Accent MC (2006-11) :: Transmission Stopped Shifting Gears
My friend has a 2007 accent with a manual transmission they said that they were driving and the transmission stopped shifting gears. The clutch pedal still has pressure so I don't think it is a master or slave cylinder issue. They freaked out and turned off the car and now the car will not start up again. Have any of you experienced anything like this before or know on this car where to start looking? I think the issue with not being able to switch gears could be a pressure plate issue but this would not cause the car not to start.
View 6 RepliesPassat (B5) :: Sounds Like A Blow Off Valve While Shifting Gears
It only happens sometimes, but definitely everyday. I have an 06 Passat 1.8T and when i'm accelerating and it shifts gears from 1 to 2 it sounds like i have a really bad blow off valve, yet i don't. I can't see anything noticeable under the hood. I am thinking its the turbo inlet pipe.
View 3 RepliesPassat (B5) :: V6 5 Speed - Hard Shifting / Slam Between Gears
Hard shifting from the car. sort of a slam between gears and while in gear.
Possibly a mount?
Passat (B7) :: 2015 - Jerking Randomly When Shifting In Low Gears
My car is less than 2 months old and randomly in low gears the car will jerk or lurch when shifting gears. Is this common or does this need to be looked at?
View 18 RepliesPassat (B5) :: No Start - Shifting Gears Allow Starter To Engage
2003 Passat 1.8t FWD.
My buddy is having a wierd issue that just recently started after it's gotten cold out. The car would not start for him so he had me look at it. Attempting to start there's no sound from the starter at all. Battery is fine. When I shift in and out of a few gears, the starter engages and the car starts. Stop the car. Attempt to start it again and nothing. Shift through the gears some more and the car almost starts but quickly dies. Shift some more, start, running like a champ.
What is it about shifting through the gears that allows the starter to engage and the car to run again?
Passat (B5) :: Gears Started To Feel Clunky When Shifting In To 2nd
When I used to change gears in my car it would feel smooth and precise, but just today when i was shifting in to 2nd, my gears started to feel clunky and like they were getting caught up on something. It feels like I'm not even engaging a gear when i put it into gear. Its so effortless and i don't get that secure feeling that i know i am in gear anymore.
View 4 RepliesLexus GX 2004-09 :: 2006 GX470 Transmission - Delay In Gears Shifting
2006 GX470, ~65k mi. When shifting from P to R, P to D, or R to D, the transmission often (but not always) seems to have to think about it a while. When it shifts fine it takes about 1sec for the transmission to change gears. When it's being cranky it takes ~4secs. There are no other symptoms.
View 7 RepliesPrius (Gen 2) :: 2006 - Engine Jerking When Going Down A Hill / Stutter Shifting Gears
I am having issues with a 2006 Gen II Prius that just approached 120K miles. When going down a hill at approx. 35-40mph, the engine jerks when downshifting or when coasting.
View 3 RepliesChevrolet - 2500 :: 2006 - Transmission Shifting Extremely Hard In All Gears
I have a 2006 Chevy 2500HD with about 180000 miles. All of a sudden the transmission is shifting extremely hard at times. It doesn't shift this way all the time. What could be causing this problem? It doesn't have to be under hard acceleration either when it does shift hard. It sometimes is during hard accelerating and sometimes it is under very little acceleration, but as I said it doesn't do it every time. When it does shift hard, it seems to do it in all gears.
View 1 RepliesGolf IV / Jetta IV :: When Shifting Through Gears Car Won't Go Into First And Second
I got a 2000 vr6 Jetta with a 5 speed manual transmission. When shifting up or down through the gears it doesn't seem to like going into first and second. All the other gears seem fine. I've tried adjusting the shift cables and changing the gear lube, but nothing seems to work. I've heard of the cable bushings going bad and possibly shot motor mounts ( I'm at 135,000 miles).
View 5 RepliesGolf/GTI VI :: Resistance In Shifting Gears
Stage 2 clutch with a diesel geek short shifter. I have started noticing shifting from 2nd to 3rd is difficult. Sometimes it will go into 5th when shifting up from 2nd. Not a lot of resistance but it is more than noticeable. How do I resolve this issue? Am I hurting my clutch if I keep driving like this? Nothing is grinding at all in between shifts.
View 2 RepliesLexus GX 2004-09 :: Binding Of Gears When Shifting Into L Or H
Is it normal to feel resistance and binding of gears when shifting into L or H, when regular shifter is in neutral? One Lexus dealer technician said no, a different Lexus dealer said yes, and a 20-year private transmission shop technician said yes; the "yes" technicians said its because the gears are not synchronized and will grind and bind a little when shifting into L or H on the 4 wheel drive shifter. Car is a 2007 GX 470 and runs great.
View 14 RepliesElantra XD (2001-06) :: Rough Shifting Between Gears
My car is a 2002 Hyundai Elantra with an automatic transmission. It was bought with about 79k miles on it and currently has about 94k miles. Last week I began experiencing rough shifting between gears. My CEL had been on for a few months but I wasn't having any performance problems so I ignored it. When I started having shifting problems I went to autozone to have the codes scanned. All that came up was P0441. I cleaned the purge valve and cleared the code. The CEL stayed off.
I continued driving and having shifting problems. The car slipped out of gear when it wanted to upshift. The engine revs until I release the gas. Once the rpms drop low enough the next gear would engage. This seemed to happen for every gear shift except 1-2. For my first few trips no CEL.
Finally, yesterday on my way to work I got a CEL, and it was intermittent, similar to other issues I had read about. However, the more I drove the car, the worse this problem got. It would not stay in gear while cruising down the road. I tried changing gears manually, revving the engine up and letting it drop to idle, but nothing would work. Luckily the car got me to work but it was a real jerky ride. Towards the end it didn't even want to take off from a stop. And it wasn't in third, the engine just wasn't engaging the transmission. It's like the car was in neutral. But moving the gear shifter didn't seem to work.
The car did not make it home, however. When I started it after work, it went fine for about 2 blocks and then started slipping. Within a quarter mile I couldn't even go in first. Turning off the car and waiting a few minutes, then going again would gain me some distance, but the car would start slipping again almost right away. I was able to turn around and park the car in my work's parking lot.
The problem is I have no way to pull the DTC's now because the car can't make it very far. If it's something simple like the input/output speed sensors, I'll replace those in the parking lot. I'm a DIYer and hate paying others for what I can do myself, but I may need to bite the bullet on this one.
Santa FE SM (2001-06) :: Delay Shifting Between Gears
Wife's Santa Fe has an issue with it's shift points. Its a 2002 with 148K on it, never has had a CEL, fluid is changed every 60K. Over the past few months the time it takes to shift through the gears is getting longer. What I am describing is not an actual delay between the gears, but rather how long it is starting to take to get the tranny to even shift. Sort of like how a vehicle shifts through its gears when your at a stop, and put the pedal to the floor and just hold it. it makes no difference if your barely on the gas or half way down, still takes a way longer time that it should to shift. It is slightly worse when cold, but still does it when warm. Is there some kind of temp sensor or vacuum line or whatnot that would cause something like this? When it does finally shift, its normal, tight, no slippage or delay. truck runs great other than this.
View 7 RepliesGolf IV R32 :: Shifting Gears - Jerking / Clunking When AC Is On
When shifting gears, mainly in 1st, 2nd, and 3rd while the air conditioner is on I'm experiencing jerking / clunking. When I shift it's not a smooth movement and produces a thump. The only way to really avoid this is by letting the clutch out very very slowly. It only happens when the A/C is turned on. Shifting is perfect when the A/C is off.
View 6 RepliesPontiac - Sunfire :: 1997 Car Is Not Shifting Gears At All
My car is an automatic 1997 pontiac sunfire SE. 2.4L. I drove into a parking space and the car would not shift out of drive into park, or any other gear. I called a tow truck and the guy said that the "link" had popped out of place and it needed to slip back in. He also said the high heat (it was 109 today) can warp the plastic to where it will not stay in. He showed me this link and popped it into place. I was able to get the car to shift from low to park and then to neutral but it popped out again. So I know it's not the transmission. My question is what is this "link" called so I can get a replacement for it.
View 6 RepliesGolf/GTI VII :: Whining Sound While Shifting 4 First Gears?
So I took delivery of my ordered PP GTI about three weeks ago, When driving under light throttle, when upshifting or downshifting amongst the first four gears, the car makes a whining/ humming noise from about 1700 to 2300RPM. I lifted the front end of the car to check things out and noticed that the left axle makes some weird sounds. I'm hoping it's a bad CV, issue with transmission (not clutch related)?
View 2 RepliesMazda - Mazda3 :: Skipping Gears While Shifting
Is it ok/better/worse to skip gears while accelerating in a manual car? Example would be starting from a stop in 1st and going strait from 1st to 3rd gear. , I have a mazda 3 and i usually run 1st up to 3500 rpm or so and when i hit 3rd its around 1400 when I let the clutch out.
View 13 Replies92 Chevy K1500 Blazer Goes Into Neutral While Shifting Into Some Gears
My 1992 chevy k1500 blazer full size is having trouble shifting from 1st and 2nd and 2nd to 3rd. I reset the linkage it did fine for a day and now it's doing the same thing but it almost goes into neutral while shifting into some gears. And seems to lack power, the 92 doesn't have cyanoids and the transmission was redone 2 years ago when I got the truck. Could this have anything to do with the fuel filter? I know the transmission isn't bad. The Rpms are shooting up way too high.
View 1 Replies