Passat (B5) :: Oil Leak Around The Timing Belt
Over the summer my car started having oil drips under it and it ended up being the valve cover gasket, so I replaced it. I noticed the half circle gasket next to the cam chain tensioner gasket was missing, so I just jammed it in there (didn't have tools/time to get cam chain gasket replaced). Before I changed these gaskets, oil would drip on the back side of the motor (farther from the front). Today I noticed drips of oil in front of the engine. Looking around there is oil in the timing belt area and is dripping down from there. It doesn't look like the VC gasket is leaking.
My question, what would cause oil to drip into/from the TB area?
engine = 1.8t ATW longitude
Passat (B5) :: Timing Belt Replacement?
I am looking for a link or instructions on replacing the timing belt on a 2.8 30V. I attempted to search and mostly came up w/ the info relating to the turbo.
View 2 RepliesPassat (B5) :: Car Died After Changing The Timing Belt
OK, so yesterday I changed my timing belt and all new components. I started the car before completely reassembling everything (bumpers, etc.) and it ran a little rough at first, then smoothed out. But this only lasted a few seconds and then it died out. I thought not much about it and finished my reassembly. Afterwards, the car would crank and crank and finally start. However, it would never idle smooth and it stalled out only after 1-2 seconds.
I did some investigation, and found the plugs all had wet oil on them. Changed them out and tried to start car with same results. Looked again at the plugs and they weren't as oily, but on their way. I looked all over for a source of this problem and found a broken "pipe" on the passenger side of the engine. It is black and sits behind a heat shield, directly under a larger black pipe. They both run from front to back. I think the broken one might be a vacuum line of some type, although when I plug it, nothing happens.
My fear is that I botched the timing belt job and subsequently, bent a mess of valves. But, I'm holding out hope for another cause of this dilemma. What is the smaller black tube/pipe on the side of the intake? The broken piece comes off a 90 degree elbow pointing to the ground. I'm guessing it was broken before the timing belt job, but who knows? Perhaps I broke it when I moved the radiator into service mode. Could it be part of the turbo? I thought that might cause the rough idle and stalling.
Oh, one other thing. When I last tried to start the car, I got a flashing "STOP" on the instrument panel, followed by something about the oil. The oil words only appeared for a split second before going away. Not even long enough for me to read the whole sentence.
Passat (B5) :: Keeps Stalling After Timing Belt Replaced
99 passat 1.8t with 5spd has 95k on it. 2 weeks ago my ex wifes car broke the timing belt and bent 12 valves so brought it to mechanics to get repaired and got it back seems to start up fine but when shes driving it stalls out on her. Mechanic says its something do with electronic throttle and nothing to do with his work. No check engine codes yet anyways .
View 1 RepliesPassat (B5) :: At What Mileage Need To Replace Timing Belt?
I was just curious and bored this morning. So I wanted to ask you all what mileage did you replace your timing belt at?
View 24 RepliesPassat (B5) :: Timing Belt Replacement After 105,000 Mile?
My 2004 Passat 1.8T GLS (station wagon) has 72,000 miles. I checked the manual which says that timing belt is to be replaced at 105,000 miles.
However, car is 8 years old - does the age matter or I should be fine until I get to 105,000 miles to replace the timing belt, tensioner, water pump etc.
Passat (B5) :: Timing Belt Replacement For 2.8 V6 Engine
I got 123000 km on my car. Manual says 144000 km is the right mileage to replace the belt, but I have heard opinions that it should be done earlier.
View 7 RepliesPassat (B5) :: 2000 - Changing Timing Belt?
I got 102k on my 2000 1.8T Passat, ATW engine code. I'm thinking about changing the timing belt. Is there any way to check if it was done before. How to recognize factory timing belt?
View 9 RepliesPassat (B5) :: Timing Belt Won't Working - How To Replace It
Of those out there whose Timing Belts HAVE failed , at what mileage have they gone bad and what damage was done?. This would be good to know to give an idea as to when to replace the Timing Belt.
View 12 RepliesPassat (B5) :: 2001 - Timing Belt Broke?
Looks like my timing belt broke. I was taking my car out of the parking lot, and heard the warning chime. I tried to look at the warning light, I think it was the malfunction one. I heard a belt/ fan snap. The engine stalled and I dint try to resart the engine. I had it towed to the dealership and am waiting to hear from them. The engine dint make mucg of a noise but sorta just died. Does this sound like a timing belt? I am worried abt the damage. how much would it cost if it was a timing belt? my car only had 73k miles on it. It is a 2001.5 1.8t.
View 5 RepliesPassat (B5) :: Timing Belt Replacement Every 60,000 Miles?
I was told that I must replace the timing belt every sixty thousand miles. Is this true?
View 24 RepliesPassat (B5) :: Serpentine And Timing Belt Needs To Be Replaced Simultaneously
Today I had my 2004 1.8T Passat in the shop for a few minor things. The car has only 89,000 KM's (NOT MILES~ I live in Canada) on it. They told me that my serpentine belt was needing to be replaced (which I knew) and they recommended that I to my timing belt at the same time. They told me that you can buy a kit that has the timing belt, tensioner and water pump in it. Anywhere I have read it has said to change your timing belt at 120,000 KMs.
View 2 RepliesPassat (B5) :: Replaced Timing Belt Now Car Idles Rough
I just had my timing belt, water pump, etc. replaced at a reputable indie VW shop. I just got the car back and it seems to idle a bit rough. The car used to purr like a kitten but now it shakes a bit in idle. Seems to run fine but the idle is rough. I'm going to bring it back to the shop on Monday. Can the timing be off a bit? Will it ever purr like a kitten again?
View 2 RepliesPassat (B5) :: 2001 - Timing Belt Correct Position?
I have a car Passat 2001 V6 and I need to know as changing the timing belt and the pump of water. Do I also need to know which the correct position of the timing belt is? As I know that this in the correct position and that the motor won't suffer damage. I wanted they could send me a diagram to see better as it is or that I use of reference to put it.
View 1 RepliesPassat (B5) :: Piston Damage After Broken Timing Belt
I recently broke a timing belt on my 1999 AEB 1.8t Passat. I'm in the process of doing all of the repairs myself while working around my college and work schedule. I have yet to pull the head off, and I'm scared of what I'll find when I do. Should I expect any piston damage? I have one completely broken valve and a bunch of bent valves.
View 12 RepliesPassat (B6) :: 2006 2.0t - Timing Belt And Water Pump Replacement?
How to change the timing belt and water pump on a 2006 2.0t passat?
View 3 RepliesPassat (B5) :: 2004 - Engine Is Backfiring After Changing Timing Belt
Recently I changed the timing belt on a 2004 Passat 1.8T and I realized I put the timing tensioner off by a few millimeters due to misunderstanding. I started the engine and it didn't sound very healthy. So I took off the timing belt and realized the tensioner was off by 8 millimeters. I corrected it and restarted the engine and it began back-firing. I re-checked and replaced the belt 3 more times and it still back-fired. The engine runs perfectly from a few seconds to a few minutes, then begins back firing and it stalls out. I had a recent post and I had suggestions to check all hoses, connections, etc. and to scan the computer for error codes. I did so and got the codes P0300, P0302, P0303, P0304. These codes mean back-fire in cylinders 2-4. I don't see any valve adjustments in the engine so could the valves be bent and do I have to replace them? God forbid D: Or do I have to reset some kind of computer code in the car or any other error that may need adjusting? All connections, hoses, wires, etc. are good. I've been a professional mechanic/technician for 25 years now and fixed cranes, bulldozers, semi-trucks, and anything else you can name that has wheels and is land based, all sorts of engines, gas, diesel, ethanol, you name it... I also worked on several VW's, including my own, and figured this V-Dub would be a walk in the park , but it turns out this Passat is the most complicated thing I've worked on in my life!
View 8 RepliesPassat (B5) :: 2002 1.8T - Ticking Noise After Replacing Timing Belt
I had the Timing belt, roller, tensioner, belts, etc replaced and I am getting this funny ticking noise after the engine tuns on. It seems to go away after the engine warms up but not all the time. I have the AWM engine and bought the kit from ECS tuning. My mechanic (who is excellent and beyond honest) thinks that I have sludge in the engine. The engine was super quiet before the whole kit was replaced so I doubt that all of a sudden the sludge, if present, would cause this. I have been meticulous with oil changes and always used the appropriate weight and type. Castol Syntec 502. My mechanic told me that the belts and everything looked in great shape at 89000 miles. I wonder if I should have bought OEM parts. Otherwise the car runs perfectly.
View 1 RepliesPassat (B5) :: Oil Leak After Replacing Timing Belt And Water Pump
I replaced a timing belt and related parts on a v 6 atq motor and three weeks later there's a pretty good oil leak, where its from or if oil leak can be related to timing belt replacement... leak seems to be in same area as crank pulley but not sure...
View 2 Replies