Passat (B5) :: How To Remove Front Wheel Bearing Clip
I am in middle of "trying to" change the wheel bearing and I have the hub out but I can't figure out how this bearing needs to come out.
I have done it on MKIV Golf and like most other cars there is a C clip, but i can't see a clip in this knuckle.
Is this thing press fit in there without a clip? I have seen a guide for MKIV Jetta and people say Passat is almost the same, but not until I find this C clip.
Passat (B5) :: 2000 - Front Wheel Bearing Replacement
I m about to replace the front wheel bearing of my 2000 1.8 t I already rent the tool (hub and bearing puller and installer) from german auto parts.com but looking for pics of step by step of the process before starting the job.
View 4 RepliesPassat (B5) :: Front Left Wheel Bearing Replacement?
I have a 2000 Passat and brought it to a local shop to have the left front wheel bearing changed. He took the car apart and said he couldnt do it because the anti lock brake wire ran threw the control arm and had no plug on it and was wired right to the dash board. Should i find a different place to take it to or is it a dealer required fix. Can i buy the bearing myself and change it?
View 1 RepliesSanta Fe (CM - 2007-12) :: 2009 3.3l AWD - Wheel Bearing Failure
At 37000km we put new tires on and after about 1000km started to hear a high 'woo-woo-woo', from the rear, not really loud but a new noise. Guessing it might be tire noise I checked them for wear and thought the left rear was a bit sharp sliding your hand one direction but smooth sliding across the other way. Went for an alignment....it was only slightly off and the mechanic found the right rear wheel bearing was kaput.
It was done under warranty......but, do these vehicles are subject to premature bearing failure or was this a fluke? I did not see the bearing so I don't know if it was one of two or a pressed-on type or whatever. It would be nice to know that a wheel won't come flying off or seize up when we're halfway to nowhere if a bearing goes bad again.
Prius (Gen 3) :: Distinct Rotational Noise At About 30 To 40 MPH - Wheel Bearing Failure?
Since the Prius is my wife's primary car, I can go a long time without driving. I recently have been driving it more, and it seems to me that it has the sounds of a failing wheel bearing. Between about 30-40 MPH there seems to be a distinct rotational noise that sounds to me like a loud wheel bearing from the front end. The sound seems to get quieter as I go faster, and at 60 mph + it seems normal.
My wife didn't notice any difference, but she drives the car everyday so maybe she didn't notice the gradual increase in noise. I know it's not tire related, because I just swapped tires. When I did, I didn't feel any play in the front bearings or feel any roughness when the wheels were rotated.
Prius (2010-12) :: Rear Left Wheel Bearing Failure
At 46,400 miles of gentle driving, my left wheel bearing failed on my 2010 Prius, which was not covered by warranty because it is not 'drive train'. I was told there was nothing I did or could have done to cause this. I have had 4 Toyotas, two with over 200,000 miles, and never had this serious a repair (that wasn't my fault!). Am I being unreasonable to think this is unusual? I'm wondering if this car is going to continue to be a problem.
View 19 RepliesImpala - Chevrolet :: Wheel Bearing Failure / Hub Assembly Replacement
I have 2012 Impala and hit a pot hole blowing out the left front tire but rim was not damaged, replaced the tire. Now the shop tells me that the wheel bearing has been damaged and the hub/bearing assembly needs to be replaced. I've never seen this happen. Is it possible that the bearing got damaged?
View 11 RepliesPlymouth - Acclaim :: Clunk / Rattle Noise Coming From One Wheel - Catastrophic Bearing Failure
My girlfriend owns a '92 Plymouth Acclaim. We noticed a few weeks ago that there was a clunk/rattle noise coming from one wheel, and since it mostly happened while cornering, thought it might be CV joints or maybe suspension. She brought it to her mechanic who inspected the brakes and found that the rear shocks were bad, but sent her away without fixing anything. The other day, on a long drive, the rattle suddenly intensified, morphed into a loud grinding noise, and then the wheel fell off.
I think I'm going to have to confront the mechanic. The bearings apparently hadn't been repacked in some time, and were surely the cause of the rattle noise. I'm less concerned with the fact that he might have overlooked an obvious problem as much as neglected to properly service the vehicle.
Are brake techs supposed to check, then tighten wheel bearings or repack them if needed?
Ford Super Duty (1999-2016) :: F250 - Front Axle Needle Bearing Replacement
I own a 1999 F250 super duty and have the front end apart to service the u joints , I noticed that i have bad axle stub needle bearings on one side. I was wondering what is involved in taking those out and replacing them, it looks like they are held in place with some type of spanner nut. My next question :Would it be worth the cost just to replace the whole bearing hub assembly? The truck has 134000 miles on it.
View 10 RepliesYaris/Scion & Vitz :: Wheel Bearing Noise / Vibration On The Front Left (driver Side) Wheel
So on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Clunking Noise From Right Side Over Bumps - Front Axle Bearing
I bought a 2000 F250 V10 Super Cab. Oddly after a few weeks it has grown on me. There has been a clunking noise out of the right front over bumps. I traced it to a bad axle bearing. The u joint moves up and down about a 1/2 inch. Besides pulling the hub/bearing assembly out and removing the axle are there any surprises getting the old bearing out?
View 1 RepliesPrius (Gen 2) :: Right Bearing Causing Noises
Had my front bearings replaced on 2005 prius about 1 month ago as the right side bearing was making all the usual noises of a bad bearing...After about 3 weeks the right side again started to make a low humming noise but not quite the same as the original problem bearing, this time there was no change in noise on wide sweeping turns like there was with the original problem...Took it back to the mechanic and had him ride with me and he immediately diagnosed that the bearing had failed again, even though the noise was different....He replaced the bearing on Friday, I drove it home with no apparent noises, put maybe 100 miles on it Saturday and noticed again a low hum starting on the right side...Now here on Sunday it is a very loud hum/growl with some shimmery coming from that side...I'm guessing it's not a bearing problem.
View 3 RepliesCamry :: Front Wheel Bearing Hub Replacement On 2007 SE
Just had an oil change and during inspection they noticed that the drivers side wheel bearing is starting to go. They brought me back in the shop and I was able to feel the play in the bearing myself. Only a matter of time before it needs to be replaced.
How to replace the front wheel bearing/hub assembly? I don't have a press for the bearing itself so I'm assuming I can just replace the entire hub assembly. I have already replaced the drivers side rear hub assembly about 1.5 years back due to a bad bearing
Golf IV R32 :: Front Right Wheel Bearing Is Making Noise
So my front right Wheel bearing is making noise and its a used Knuckle so its w/e. Guess ill use tonight to do all my bushings and fluids n stuff.
View 6 RepliesSonata NF (2006-10) :: Front Wheel Bearing Replacement
2006 Sonata with 90k ... When I make right turns the left front wheel is making a rubbing sound with the motion of the wheel. It's not doing it on a straight line, just turning right. I've talked to a couple of my friends and they are telling me it's a wheel bearing. I have a service manual but it's not really going into detail on what I'm in for. I work on motorcycles all the time and my good friend said he has a press if I can bring him the knuckle and the OEM bearing. Looking for a little guidance before I take the wheel off and get started. Are there any special tools involved, etc...should I do the other side while I'm doing this also...
View 11 RepliesPrius (Gen 2) :: 2007 - Front Wheel Bearing Started Humming
I have a 2007 the front wheel bearing started humming real bad, changed it out. Can't seem to get the right front brake bled good. Did it three times. No air. Today locked up the left wheel upon putting on the brake, the right one ain't working. Is there any thing I can do other than bleed the left front again, check fluid?
View 2 RepliesMazda :: No Power To Front Passenger Wheel After Bearing Replacement
I have decent mechanical ability and recently took off both front wheel knuckles to have the wheel bearings pressed out and new ones back in. I own a 2006 Mazdaspeed 6 with 106,000 miles. I didn’t have much problem getting the wheel hub knuckles off and back on and after they were reinstalled with all bolts tightened, I took the car for a test drive and right away knew something was very wrong. I heard the sound of the drive-shaft CV joint boot twisting and there was a serious lack of power. The engine speed did not correspond with the vehicle speed. Continuing a little ways, small metal noises could be heard from the passenger side wheel. The only indication I had of some problem from that side was during the reinstallation of the drive shaft into the wheel hub. The CV joint dust boot was fully extended and didn’t compress like it should. I put the car back on jacks, took off the wheel and saw that the drive-shaft boot was all twisted. It was obvious that power was going through the drive-shaft past the first CV joint, but no power was making it past the second CV joint to the wheel.
Knowing that something was seriously wrong, I had it towed to Firestone down the road. The mechanic removed the boot and said that the drive-shaft had broke. I also inspected this and saw that the drive-shaft was not connected at the wheel hub. The morning of, the car was working just fine without problems. The tool I used to remove the drive shaft from the wheel hub was a Seven Ton Reversible Puller which I rented from O'Reilly's Auto store. The drive shaft was so stuck on, that I had to use an impact wrench to turn the bolt. Could the highly forced removal of the drive-shaft from the wheel hub shatter the CV joint on the drive-shaft?
DSC00261.jpg800x600
Elantra MD (2010-15) :: Left Front Wheel Bearing Noise
Having issues with noise from either LT or RT front wheel bearings? My 2011 Elantra has some sort of noise coming from the LT frt wheel
View 10 RepliesPrius (2004-09) :: Noise In The Right Front Wheel - Bearing Failed
I devloped a noise in the right front wheel. I thought it was a tire going bad so I rotated the tires & still had the noise. I was told by shop it is a wheel bearing. If that is the problem is that a DIY repair ?
View 5 Replies