Passat (B6) :: CEL Turned On - Car Running Too Lean
My CEL turned on about 2 weeks ago. I took it to autozone and they ran it, and it came up as that my car is running too lean. Would this have to do with my MAF sensor? Also, It seems that my car is also burning oil. I have a 06 passat 2.0T.
View 24 RepliesPassat (B5) :: How Much Boost Without Running Too Rich / Lean
How much boost can you push on the stock turbo without it running too rich or lean?
View 3 RepliesMazda - Protege :: 1996 - Lean Running Condition
I own a 1996 Mazda Protégé with 128,000 miles. I had it in for a check of a sewing machine sound. The mechanic tested it and found, among things, a "lean running condition". What does that mean?
View 4 RepliesFord - Ranger :: 1998 - Fuel Running Lean?
1998 ford ranger 4.0 ... fuel running lean ... how do you adjust it??
View 3 RepliesTiguan :: CEL Code P2187 / Running Lean At Idle
Driving home yesterday and a check engine light came on while I was at a stoplight. When I got home I plugged my scanner in and came up with a P2187 code, running lean at idle. Cleared the code and went inside to start doing my google homework.
Looking around various threads I'm leaning towards the PCV valve being shot. Seems like they go quite a bit and it describes quite a few of my problems going on; CEL, lumpy idle, and a bit sluggish.
Currently at 50k miles on my 2011. I've been Revo stage one for about 7k if that makes a difference too.
GTI 337/20th Anniversary :: CEL On - Code Is Running Lean With A Base One
I was parking today and when i looked up my CEL was on. So I got the code pulled and it turns out I'm running lean with a base one. I think it was? the mechanic told me it was my o2 sensor but I'm not sure which one it may be whether it be before or after the cat?
View 5 RepliesFord F-150 - 1997-2003 :: Running Too Lean On Both Banks
My F150 5.4 V8 is running to lean on both banks according to my code reader. I have replaced the fuel filter cleaned up the air filter and I am about to put in seafoam in the gas tank to clean out the jets and carb. I thought fuel pump but have never had to deal with this before. I just bought the truck last thursday. Also my gas gauge is stuk at empty and the low fuel light is on ....
View 14 RepliesCamry :: Codes For Running Lean And Airflow Leak Detected
My mother-in-law has a Camry and she is pulling codes for running lean and airflow leak detected. The little red circled device mounted on the side of the air intake boot is hissing out air, yet I don't even know what the thing is called....
View 7 RepliesFord - Ranger :: 2000 V6 - CEL Code Saying Both Banks Running Lean
I have a 2000 Ranger, with a 4.0 V6, 4X4, with 175,000 miles and it still runs great except the check engine light is on and it is saying that both banks are lean. I put in new plugs, all 3 O2 sensors, cleaned the MAF and checked for vacuum leaks, all to no avail...
View 17 RepliesBuick - Lesabre :: 1998 - Engine Light Won't Go Off / Running Lean
Engine light won't go off - printout says it's running lean - replaced mass airflow sensor, upper & lower O2 sensors, spark plugs, wires and coils. What else I need to do to get the light to go out so it'll pass inspection?
View 4 RepliesAudi - A4 :: 2001 - Misfire On All Cylinders And Car Appears To Be Running Lean
I have a 2001 Audi A4 1.8t (AWM engine, B5 platform). When I start the car, I get misfires on all cylinders (very rough idle, sometimes it stalls when the engine is cold) and the car appears to be running lean. Once the CEL comes on, it runs fine (albeit the slight loss of power do the ECU going into limp mode to correct the problem).
So far, I've done the following myself: new O2 sensors, new SAI pump, new EGR valve, new diverter valve, new N75 valve, new vacuum hoses, cleaned the throttle body, new MAF sensor, cleaned the air filter, new plugs, and new coils. When the problem persisted, I had my mechanic change the timing belt, check for vacuum leaks, change the valve cover gasket, replace the fuel pump and filter. None of this has solved the problem! This is driving me nuts.
At this point, there are only two possibilities that I can think of:
1) Catalytic converter is clogged? I pulled out the pre-cat O2 sensor, started the car, but it still misfired. This seems to mean that there's another problem (i.e., if the cat is clogged, it's in addition to something else).
2) Dirty fuel injectors? I've put two bottles of Techron through the car to no avail. From the outside, they look pretty dirty, so I'll definitely try removing them, cleaning them, and replacing the gaskets. Hopefully this solves it.
Is there something I'm missing?
Ford - F150 :: 1999 - Code P1131 / O2 Sensor Running Lean
I have a 1999 Ford f150 4.6L automatic. My check engine light had been on for awhile so I dug out my DTC code reader erased it, came back on 10-15 minutes later. I got the code P1131 sensor indicates lean which you would think is the O2 sensor a week later it won't start. Then randomly a couple days later it starts then that night it didn't. Hear is the parts that confused me. I don't believe an oxygen sensor would cause it not to start, it's cranking nice just won't turn over. And when you get the code P1131 I believe it bay 1 where the readings are off Well here's my readings.
Fuel system 1 CL-FaultCalc load 34.1%ECT 201.2 FSTFT B1 -1.6%LTFT B1 0.0 %STFT B2 -1.6%LEFT B2 0.0%ENG RPM 1101VEH SPEED 27 MPH
It looks like to me bay 1 and 2 are off? I'm not mechanically challenged, but not a mechanic either, I do most my own work on my vehicles..
Ford Ranger / B-Series :: 1990 - Rough Start - Running Lean?
]I recently bought a 1990 ford ranger with a 2.9 @187,000 miles. That being said I went through and changed a few vacuum lines, the oil, air filter, pcv/grommet, and fuel filter.
The problem is it hates to start. I could crank on it for 10 seconds and not a single thing. Sometimes if i turn the key to the off position, wait a second, and try again, Ill get the truck to fire. When it does fire up it just reeks of the lean exhaust. It also gives me some hesitation when I rev it. I did a fuel pressure test (KOEO) last night and it gave me 32 psi and within a minute the needle fell to about 25 psi. I hear the fuel pump run for only 2-3 seconds too.
I've already pulled the MAF off and cleaned it, replaced the TPS, and did a fuel pressure test. The fuel filter is brand new
Elantra XD (2001-06) :: P0171 Generic Engine Running Too Lean Code Popping Up
I picked up a really cheap Hyundai Elantra 2005 that the kid that owned it really beat up on. Right now I am trying to sort out the issues so that it can become my daily driver for the next few years.
Second issue, The check engine light is on and it is popping up a P0171 generic engine running too lean code. The car looses power sometimes and I can smell gas in the car. I have a friend that is going to be loaning me his MAC code reader so that I can see if it is one of the O2 sensors and if so which one tomorrow.
Ford F-150 (2004-2008) :: 2005 - Misfiring On Cylinder 7 / Running Lean Bank One
i have a 2005 f150 4x4 5.4 3 valve. it ides good but when it is in on it splutters, and also feels like dead cylinders in passenger gear. i checked the codes the other day and i had a cylinder 5 misfire. so i cleared it and today checked again and had running lean bank one and cylinder 8 misfire, then checked one more time and had cylinder 7 misfire. I am sure it is a bad coil but how do I know which one?
View 2 RepliesFord Ranger / B-Series :: Truck Sputters - Cylinders 2 / 3 And 4 Misfiring - Bank 1 And 2 Running Lean
I have a 99 ford ranger xlt 4.0 ohv basically it sputters so bad while driving it sounds like a dump truck but it all started when I changed my o2 sensors but in doing so I broke my heater control valve and when I was going down the road it started sputtering well it started sputtering so I checked the o2 sensors there good and I changed the heater control valve. But nothing so I changed my coil pack spark plugs and wires but still nothing. But on my reader it says cylinders 2,3, and 4 are misfiring and bank 1 and 2 are running lean plus it has a bad aroma of gas in the engine compartment but when it idles its somewhat smooth but when I'm driving it its horrible the sputtering is so bad it takes awhile to get up to speed plus I'm only getting 100 miles to a whole tank that's like 8 or 9 mpg I need to fix this soon. This is my only transportation...
View 11 RepliesFord F-150 (2009-2014) :: 2011 - Hesitation From Idle - Missing Or Running Lean / Rich During Spin Up Of RPMs
I have recently purchased a 2011 F150 Ext cab with 3.5L ecoboost with 69k miles. I have no experience with these engines prior to now. I've always wanted a full size truck and after driving my 98 S10 for 17 years, I decided it was time for a new truck. I hope I made the right choice in going for the 3.5 instead of 5.0.
On to my question. I've noticed that the truck hesitates from a dead stop or anytime the RPM's are under 1k. It feels like its missing or running lean/rich during the spin up of RPM's. When I drive it hard, it does seem to subside for a little, and I've heard people say that they run better when run hard. I can attest to that, but is this hesitation normal for an almost 70k mile engine? I am getting 15ish MPG on almost all city driving since I have bought it, but I do expect that to change (job hunting and current commute is less than 2 miles each way).
The only time I get to open it up is when I go run errands out of the immediate local area or visiting friends and family. On one of those trips, before I noticed the hesitation, I attempted to accelerate from 60 to pass on the expressway and it bucked and resisted like a horse. It finally took off up to 80 and completed that journey with no issue but the check engine light came on for a bit. The check engine light went off when I shut it down and hasn't come back on since.
New ride: 2011 3.5L Ecoboost....
Ford Fuel System :: 2003 F150 - Service Light Randomly Comes On / Code For Left Bank Running Lean
2003 f150 supercrew with 166,000 miles on it. Daily driver. Service light randomly comes on and when code reader was put to it shows "left bank running lean." Will clear it and will randomly come back on. Truck seems to be running fine. No issues engine. Bad sensor? Or bad injector? Maybe way to test?
View 1 RepliesPassat (B6) :: CEL Came On - Cooling System Too Lean
So CEL came on a few weeks ago as it does here and there so got it scanned today and it said "cooling system too lean" could it just be the mods throwing the light. car is tuned so i thought cel wasn't suppose to come on and no mods to the cooling system beside cold air intake..
View 6 Replies