Honda - Odyssey :: 2006 - Serpentine Belt Breaking The Timing Belt
Serpentine belt on a 2006 Honda Odyssey fraying and then ripping into the timing belt causing that belt to break? I recently had this scenario given to me as the cause of my recently replaced timing belt breaking.
View 11 RepliesPassat (B5) :: Keeps Stalling After Timing Belt Replaced
99 passat 1.8t with 5spd has 95k on it. 2 weeks ago my ex wifes car broke the timing belt and bent 12 valves so brought it to mechanics to get repaired and got it back seems to start up fine but when shes driving it stalls out on her. Mechanic says its something do with electronic throttle and nothing to do with his work. No check engine codes yet anyways .
View 1 RepliesPassat (B5) :: Replaced Timing Belt Now Car Idles Rough
I just had my timing belt, water pump, etc. replaced at a reputable indie VW shop. I just got the car back and it seems to idle a bit rough. The car used to purr like a kitten but now it shakes a bit in idle. Seems to run fine but the idle is rough. I'm going to bring it back to the shop on Monday. Can the timing be off a bit? Will it ever purr like a kitten again?
View 2 RepliesPassat - Volkswagen :: 2003 - Shakes When Idling After Timing Belt Replaced
We recently had the timing belt replaced in our 2003 Volkswagen Passat (1.8T). Now it shakes and vibrates badly when we put it in drive and idle. It ran smoothly before we had the belt replaced. The mechanic hasn't found a solution yet.
View 2 RepliesPrius (Gen 2) :: How Often Serpentine Belt Should Be Replaced
I am very concerned regarding how often my serpentine belt needs to be replaced. First time it was replaced at 104k, second time dealer replaced it at 126k, third time at 153k. Today I went for oil change (173k) and the dealer told me that it has little cracks and recommend replacing it. Is it normal? Could it be something else is affecting it?
View 11 RepliesFord - Taurus :: Serpentine Belt Squeak Due To Contamination / Timing Cover Leak
My serp belt squeaks due to contamination due to timing cover leak. I removed belt and cleaned it with mild degreaser solution and it was quiet for 1 day. If I had 100% water in cooling system, would any more leakage cause a belt squeak? I am putting off fixing timing cover gasket since it is a 5hr job. Coolant is @ 90% water concentration now.
Taurus 3.0 Vulcan motor.
Sonata NF (2006-10) :: Just Replaced Serpentine Belt Now Squeaking
I just replaced the original serpentine belt at 95k miles (more preventative than anything) and now it's squeaking. Does this mean I have to replace the tensioner?
View 11 RepliesPrius (2004-09) :: Serpentine Belt Just Replaced And Car Dies
I took my Prius II to the dealer to get my key fob reprogrammed. While doing that they did a routine check and noticed that my serpentine belt was quite worn. I had them replace it.
View 2 RepliesSanta Fe (CM - 2007-12) :: Serpentine Belt Replaced Still Squeaking And Slipping?
Long story short is, I replaced my 2007 Santa Fe's serpentine belt and it still squeals for some time after we start the vehicle (then stops) ... but more importantly I *think* its still slipping if we're driving during rain or on very wet roads.
Long story long is ... the problem appeared as loss of power steering and air conditioning when driving during rain. Took it to the dealer and they suggested to replace the serpentine belt, replace the shroud (plastic) that covers the belt, and replace the timing belt. As we have 36k miles on it, no one I talked to understood the timing belt suggestion. I see though perhaps its just because the car is 4 years old? The shroud the dealer claimed was cracked and may be letting water in on to the belt. However, they completely removed it and did not replace it so I was not able to inspect this myself (wife took the car in for the appointment).
I bought the new belt and put it on. The squeaking was gone but as soon as I hit rain again, the slipping was back as bad as before (and we'd lose power steering / air conditioning same as before). I had a 1.5 hour drive in rain where the belt was slipping almost nonstop; constant back and forth between catching and slipping.
When the replacement shroud came in I thought that might solve the problem - keeping moisture off the belt. However with that in place I'm afraid there is still some slippage as I've noticed some dashboard lights come on during brief heavy rain. Also the initial squeaking is back when we start the car.
Chrysler - Towncountry :: Won't Go Past Second Gear After Serpentine Belt Replaced
My wife's town and country had its serpentine belt replaced. Now it won't go past second gear and is running 3.5 rpms at 40 mph. What do I do?
View 3 RepliesElantra XD (2001-06) :: Timing Belt Replaced Now Car Won't Crank Over
Changed the timing belt. Used the red mark up top and the cut in the block on the lower one to get TDC. Changed everything with new parts. Double checked the marks after the belts were on (rotated by hand through two full turns and checked to see if the marks were in the same spot). I followed the write up that was posted here by U95.
Anyway, the car won't start. It tries cranking, but won't actually start. There is fuel and the battery should be good to go. There shouldn't be any Fuel/Compression/Air issues.
I guess my question is: If the timing belt is not tightened enough, would that keep it from firing?
Also, in trying to crank it by key every thing sounds normal (no knocks or pings or valves getting bent sounds) and turning by hand gives just the little bit or normal resistance but spins nicely.
I'll probably take the battery to get it load (I used my tender to try and start it as well, didn't make a difference) tested tomorrow and then try the starter (shouldn't be bad though, only 60k on the car). Otherwise I'll have to teardown and start over.
Dodge - Stratus :: Replaced Timing Belt Now Won't Start?
Brought my car to a garage that someone suggested to have a new timing belt put in. After I picked it up I was having problems ((I would try and start car but it would take a few trys to get it started)I called garage told them i thought the timing belt needed to be adjusted. They told me that was not the problem but i needed some censor. Well now my car wont start at all so i brought it to another garage who tells me that the timig belt was placed wrong. My question is..Now what? lol. Do I ask for my money back seeing that they didnt fix it? Do i have the same garage just fix it?(i didnt like them in the first place so really dont want to go back. If i do ask for them for money back and they give me a hard time,what can i do? or who do i call first?
View 4 RepliesGolf IV / Jetta IV :: Car Turns Over But Will Not Start After Timing Belt Replaced
I just got my timing belt replaced by my mobile mechanic thats been doing it for years. I saw him do the work and get the timing right. When he was done the car turned on and ran perfect. After about a minute the car just shuts off. Now the car won't start at all. The car turns over but no start. The car ran perfectly before I had this job done.
View 9 Replies2006 Dodgr Stratus SXT Timing Belt Replaced - Rough Idle
My car has 103000 miles on it and the timing belt was replaced several hundred miles ago. After the service I noticed it had a bit of a rough idle and a very slight sputtering noise, but still no check engine light. Was the timing belt put on wrong? The engine is non-interference, by the way.
View 1 RepliesAccent MC (2006-11) :: Can Water Pump Be Replaced Without Removing Timing Belt?
I have a 2007 Accent with 119K on it.
I wanted to replace the water pump and I was wondering if this can be replaced without removing the timing belt or the lower timing belt cover?
Mitsubishi - Endeavor :: Sputtered Out And Won't Start After Timing Belt And Water Pump Replaced
A mechanic has my car and replaced my timing belt and water pump....he said he had it running and then it sputtered out and wont start..i have never had a problem with this car. Just replacing before it went out.. he is missing something.
View 19 RepliesGolf IV / Jetta IV :: TDI Won't Start After Timing Belt Replaced / Cranks And Blows Black Smoke
So i just spent over $1700 at a vw service ctr having a sched 140k timing belt replaced with thermo and fuel filter. This was 3 days ago and when i picked it up it was slower to turn over then got worse and todsy it won't turn over at all even when jumped. It cranks and blows black smoke. Problem is i'm 160 miles from that svc center and it's sunday. There is a vw svc center 14 miles away but i feel like it needs to ho back to where the work was done because it ran great before taking it there.
View 5 RepliesPassat (B5) :: How To Access The Serpentine Belt
Pulled off front bumper today with no success, seems like the whole radiator and a/c unit must be removed?
View 5 RepliesPassat (B5) :: Serpentine Belt Slippage On Takeoff Or Throttle Change
I know the serp belts were done on my 1.8T passat 25k miles ago. The tensioners were not done, of course.
While the engine is still cool I sometimes hear belt slippage on take off or throttle change. I was thinking to just replace the serp belts but then it occurred to me that it could be one of the tensioners causing the problem.
Are the tensioners prone to failure? Or I should just change belts? Car has 92k miles on it total.