Passat (B5) :: How To Remove Front Wheel Bearing Clip
I am in middle of "trying to" change the wheel bearing and I have the hub out but I can't figure out how this bearing needs to come out.
I have done it on MKIV Golf and like most other cars there is a C clip, but i can't see a clip in this knuckle.
Is this thing press fit in there without a clip? I have seen a guide for MKIV Jetta and people say Passat is almost the same, but not until I find this C clip.
Passat (B5) :: 2000 - Front Wheel Bearing Replacement
I m about to replace the front wheel bearing of my 2000 1.8 t I already rent the tool (hub and bearing puller and installer) from german auto parts.com but looking for pics of step by step of the process before starting the job.
View 4 RepliesPassat (B5) :: Front Left Wheel Bearing Replacement?
I have a 2000 Passat and brought it to a local shop to have the left front wheel bearing changed. He took the car apart and said he couldnt do it because the anti lock brake wire ran threw the control arm and had no plug on it and was wired right to the dash board. Should i find a different place to take it to or is it a dealer required fix. Can i buy the bearing myself and change it?
View 1 RepliesPassat (B7) :: Front End Makes A Squeak When Hit A Bump
The front end makes a squeak when you hit a bump. Not all bumps, but some bigger bumps will make a little squeak. The car is a 2012 passat se. Sitting on h&r sport springs, and stock shocks and struts. 35k miles.
View 7 RepliesPassat (B5) :: 2002 - Squeak From Front End Brakes
I have a 2002 passat and i have a squeak coming the front end of my car when i decelerate (let off the gas and coast, at low speeds). The car is a 5 speed. From other cars I have had, it sounds like it is the ebrake, like it kind of sticks on a little bit. When I coast while in neutral it does not do it. It also does it when I am in reverse, like leaving a parking spot.
View 6 RepliesPassat (B5) :: New Front Axle Causing Wheel Bearing Failure?
I had a ripped drivers side CV boot and had my indy replace the axle with a new Raxle. ~200 miles after the replacement the wheel bearing on that side went south. I shugged it off and had it replaced. Well, after 200 miles on the new bearing, it has also failed (100 miles from home). I gotta believe the 2 bearing fails are related to the new axle, but I don't understand how!
View 2 RepliesSubaru - Forester :: 2003 - Squeak From New Wheel Bearing
I have an '03 Subaru Forester and my mechanic recently replace the rear wheel bearings and seals. Afterward, I noticed a high pitch squeak from the rear right wheel at slow speeds. I brought it back for my next oil change and had them look at it. I watched them take off the wheel and brake drum. He hand-turned the wheel mount and it made the squeak sound from the bearing. Then he said that it's no big deal and put it all back together.
So, is it really not an issue? I'd rather not have noises coming from something brand new, but I also like my mechanic and don't want to make him do a lot of extra work if this thing is just going to go away on it's own.
Passat (B6) :: Front Suspension Squeak Very Loudly When Going Over Even Slightest Bump
My front suspension squeaks very loudly when going over even the slightest of bumps. I've looked at similar threads and have noticed some people replace the entire control arm, some just replace control arm bushings, others change the strut mounts/bearings.
Am I better off replacing all 3 components (control arms, bushings, and strut mounts/bearings) or just doing CA bushings and/or strut mounts? Do control arms normally need to be replaced? Car has 90K miles, and is daily driven year around during the cold Minnesota winter. My knowledge of suspension components is limited.
Passat (B5) :: 1999 - ABS And Brake Light Come On - Squeak From Front Brakes
I have a 1999 VW Passat 1.8T and the ABS light and Brake light come on from time to time but never steady for more than a few days at a time. I'm not sure why but my brakes work fine. The only possible thing is a squeak from the front brakes but they squeaked before the light came on. What this might be or how to fix it?
View 3 RepliesFord Super Duty (1999-2016) :: Bearing Squeak And Headlights Flicker / Battery Not Charging
I replaced my alt. because in the morning the bearing would squeak and the head lights flicker. It was a life time alt. Put the new one in now it wont charge. Took it back and got another, same thing. Also replaced the starter relay and battery. I checked the fusible links and replaced a terminal connector. The wires look good. There is 12v on the alt lug and pins 1 and 3 on the connector with the key off. Turn key on and 12v disappears form pins 1 & 3. Also checked all fuses in both boxes. I ohmed out the wire harness from the alt back to the connectors, all good. What am I missing? This is a 99 f530 5.4l.
View 9 RepliesFord Super Duty (1999-2016) :: 2002 - Vibration From Front Side - Spongy Brake Pedal - Front Hub Bearing?
Ive got a 2002 f250 Sd 4x4 with 93000. Im getting severe vibration from the front drivers side at highway speed. I thought it might be a warped rotor but i cant feel it in the brake pedal, when I put the brakes on. How can you tell when the hub bearing assembly is going bad? The truck doesnt pull to that side either. I can hear it, and feel it more when i'm going around highway corners. When im driving through town, I can hear a "clunk,clunk,clunk" noise coming from that side also.
View 14 RepliesPrius (2001-03) :: Changing 02 Front Bearing?
Need to change an 02 front wheel bearing. Can the the bearing be replaced without taking hub off? It slides or presses in.
View 4 RepliesCamry :: Front Wheel Bearing Hub Replacement On 2007 SE
Just had an oil change and during inspection they noticed that the drivers side wheel bearing is starting to go. They brought me back in the shop and I was able to feel the play in the bearing myself. Only a matter of time before it needs to be replaced.
How to replace the front wheel bearing/hub assembly? I don't have a press for the bearing itself so I'm assuming I can just replace the entire hub assembly. I have already replaced the drivers side rear hub assembly about 1.5 years back due to a bad bearing
Golf IV R32 :: Front Right Wheel Bearing Is Making Noise
So my front right Wheel bearing is making noise and its a used Knuckle so its w/e. Guess ill use tonight to do all my bushings and fluids n stuff.
View 6 RepliesSonata NF (2006-10) :: Front Wheel Bearing Replacement
2006 Sonata with 90k ... When I make right turns the left front wheel is making a rubbing sound with the motion of the wheel. It's not doing it on a straight line, just turning right. I've talked to a couple of my friends and they are telling me it's a wheel bearing. I have a service manual but it's not really going into detail on what I'm in for. I work on motorcycles all the time and my good friend said he has a press if I can bring him the knuckle and the OEM bearing. Looking for a little guidance before I take the wheel off and get started. Are there any special tools involved, etc...should I do the other side while I'm doing this also...
View 11 RepliesPrius (2004-09) :: Disassemble Front Strut / Top Bearing
I was going to put on some lowering spring on my prius last night but i couldnt figure out how to get the top bearing off. Looking for pictures or a guide or something?
View 1 RepliesPrius (2004-09) :: 2006 - Front End Has Bag Bearing Like Noise?
noise in my front end. I know there is a lot of stuff going on there so let me try. Noise is more like a groan not a squeak, tick, not an engine noise or a brake noise. Applying the brakes or turning the wheels does not make a noise. Best way to describe it to me it is like a bad bearing type of noise. The noise is starting to get louder.
View 19 RepliesToyota - Tacoma :: 2007 - Front End Bearing Noise
Got a 07 Tacoma with front end wheel bearing noise. How far can I push this ....
View 7 RepliesGolf V R32 :: Getting Front Brake Squeak
got my new brake set up installed about 3 days ago. Adams double slot rotors, ebc redstuff pads. I put about 250 miles on the new set up after bedding in the setup. Im now getting a squeak from the fronts when i hit the brakes normally. Is this something that will work its way out or is there an issue?
View 7 Replies