Avalon 2005-12 :: Slight Rattle - Loose Right Front Caliper Bolt
My 2012 Avalon developed a slight rattle at 9000 miles that continued to get worse. I took off the right front wheel today and found the top caliper bolt partially loosened. I could turn it with my FINGERS! The other one was tight as were the ones on the left side.
To diagnose this rattle, find a bumpy road that makes it rattle. Put your foot lightly on the brake (to load the caliper). If the noise goes away, it is probably a loose caliper bolt.
Lexus LS 2007+ :: Dash Rattle Only Occurs When Cold Seems Like Bolt Is Loose
I own a 2011 IS350 RWD. My 4 year warranty just expired. So when it comes to rattles, the 4yr/50k miles no longer cover my rattle concern.
I spent about my 3rd year on a rattle that seems like only occurs when its cold. On cold days/morning, this rattle between the dash will come and it sounds like a bolt is loose, and is moving around or something like that along the lines of that.
So right before my 4th year mark came, I brought it in one last time to hope they can get rid of it. Once I got the car back, it was during winter.. so it still happened, but instead it was a lot louder than before.
Is there anything I can do? Since I've been trying to bring it in to get it checked out for a good year, I'm hoping there's a way for the dealership to honor that one concern I have with my IS.
Other than this rattle, I love my car. The rattle can get pretty bad/annoying especially when you're on a phone call. I bring this issue up during every oil change to get it checked out.
Honda - Accord - Suspension :: Rattle From Front Passenger Side As If A Bolt Is Loose And Jiggling Around
I have recently replaced all 4 struts in my car with monroe quick struts. I have a 2002 Accord. Everything went wonderful until a few weeks later I heard a rattle from the front passenger side. Its a light "tinny" rattle, almost as if a bolt was loose and it was jiggling around. It doesn't happen every time and sometimes goes away altogether. I took it to my trusted mechanic, and they spend a good 45 minutes inside looking at things and overtightened everything to no avail. I have ruled out a defective strut (as I replaced it with one and the new one does the same thing) and I ruled out the stabilizer bar bushing (brand new OEM part I installed) and I ruled out the sway bar link (also new).
View 4 RepliesFord 6.0L Power Stroke Diesel :: Center Bolt That Holds AC Clutch To The Compressor Loose
I have a 04 F250 6.0L ,The center bolt that holds the a/c clutch to the compressor. I'm assuming that bolt needs to be tight, correct? Mine was loose when I looked at it last night. My a/c squeals for a while trying to engage. Also, is that bolt right or left hand threads? Can that clutch be replaced without removing the compressor?
View 9 RepliesFord Super Duty (1999-2016) :: Loose Bolt Or Nut On Steering Column - Slipping?
My steering wheel is loose as in moves back and forth if pushed or pulled right at the wheel.. everything else seems tight and still turns and drives fine.. took off the airbag and the center nut is tight.. it's been getting progressively worse since I bought it.. What it could be??? Loose bolt or nut or the steering column?
View 2 RepliesPassat (B5) :: What Should Be The Bolt Pattern For 99 1.8t
What bolt pattern the wheels are on my 99 passat. Fairly new to the game. and can I put on the audi phat fives or the S4 wheels also what problems are run into when you put on 17's. does it mess up the on board computer that computes mpg and all that good stuff?
View 4 RepliesPassat (B5) :: How To Remove Restraining Bolt For Tie Rod
First of all... do I need to remove both, the restraining bolt AND nut to remove the tie rod end... if yes, than this bolt seized, the nut is easy but even if I punch the bolt it wont move... ??
View 4 RepliesPassat (B5) :: Changing Sway Bar - Can't Get The Bolt Out
I did change my motor mounts this weekend but when I tried to remove the sway bar,one of the nuts jammed on the bolt. Let me explain:The nut unscrewed well until the lasts mm, and then, the bolt head came loose, so it was spining freely with no way to remove it but cutting it, the bolt seems to be BUILT IN the alum. bracket that supports the engine mount. Question: can I change this bolt or is it really built in the bracket? I searched on ETKA but it just shows the nut and I can't find the bolt that I need.
View 1 RepliesPassat (B5) :: Can't Remove Sway Bar Link Bolt Out
Car: 02 Passat GLX 4motion V6 AWD
I'm in process of replacing the rear strut and I can't remove the way bar link bolt out. It is really tight into the inner rubber and it won't buzz. The bolt sits in a way that I can't use a hammer.
Passat (B6) :: Bolt Failure On Oil Pump Assembly?
Bolt failure on oil pump assembly in 2.0t FSI engine
View 9 RepliesPassat (B6) :: What Is The Part Number For Torque Insert Stretch Bolt
As the title implies I need the part # for the OEM VW Stretch bolt that holds the Torque Arm insert in place. I've had the mount on my car for a few months now and I've grown tired of it.
I re-used the OEM bolt the first time and I think I'm better off replacing it as it may not be wise to unbolt it and re-torque it for a third time. Looking for the part # for the stretch bolt? I believe it's 21mm.
Passat (B6) :: Replacing Brake Lines - Banjo Bolt Torque Setting
Going to replace brake lines tomorrow and would like to confirm the torque spec on the actual banjo bolt as not to break them but also don't want to leave them too loose...
View 3 RepliesPassat (B5) :: How To Get Passenger Side Engine Mount Bolt To Stop Spinning
So I just replaced my oil pump and i am reassembling my front end and I just cant get my passenger side engine mount bolt to stop spinning so i can get the nut on (the mount underneath the car) , I have no clue how to stop the spinning
View 1 RepliesPassat (B6) :: Changing Lower Control Arms / Driver Side Bolt Is Hitting Transmission Oil Pan
I changed the Passenger side with no problem , the driver side bolt is hitting the transmission oil pan. I am thinking of loosening the mounts and try to jack the pan up to get that 1 clearance or worst case drain the transmission take the pan off remove the bolt and put in fluid in. If I drop the the transmission pan is there a filter in there? also how much transmission fluid does it hold.
[IMG] ....
Passat (B7) :: Covering On The Rear Headrests Come Loose
I noticed that mine covering on the rear headrests come loose, so I took them into the dealer to get warranty replacements. The dealer replaced them, but out of their own stock; they did not file a claim with corporate because the service manager said VWoA is refusing to do so because they consider this damage to be owner caused. In reality though it's a very bad design, prone to failure.
View 1 RepliesPassat (B5) :: 1999 - Cover Under The Car Comes Loose On Front Side
I was driving and heard a noise. I immediately parked to the side and looked under and I noticed the thing was loose. My friend said the screws are missing.
Do I need to replace the whole thing? How much would it cost? Can I get the screws at a mechanic place?
Btw, I don't really wanna remove the whole thing. 99 Passat
Passat (B7) :: Engine Rattle / Mount Bolts Loose
Finally took the Wolf in to see about an engine rattle thats been getting worse. The culprit - loose engine mount bolts! Dealer decided to order new bolts, not just tighten the old ones. Also mentioned a recall for the transmission software. Odd that the "recall" wasn't listed on-line for my VIN. It must be the one that smooths the tranny a bit, it is a bit jumpy at low speed.
View 2 RepliesPassat (B7) :: Pedal Feels Almost Loose When Applying The Brakes
2014 Passat... I've got a little over 2,000 miles on mine now and I really do like the car. However, one thing that is really bothersome to me is----the brakes.
I'm not sure if it is specific to my car or to the passat in general. Here's the issue:
When applying the brakes, the pedal feels almost loose, as though the is no pressure on it, but once you push the pedal down far enough the brakes come on heavy, hard and fast. It's like turning on a light switch.
I am wondering if this is an adjustment that I can have done at the dealer to put more feel into the brakes or if this is just something that we all have to live with, of if maybe there could be something wrong with the brakes on my car.
Passat (B5) :: 2003 GLX 4 Motion V6 Rear Viscous Coupling Loose
I am looking at purchasing a 2003 passat glx 4motion (V6) with 170,000 miles on it for a winter car. The car I'm looking at has been diagnosed with a "rear viscous coupling loose" and a repair estimate of $1700 to fix. The car will be priced accordingly but I'm curious if this is something that I can repair myself and save a few beans.
I am pretty handy with repairs so that's not too big of a problem. I've been searching the forums and can't seem to find anything on this problem. Is this in the rear differential or is it a part of the Torsen center diff?
The car also has a clogged heater core, I've located plenty of info on this site on how to repair this so that won't be to hard.