Passat (B5) :: 2000 - Front Wheel Bearing Replacement
I m about to replace the front wheel bearing of my 2000 1.8 t I already rent the tool (hub and bearing puller and installer) from german auto parts.com but looking for pics of step by step of the process before starting the job.
View 4 RepliesPassat (B5) :: Front Left Wheel Bearing Replacement?
I have a 2000 Passat and brought it to a local shop to have the left front wheel bearing changed. He took the car apart and said he couldnt do it because the anti lock brake wire ran threw the control arm and had no plug on it and was wired right to the dash board. Should i find a different place to take it to or is it a dealer required fix. Can i buy the bearing myself and change it?
View 1 RepliesPassat (B5) :: New Front Axle Causing Wheel Bearing Failure?
I had a ripped drivers side CV boot and had my indy replace the axle with a new Raxle. ~200 miles after the replacement the wheel bearing on that side went south. I shugged it off and had it replaced. Well, after 200 miles on the new bearing, it has also failed (100 miles from home). I gotta believe the 2 bearing fails are related to the new axle, but I don't understand how!
View 2 RepliesYaris/Scion & Vitz :: Wheel Bearing Noise / Vibration On The Front Left (driver Side) Wheel
So on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 RepliesLexus ES 2007-12 :: Headlight Replacement - Can't Remove Retaining Clip
I can't remove the retaining clip to replace the passenger's side low beam headlight bulb. I was able to, with some difficulty, replace the driver's side but space is tighter on the passenger side.
View 1 RepliesCamry :: Front Wheel Bearing Hub Replacement On 2007 SE
Just had an oil change and during inspection they noticed that the drivers side wheel bearing is starting to go. They brought me back in the shop and I was able to feel the play in the bearing myself. Only a matter of time before it needs to be replaced.
How to replace the front wheel bearing/hub assembly? I don't have a press for the bearing itself so I'm assuming I can just replace the entire hub assembly. I have already replaced the drivers side rear hub assembly about 1.5 years back due to a bad bearing
Golf IV R32 :: Front Right Wheel Bearing Is Making Noise
So my front right Wheel bearing is making noise and its a used Knuckle so its w/e. Guess ill use tonight to do all my bushings and fluids n stuff.
View 6 RepliesSonata NF (2006-10) :: Front Wheel Bearing Replacement
2006 Sonata with 90k ... When I make right turns the left front wheel is making a rubbing sound with the motion of the wheel. It's not doing it on a straight line, just turning right. I've talked to a couple of my friends and they are telling me it's a wheel bearing. I have a service manual but it's not really going into detail on what I'm in for. I work on motorcycles all the time and my good friend said he has a press if I can bring him the knuckle and the OEM bearing. Looking for a little guidance before I take the wheel off and get started. Are there any special tools involved, etc...should I do the other side while I'm doing this also...
View 11 RepliesPrius (Gen 2) :: 2007 - Front Wheel Bearing Started Humming
I have a 2007 the front wheel bearing started humming real bad, changed it out. Can't seem to get the right front brake bled good. Did it three times. No air. Today locked up the left wheel upon putting on the brake, the right one ain't working. Is there any thing I can do other than bleed the left front again, check fluid?
View 2 RepliesMazda :: No Power To Front Passenger Wheel After Bearing Replacement
I have decent mechanical ability and recently took off both front wheel knuckles to have the wheel bearings pressed out and new ones back in. I own a 2006 Mazdaspeed 6 with 106,000 miles. I didn’t have much problem getting the wheel hub knuckles off and back on and after they were reinstalled with all bolts tightened, I took the car for a test drive and right away knew something was very wrong. I heard the sound of the drive-shaft CV joint boot twisting and there was a serious lack of power. The engine speed did not correspond with the vehicle speed. Continuing a little ways, small metal noises could be heard from the passenger side wheel. The only indication I had of some problem from that side was during the reinstallation of the drive shaft into the wheel hub. The CV joint dust boot was fully extended and didn’t compress like it should. I put the car back on jacks, took off the wheel and saw that the drive-shaft boot was all twisted. It was obvious that power was going through the drive-shaft past the first CV joint, but no power was making it past the second CV joint to the wheel.
Knowing that something was seriously wrong, I had it towed to Firestone down the road. The mechanic removed the boot and said that the drive-shaft had broke. I also inspected this and saw that the drive-shaft was not connected at the wheel hub. The morning of, the car was working just fine without problems. The tool I used to remove the drive shaft from the wheel hub was a Seven Ton Reversible Puller which I rented from O'Reilly's Auto store. The drive shaft was so stuck on, that I had to use an impact wrench to turn the bolt. Could the highly forced removal of the drive-shaft from the wheel hub shatter the CV joint on the drive-shaft?
DSC00261.jpg800x600
Elantra MD (2010-15) :: Left Front Wheel Bearing Noise
Having issues with noise from either LT or RT front wheel bearings? My 2011 Elantra has some sort of noise coming from the LT frt wheel
View 10 RepliesPrius (2004-09) :: Noise In The Right Front Wheel - Bearing Failed
I devloped a noise in the right front wheel. I thought it was a tire going bad so I rotated the tires & still had the noise. I was told by shop it is a wheel bearing. If that is the problem is that a DIY repair ?
View 5 RepliesFord - Explorer :: Thumping Noise From Front / Wheel Bearing?
I have a 03 explorer with approx 160k, I am experiencing a thumping noise while driving. It gets worse on right turns and gets better on left turns. initially i thought LF wheel bearing so i ordered a hub assy and replaced LF. noise is still there. I guess, thumping noise caused by wheel bearings, i know its usually a grinding kind of whirring noise.
The noise doesn't seem to change with accel/decel so I don't think it is driveline related (diff, drive shaft etc.) should i bite the bullet and replace the rf as well??? I should also mention that there is also a shake in the steering wheel that seems to coincide with the thumping (i.e., my hand shakes along with the thumping, and the shake gets worse when the noise does)...
Ford - Explorer :: 1999 - Front Wheel Bearing Nut Size?
1999 explorer Eddie bauer. Front wheel bearing nut size? 33mm?
Looking for a torque spec procedure. Need to replace an abs sensor. Sensor alone was 120 bucks so just bought the whole hub assembly with sensor. Might just put the whole thing on.
Is there a good thread for a complete socket size portfolio on the explorers. Thinking sizes over and above normal socket sizes found in your typical socket set?
Ford - Explorer :: 1997 4x4 - Rumble Up Front Above 90 Km/h - Wheel Bearing?
My wife's Explorer 4x4 has a noise in the front at around 100km/h. It is not detectable below 90km/h. Its not noticeable from a standstill until around 100, then you hear it a little. I find I can make it more noticeable if I vary my speed from 110 to 105 up and down, then its easier to hear. Once you get below 90 km/h you cant hear it at all.
I have a broken leg right now, and I normally do ALL my own work so I'm a little-limited mobility wise at the moment.
I'm suspecting a wheel bearing. I put the Explorer in the garage and my son jack up both wheels on the drivers side. I started the engine and SLOWLY accelerated up through the gears to 100. I know the hazards with this as I've done it with other vehicles, but this was the first 4x4. Then we jacked up the passenger side (after lowering the drivers side) and did the same thing. I could slightly hear/feel the rumble when the passenger side was jacked up.
I did drive the vehicle on my outdoor ramp/pit so I could use my crutches and get underneath to have a look. I grabbed the cv axles and they feel solid. The propeller shaft was replaced last year, and the cv axles look brand new. (bought the vehicle off a friend two years ago.).
So, are my suspicions correct, is it the pass. side wheel bearing? The Explorer has 294000kms. Never did test it on corners as I didn't want to swerve back and forth on the highway with the amount of traffic.
Ford Excursion :: Changing Out Front Wheel Bearing Hub Assembly
This past week I changed out the front wheel bearing hub assemblys on both sides. I'm curious if completely disassembled one of the units? If so what did you use to get the large nut with the 4 notches in it off?
View 2 RepliesFord F-150 (2004-2008) :: Left Front Wheel Bearing Keep Going Bad
What is causing the right front wheel bearing to keep going bad on my 06 f-150 2 wheel drive....
View 1 RepliesPrius (Gen 2) :: Dreaded Front Wheel Bearing Noise After Crossing A Puddle
I have the dreaded front wheel bearing noise front left had a monsoon last month in orlando. Went through a puddle. Did the front right 8 months ago,everythings fine I am doing uber. Can I spray some deep creep or oil in there to tempt calm the noise?
View 1 RepliesLeSabre :: Traction Control, ABS Light Came On - Replaced Front Wheel Bearing
I have a 2003 Buick Lesabre Custom, 146K miles on it
1st problem was that the passenger front wheel bearing went bad, I replaced it with a new bearing from Napa(cheaper one) drove it 1 day everything seemed fine, next day it was raining, and Traction control and abs light came on and continues to do so almost everytime I run the car. My Mechanic friend said this was a defective wheel sensor and that i should get a new one, I do not know if I should get the better one, every time I've ever changed the wheel hubs I have had this problem except when I use the more expensive hubs. Maybe I answered my own question on this one!!
Today when my wife was driving the car, the Service engine Soon light lit and it started bucking and shuddering going uphill, and it threw a code that said that TCC was stuck etc. I had been running the failing hub for a few weeks prior to this with no problems but when I changed this the other day, I started having problems.