Mazda - Tribute :: Car Stalls / Engine Starts Up Then Cuts Out
I have a Mazda Tribute with a manual transmission. About two years ago a sporadic issue started occurring. I would drive somewhere with no problems. Stop the car and park. Then when I would go to drive off the car would stall. It stalls and stalls and stalls. Start up the engine, it cuts out. Weird thing is that I can limp home. I give it gas and I back up. Then when I stop it stalls. I shift into 1st and drive, I can get up to highway speeds no problem, then drive (the most I have had to go is 45 miles) on the highway, but when I get off and get to a stop or a light, the car stalls. Start it up and keep this going all the way home.
Two hours later, get in the car... like NOTHING happened. I have brought it to my mechanic, the dealership and asked countless friends to no avail. They always say "bring the car to me when its doing that." The one time I had a shot at that, I got it to the dealer, and then it didn't stall. It stalled the whole way to the dealer, but not when I got there.
Mazda - Tribute :: O2 Sensors Causing Check Engine Light To Come On
I have a 2001 Mazda Tribute with 141,000 miles. Recently, I've burned up both O2 sensors causing the check engine light to come on. My mechanic has replaced each and they've burned out again. The head gasket was replaced after that, to no avail. The check engine light continues to come on after being cleared in the computer. I have also noticed that on humid days, the car misfires on at least one cylinder., but any other time, it seems fine. What to check next? My mechanic is at a loss.
View 2 RepliesMazda - Tribute :: Stalling Out When Come To A Stop
I am a proud owner of a 06 Mazda tribute 3.0, 6 cylinder, 2 wheel drive, automatic. That is not the problem. The problem is on long drive 100 miles or more when we take a pit stop, to stretch our legs, we exit and when we come to a stop the suv stalls out. Its like we are driving a manual and forgot to push in the clutch. We can start it right back up and when we put it in drive it does it again. If we start it in neutral it will ideal but as we shift to drive it stalls out. We are not seeing any other problems. The MPG are the same and haven't gotten any worse. What should I look into fixing?
View 11 RepliesMazda - Tribute :: 2006 - Cannot Get Pedal To Depress When Trying To Move From A Stop
I can't get the pedal to depress when trying to move from a stop. I was doing fine until this evening when heading back to my hotel following a theater performance. When attempting to accelerate from a stop light . . . NOTHING. I put the car in neutral and stomped on the pedal a few times and it finally engaged. Happened again when trying to merge onto the highway. As long as I keep pressure on the pedal it is fine, but as soon as I release it sticks in the "up" position. Naturally, I'm away from home, the roads are icy, and it's Sunday!
View 4 RepliesGolf IV / Jetta IV :: 2002 VR6 Just Quit When Came To A Stop Sign Now Won't Restart
I came to a stop at a stop sign and the car just quit. Its a 02 12v vr6 5 speed...
So I tried restarting it and it will only crank...
Mazda - Tribute :: 2002 V6 Engine Would Sputter Or Misfire
I have a 2002 Mazda Tribute V6 with 151K. My check engine light has come off and on for quite a while now, mostly it would come on when it rained and then go off when the weather cleared. When it was on, the engine would sputter or misfire. I first had Auto Zone hook it up and they said it needed its plugs and wires changed. No problem. I took it in to a repair place and was informed that I don't have plugs and wires, but something with coils and that since it was impossible to determine which coil was bad, all would have to be replaced at a cost of $1500. I then took it to another repair place and they said the same thing. Now I have seen some discussions regarding this same thing and apparently some people have been able to identify a specific coil. At this point my check engine light is now on all the time and I'm really worried about doing terrible damage.
View 19 RepliesMazda - Tribute :: 2006 - Engine Knocking Noise
The engine in my 2006 Mazda Tribute seems to have developed a knocking noise. I am not sure what causes it or how to determine where it is coming from.
View 11 RepliesMazda - Tribute :: 2003 - Engine Idle Gets Really Low (like 500 RPM Or Less) And Sometime Stalls
When I am slowing to a stop, my engine idle gets really low (like 500rpm or less) and sometime stalls. At the same time, the oil light comes on. It does this all the time, and yes I've had my oil changed recently and actually I just checked it the other day and it was fine (along with all other fluids).
I've had the mechanic take a look at this three times and every time something gets fixed but this problem remains. They now say it's a ghost. It is not the air intake (I've had all of the hoses checked and a bad one replaced). It's not the electrical (I've had the spark plugs and cables replaced about a year and a half ago).
I've pretty much had everything that a car of a certain age needs done fixed/replaced in the past year or so, and I still can't figure out what could be causing this. A recent show had a similar problem, but the gal didn't mention the low idle/stalling. In that show they mentioned that she should have the oil pressure gauge checked or replaced, but would that cause the low idle/stalling? I don't know what to do and I'm very reluctant to go to a dealer.
Mazda - Tribute :: 2005 - ABS Warning Light Comes On When Reach 40mph
My 2005 Mazda Tribute has an ABS warning light that comes on as soon as I reach 40 mph. It will remain on after that no matter what speed I drive until I turn the car off. The braking system appears to function normally with normal breaking even if the light is on. With hard braking the ABS performs as it should too, rapidly oscillating the braking force. If I restart the car and keep the driving speed below 40 mph the ABS light never comes on. Otherwise, the car runs great. What is causing the ABS light to come on at 40 mph and how do I fix it?
View 2 RepliesMazda - 626 :: After Driving In Stop And Go Traffic Car Won't Restart On Hot Days
Recently when I drive for a while in traffic (stop and go) and then park my car for a quick errand and try to restart it won't start. This has only happened on extremely hot days ( over 90 degrees). I replaced the battery after the first time which was in April. It is now June and its happened 2 times in 2 weeks again. I have been able to start it after letting it sit for over an hour or with a jump. I'm getting nervous to run errands and the weather isn't getting any cooler.
View 7 RepliesMazda - Tribute :: 2003 - Squeak Come From Main Belt On Left Side Of Engine?
My 2003 Tribute has started squeaking. Seems to come from the main belt on the left side of the engine. Faint at idle, but gets somewhat louder as the rpms go up. What is the accepted protocol for dealing with this? How do I understand if the belt needs replacing, or if something is out of alignment? BTW, as best as I can see/feel it, the belt itself is in OK shape. Is there some kind of lube? (Though it's a smooth belt, so that might not be smart ...)
View 6 RepliesMazda - Tribute :: 2002 V6 - Releasing Throttle Does Not Result In Engine Decelerating Or Returning To Idle
We've owned this 2002 Mazda Tribute v6 for six years. Recently, the car has become somewhat dangerous to drive. While driving down the road at any speed, releasing the throttle does not result in the engine decelerating or returning to idle. Instead, it continues to hold the speed steady for 3-5 seconds before the RPMs drop. At lower speeds (~5mph or so) the car will even accelerate a bit, which can be a problem in tight parking situations. At higher speeds (e.g. on the freeway) releasing the throttle has no effect for a few seconds (ie it does not decelerate), which can be very surprising if you're responding to suddenly slowing traffic. The brakes can, of course, overpower the engine, but you do have to push harder to get the same braking effect as if you were not fighting against the engine. Releasing the throttle and shifting into neutral while driving causes the engine to rev quite high (3,000rpm) for the same 3-5 seconds before dropping to a steady idle, but it does allow you to brake normally. Shifting back into Drive while in motion but not touching the throttle causes the engine to decelerate the car normally. Touch the gas even briefly, though, and the engine will once again surge.
Oh, and turning the steering wheel from side to side, as you might do while parking, also causes the engine to surge, though not as much as it does when I touch the gas pedal. Also, I've disconnected the throttle and cruise control cables and worked the throttle plate by hand. Doing so causes the RPM to rise, as you expect, but it does not immediately return to idle when the throttle plate snaps shut. Instead, the RPMs stay around 12~1500 for 3-5 seconds before it drops to idle.
Over the years, I've replaced the throttle position sensor, idle air control valve, and other normal maintenance items. I used a meter to troubleshoot the IAC and TPS and used propane to look for vacuum leaks, but everything is within spec. There are recall notices related to unintended acceleration for these vehicles, but those are reportedly caused by interference between the engine cover and cruise control. I do my own maintenance and don't like engine covers, so I removed the cover from this car shortly after buying it; the engine cover cannot be causing this problem. I have disconnected the battery for an hour to reset the computer, but that has no effect. There are no trouble codes that show up on a OBD-II scanner, and the CEL is not illuminated. There are many internet reports of this problem, but thus far I've found none that indicate a solution.
Mazda - Tribute :: Rough Idle When Cold / RPMs Drop Close To Stalling When Stopping At A Light
I have a 2001 Mazda Tribute with 150,000 miles that is meticulously maintained. This past winter (as far as winter goes in San Diego) the engine would run rough and the rpm's would drop close to stalling when stopping at a light for the first 2 or 3 miles. After that the engine has warmed and there is no problem. Could this be the intake gaskets needing replacement. This only happens on a cool or damp, rainly morning.
View 6 RepliesFord F-150 (2004-2008) :: Bump Every Time When Stop At A Light Or Stop Sign
I have a 04 lariat f150. Problem is every time I stop at a light or stop sign I hear and feel a bump. Coming from the rear I guess . Had my truck aligned asked the alignment person about the situation he said ford just do that. True or false ...
View 2 RepliesMazda :: 1986 B2000 Engine Would Run For A Few Minutes And Will Not Restart
My 1986 B2000 problems started when the engine would run for a few minutes and not restart. After it sat a while, it would restart.
Through out the process of seeking a fix, I have replaced the fuel pump, coil, distributor cap, rotor, pick-up coil in the distributor, condenser, and spark plug wires and coli wire.
Currently, there is no spark out of the coil wire feeding the distribute.There are 12 volts at the positive and negative side of the coil terminals when the key is in the “run” position.There is about 10 volts to each coil terminal when the engine is cranking over.
I have tried using the old coil and the old pick-up coil in the distributor, but with no luck.
Mazda - Tribute :: 2008 - Front End Noise
I have a 2008 Mazda Tribute with 93k miles on it. These last few years have been a nightmare. The car is constantly in the shop. I’ve been trying to diagnose and repair front end problems. Recently, I had my tires rotated and balanced. New sound: Now I’m having loose play in my steering wheel and a loud clicking/creaking sound when I turn the wheel at low speeds or attempting to parallel park. Ongoing sound: the car makes a tight creaking noise when I stop at low speeds. This sounds like something is tightening or screechy brakes. Here’s all of the repairs that I’ve done to the vehicle:
46,000 (11/16/12) Replaced entire right-front CV axle.
52,201 (3/10/13) Replaced front brake pads and rotors. Replaced both front sway bar links.
58,602 (7/10/13) Replaced both front control arms, serpentine belt, and tensioner/pulley for belt.
66,257 (3/23/14) Transmission fluid changed, leaking value seals replaced, spark plugs + wires changed.
81,258 (8/16/15) All four tires replaced with new ones.
84,797 (9/12/15) New front brake pads (ceramic), rotors serviced.
86,391 (10/5/15) Both front struts replaced, both outer tie-rods replaced, wheel alignment performed.
91,308 (1/12/16) Both front ball joints replaced. Both front wheel bearings replaced.
93,744 (3/5/16) Tires rotated and balanced.
I’m running out of things to fix on the front suspension of this vehicle it’s extremely frustrating. I’m nervous to drive on freeways at high speeds because the steering is wobbly but I don’t know how to fix it.
Here's a youtube video where you can hear the noise. Note the "play" in the wobbly steering wheel when the video first starts. [URL] ....
Mazda - Tribute :: 2001 - Stuck In Neutral
I was backing out of the driveway a day ago and my gear got stuck in neutral,can not move the gear shifter and just don't know what to to do. This has never happened before.
View 9 RepliesMazda - Tribute :: 2005 - Knocking Getting Worse?
i have a 2005 mazda tribute v6. it has been knocking for about a year slowly geting worse. no check engine lite on, so i think it may be the egr valve. just wonder how to check it.
View 7 RepliesMazda - Tribute :: 2008 - Losing Power And Bucking Really Bad
I have an 08 mazda tribute 2.3litre 5 speed. The truck started losing power and bucking really bad about 2 months ago. If I shut the truck off and let it sit for a few minutes, then start it back up, it runs fine for maybe 10 minutes or maybe a week then it eventually starts missing and bucking again. It throws the code p0191 which is the fuel rail pressure sensor. I have replaced the sensor twice and put new plugs, wires, coil packs, fuel filter and even replaced the pcm. The truck is still doing the same thing and throwing the same code. My Mechanic and myself are stumped.
View 8 Replies