Passat (B6) :: High Beams Are Not Working

I have a b6 Passat and the high beams are not working. I am going to be installing HIDS in the next week or so so I located a vag com disabled the drls and enabled Xenon without the shutter. now no high beams. they will only work with the car off and pull back the switch instead of pushing it forward.. I'm sure there are ppl on here with HIDs and there high beams working on a b6.

View 9 Replies

Passat (B6) :: 2007 - Bi-xenon High Beams Aren't Working On One Side?

I have an 07 with the AFS lighting. bulb error on dash- as I understand it, this has to do with a faulty shield for the high beam on the passenger side. Can this be repaired? Or should I just shell out the 300 for a used one on ebay.

View 3 Replies

Santa Fe (CM - 2007-12) :: Low Beams Not Working

I have a 2007 Hyundai Santa Fe. At first just the left head light went out, the next night I tried to turn my headlights on and they didn't come on. The high beams work but the low beams doesn't. I've replaced the bulbs from assuming they went bad. That didn't work, so I checked out the fuses, all of them were good. I don't know what else to check.

View 3 Replies

Golf V R32 :: 2008 - Low Beams Not Working

2008 R32... Why would my low beams not working, high beams work?

View 9 Replies

Prius (Gen 2) :: 2005 - High Beams Not Working

I'm a new owner of an 05 Toyota Prius. Im loving the car so far, however, i am having an issue with my high beams not working. After doing lots of research it looks like the high beams on the Prius comes from the same bulb, what controls the high beams is the reflector.

My low beams and all other lights are working fine. After removing my bumper and looking through all the wiring I have noticed that their are two plugs that are not attached to anything. The lights look brand new, so my thoughts are that this car had HID lights and they were then replaced to non-HID lights.

How to get the high beams working. I don't see any HID ballast anywhere, so converting it back to HID would be costly since i would need new headlight plus ballast and bulbs.

I tried looking for wiring diagrams but can seem to find any.

Here is the link to some images: Prius Photos by Izzy25323 | Photobucket

View 2 Replies

Santa Fe (CM - 2007-12) :: Low Beams Not Working Suddenly

I've seen a couple posts about low beam lights not working suddenly, but no real fixes to the issue. Looking for an actual fix that worked.

My lights; running, fog, high, and low beam, all worked yesterday. This morning when I try to go to work, all but the low beam lights work. Nothing was done differently, all fuses and relays appear to be intact, and the bulbs appear to be fine.

View 12 Replies

Santa FE SM (2001-06) :: 2004 - Low Beams Not Working

Replaced bulbs and checked fuses ... if u bump high beams they will flash ...

View 9 Replies

Sonata NF (2006-10) :: No High Beams Working

I replaced the high beam headlight bulbs in my 09 Sonata, resulting in no high beams working at all. Took out the new and put the old ones back in. Still not working. Checked all the fuses, and the relays. No problems there.

View 3 Replies

Jetta - Volkswagen :: 1986 - Low Beams Not Working

I just purchased an 86 turbo diesel jetta. The low beams aren't working. First of all, I must admit, how to turn them on. Second, the problem is probably not the bulbs, since the bulbs seam fine. I would like to try and fix this myself.

View 3 Replies

Prius (2010-12) :: Both Low Beams Stopped Working

Started my car this morning (2010) and both low beams aren't working. When set to on, only the daytime running lights come on (and yes I made sure the light switch was turned all the way). High beams work fine. Turned car off/on but still no good.

View 10 Replies

Chevrolet - Cobalt :: 2009 - Low Beams Won't Working

A week ago today my Low Beams stopped working, I turned on my car and they flashed on like normal, then a split second later went out; Just as the sun was setting too.

After finding a place to leave my car and hitching a ride home, I went back the next day to check it out.

Checked and double checked all the fuses, all were ok (I checked every single fuse, not just the lo beams)Checked all the wire connections to ensure they are tight.Replaced the light bulbs, still nothing.Ordered a new Headlight Switch, and just installed it today, Low Beams still don't work.

My High Beams, Blinkers, Hazards, Break Lights, and Daylights all work, just not my Low Beams, any clues as to what might the problem be?

2009 Chevy Cobalt, Just under 100k Miles

View 2 Replies

Malibu :: 2004 Only High Beams Working After A Replacement

Driver side low beam was burnt out. I replaced the bulb with a new one then no low beams would work, high beams work. Turning on manual switch and I checked fuse 7 & 10 fuses which were okay still no lights.

Could it be the low beam relay? The passenger side was working. Do they only come on when it is dark enough as I can't remember if they are running lights and worked in daylight?

View 1 Replies

Camry :: 2007 - All Lights Are Working Except High Beams

I've ran into an issue with my high beams on my 07 Camry SE. All lights are working except high beams. When you switch to high beams the lows only stay on. The dash light comes on and shows high beam indicator, but no brights! Fuses look good, and so do both bulbs. Going to go buy a bulb later today just to try. Like I noted they both just suddenly stopped. I'm leaning towards dimmer switch on column now.

View 11 Replies

Elantra MD (2010-15) :: 2011 - Low Beams Quit Working

I have a 2011 Elantra Sedan and my low-beams quit working. The high-beams work fine. I assumed the obvious and went to replace the bulbs but they appear to be intact and not burnt out. This led me to believe that it is related to a fuse or a relay. That being said, I cannot locate the fuse/relay in the fuse box under the hood that relates to this. What the fuse/relay is labeled as? I assumed it was under the hood but is it located in the fuse box in the cab?

View 4 Replies

Chevrolet - Equinox :: 2006 - Low Beams Working Intermittently?

We have an 06 Equinox, and lately the low beams have been working intermittently. Also, I don't think the running lights are working either. Low beams don't work on auto or in the "on" position. The high beams do work. We took it to the dealership yesterday and they said we had a bad resistor and replaced it for $270. Tonight my wife tried to drive home after dark and no headlights. She has to take this vehicle on a business trip soon.

View 11 Replies

GTI 337/20th Anniversary :: Low / High Beams And Blower Fan Not Working?

So I pullled into a reststop to relieve myself and when I drove off none of my lamps (high,low,or fog) worked. Along with them my blower fan does not work nor the rear defoggers, wipers, spray with wipers, turn signal (hazards do work though). Is there a fuse or relay that connects them together?

View 2 Replies

Prius (2010-12) :: Low Beams Stopped Working Unexpectedly

2010 Prius owner here. Both low beams stopped working unexpectedly last night. High beams still work, but when I switch to low beams, I just get the park lights.

View 3 Replies

Ford Excursion :: 2000 - High Beams Not Working

Low beams work fine. When I push the Multi-Function lever on the column forward to activate the high beams, I have no lights at all. When it is in low beam (middle) position, low beams work fine. When I pull back for click to pass, only the low beams are active. No high beam indicator in instrument cluster. I have:

1. Replaced both headlight bulbs

2. Replaced the multi-function switch on the column. Checked test pins on switch (MF) they are hot when in either high beam position or click to pass position

3. checked fuses (interior)
#8 - power on both sides of fuse
#16 (15a) High beam headlamps, instrument cluster. ***NO POWER ON EITHER SIDE***

4. checked fuses (engine compartment)
#10 - power on both sides
#21 - Power on both sides
#23 - power on both sides of fuse

View 14 Replies

Cavalier :: 2003 - High Beams Not Working / Bulbs Are Good

My High beams for a 2003 cavalier are not working. I checked the bulbs and they are good, The Low Beams Work and my drls work. I switch from low to high and the blue indicator on the cluster panel comes on.

View 5 Replies