people with LED bulbs in their cars so I didn't think anything could go wrong? Do I just go back to the stock bulbs?
Passat (B5) :: 2001 With Airbag / Flashing Oil / Brake / ABS Lights And No Tach
So I have a 1.8 5spd wagon which flooded out the comfort control module. I got another CCM but I still have a flashing oil pressure light. a flashing brake warning, a solid ABS light and an airbag light. The tach doesn't work and the MFD only occasionally works. Before I replace the ABS module I would like to eliminate anything else that might be in common with all these systems, is there a hidden fuse anywhere or a relay?
I tried unplugging the ABS module and it didn't change anything, do I need to code the CCM it has the same numbers on it but even after replacement the power windows still don't work even though the door locks, mirrors, and dome light on all but the drivers door ( I assume the micro switch is bad)work now, also the car starts.
Passat (B6) :: Airbag Fault And Tire Sensor Lights On After Sound System Installed
Why my low pressure light is on and why my mfd is telling me I have an airbag fault? Where would I want to start diagnosing this problem? I ran power and ground wire with no sensor issues, but once the remote and RCA wires were connected I got the sensor issue.
View 10 RepliesLexus GS 2006-11 :: VSC / ECB Lights Came On When Changing Brakes - How To Clear
This is how to clear the VSC, ECB light... I just did it my 06 GS430 after changing my brake pad and the lights came on.
If the code is able to be cleared, jumper connectors TC and EG (PINS 13 and 4)at the DLC 3 and press the brake 8+ times in 5 seconds. The pic and description below is just for reference and not the pins you need!
Lexus LS 2007+ :: 08 LS460 - How To Clear Warning Lights On Dash After Battery Go Low And Set Off
A little over a week ago I had my battery go low and set off several brake warning lights on the dashboard. I have a very trusted mechanic and had him look it over. There were no issues whatsoever with the braking system and the lights simply occurred due to a drop in battery voltage. My question would be how to clear the lights. I have seen various people use something called a techstream and was wondering if this would be viable in my situation. If so what is the most updated version of the tech stream as well as a possible tutorial. Below for reference is a picture of the lights that were set off on the dashboard(circled). The dash isn't mine just one that I found but the four lights in question are the same.
View 7 RepliesElantra MD (2010-15) :: How To Install Load Resistors In Front Turn Signals
How to install load resistors in the front turn signals to fix fast blinking after led changing? I have two 6 ohms 50 watts resistors but I don't know how to install in the front turn signals.
View 7 RepliesFord 7.3L Power Stroke (1999-2003) :: Re-soldered The Resistors Back Down - Display Still Dim
Have taken it out about 4 times and re-soldered the resistors back down. I think I probably fried one. The display is still so dim that you have to look real close to see it.
View 14 RepliesPassat (B5) :: Clear Coat Is Peeling In The Thin Gutter
On my 2001 Passat the clear coat is peeling in the thin gutter area between the roof and area above the doors. Its only on the passenger side.
View 2 RepliesPassat (B6) :: Cannot Get Steering Assist / ABS Fault Codes To Clear
I have followed the process for clearing and resetting the Steering Assist/ABS fault codes. I have done all the steps several times and cannot get the faults to clear, although the VAG-COM indicates all is green during the testing phase.
[URL].................... And the faults will not clear.
Here is the scan results, (non-fault sections removed):
VAG-COM Version: Release 704.1
Data version: 20070422
Sunday,03,June,2007,17:47:17:25986
Chassis Type: 3C0
Scan: 01 02 03 08 09 0F 15 16 17 19 1C 25 36 42 44 46 47 52 53 55 56 62 65 72 76
[Code] ....
Passat (B6) :: TPMS Error - Clear Coat On Wheel Peeling Off
I got our car back from the dealer for catalytic C. Replacement and the pressure tire light was on. Check tire pressure in the morning and went up to 40psi to see if they reset. No luck.
Lower back to normal after three weeks all tires including spare are at 33psi. Also, the clear coat on my wheels is peeling off.2006 2.0T 85K Miles.
Passat (B7) :: 2012, 2.5 SE - Clear Coat Peeling Near Trunk / Rear Panel Area
My MY2012 Passat 2.5 SE currently at 37k miles all of a sudden is showing clear coat peeling near the trunk/rear panel area. Car is a CPO and clean carfax (no accidents) and currently still under warranty. Planning on taking it back to the dealership and hopefully start a case for warranty work under VWoA.
I've never encountered clearcoat failure this early on, case in point my B5 (MY1999) still has excellent clear coat uniformity despite the paint/body being 17+ years old.
Camry :: 2004 Solara - Both Airbag Lights Are On
I have a 2004 Solara and both airbag lights are on. The red dash light and the passenger sensor says off. It is giving codes B1785 and B1650 which I am told are air bag module codes.
View 3 RepliesElantra XD (2001-06) :: TCM / ABS / Brake And Airbag Lights On At Once
I have a 2002 Elantra and all of the TCM, ABS, AIR BAG and BRAKE lights come on as soon as I push the throtle and the car starts moving forward. I looked inside the owner's manual but all it says is that if all these lights come on at the same time and stay on the car needs to be taken to the dealership ASAP.
View 4 RepliesLexus RX 2004-09 :: 2007 RX350 - Airbag Lights Comes On Once In A While
My parents have a 2007 RX350 and they had the airbag light come on once in a while. I have the car right now so I could figure out the issue for them and get it fixed.
The light wouldn't come on for the first couple days and it off today for a while until I move the seat fully backward and then forward. After I restarted the vehicle the light came on.
I got to work and tried tightening all connectors under the seat and the light did go off and stay off but I didn't drive it after that.
When the light is on it blinks in the 1-second on / 1-second off pattern. When my dad's friend-mechanic checked it out, he said that the description of the code he could read was something like "open [squib] circuit connector", unfortunately, he can't remember.
Lexus GS 2006-11 :: Seatbelt And Airbag Lights Keep Flickering On And Off
Just recently bought the car a month ago. This car has been giving me a lot of headaches. First my radio unit wouldn't work properly. Just started my car today and my gauges are flickering. Seatbelt and airbag keep flickering on and off. AC says 32.0 temp and wont let me adjust it. Passenger windows don't work. Driver window goes up and down but isn't automatic anymore. I have to hold it both ways.
View 14 Replies