Camry :: 2007 XLE 4 Cylinder - E Appeared In Multi-function Display And Will Not Shift Out Of Park
The wife was driving the 07 XLE 4 cylinder the other morning. Temperature was around 2 F. She started the car. It started right up. Drove for around 5 minutes and shut the car off and went in to a store for 5 minutes. When she came back out and restarted the car an "E" appeared in the XLE's multifunction display and the low tire pressure light was also on. The car would not shift out of Park. The wife called me. I told her to shut it off and try restarting it. Same thing.
I then told her to shut it off and take the key out of the ignition and then try reinserting it and restarting it. That worked; it eliminated both codes and the car was able to be shifted normally out of Park. Since I still have about 10 months coverage left on my Platinum Extended Warranty the wife and I took the car over to the dealer. When I had my wife explain what happened to the dealer's service writer he just said I have never even heard of the "E" symbol. The tech said he never heard of it either. They did check out the car's shift/interlock system including the brake light switch, but could find nothing wrong.
Prius (2004-09) :: Gauge Stayed At One Pip And Fuel Display On Multi-Function Display Won't Reset
Not the usual. I stopped on my way home to get gas tonight when the gauge was showing one pip. Naturally it wasn't low, but I'm used to that.
The odd thing is that after I got in the car and turned it back on the gauge stayed at one pip and the fuel display on the multi-function display didn't reset.
Prius (2004-09) :: Multi-Function Display Is Starting To Work Intermittently
I have a 2004 Prius with 108,000 miles on it. The MFD is starting to spaz out and work intermittently. It just started to stop working, would be listening to some music and all the sudden would die, no temp, no climate control, no avg mpg, no miles driven, no battery info, the base screen would be there without any data. So its sometimes there when I start the car and sometimes not, sometimes it dies and others it cames back. I called my local Toyota dealer they suggested I needed to replace the Multi-Function-Display with a refurb. I am wondering if there might even be a way to fix the glitch in my current unit...
View 9 RepliesGen 2 Prius (Audio/Electronics) :: Multi-Function Display (MFD) Only Shows Toyota Logo
My MFD now only shows the Toyota Logo, whatever I do. Also, I cannot play music. The trick with pressing (hold) INFO and headlights three times does not bring up a diagnostic screen. My theory is that the MFD is waiting for some signal over the network before showing the usual screen (and it never gets that signal). Some years ago, I had a third party fit a new audio tuner and player (non-Toyota), and that worked more or less fine for years.
They had to leave the old faulty Toyota audio in the circuit to make it all work, and they said to leave the graphic equaliser on even settings, and then forget it. The old Toyota audio CD changer had failed, but the rest was OK. My 'guess' is that they had to leave the old audio device connected because it terminates the AVC-LAN with a 60 ohm resistor. Maybe that connection came off, and now the LAN signals are not good, and the MFD is locked up 'always waiting' for the signal from an ECU.
Prius (Gen 2) :: 2007 Multi Information Display Stopped Working
In my 2007 Prius my multi information display didn't come on when I started it up.
View 4 RepliesPrius (2010-12) :: Dead Pixel In MFD / Blue Display
Have a line of dead pixels in the blue display? Is it something worth complaining over to toyota you think?
View 6 RepliesLexus RX 2004-09 :: Non Multi-information Display Panel To Touch Screen Display?
Recently, i just bought an multi-information display panel (with touch screen support) to integrate into my RX330 which is a non touch screen NAV display panel.
The 2nd hand multi-information display panel is from a 2004 RX330 and what are the socket behind the display panel meant for.
what is the 4 socket connectors as indicated in the red circle in the image should be connected to?
Aurora :: Parking Lights Go On And Off - Bad Multi Function Switch Or Module?
My parking lights go on and off when the car is off. I had problems with the headlights flashing about 3 years ago and fixed it with spaying contact cleaner and air in the multi function switch and that fixed that. I tried the same thing several times to try and fix the blinking tail lights but doesn't work. I just replaced the (LCM) lamp control module but still does it. Somebody told me today that it could be the security module. I'm thinking that the multi-function switch needs to be replaced. Is there a fuse or a way to shut down the (LCM) and just turn the lights on and off manually?
View 2 RepliesPrius (2001-03) :: Won't Start / Multi Function Goes Off / Ready Light Doesn't Come On?
Multi function goes off and ready light doesn't come on when turn key to start.
View 1 RepliesFord Super Duty (1999-2016) :: 2000 - Multi-function Switch Won't Working?
I have a 2000 Excursion LTD with a V10, auto, 2wd. My problem is in the multifunction switch...I have no high beam flash function when the headlights are off, nor will the high beams illuminate when the lever is pushed forward. All other functions work as expected. I feel that the malfunction is minor and may be nothing more than a poor contact or bad fuse. I would rather not have to buy a new switch.
View 6 RepliesFord F-150 (2009-2014) :: Wiper / Turn Signal Multi-function Switch Replacement
Looking for a tutorial on how to remove the multi-function switch? I have the, seemingly, common issue of wipers not turning off. I bought the new switch, but don't see how to get it out without taking the whole steering wheel off. I can't get to the screws on it at all. I got the plastic covers off, but can't see how to get the switch out.
View 3 RepliesSanta Fe (CM - 2007-12) :: Turn On Nav And Pixel Was Red - Is It Broken
2012 Santa Fe 3.5 limited w/ nav. Suv is 3 weeks old I turn on the nav today and a pixel was red I'm guessing it's a broken pixel? I turned it on and off for a bit, changed channel and played around. It's dead center upper screen. What would you do? I really don't want my dash ripped apart but if it's going to get worse... And it's not perfect and I do have OCD with my vehicle.
View 11 RepliesPrius (Gen 3) :: Multi Information Display Blank / Not Working
My wife on her way home from work called me to say that the MID screen was blank - not working. I asked if she could drive the car, she could, but the energy monitor screen that she has on usually was not coming on. Her concern while driving was that she could not tell how fast she was going.
Fortunately, just a week ago I had installed Scangauge II in her car and had her convert one of existing gauge to MPH. This is a new 2012 Prius IV that is about 2 months old. I'm pretty sure that MID can't be turned off.
Prius (2010-12) :: Lights Goes On - Multi Informational Display Goes Off
When I have my daytime running lights on, all is fine. When I switch to anything else on the stalk, including my night time head lights, it goes off, along with some temperature control background illumination. Only the shift icon stays on the MID. When I switch back to daytime running lights, everything goes back on.
View 6 RepliesPrius Plug-in 2012-15 :: Multi-information Display Changes On Its Own?
Every day I stop at my mailbox to get the mail. I get out of the car with the FOB in my pocket and leave the car running. When I close the door the car beeps three times to let me know it's still on. This is exactly how my 2010 Prius operated. However, when I get back in the car the multi-information display always changes from the hybrid system indicator screen to the energy monitor screen. I always have the HSI on as default. This isn't a huge deal but it's kind of annoying. Is there a setting somewhere that I can change that I've missed?
View 6 RepliesPrius (2010-12) :: Turning Off The Multi-information Display?
It distracts me too much and I can't seem to get better than 45 mpg no matter how I drive (regular mode mostly highway). Any way to turn it off permanently?
View 11 RepliesCamry 2012+ :: Multi Informational Display Screen Blank
Recently brought a 2015 camry SE and wouldn't you know it, someone pulls out in front of me on the highway within a week of buying it. After getting the car back from the auto body shop, I've noticed that my multi information display has a blank screen. Didn't notice that before the accident. The first 3 screens I can set up as I want, the 4th screen is tire pressure and the 5th screen is blank. I've tried to find out what the 5th screen should be but I haven't been able to find an answer.
View 2 RepliesFord F-150 - 1997-2003 :: Headlights Sometimes Working And Turn Signals Not Working - Multi Function Switch Replacement?
Well now I have to replace the multi function switch due to moving my steering wheel and the headlights sometimes working and turning signals not working. I saw a great video on youtube about changing a Multi Function Switch and it shows where the air bag needs to be removed. I was hoping that since my truck is an older 1997 F250 LD I wouldn't have to remove the airbag. Is there a way to do this w/out messing with the airbag on the 1997?
View 1 RepliesCamry 2012+ :: 2015 SE - Entune Audio Plus / Multi Information Display?
I had the basic Entune radio but recently upgraded to the Entune Audio Plus with navigation after talking with a tech at the dealership. I unfortunately don't have the audio tab at all, how to add it to my display. No one at the dealership knows how and they referred me to Toyota Corporate about my situation. Any button sequence that can add or delete tabs on the display?
View 9 Replies