GTI 337/20th Anniversary :: Gears Sounds Like Car Is Shifting But It Doesn't Move
First off i couldn't get the car into reverse to back out of a convenience store and then i let off the clutch to try and pump it again and the car just dies. drove just fine up until i parked. Now when i try to move through gears it sounds like it's shifting but the car doesn't move. The car does have a stronger clutch and unitronic chip if that would have to do with anything.
View 13 RepliesPassat (B6) :: 2006 - Gears Won't Shifting Normally
i have an 06 passat in manual, to put things short i was racing a friend last year on the highway and went from 5th to 4th at 120 thinking it was 6th and let the clutch grab ...needless to say i messed up the clutch and 2nd 4th and 6th gear felt like i was shifting into oatmeal if the RPMs were too high, BUT they would still grab.
thinking i only messed up the clutch setup, i went and got a clutch masters stage fx300 stage 3 kit with the steel flywheel (plan on going big turbo by summer)
after the shop installed the clutch, im getting the same results, better grabbing from the clutch in all gears EXCEPT FOR 6TH! 6th wont engage at all
so now im thinking i actually damaged the actual gears.
Passat (B5) :: V6 5 Speed - Hard Shifting / Slam Between Gears
Hard shifting from the car. sort of a slam between gears and while in gear.
Possibly a mount?
Passat (B7) :: 2015 - Jerking Randomly When Shifting In Low Gears
My car is less than 2 months old and randomly in low gears the car will jerk or lurch when shifting gears. Is this common or does this need to be looked at?
View 18 RepliesPassat (B5) :: No Start - Shifting Gears Allow Starter To Engage
2003 Passat 1.8t FWD.
My buddy is having a wierd issue that just recently started after it's gotten cold out. The car would not start for him so he had me look at it. Attempting to start there's no sound from the starter at all. Battery is fine. When I shift in and out of a few gears, the starter engages and the car starts. Stop the car. Attempt to start it again and nothing. Shift through the gears some more and the car almost starts but quickly dies. Shift some more, start, running like a champ.
What is it about shifting through the gears that allows the starter to engage and the car to run again?
Passat (B5) :: Gears Started To Feel Clunky When Shifting In To 2nd
When I used to change gears in my car it would feel smooth and precise, but just today when i was shifting in to 2nd, my gears started to feel clunky and like they were getting caught up on something. It feels like I'm not even engaging a gear when i put it into gear. Its so effortless and i don't get that secure feeling that i know i am in gear anymore.
View 4 RepliesGolf IV / Jetta IV :: Whirling And / Or Blow Off Sounds
My car recently started making strange noises sometimes. Sometimes I hear a whirling sounds coming from the bottom half of the block which I'd hope it isn't the water pump. Also when i start my car and it cranks over, I hear what sounds like a blow off sounds but its not from my diverter valve.
View 5 RepliesGTI 337/20th Anniversary :: Blow Off Valve On Stock 1.8T?
I wanted to get a blow-off valve for my GLI but its bone stock, i was wondering if its possible or if it would cause problems. and if i can whats a good brand?
View 17 RepliesGTI 337/20th Anniversary :: Valve Blow Off With Vacuum - Negative Boost?
This is my other question. I have an APR program and turbo-back billy boat exhaust. I installed a boost gauge that gets the reading off of the intake manifold (fuel regulator.)
So if I'm just tooling along, short-shifting and only using 1/10 throttle, and my boost gauge never reads above -5, let alone 0 or positive, why does my valve release pressure?
Why would there be pressure to release if there is a vacuum, according to the gauge? I wouldn't think that a recirculating or blow-off valve would work in reverse.
GTI 337/20th Anniversary :: Forge Splitter / Recirculation And Blow Off Valve Installation?
Looking to have it installed? I bought it but I haven't installed it yet...
View 2 RepliesGolf IV / Jetta IV :: Blow Off Valve Started Making Flutter Noise When Dumping
I recently put a cold air intake on my car and I could hear the dump when I let off of the gas. But I also put in a boost gauge but I think I had a leak in the hose going to the gauge. After I drove it for awhile the blow off valve started making a flutter noise when dumping. I fixed the leak in the hose but the flutter is still there. How do I fix the flutter? A new blow off valve? Mk4 Jetta 1.8.....
View 6 RepliesElantra GD (2013+) :: Blow Off Noise When Accelerating / Shifting
Here is a video I made of the "Blow off" noise I hear when accelerating/shifting (more than 50% throttle). Sounds kinda cool IMO
[URL] ....
The times are listed in the description of the video...
Ford Ranger / B-Series :: 1999 - No Gears After Replaced Valve Body Gasket
I just finished replacing the Valve body gasket in my 99 ranger with the 4.0 liter v6 with the 5r55e trans. My problem now is that I have no gears i can shift it but the gears do not engage.. I did install the updated bonded separator plate and the tsb for the blow off valve with it.
View 6 RepliesGolf IV / Jetta IV :: When Shifting Through Gears Car Won't Go Into First And Second
I got a 2000 vr6 Jetta with a 5 speed manual transmission. When shifting up or down through the gears it doesn't seem to like going into first and second. All the other gears seem fine. I've tried adjusting the shift cables and changing the gear lube, but nothing seems to work. I've heard of the cable bushings going bad and possibly shot motor mounts ( I'm at 135,000 miles).
View 5 RepliesGolf/GTI VI :: Resistance In Shifting Gears
Stage 2 clutch with a diesel geek short shifter. I have started noticing shifting from 2nd to 3rd is difficult. Sometimes it will go into 5th when shifting up from 2nd. Not a lot of resistance but it is more than noticeable. How do I resolve this issue? Am I hurting my clutch if I keep driving like this? Nothing is grinding at all in between shifts.
View 2 RepliesFord Super Duty (1999-2016) :: Engine Sounds Pretty Rough And Hear A Lot Of Valve Chatter
I have a 2006 f-250 with 5.4L 3valve engine. I was worried about my variable valve timing system because my engine sounds pretty rough and I hear a lot of valve chatter. I know that low oil pressure can be a big problem on these engines. Here is a pic of my oil pressure gauge. This was taken while the truck was warm while parked.
View 14 RepliesLexus GX 2004-09 :: Binding Of Gears When Shifting Into L Or H
Is it normal to feel resistance and binding of gears when shifting into L or H, when regular shifter is in neutral? One Lexus dealer technician said no, a different Lexus dealer said yes, and a 20-year private transmission shop technician said yes; the "yes" technicians said its because the gears are not synchronized and will grind and bind a little when shifting into L or H on the 4 wheel drive shifter. Car is a 2007 GX 470 and runs great.
View 14 RepliesElantra XD (2001-06) :: Rough Shifting Between Gears
My car is a 2002 Hyundai Elantra with an automatic transmission. It was bought with about 79k miles on it and currently has about 94k miles. Last week I began experiencing rough shifting between gears. My CEL had been on for a few months but I wasn't having any performance problems so I ignored it. When I started having shifting problems I went to autozone to have the codes scanned. All that came up was P0441. I cleaned the purge valve and cleared the code. The CEL stayed off.
I continued driving and having shifting problems. The car slipped out of gear when it wanted to upshift. The engine revs until I release the gas. Once the rpms drop low enough the next gear would engage. This seemed to happen for every gear shift except 1-2. For my first few trips no CEL.
Finally, yesterday on my way to work I got a CEL, and it was intermittent, similar to other issues I had read about. However, the more I drove the car, the worse this problem got. It would not stay in gear while cruising down the road. I tried changing gears manually, revving the engine up and letting it drop to idle, but nothing would work. Luckily the car got me to work but it was a real jerky ride. Towards the end it didn't even want to take off from a stop. And it wasn't in third, the engine just wasn't engaging the transmission. It's like the car was in neutral. But moving the gear shifter didn't seem to work.
The car did not make it home, however. When I started it after work, it went fine for about 2 blocks and then started slipping. Within a quarter mile I couldn't even go in first. Turning off the car and waiting a few minutes, then going again would gain me some distance, but the car would start slipping again almost right away. I was able to turn around and park the car in my work's parking lot.
The problem is I have no way to pull the DTC's now because the car can't make it very far. If it's something simple like the input/output speed sensors, I'll replace those in the parking lot. I'm a DIYer and hate paying others for what I can do myself, but I may need to bite the bullet on this one.
Santa FE SM (2001-06) :: Delay Shifting Between Gears
Wife's Santa Fe has an issue with it's shift points. Its a 2002 with 148K on it, never has had a CEL, fluid is changed every 60K. Over the past few months the time it takes to shift through the gears is getting longer. What I am describing is not an actual delay between the gears, but rather how long it is starting to take to get the tranny to even shift. Sort of like how a vehicle shifts through its gears when your at a stop, and put the pedal to the floor and just hold it. it makes no difference if your barely on the gas or half way down, still takes a way longer time that it should to shift. It is slightly worse when cold, but still does it when warm. Is there some kind of temp sensor or vacuum line or whatnot that would cause something like this? When it does finally shift, its normal, tight, no slippage or delay. truck runs great other than this.
View 7 Replies